• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.14 no.1
• /
• pp.8-18
• /
• 2002

In this paper, wave energy absorption of OWC(oscillating water column) device is analyzed. The analytic model consists of a partially immersed circular vertical cylinder open at its end and an air turbine connected with the air chamber. The boundary value problem is decomposed into scattering problem related to scattering by an incident wave in the absence of a pressure variation and radiation problem describing the flow due to an oscillating pressure in the absence of an incident wave. By invoking the continuity of an air flow inside the chamber, the oscillating pressure in a chamber is derived. With oscillating pressure, the mean power absorbed by OWC device and the capture width are obtained. In numerical calculation, the induced volume flux across the internal free surface of the chamber in the scattering and radiation problem and the maximum capture width are compared with various design parameters such as radius and submergence depth of chamber and wave conditions. The maximum capture width obtained by choosing the optimal value of turbine constant occurs at the first resonant mode (Helmholtz mode) among the natural frequencies of a circular cylinder chamber.

• Korean Chemical Engineering Research
• /
• v.44 no.5
• /
• pp.498-504
• /
• 2006

The etch rates of photoresist (PR) and the etch selectivity of $SiO_2$ to PR in a high density $CHF_3$ plasma were investigated at different ion-incident angles and bias voltages. A Faraday cage was employed for the accurate control of ion-incident angles. The ion energy was controlled by changing bias voltages. The etch rate of $SiO_2$ continuously decreased with ion-incident angles but the etch rate of PR remained constant up to the middle angle region and decreased afterwards. The etch rates of $SiO_2$ normalized to those at $0^{\circ}$ incident angle changed with the ion-incident angle following a cosine(${\theta}$) curve. On the other hand, the normalized etch rates of the PR changed showing a drastic over-cosine shape in the middle angle region. The etch selectivity of $SiO_2$ to PR decreased with an increase in the ion-incident angle because the etch yields of PR were enhanced by physical sputtering in the middle angle region compared to the case of $SiO_2$ etching. The etch selectivity of $SiO_2$ to PR decreased with an increase in the bias voltage at nearly all ion-incident angles.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2013.05a
• /
• pp.205-205
• /
• 2013

플라즈마 밀도, 전자 온도, 쉬스 전압이 플라즈마 디웨팅으로 나노 분말 어레이를 제작할 때에 끼치는 영향을 연구하였다. 플라즈마 변수를 조절하여 기판에 입사하는 이온 충돌 에너지가 높은 조건에서는 디웨팅 시에 홀이 상대적으로 많이 생성이 되어 균일한 구리 나노 분말이 생성되었고, 반대의 경우에는 디웨팅 시 홀이 적게 생성되어 크고 작은 나노분말이 혼재해 있는 불균일한 구리 나노 분말 어레이가 형성되었다. 따라서 이온 충돌 에너지를 조절하면 구리 나노 분말의 균일도를 조절할 수 있다.

• Proceedings of the Korean Society of Coastal and Ocean Engineers Conference
• /
• 1998.09a
• /
• pp.84-87
• /
• 1998

본 연구에서는 음향학에서 음파를 제어하는데 주로 이용되는 헤름홀츠 공명장치의 원리를 방파제에 응용하였다. 외해에서 발생된 입사파는 Fig.1에 보여진 입구를 가진 공명 구조물(Resonant Structure)을 만나면 에너지 일부는 입구를 통하여 방사(Radiate)되며 또 일부 에너지는 입구를 통하여 공명 구조물 안으로 방사된다. 공명 구조물 안으로 들어온 파의 주파수와 공명 구조물의 고유 주파수(Natural Frequency)들 중 첫 번째 공진 모드(Resonance Mode)의 주파수가 일치되면 구조물 내부에서의 파는 크게 증폭된다. (중략)

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.11 no.4
• /
• pp.216-230
• /
• 1999

A Galerkin finite element model for the analysis of harbor oscillation has been developed based on the extended mild-slope equation. Infinite elements are used to accomodate the radiation condition at infinity and joint elements to treat the matching conditions at the harbor entrance which include the energy loss due to flow separation. The numerical tests for rectangular harbors with fully or partially open entrances show that the energy loss at the harbor entrance considerably reduces the the amplification ratios at the innermost parts of the harbors and that the amplification ratios decrease considerably with increasing incident wave heights and jet lengths at the harbor entrance. Application of the model to the Gamcheon harbor show that when the incident wave amplitude is small the amplification ratios rather increase when the entrance energy loss is included than when ignored because of the shift of the resonance periods. Even though the entrance energy loss was insignificant for the measured long-period incident waves, it would be of great importance if the incident waves were large as in the attack of tsunamis. The resonance period of the Helmholtz mode at the Gamcheon Harbor was calculated to be 31 minutes, which agrees well with the measured one between 27 and 33.3 minutes. The measured resonance periods between 9.4 and 12.1 minutes and 5.2 and 6.2 minutes were also calculated by the numerical model as 10.4 minutes and 6.6 or 5.6 minutes, indicating good performance of the model. On the other hand, it was shown that a variety of oscillation modes exists in the Gamcheon Harbor and lateral resonances of considerable amplification ratios also exist at the periods of 3.6 and 1.6 minutes as in the Young-II Bay.

• Journal of the Korean Society of Radiology
• /
• v.11 no.2
• /
• pp.87-94
• /
• 2017

Monte Carlo simulations were used to assess dose enhancement effects for 60-, 90-, 120-, and 150-kV X-rays, and for 6- and 15-MV X-rays. The MCNPX code was used for a computer simulation of the ICRU slab phantom, and gold, gadolinium, and iron oxide (Fe2O3) were employed as dose enhancement agents. In consideration of the buildup region of the incident energy, agent concentrations of 5, 10, 15, and 20 mg/g were inserted on the surface of the phantom at a depth of 5 cm. Based on baseline values obtained in the absence of dose enhancement agents, a quantitative analysis was performed by evaluating depth-dependent changes in the absorbed energy and the dose enhancement factor (DEF). A higher concentration of dose enhancement agents led to a greater dose enhancement effect with iron oxide, gadolinium, and gold in descending order. For kilovoltage (kV) X-rays, as the incident energy was decreased and as the energy became closer to the ionization potential of the atoms in the enhancement agent, the dose enhancement effect increased. In the megavoltage (MV) X-ray range, dose enhancement was higher at 6 MV compared with 15 MV. However, the overall dose enhancements were significantly lower compared to the results obtained with kV X-rays.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.03b
• /
• pp.39-39
• /
• 2010

낮은 에너지를 이용하여 상대론적 영역에서 동작하는 마이크로파 출력장치를 연구하였다 그에 따른 후진파 발진기는 대전력 마이크로파를 발생시키는 장치로서 연구하였으며 관내에 전자빔을 입사시킴으로서 발진이 일어나 출력을 발생 시킨다.

• Electric Engineers Magazine
• /
• v.228 no.8
• /
• pp.58-63
• /
• 2001

낮시간에 창이 있는 장소에서는 주광의 입사로 제법 높은 조도가 얻어지면 그의 정도는 기상조건이나 건물 및 창의 구조, 실내조건 등에 따라서도 변화한다. 따라서 변화하는 외광의 밝음을 실내에 설치된 주광센서로 검지하여 창가에 있는 일정범위내의 조명기구를 자동적으로 점멸 제어하여 전력절감을 도모하는 것이다.

• Progress in Medical Physics
• /
• v.6 no.2
• /
• pp.3-12
• /
• 1995

A 50 $\mu\textrm{m}$ thick niobium filter and its quantitatively determined aluminum equivalent filter were evaluated for effects on entrance skin dose, image quality, and x-ray tube loading for three different tube voltages in radiology. There was no significant difference in the reducion in entrance skin dose and increase in tube loading between two filters while keeping radiographic contrast on the film. For the clinical use of the aluminum equivalent filter as an alternative to the niobium filter in radiology, aluminum equivalent filter thickness at the mid energy range of radiology, 90 kVp, was measured and the filter was applied to the other kVp values, 73 and 125 kVps, to evaluate the effect on the entrance skin dose and tube loading. There was no significant difference between two filter cases at the selected kVp. The aluminum filter with equivalent thickness can be used as an inexpensive alternative to the niobium filter.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.16 no.4
• /
• pp.234-240
• /
• 1997

We studied the resolution enhancement of a novel scanning laser acoustic microscope (SLAM) using transverse waves. Mode conversion of the ultrasonic wave takes place at the liquid-solid interface and some energy of the insonifying longitudinal waves in the water will convert to transverse wave energy within the solid specimen. The resolution of SLAM depends on the size of detecting laser spot and the wavelength of the insonifying ultrasonic waves. Science the wavelength of the transverse wave is shorter than that of the longitudinal wave, we are able to achieve the high resolution by using transverse waves. In order to operate SLAM in the transverse wave mode, we made wedge for changing the incident angle. Our experimental results with model 2140 SLAM and an aluminum specimen showed higher contrast of the SLAM image in the transverse wave mode than that in the longitudinal wave mode.