• Korean Journal of Soil Science and Fertilizer
• /
• v.10 no.2
• /
• pp.93-97
• /
• 1977

A pot experiment was conducted to find out suitable method in determining the rate of phosphorus application. Soybean was planted under optimum moisture condition. The soils used in this experiment were cultivated and non-cultivated mineral soils, and volcanic ash soils. The results were summarized as follows: 1. Phosphorus adsorption maximum(PAM) was the good parameters to determine phosphorus adsorption capacity of all tested soils. 2. Phosporus adsorption maximum was increased with the content of ammonium acetate extractable aluminum, and the organic matter effects on PAM was considerably high in volcanic ash soils. 3. Requirement of phosphorus for maximum yields were in the range of 30~35% of PAM for tested soils. 4. PAM was considered as a suitable criteria to determine the rate of the phosphorus application and it was also considered to be more attractive than phosphorus absorption coefficient.

• Applied Biological Chemistry
• /
• v.44 no.2
• /
• pp.92-96
• /
• 2001

Soil physical-chemical properties and phosphorous adsorption characteristics were investigated to obtain the informations of the appropriate fertilization and soil management in Baicheng region, China, where agricultural circumstances at present forces to consider the use of land for crop production. Soils were collected from one uncultivated and three cultivated lands on August 1993. Soil $_PH$ was very higher in uncultivated land than in cultivated land, their values were 10.2 and 7.4, respectively. Regardless of cultivation, soil organic matter contents were below 2%, and concentrations of available soil phosphorus expressed as Bray 1 P and Olson P were less than 10 mg P $kg^{-1}$, however, cation exchange capacity was higher than 20 cmol(+) $kg^{-1}$. For uncultivated soil, the values of exchangeable sodium percent and calcium saturation percent were higher than 100%. The major cation of soil saturation paste extracts was Na regardless of land use type. Based on electrical conductivity and sodium adsorption ratio of saturation paste extracts, uncultivated soil was classified as saline-sodic soil and cultivated soil was classified as sodic or normal soil. The maximum adsorption capacity of phosphorus calculated by Langmuir isotherm ranged from 406 to 521 mg P ,$kg^{-1}$. The constraints of soils in Baicheng regions for agricultural cops werw high salt concentration, unfavorable soil chemical composition such as low concentration of available phosphorous, and poor drainage due to soil dispersion by high Na concentration. Therefore, the soil in Baicheng region, need the application of phosphorus fertilizer to increase the soil fertility and the proper soil management to improve the soil physical property especially permeability and soil structure.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.9
• /
• pp.907-912
• /
• 2008

In order to reduce the availability of dissolved inorganic phosphorus in surface water, lakes, and estuaries, black shale and zero valent iron can be used as reacitve materials. Sorption of phosphate to sampled sediment, black shale, and zero valent iron was quantitatively evaluated in this research. Effect of coexistence of calcium was also tested, since coexisting ions can enhance the precipitation of phosphate. An empirical kinetic model with fast sorption(k$_t$), slow sorption(k$_s$), and precipitation(k$_p$) was well fitted to experiment data from this research. Langmuir and Freundlich sorption isotherms were also used to evaluated phosphate maximum sorption capacity. Calcium ions at 0, 1 and 5 mM affected the precipitation kinetic coefficient in empirical kinetic model but did not have impact on the maximum sorbed concentration.

• Journal of the Mineralogical Society of Korea
• /
• v.17 no.2
• /
• pp.147-155
• /
• 2004

Anion adsorption properties of organobentonites modified by two cationic polymers, hexadecyltrimmethylammonium (HDTMA) and cetylpyridinum (CP), were investigated. The organobentonites showed the significant expansion of basal spacing to 42.0 $\AA$ at room temperature. The adsorption experiments were conducted for the 0.2 g of organobentonites with 40 mL solutions of various concentrations of anions such as nitrate, sulfate and phosphate. As a result, the organobentonites showed excellent adsorption capacities for those anions whereas untreated bentonite showed very low adsorption capacity. Adsorption rate of HDTMA-bentonite was about 90% for 100 mg/L solutions of nitrate and phosphate, and that of CP-bentonite was 97% for 100 mg/L solution of nitrate. Adsorption behaviors were slightly different for the different organobentonites and anions. Both organobentonites showed relatively higher adsorption rate for nitrate and phosphate than sulfate. Therefore, these organobentonites showing high anion adsorption capacities can be used far the removal of deleterious anions in the treatment of environmental pollution.

• Korean Journal of Soil Science and Fertilizer
• /
• v.24 no.2
• /
• pp.109-115
• /
• 1991

This study examines the effect of submergence on phosphorus adsorption characteristics in Gangseo(paddy soil), Yesan(non-cultivated soil), and Jungdong soil(upland soil). The soils were submerged with glucose sol'n at $28^{\circ}C$ for 17 days. After the submergence, the phosphorus adsorption was conducted at three temperatures(5, 25 and $45^{\circ}C$). The phosphorus adsorption maximum($X_m$) and the equilibrium constant(K) were obtained by Langmuir adsorption isotherm, and the heat of adsorption(${\Delta}H$) was calculated by van't Hoff's equiation. Results obtained are as follows ; 1. The amounts of adsorbed P were increased with temperature, but the effects of temperature on rate of P adsorption were very small in all three soils. 2. By submergence, $X_m$ were increased from 500mg P/kg to 850mg P/kg in Gangseo soil, from 1,850mg P/kg to 3,300mg P/kg in Yesan soil, and from 310mg P/kg to 670mg P/kg in Jungdong soil. But the effects of temperature on $X_m$ were very small in all three soils. 3. Submergence decreased K for Gangseo and Yesan soils, but increased for Jungdong soil. Whereas K were increased with temperature in all three soils. 4. By submergence, ${\Delta}H$ for Gangseo soil was greatly increased (from 2.2 Kcal/mole to 3.5 Kcal/mole), whereas that for Yesan soil changed little (from 5.7 Kcal/mole to 5.5 Kcal/mole). It was 4.4 Kcal/mole in submerged Jungdong soil.

• Polymer(Korea)
• /
• v.27 no.3
• /
• pp.242-248
• /
• 2003

PP-g-(AN/Sty) was synthesized by grafting with acrylonitrile (AN) and styrene (Sty) onto PP staple fiber using an electron beam accelerator and followed by amidoximination and phosphorylation. Mole fraction of AN in the graft chain increased with the increase of the AN content in the monomer mixture. The highest AN grafting yield of 45% was obtained at a monomer ratio of 40 vol% AN/60 vol% Sty. Mole fraction of AN in the graft chain decreased with the increase of methanol amount used its solvent. As reaction temperature increased, the grafting yield of copolymer increased and reached equilibrium at 50$^{\circ}C$. Amount of amidoxime group in fibrous ion exchanger was increased as increasing amount of hydroxylamine, and the maximum content of amidoxime group was observed at 5.8 mmol/g with the 9 wt% hydroxylamine concentration. Content of phosphorous group in fibrous ion exchanger increased up to 0.5 N phosphoric acid concentration, and then leveled off. The adsorption ability of the copolymer for uranyl ion by the chelating adsorbents was in the following order : bifunctional PP-g-(AN/sty) > amidoximated PP-g-(AN/Sty) > phosphorylated PP-g-(AN/Sty).

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.2
• /
• pp.196-202
• /
• 2018

In this study, we investigated phosphate removal efficiency according to pretreatment (pyrolysis temperature, pyrolysis time, particle size) of oyster shells as a basic study for their recycling. And XAFS analysis and isothermal adsorption experiments were performed to investigate the phosphate removal characteristics of oyster shells. As a result, the removal efficiency was good at $600^{\circ}C$ pyrolysis temperature with 6 hour pyrolysis time and 0.355 ~ 0.075 mm particle size. Isothermal adsorption experiments showed that the Langmuir model is suitable for adsorption of oyster shells. XAFS analysis showed that calcium phosphate formed on the oyster shell pyrolyzed at $600^{\circ}C$. In other words, it was confirmed that the formation of calcium phosphate by the calcium ion elution of the oyster shell contributes to the decrease of phosphate concentration.

• Analytical Science and Technology
• /
• v.12 no.1
• /
• pp.7-12
• /
• 1999

The cation-exchange adsorbent (CEA) was prepared by radiation-induced grafting of glycidyl methacrylate (GMA) onto polypropylene (PP) fabric and its subsequently phosphonation. The adsorption characteristics of $Pb^{2+}$, $Cu^{2+}$ and $Co^{2+}$ for the CEA were discussed. In the grafting of GMA onto PP fabric, the degree of grafting (%) increased with increasing reaction time, reaction temperature, and pre-irradiation dose. The maximum grafting yield was observed around 60% GMA concentration. The content of phosphoric acid ranges from 2.5 to 3.5 mmol/g with the 85% phosphoric acid. The adsorption of $Pb^{2+}$, $Cu^{2+}$ and $Co^{2+}$ by the CEA was enhanced with increasing phosphoric acid content. The order of adsorption capacity of CEA was $Pb^{2+}$>$Co^{2+}$>$Cu^{2+}$.

• Journal of Navigation and Port Research
• /
• v.36 no.6
• /
• pp.459-463
• /
• 2012

In the present study, experiments have been performed to investigate the effects of the type of adsorbent, pH, and ionic strength on the adsorption of nutrients (nitrate and phosphate in artificial solution) onto the dredged sediment from a coastal fishery. In addition, this study aims to evaluate the possibility of removing the nutrients from the water using the dredged sediment. In the adsorption experiments of the nutrients, the reactions were completed within 10 minutes using ${NO_3}^-$-N($100{\mu}M$, 10mM) and ${PO_4}^{3-}$-P($100{\mu}M$, 10mM). In the steady state, 61% and 77% of the initial amounts were removed respectively for $100{\mu}M$ ${NO_3}^-$-N and $100{\mu}M$ ${PO_4}^{3-}$-P. The thermal treatment of the dredged sediment at $900^{\circ}C$ was not helpful to increase the removal efficiencies of the nutrients. Additives such as CaO and MgO dropped the removal efficiency of ${NO_3}^-$ to 0%, but increased that of ${PO_4}^{3-}$ up to 98%. Adsorption isotherms of ${NO_3}^-$ and ${PO_4}^{3-}$ could be explained by the Freundlich equation ($R^2$>0.99). The adsorption reaction was little influenced by the pH and ionic strength. Based on the results showing short reaction time and considerably high removal efficiencies of the nutrients, it is proposed to apply the dredged sediment from a coastal fishery to removing nutrients such as nitrate and phosphate in the water.

• Resources Recycling
• /
• v.12 no.3
• /
• pp.13-24
• /
• 2003

The production characteristics of activated carbon from waste walnut shell have been investigated by taking activation temperature, activation time, amount of activating agent, and kind of activating agent as the major influential factors. The adsorption capacity of the activated carbon which was produced using phosphoric acid as the activating agent increased with activation temperature and showed its greatest value at about $550^{\circ}C$. Yield for activated carbon was observed to decrease continuously as the activation temperature was raised. The optimal activation time for the highest adsorption capacity was found to be about 2 hr, and as the activation time increased the yield for activated carbon was showed to decrease continuously. The increase in the amount of activating agent resulted in the increase of the yield for activated carbon, however, excessive amount of activating agent deteriorated its adsorption capacity reversely. The variations of the microstructure of activated carbon observed by SEM with several influential factors, correlated very well with its changes in the adsorbability with the same factors and the kind of activating agent was found to play an important role in the determination of the adsorption capacity of activated carbon. To investigate the adsorption characteristics of the produced activated carbon, the adsorption reactions of $Cu^{2+}$ ion were examined using the produced activated carbon as the adsorbent. In general, the kinetics of the adsorption of $Cu^{2+}$ ion was observed to follow a 2nd-order reaction and the rate constant for adsorption reaction increased as the initial concentration of adsorbate was diminished. The equilibrium adsorption of $Cu^{2+}$ was explained well with Freundlich model and its adsorption reaction was found to be endothermic. The activation energy for adsorption was calculated to be 13.07 kcal/mol, which implied that the adsorption reaction was very irreversible, and several thermodynamic parameters of adsorption reaction were estimated using van't. Hoff equation and thermodynamic relationships.