• Journal of the Korean Arthroscopy Society
• /
• v.16 no.2
• /
• pp.190-194
• /
• 2012

The role of arthroscopy for the diagnosis of polyethylene wear after total knee arthroplasty has been reported previously. In this report, we demonstrate a case of wear of meniscal bearing in unicompartmental knee arthroplasty (UKA) and recurrent meniscal bearing subluxation which was diagnosed by arthroscopy. Arthroscopic examination has its role in diagnosing the wear and subluxation of polyethylene bearing after UKA.

• Reproductive and Developmental Biology
• /
• v.36 no.1
• /
• pp.27-32
• /
• 2012

This study was carried out to investigate artificial insemination (AI) failure status and frozen semen characteristics in Korean proven bulls' number (KPN) semen used for AI of Hanwoo cows in Gangwon East region (Gangneung, Donghae, Taebaek, Samcheok, Sokcho, Yangyang, Goseong). Among semen used for AI, AI failure rate showed lowest at KPN506 (27.6%), whereas highest at KPN593 (77.2%). Correlations of AI failure in between Korean proven bulls semen and cows was 0.2941, which means that AI failure rate of Korean proven bulls semen may have respectable effect on reproduction of Hanwoo cow. In addition, present study was conducted to investigate spermatozoal viability rate, ruptured acrosome rate and active mitochondria in frozen Korean proven bulls semen with flow cytometry. The semen of KPN593 showed significantly ($p$<0.05) higher viability rate in KPN593 (30.49%) than that in KPN637 (37.34%). Furthermore, percentage of ruptured acrosome was lower in KPN637 as 21.37% than in KPN637 (21.37%), but it was not statistically significant. In conclusion, these results indicate that choice of Korean proven bulls semen may correlate positively with conception rate in Hanwoo cow. Therefore, KPN with high AI failure rate might be avoid to increase conception rate and characteristics of frozen semen might be evaluated before its use for AI.

• Journal of Sericultural and Entomological Science
• /
• v.28 no.2
• /
• pp.38-47
• /
• 1986

Silkworm(Bombix mori) were reared with modified artificial diets which were mixed with, as additives, leaf powders of Erigeron canadensis L., Cassia tora L., Cyperus anuricus Var.Laxus and Vigna Sinensis NEDL. The effects of additives on silkworm characteristisc of tested plants were summarized as follows ; 1. About 2-5% addition on dry weight base of leaf powders of E. canadensis, C. tora, C. anuricus or V.sinensis to the basic artificial diet promoted feeding response and digestion and resulted in good practical silkworm characteristics. The addition of V.sinensis and C.anuricus showed especially good effects. 2. The syneristic effect between different plant species was not recognized based on the feeding response and digestion of silkworm reared with various combinations of 2-4 different plant additives. 3. Electrophoretic zymograms of estrase, protease and phosphatase on haemolymph, intestine and silkgland were significantly different among treatments. In general, 1 or 2 more electrophoretic bands were detected when feeding response and digestion were promoted. 4. Contents of starch, crude fat, crude protein and inorganic base were apparently higher in the tested plants than in mulberry leaves. However, no volatile ingredent which is directly realted with feeding response was identified.

• Journal of Sericultural and Entomological Science
• /
• v.23 no.2
• /
• pp.37-49
• /
• 1982

Larvae of the silkworm (Bombyx mori L.) were reared during the 5th instar on the four kinds of artificial diets on the basis of the different amounts of soybean meal used as the protein source. In this experiment it was shown that the various levels of protein in the diet affected not only the growth and silk production but the digestibility of the diet. haemolymph protein and uric acid excretion. The results obtained are summarized as follows; 1. By an increase of the level of protein in the diet the apparant digestibility was increased. but the protein digestibility was comparatively decreased. 2. Larval body weight increment was not observed by the 3rd day of the 5th instar, but was increased from the 4th day as the level of protein was increased in the diet. 3. After the 3rd day of the 5th instar, protein content in the hemolymph was increased steeply by an increase of the protein content in the diet. However, the percentage of hemolymph protein to the ingested protein was decreased from the 2nd day of the 5th instar and increased more or less after the 4th day. 4. An increase of the uric acid excretion was observed as the content of protein in the diet was increased but the pattern of the uric acid excretion was different between high and low-protein diet. However, the percentage of the uric acid excretion to the ingested protein and to the hemolymph protein were both decreased steeply after the 2nd day of the 5th instar. 5. It was also evident that the high-protein diet increased the cocoon productivity. 6. It showed that the feed efficiency for body weight increment and silk formation was high by an increase of the level of protein in the diet, but the protein efficiency was not.

• Journal of Digital Convergence
• /
• v.12 no.2
• /
• pp.439-446
• /
• 2014

To evaluate the effects of an artifact by metal material for orthodontics in Magnetic Resonance Image (MRI) examination, wires and brackets used in orthodontics were selected and compared. Using a head coil, a $T_2$-weighted image, $T_1$-weighted image and FLAIR image were obtained. With obtained images, the sizes of the artifacts were measured and compared using Image J Program. In the research, the material with the biggest artifact in the wires and brackets for orthodontics was stainless steel wire. In the future, selecting and developing metal for correction should be considered also in other fields along with the purpose of orthodontics.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.15 no.5
• /
• pp.25-33
• /
• 2011

In the nonlinear response history analysis of building structures, the input ground accelerations have considerable effect on the nonlinear response characteristics of structural systems. As the properties of the ground motion, using time history analysis, are interrelated with many factors such as the fault mechanism, the seismic wave propagation from source to site, and the amplification characteristics of the soil, it is difficult to properly select the input ground motions for seismic response analysis. In this paper, the most unfavourable real seismic design ground motions were selected as input motions. The artificial earthquake waves were generated according to these earthquake events. The artificial waves have identical phase angles to the recorded earthquake waves, and their overall response spectra are compatible with the seismic design spectrum with 5% of critical viscous damping. It is concluded that the artificial earthquake waves simulated in this paper are applicable as input ground motions for a seismic response analysis of building structures.

• Journal of agriculture & life science
• /
• v.50 no.5
• /
• pp.183-188
• /
• 2016

This experiment was conducted to investigate the effects of artificial insemination(AI) frequency on reproductive performance of sows. A total of 48 F1 sows(Yorkshire×Landrace) were allocated to 1 of 4 treatments using completely randomized design(CRD). Four experimental treatments were AI frequency from one to four times(AI1, AI2, AI3, AI4) respectively. Estrus detection was done at approximately 09:00 and 21:00 daily by applying back pressure to females with the presence of a mature boar and the weaning to estrus interval(WEI) of all sows were 5~6 day. Sows detected in estrus were mated at 12 hour after and mating interval was 12 hour by treatments. This experiment demonstrated that the lowest farrowing rate was observed AI3 treatment. Frequency of AI did not influence on reproductive performance when WEI was 5-6 day. No significant differences were observed on litter size, born alive and litter birth weight. Consequently, decreased AI frequency did not have any detrimental effect on reproductive performance when estrus detection was adequate. Decreased AI frequency could reduce cost of production of pigs when sows showed normal reproductive performance.

• Journal of Animal Science and Technology
• /
• v.48 no.3
• /
• pp.467-478
• /
• 2006

Maintenance of an optimal air quality in the enclosed pig building is potentially important in terms of pig performance and farmer health. The objective of this on-site experiment is to evaluate and compare efficiencies of currently utilized biological additives to reduce odor emissions from the enclosed pig building. As a result, generally all the additives except for salt water, artificial spice and essential oil were proved ineffective in reducing odor generation. The beneficial effects of salt water, artificial spice and essential oil on odor reduction were highlighted on ammonia, odor intensity and offensiveness, and sulfuric odorous compounds, respectively. To efficiently utilize odor masking agent such as the artificial spice, ventilation rate should keep slightly lower than the optimal level. Essential oil functioned well as not only masking agent but also antimicrobial agent for reducing odor. To precisely quantify odor concentration, it should be measured by not the odor sensor but the olfactometry technique.

• Korean Journal of Poultry Science
• /
• v.12 no.2
• /
• pp.127-134
• /
• 1985

Battery trial with 240 broiler chicks of Hubbard strain was conducted for a period of 2 weeks in order to compare the anticoccidical efficacy of polyether ionophorous antibiotics ; Maduramicin ammonium, Monensin and Salinomyc in sodium. The criteria used in these anticoccidial efficacy studies were anticoccidial index, growth rate, feed efficiency, mortality, lesion score and the number of oocysts produced after artificial inoculation with 70,000 sporulated oocysts of Eimeria tenella(90%) and E.necatrix (10%) to each bird. The result obtained are summarized as follow: 1. All groups medicated anticoccidial feed additives improved body weight gain and feed efficiency. However, it was found that the group medicated with Maduramicin showed better body weight gain (352.5 and 648.8 g) and feed efficiency(1.603 and 1.680) during the first and the second week experiments, 2. The mortality rate(4.2%) and lesion scores (1.72) of Maduramicin medicated group, from artificial coccidiosis were comparatively lower than those of other two medicated groups, 3. It was also found that oocyst output (0.25 ${\times}$ 10$^4$) in Maduramicin medicated group were lower than those of other two groups. 4. Anticoccidial indexes during the first week were 177.9 in Maduramicin medica-group, 158.7 in Salinomycin medicated group, 141.6 in Monensin medicated group and 78.0 in infected, nonmedicated group as compared with 200.0 in noninfected, nonmedicated group (NNC) 5. Anticoccidial indexes during the second week were 201.1 in Maduramicin group 184.0 in infected, nonmedicated group as compared with 200.0 in noninfected, nonmedicated group (NNC).

• Journal of the Korean Society of Radiology
• /
• v.12 no.3
• /
• pp.389-395
• /
• 2018

The study attempted to use computed tomography images to determine the usefulness of the reduction in the axial reduction algorithm in the event of a metallic artifacts reduction in the image of the beam-hardening effect, which is known as the most effective method of reducing metallic artifact reduction in the image and the reduction of the metal produced in this study. As a result, the result is increased to 140 kVp to reduce the value of the CT value by 0.02 to 0.05 %, resulting in decreased axial effect (P > 0.05). The CT value decreased from 12.4 to 26.9 % when applied to the reduction of the metallic. 12.4 to 26.9 % (p<0.05). In addition, in the qualitative assessment by the clinical trial evaluation, it was assessed as 1.8 points after applying the MAR algorithm, In the resolution of resolution and contrast evaluations, the estimation of the decrease in metallic artifact effects was assessed as the metal was assessed to be scored 7.2 points after the MAR algorithm was evaluated. Therefore, in case of artifacts due to irreversible beam hardening effect, it is useful to reduce artifacts caused by beam hardening effect by using various methods derived from existing researches and scanning by applying the metal artifact reduction algorithm proposed in this experiment.