• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.1
• /
• pp.111-118
• /
• 2004

In order to compare the NVOC (Natural Volatile Organic Compound) emission rates from oak trees, the emission rates of isoprene were quantitatively measured in situ based on tree species and region. As a result, the emission rates from Quercus serrata T. were found to be 1000 times greate. than those from Quercus acutissima C. However, the emission rates at the Chili and Gumsung mountain sites did not show any significant differences in summer. Cuvette tests using four different oak species also supported that there was a tremendous difference in emission rates between Quercus serrata T. and Quercus acutissima C. It was found that the emission rates from the trees were highest on the order of Quercus serrata T., Quercus aliena B., Quercus acutissima C. and Quercus variabilis B.

• 보존과학연구
• /
• s.27
• /
• pp.215-226
• /
• 2006

In the field conservation treatment, it is important that the method chosen to lift an object out of the ground depends on its surrounding weather, strength, size, composition, and condition. This paper describes a physical support(Urethane bandage, De naturation - polyisoprene resin) created for lifting delicate relics in this field. The advantage of Urethane bandage method is of conveniently portable size, and it's convenient for use, while curing time is very fast.(approx. 5~10minute)Denaturation -polyisoprene resin is able to be soft by the hot water(approx. $60^{\circ}C$ ). so it's good to stick to the relic surface of an indeterminate form. The results of use of these reinforcement methods are of utility value.

• Elastomers and Composites
• /
• v.49 no.1
• /
• pp.43-52
• /
• 2014

The effect of nanoclay (Cloisite 20A) on the self-adhesion behavior of uncured brominated-isobutylene-isoprene rubber (BIIR) has been studied. The dispersion state of nanoclay into the rubber matrix was examined by SEM, TEM and XRD analysis. The thermal degradation behavior of the filled and unfilled samples was examined by TGA and improvement in the thermal stability of the nanocomposites occurred based on the weight loss (%) measurements. Also, addition of nanoclay enhanced the cohesive strength of the material by reinforcement action thereby reducing the degree of molecular diffusion across the interface of butyl rubber. However, the average depth of penetration of the inter-diffused chains was still adequate to form entanglement on either side of the interface, and thus offered greater resistance to peeling, resulting in high tack strength measurements. The improvement in tack strength was only achieved at critical nanoclay loading above 8 phr. Contact angle measurement was also made to examine the surface characteristics. There was no significant interfacial property change by employing the nanoclay.

• Applied Chemistry for Engineering
• /
• v.5 no.5
• /
• pp.851-856
• /
• 1994

Compatibility and viscoelasticity in non-solvent type pressure sensitive adhesive of styrene-isoprene-styreno(SIS) block copolymer with tackifier resin were investigated. In the isoprene phase of SIS block copolymer, it was found that it's compatibility with $C^5$ petroleum resin was good, but that with Coumarone-indents resin was not so good. The magnitudes of peel strength, tack, and holding power were as follows : $C^5$ petroleum resin>rosin ester resin>coumarone-indene resin. The tackifier resin with good compatibility in rubber phase was also effective. However, with plateau modulus value of $1{\times}10^6-3{\times}10^6dyn/cm^2$, the effect of pressure sensitive adhesives was excellent.

• Polymer(Korea)
• /
• v.25 no.5
• /
• pp.625-634
• /
• 2001

New polymeric photostabilizers containing hindered amine light stabilizer (HALS) were prepared by the reaction of liquid polyisoprene rubber grafted maleic anhydride (MAH) and 2,2,5,6-tetramethyl-4-piperidinol (TMPO). Their chemical composition and physical properties were characterized by titration, GPC and TGA analysis. The effects of polymeric HALS on the photooxidation of the styrene-butadiene rubber were studied from the UV, IR spectral changes, and photo-crosslinking was examined by the measurement of the insoluble fraction. The photooxidation of SBR upon irradiation was inhibited by addition of the new polymeric HALS. The extraction resistance of new polymeric photostabilizer was much better than that of the low molecular weight compound which is prepared by the reaction of MAH and TMPO. The new polymeric HALS ate fairly compatible with the SBR.

• Journal of Korean Society for Atmospheric Environment
• /
• v.22 no.6
• /
• pp.791-798
• /
• 2006

In order to investigate the NVOC (Natural Volatile Organic Compound) emissions from White Oak, the emission rates of isoprene were measured according to season, weather conditions, and the age of the tree. The analysis of seasonal emission rates showed that the emission rates were the highest during summer followed by spring and fall. The emission rates during summer were found to be nearly 8 times greater than those during fall. In addition, it was observed that the emission rates of isoprene depends on PAR and temperature. Moreover, the effect of age on the emission rates was studied, and the White Oak in the age range of $21{\sim}30$ had higher emission rates than that in the range of $41{\sim}50$. Accordingly, the current result indicates that the isoprene emissions are affected by both meteorological parameter and the age of a tree.

• Analytical Science and Technology
• /
• v.14 no.1
• /
• pp.44-49
• /
• 2001

Solid-phase microextraction (SPME) with $85{\mu}m$ polyacrylate fiber, coupled to gas chromatography-mass spectrometry was used to analyze the plasticizers contained in balloon samples. The balloons were identified to be made of polyisoprene by IR spectroscopy. The plasticizers extracted from the balloon samples soaked in acetone-added water solvent for an hour were quantified by external standard method using nine kinds of plasticizers. The quantification method was validated for standard plasticizers in the range of $0.25-25{\mu}g/g$. The detection limits were $0.11-0.38{\mu}g/g$ for different plasticizers. The RSDs for the reproducibility of this quantitation method were 3.7-14.2%. A few of balloons included risky level of plasticizer concerned as and endocrine disrupter, and it is necessary to regulate these products.

• Journal of Environmental Science International
• /
• v.16 no.3
• /
• pp.269-275
• /
• 2007

The standard emission rate(ERs) of isoprene was quantitatively measured in situ from Quercus mongolica Fischer that dominates more than about 85% of domestic oak trees. The ERs values in spring and summer were similar to 64.4 and 58.1 (${\mu}gC/gdw/hr$), respectively. The ERs in autumn, 7.06(${\mu}gC/gdw/hr$), was about $8{\sim}9$ times lower than those in spring and summer. The coefficient of determination ($r^2$) between ERs and $C_L\;C_T$ ranged from 0.593 to 0.836. The correlation coefficients between the ERs and PAR. the ER and temperature suggested that ERs have strong correlation with PAR(photosynthetically active radiation) and temperature. In addition, the high values of PAR, temperature, and ERs were found in the time zone of $15:00{\sim}17:00$(spring), $15:00{\sim}16:00$(summer), and $14:00{\sim}15:00$(autumn).

• Korean Chemical Engineering Research
• /
• v.55 no.5
• /
• pp.690-697
• /
• 2017

In this study, styrene-isoprene-styrene (SIS)-styrene-butadiene-styrene (SBS) modified asphalt was prepared for waterproof-sheet to measure its properties including softening point, penetration, low temperature flexibility, viscosity and adhesion. Then the properties of SIS-SBS modified asphalt imparted with self-healing were optimized to seek for optimal compositions of SIS and SBS versus asphalt according to response surface methodology (RSM). As the content of SBS or SIS was increased, both properties of softening point and viscosity, measured at high temperature, were increased with a statistical significance. However, the increments of softening point and viscosity per unit content of SBS added, were observed to be greater than those per unit content of SIS added, respectively. It was due to the difference of thermal properties of SBS and SIS at high temperature that the cross-linking degree of SBS was increased by gelation accompanied with the increase of viscosity, while chain-entanglement of SIS was relatively reduced owing to a chain scission of poly(isoprene) blocks causing the decrease of viscosity. To the contrary, SIS-SBS modified asphalt showed a behavior of the least elasticity resulting in both the maximum of penetration and adhesion, measured at room temperature, as well as the lowest low temperature flexibility at the composition of SIS, 4 g and SBS, 8.5 g based on asphalt, 63 g.

• Elastomers and Composites
• /
• v.38 no.3
• /
• pp.235-242
• /
• 2003

A vulcanization reaction characteristics of an isoprene rubber (IR)-modified natural rubber/carbon black (NR/CB) composite was studied using in-situ electrical property measuring technique. Since the electrical conductivity of the sample composite would be changed continuously during the vulcanization reaction by rearranging of the carbon black particles within the sample, volume resistivity (${\rho}$) might be obtained as a function or reaction time. A stabilization time ($t_i$), maximum reaction speed time ($t_p$), and volume resistivity at that time(${\rho}_p$) were defined from the data for the Arrhenius analysis. Volume resistivity ${\rho}$ showed a comparatively high value of ${\sim}10^8$ order before the reaction started, and dramatically decreased to be stabilized within $1{\sim}2$ minutes as soon as the reaction started. As the more time elapsed, thereafter, ${\rho}$ decreased monotonously to a certain constant value through a peak, ${\rho}_p$ at time $t_p$, which was considered as the maximum reaction rate. As a result, while $t_i$ values were comparatively constant as $1{\sim}2$ minutes, $t_p$ values showed to become shorter and shorter as the reaction temperature.