• Journal of Korea Society of Industrial Information Systems
• /
• v.27 no.6
• /
• pp.41-49
• /
• 2022

The Internet Engineering Task Force (IETF) has standardized RPL (IPv6 Routing Protocol for Low-power Lossy Network) as a routing protocol for Low Power and Lossy Networks (LLNs), a low power loss network environment. RPL creates a route through an Objective Function (OF) suitable for the service required by LLNs and builds a Destination Oriented Directed Acyclic Graph (DODAG). Existing studies check the residual energy of each node and select a parent with the highest residual energy to build a DODAG, but the energy exhaustion of the parent can not avoid the network disconnection of the children nodes. Therefore, this paper proposes EC-RPL (Enhanced Connectivity-RPL), in which ta node leaves DODAG in advance when the remaining energy of the node falls below the specified energy threshold. The proposed protocol is implemented in Contiki, an open-source IoT operating system, and its performance is evaluated in Cooja simulator, and the number of control messages is compared using Foren6. Experimental results show that EC-RPL has 6.9% lower latency and 5.8% fewer control messages than the existing RPL, and the packet delivery rate is 1.7% higher.

• Korean Chemical Engineering Research
• /
• v.60 no.3
• /
• pp.386-391
• /
• 2022

This study is about a technique for obtaining collagen by extracting fat by treating collagen-containing liposuction effluent in the presence of supercritical fluid. Using a supercritical solvent, a collagen extract could be obtained from animal-derived fat in a short time (about 6 hours), and about 2-3% of collagen by mass compared to the raw material could be obtained. The presence of collagen in the extract obtained by supercritical extraction was confirmed by SDS-PAGE, and it was confirmed that it was type 1 collagen having a relatively large molecular weight. In addition, the growth factors of IGF-1, bFGF, VEGF and NGF were analyzed to find out which growth factors were present in the collagen obtained by supercritical extraction, and it was found that these growth factors were contained in the extract. There was no significant difference in DNA content per mg of sample before and after supercritical treatment. Further in-depth studies are likely to be needed on decellularization technology using the supercritical process. In conclusion, the extracellular matrix obtained through the solvent extraction process using a supercritical fluid contains growth factors above a certain amount even after decellularization and removal of fat, so that it was found that not only biocompatibility is greatly increased, but also tissue regeneration can be rapidly induced.

• Journal of Space Technology and Applications
• /
• v.1 no.2
• /
• pp.199-216
• /
• 2021

In 2020, the solar and space environment division at the Korea Space Science Society surveyed the status of data archives in solar physics, magnetosphere, and ionosphere/upper atmosphere in Korea to promote broader utilization of the data and research collaboration. The survey includes ground- and satellite-based instruments and developing models by research institutes and universities in Korea. Based on the survey results, this study reports the status of the ground-based instruments, data products in the ionosphere and upper atmosphere, and documentation of them. The ground-based instruments operated by the Korea Polar Research Institute and Korea Astronomy and Space Science Institute include ionosonde, Fabry-Perot interferometer in Arctic Dasan stations, Antarctic King Sejong/Jang Bogo stations, and an all-sky camera, VHF radar in Korea. We also provide information on total electron content and scintillation observations derived from the Global Navigation Satellite System (GNSS) station networks in Korea. All data are available via the webpage, FTP, or by request. Information on ionospheric data and models is available at http://ksss.or.kr. We hope that this report will increase data accessibility and encourage the research community to engage in the establishment of a new Space Science Data Ecosystem, which supports archiving, searching, analyzing, and sharing the data with diverse communities, including educators, industries, and the public as wells as the research scientist.

• Journal of the Korean Applied Science and Technology
• /
• v.39 no.1
• /
• pp.52-62
• /
• 2022

The purpose of this study was to find a way to improve the stability and quality of urinalysis by checking the changes in the measurement values of representative clinical chemistry test items according to the repeated freezing and thawing before the urine test and the thawing process. All subjects were 10 healthy males, and the freeze and thaw stability test was performed using their urine samples. In the case of micro-albumin and amylase, there was no statistical significance at 37℃ with time, but at 42℃ and 60℃, there was a statistically significant change in the results with time. There were statistically significant changes in BUN, creatinine, uric acid, and glucose. As a result of long-term stability, after 7 days, glucose mutation increased and amylase decreased at 60℃. In the case of glucose and amylase, there was a statistically significant change in the results over time. To obtain accurate test results, accurate standardization of urinalysis including appropriate collection, storage, and storage methods of urine samples is required and systematic study of conditions for securing stability for each biomaterial is required.

• Journal of the Korean Electrochemical Society
• /
• v.25 no.4
• /
• pp.184-190
• /
• 2022

Spinel LiMn₂O₄ (LMO) and layered LiNi_0.5Co_0.2Mn_0.3O₂ (NCM) are widely used as positive electrode materials for lithium-ion batteries. LMO and NCM positive electrode materials have a complementary properties. LMO has low cost and high safety and NCM materials show a relatively high specific capacity and better cycle life even at elevated temperature. Therefore, the LMO and NCM active materials are blended and used as a positive electrode in large-size batteries for electric vehicles (xEV). In this study, the cycle performance of a blended electrode prepared by simply mixing LMO and NCM and a bi-layer electrode in which two electrode layers aree sequentially coated are compared. The bi-layer electrode prepared by composing the same ratio of both active materials has similar capacity and cycle performance to the blend electrode. However, the LN electrode coated with LMO first and then NCM is the best in the full cell cycle performance at elevated temperature, and the NL electrode, in which NCM is first coated with LMO has a faster capacity degradation than the blended electrode because LMO is mainly located on the top of the electrode adjacent to electrolyte and graphite negative electrode. Also, the LSTA (linear sweep thermmametry) analysis results show that the LN bi-layer electrode in which the LMO is located inside the electrode has good thermal stability.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.4
• /
• pp.595-606
• /
• 2022

Korea has the characteristics of traditional power system such as large-scale power generation and large-scale power transmission systems, including 20 GW large-scale power generation complexes in several regions with unit generator capacity exceeding 1.4 GW, 2-3 ultra-high-voltage transmission lines that transport power from large-scale power generation complexes, and 6 ultra-high-voltage transmission lines that transport power from non-metropolitan areas to the metropolitan area. Due to the characteristics of the power system, the penetration level for renewable energy is low, but due to frequency stability issue, some generators are reducing the output of generators. In the future, the issue of maintaining the stability of the power system is expected to emerge as the most important issue in accordance with the policy of expanding renewable energy. When non-inertial inverter-based renewable energy, such as solar and wind power, surges rapidly, the means to improve the power system stability in an independent system is to install a natural inertial resource synchronous condenser (SC) and a virtual inertial resource BESS in the system. In this study, we analyzed the effect of renewable energy on power system stability and the BESS effect to maintain the minimum frequency through a power system simulation. It was confirmed that the BESS effect according to the power generation constraint capacity reached a maximum of 122.81 %.

• Korean Journal of Culture and Social Issue
• /
• v.28 no.1
• /
• pp.23-41
• /
• 2022

This study aims to examine the mediating effects of paternal depression on the relationship between traditional gender role attitudes and the perceived maternal gatekeeping roles of fathers with young children. For this purpose, a survey was conducted by 366 married fathers who raises at least one child who is under seven years old. Mplus 7.0 was used to analyze the structural equation model, and the result showed that higher traditional gender role attitudes relate to more depressive symptoms, higher perceptions of maternal gate closing and lower perceptions of maternal gate opening. Also, more depressive symptoms were related to higher perceptions of maternal gate closing and lower perceptions of maternal gate opening. Additionally, the partial mediation effects of depression were observed in the relationship between traditional gender role attitudes and maternal gate keeping. Based on the findings, implications for therapeutic interventions were discussed, and recommendations for future research are presented.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.34 no.4
• /
• pp.378-383
• /
• 1989

For selection of mutants two rice varieties, Sangpungbyeo and Seomjinbyeo, were irradiated with 20 kR and 25 kR of gamma rays. One panicle per each plant was harvested in Ml, and single needling per hill was planted for M2 and M3 generations. Mutations for short culm, earliness and the major traits were examined. 1. The mutation rates were varied with the rice varieties and the doses of radiation, higher in Sangpungbyeo and 25kR than in Seomjinbyeo and 20 kR, respectively. 2. The rates in Sangpungbyeo with the 20 kR and 25 kR were 1.10％ and 1.47％. respectively and those of Seomjinbyeo were 0.51％ and 1.25％, respectively. 3. The culm lengths of short-culm mutants derived from Sangpungbyeo and Seomjinbyeo were reduced about 10％ compared to their mother varieties, especially it was possible to select the dwarf mutants reducing 57％ and 40％ of culm length in Sangpungbyeo and Seomjinbyeo, respectively with the dose of 25 kR irradiation. 4. The range of heading date of the mutant ion in the M3 generation was comparatively wide. Many earliness mutants shortened about 7 days were selected as compared with their mother varieties, some mutants of the irradiated group had early matured by 20 days and 30 days, respectively in both Seomjinbyeo and Sangpungbyeo.

• Journal of Intelligence and Information Systems
• /
• v.29 no.1
• /
• pp.397-412
• /
• 2023

In order for social robots to take root in human life, it is important to consider the technical implementation of social robots and human psychology toward social robots. This study aimed to derive potential social robot clusters based on the emotions consumers feel about social robot appearance design, and to identify and compare important design characteristics and emotional differences of each cluster. In our study, we established a social robot emotion framework to measure and evaluate the emotions consumers feel about social robots, and evaluated the emotions of social robot designs based on the semantic differential method, an kansei engineering approach. We classified 30 social robots into 4 clusters by conducting a multidimensional scaling method and K-means cluster analysis based on the emotion evaluation results, confirmed the characteristics of design elements for each cluster, and conducted a comparative analysis on consumer emotions. We proposed a strategic direction for successful social robot design and development from a human-centered perspective based on the design characteristics and emotional differences derived for each cluster.

• Journal of the Society of Disaster Information
• /
• v.18 no.4
• /
• pp.806-816
• /
• 2022

Purpose: In this study, the luminance measurement analysis results of the smoke generation state are considered for visual signal display light color for real-time escape guidance in the underground common area. Method: We will analyze the scattering characteristics of light in the atmosphere and optical technology based on the visibility theory, and try to classify the elemental technology as a guidance function through a prototype of a visual signal display device for evacuation guidance. Result: In the experiment conducted under the smoke-generating condition, the results were derived with low luminance ratio and good visibility in the order of red, green, and yellow. However, this result is different from general lighting in which color rendering is considered, and is limited to signals for signals and detection. Conclusion: A conclusions were drawn by reflecting both the luminance measurement results in the smoke generation situation and the preference survey results conducted in previous studies for the light color of the visual signal for signal and detection. When events such as smoke occur, it is better to use the escape guidance visual signal in red or green.