• Resources Recycling
• /
• v.12 no.4
• /
• pp.38-43
• /
• 2003

Phosphate is an essential material for the growth of organisms. However. since relatively small amount is required. a large amount of phosphate is abandoned in wastes and wastewater. which contaminate the ecological environment including aquatic system. Purpose of this study is to treat especially high concentrated phosphate wastewater by use of calcium precipitation method. The pH range considered was from 6 to 12 and the maximum removal of phosphate was attained at pH 12. The con-centration of phosphate was observed to decrease rapidly until a half amount of calcium ion to its equivalent for the formation of calcium phosphate precipitate was added. which resulted in the decrease of the remaining concentration of phosphate down to 0.0027 mM. The effect of fluoride ion was examined and the concentration ratio between the phosphate and fluoride ion did not have any significant influence on the removal efficiency of phosphate. The effect of pH was also investigated. With the increasing of the pH in solution, the removal rate of phosphate was increased. Also it was investigated that the effect of fluoride on the phosphate removal was not significant.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.6
• /
• pp.1127-1137
• /
• 2000

Applications of lanthanum ion and crude rare earth chloride to the phosphate wastewater and fluorine wastewater, respectively, as treatment agents were studied. For the investigation of phosphate removal characteristics according to the amount of lanthanum ion, initial phosphate content was decreased by about 50% when molar ratio of [$La^{3+}$]:[$PO_4{^{3-}}-P$] was 0.25 and nearly all of phosphate was removed when the molar ratio of [$La^{3+}$]:[$PO_4{^{3-}}-P$] to be doubled. The removal of phosphate by $La^{3+}$ appeared to reach equilibrium state rapidly, and it was exothermic reaction since the removed amount of phosphate was diminished somewhat when the reaction temperature was increased. The zeta potential of combined particulate compound of lanthanum ion and phosphate was located for its isoelectric point at pH 5.5 and the turbidity of treated wastewater was found to vary according to the pH in a similar manner as the absolute value of zeta potential of the combined particulate compound did. For the treatment of fluorine wastewater by crude rare earth chloride, the remaining fluorine content after treatment decreased as the dosage of crude rare earth chloride increased. Whereas, the turbidity of treated wastewater and the amount of sludge generated were shown to increase as more crude rare earth chloride was added. The remaining fluorine content and the turbidity of treated wastewater were decreased and the amount of sludge generated was observed to increase according the increase of coagulant dosage under the condition of constant input of crude rare earth chloride.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.8 no.2
• /
• pp.372-379
• /
• 2007

The converter slag can be used to remove phosphate ion into the form of solid state from the wastewater. This research aims to evaluate the change of pH, alkalinity, leaching of positive ion in the wastewater and the removal of phosphate from the initial condition of wastewater. The change of pH was abruptly increased upto pH 11 for the initial condition of pH from 7.0 to 8.5 fer 0.5 unit of pH. The alkalinity was steadily increased from 10 hours of reaction time not same as pH increase. The removal of phosphate was very effective till 10 hours of reaction then it was slow after that time. The positive ion, magnesium ion was leached from the concentration of 2.0 mg/L to 4.3mg/L at the reaction time of 27 hours and 36 hours. Therefore, converter slag can be used to remove the phosphate in the form of Struvite from the wastewater.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.4
• /
• pp.709-714
• /
• 2006

The propose of this study was to investigate the feasibility of using waste lime core to remove phosphorus from wastewater in continuous flow reaction. The phosphorus was found to be removed from municipal wastewater by hydroxyapatite crystallization and precipation. Waste lime core size 1, 2 showed phosphorus removal rate of about 90% during early 11 hrs of run time. In addition, breakpoint time was decreased by increased inflow rate regardless of waste lime core size.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.8 no.1
• /
• pp.136-142
• /
• 2007

Recent publications have paid attention on the utilization of solid reagents for the removal of substances causing eutrophication, in particular $PO_4^{3-}$ ions. The adsorption of dissolved inorganic phosphate on slag produced by the refining process of iron ore was fundamentally studied for suppressing the liberation of phosphate from wastewater. This study has been conducted in order to find a possibility to improve the phosphate removal and to evaluate the phosphate removal variation to form hydroxyapatite, when the converter slag is used for phosphate removal. The result shows that the converter slag can be applied to remove phosphate using Freundlich isotherm. The size of converter slag, $2{\sim}0.425 mm$ was more efficient than $2{\sim}4.75mm$ to remove phosphate. In particular, 1 mg/L of phosphate can be removed up to 80% of the initial concentration for the continuous column experiment.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.4 no.2
• /
• pp.1-9
• /
• 1996

The possibility of using waste brine and cabbage waste from kimchi industry as raw materials for the production of yeast cell mass was investigated. Among four strains of osmotolerant yeast, Candida guilliermondii ATCC 6260 showed the best growth in the waste brine containing about 1.0g/L of reducing sugar and 7% to 12% of NaCl. The growth of C. guilliermondii in waste brine was affected slightly between the temperature range of $25^{\circ}C$ to $35^{\circ}C$ and the initial pH of 3 to 6. The NaCl concentration up to 9% was not inhibitory to the growth of C. guilliermondii and the addition of 10mM of ammonium salts or 5mM of potassium phosphate had no effect on the growth. The growth of yeast reduced BOD of the waste brine by 85% within 24hours. When C. guilliermondii was cultured in waste brine added with cabbage juice extracted from waste cabbage, the cell mass was increased significantly.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2022.06a
• /
• pp.246-248
• /
• 2022

커피박을 FeCl₃·6H₂O, MgCl₂·6H₂O 및 AlCl₃·6H₂O 용액으로 전처리하여 제조한 커피박 바이오차 복합재 중에서 MgCl₂·6H₂O 용액으로 전처리하여 제조한 바이오차 복합재가 인산염에 대한 가장 큰 제거율을 나타내었다. 커피박 바이오차 복합재의 인산염에 대한 제거율을 높이기 위해서는 FeCl₃·6H₂O 또는 MgCl₂·6H₂O 용액의 농도를 0.5 M 이상에서 커피박을 전처리 하여야 한다.

• Journal of Life Science
• /
• v.15 no.4 s.71
• /
• pp.584-589
• /
• 2005

To investigate factors affecting the removal of phosphorus from the practical wastewater in the F-STEP PROCESS using a loess ball and Chromobacterium WS 2-14, first, the loess ball size and calcining temperature, initial pH, initial phosphorus concentration, working temperature, and aeration were studied. A $2\~4mm$ of loess ball made at $960^{\circ}C$ of calcining temperature was the most suitable one for the removal of phosphorus. When the initial pH was increased from 3.0 to 6.0, the removal efficiency of phosphorus was increased. Especially, at 6.0 of initial pH, the maximum removal efficiency of phosphorus was $88.7\%$. The maximum removal efficiency of phosphorous was gained, 1.8mg/h when the initial concentration of phosphorous was 5.0mg/1. When the operating temperature was $30^{\circ}C$, the maximum removal efficiency of phosphorus was obtained. In the case of aeration, when it was increased from 0.5 to 5.0L/min, the removal efficiency of phosphorus was increased. On the other hand, above 7.0 L/min, the removal efficiency of phosphorus did not increased. Using the optimum operation conditions, pilot tests for the effective removal efficiency of phosphorus were carried out for 65 days. The average removal efficiency of phosphorus was $92.0\%$. The average removal efficiency of COD, BOD, and SS were 77.1, 74.2, and $86.4\%$, respectively. from the results, it can be concluded that F-STEP PROCESS using loess ball might be useful process for phosphorus removal.

• Journal of Korean Society of Water and Wastewater
• /
• v.26 no.6
• /
• pp.841-849
• /
• 2012

The effluent quality of phosphorus is strengthened by the national standard to conserve water resources to lessen the eutrophication threat. The soluble phosphate in the wastewater effluent can be removed using the converter slag as solid waste produced through the steel making process. The experiments for removal efficiencies and removal constants were performed for this research with the artificial wastewater following several different conditions, particle size, phosphate concentration and initial pH. The correlation coefficients of Freundlich adsorption isothem were 0.9505 for $PS_A$, 0.9183 for $PS_B$, respectively. The removal efficiency was 87-94 % for $PS_A$ and 90-96 % for $PS_B$ respectively. The pH of the wastewater was elevated to pH 11.8 for the initial pH 8.5, phosphate removal efficiency was the highest as 84 % ~ 98 %. In case of 10 mg/L of the intial phosphate, the removal efficiency was 96 ~ 98 %. The more initial pH increases, the higher the reaction rate constant is.

• Journal of Korean Society of Water and Wastewater
• /
• v.27 no.6
• /
• pp.751-759
• /
• 2013

This study is carried out to get the basic design parameters for phospate removal facilites from wastewater by Tobermolite. The phosphate removal by the apatite formation on the surface was affected by several important factors, temperature, ions present in wastewater stream, contact time, recirculation rate, and etc. In case of the temperature, with the increase of temperature, the apatite formation was accelerated. When temperature increased from $15^{\circ}C$ to $35^{\circ}C$, removal efficiency of phosphate increased from 83 % to 93 %. An increase of calcium and fluoride ion content increase the apatite formation, however, bicarbonate and magnesium ion inhibited the crystallization of apatite. As expected, when the recirculation rate was increased from 1 Q to 3 Q, at EBCT (Empty Bed Contact Time) 60min enhanced removal efficiency was observed. The more the recirculation rate increased, the more the removal efficiency increased. According to the results of column experiment using an actual wastewater with low and high phosphate concentration (5 mg/L and 50 mg/L-P), the removal efficiency was 77 % at EBCT of 45 min, and 80 % at 60 min. It was suggested that optimum EBCT was 45 min.