• 한국기계가공학회지
• /
• 제5권2호
• /
• pp.36-41
• /
• 2006

This study was carried out to install the lifting force of a two hinge type stand mechanism by 6 Sigma process in advance. This unit is designed for the display device in order to enhance the ergonomics for effective height adjustment and maintenance at any preferred position. The unit will be very useful for the mechanism fabricated with coil springs and disc springs as a torque generator. The 6 Sigma process was applied to select two key factors among 7 elements to lift the head unit and to find out applicable tolerance securing the 3.4 ppm of defects as well as what deviation of lifting force we can expect between calculation and experiment at the design stage of development. The result of this study can be applied to various units for the optimization of the smooth lift.

• 한국기계가공학회지
• /
• 제6권3호
• /
• pp.85-91
• /
• 2007

This study was carried out to minimize the lifting force of a two hinge type stand mechanism. This unit is designed for the display devices in order to enhance the ergonomics for effective height adjustment and maintenance at any preferred position. The unit will be very useful for the mechanism fabricated with a coil spring and disc springs as a torque generator. The maximum and the minimum torque value should be calculated initially for the smooth lift. And the reasonable torque distribution is necessary to prevent any auto lift and auto dropping at any position because the torque generated by coil spring is more sensitive than disc spring in tilting the position. Therefore, the analysis of the coil spring is requisite to issue the specific torque value depending on the distorted angle with securing reliability of a long time storage condition. After the theoretical torque value was calculated, the evaluation was carried out by making a proto-type sample, then distorted angle was updated by experiment. The result of this study can readily be applied to various units for the optimization of the smooth lift.

• 한국기계가공학회지
• /
• 제4권4호
• /
• pp.48-53
• /
• 2005

This research is materialized the mechanism of a interlocking elevator device to meet with customer's requirement demanding a variety of function. On this suitably theoretical translation and by considering of material significance of the most factor's tension spring and torsion spring, it's compared and reviewed the stress's calculation according that SWC and SWPB applied differently. And also that is approved through actual experiment. Out of a variety of feasible movement. Torque Balance is materialized by combination of tension spring, torsion spring and disk spring. So that application of 3 factors for optimal design is very important factor. In future, this research thesis make sure to play a highly role for application and improvement mechanically in various industry sector out of materializing interlock.

• 한국공작기계학회논문집
• /
• 제16권1호
• /
• pp.92-97
• /
• 2007

This study was carried out to minimize the lifting force and to design the slim sized frame of a height adjustment mechanism. This unit is designed for the display devices in order to enhance the ergonomics for effective height adjustment as well as to achieve much slimmer frame for the pedestal. A tolerance analysis of 6 sigma was applied to achieve smooth lift at design stage not to change the tolerance specification of gap several times in a roller type of lifting mechanism at mass production stage. The specification of minimum gap and the target of production yield ratio were agreed with a quality team before tooling. A DFSS simulation on drawings had been done with reasonable tolerance and achievable standard deviation(${\sigma}$) several times until the target specification of gap and yield ratio was met. Once tolerance and deviation(${\sigma}$) were fixed tooling start was done successfully. A CAE method was applied to achieve a slim design. Design parameters were frozen when those parameters matched the reference strength data of standard model. Through those tolerance analysis and CAE simulation the number of tool modification was reduced and production yield ratio was raised up without arguing quality specification at production stage in the end.