• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.21 no.10
• /
• pp.1303-1313
• /
• 1997

A micro-macroscopic analysis on the conduction-controlled directional casting of Al-Cu alloys is performed, in which emphases are placed on the microstructural features. In order to facilitate the solution procedure, an iterative micro-macroscopic coupling algorithm is developed. The predicted results show that the effect of finite back diffusion on the transient solidification process in comparison with the lever rule depends essentially on the initial concentration of an alloy. In the final casting, the eutectic fraction is distributed in an increasing-decreasing-increasing pattern, each mode of which is named the chill, interior and end zones. This nonuniformity per se suffices to justify the necessity of this work because it originates from the combined effects of finite back diffusion and cooling path-dependent nature of the eutectic formation. As the cooling rate is enhanced, not only the influence depths of boundaries narrow, but also the eutectic fractions in the chill and interior zones increase. In addition, it is revealed for the first time that the micro segregation band is formed in response to a sudden change in cooling rate during the directional casting. An increasing change creates an overshooting band in the eutectic fraction distribution, and vice versa.

• Korean Journal of Materials Research
• /
• v.3 no.2
• /
• pp.121-130
• /
• 1993

The GaP crystals were grown by synthesis solute diffusion method and its properties were investigated. High quality single crystals were obtained by pull-down the crystal growing ampoule with velocity of 1.75mm/day. Etch pits density along vertical direction of ingot was increased from 3.8 ${\times}{10^4}$c$m^{-2}$ of the first freeze to 2.3 ${\times}{10^5}$c$m^2$ of the last freeze part. The carrier concentration and mobilities at room temperature were measured to 197.49cc$m^2$/V.sec and 6.75 ${\times}{10^{15}}$c$m^{-3]$, respectively. The temperature dependence of optical energy gap was empirically fitted to $E_g$(T)=[2.3383-(6.082${\times}{10^{-4}}$)$T^2$/(373. 096+TJeV. Photoluminescence spectra measured at low temperature were consist with sharp line-spectra near band-gap energy due to bound-exciton and phonon participation in band edge recombination process. Zn-diffusion depth in GaP was increased with square root of diffusion time and temperature dependence of diffusion coefficient was D(Tl = 3.2 ${\times}{10^3}$exp( - 3.486/$k_{\theta}$T)c$m^2$/sec. Electroluminescence spectra of p-n GaP homojunction diode are consisted with emission at 630nm due to recombination of donor in Zn-O complex center with shallow acceptors and near band edge emission at 550nm. Photon emission at current injection level of lower than 100m A was due to the band-filling mechanism.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.10 no.4
• /
• pp.295-303
• /
• 2012

Based on the data observed and analyzed on a groundwater flow system in the KURT (KAERI Underground Research Tunnel) site, the transport of radionuclides, which were assumed to be released at the supposed position, was calculated on the time-domain. A groundwater pathway from the release position to the surface was identified by simulating the groundwater flow model with the hydrogeological characteristics measured from the field tests in the KURT site. The elapsed time when the radionuclides moved through the pathway is evaluated using TDRW (Time Domain Random Walk) method for simulating the transport on the time-domain. Some retention mechanisms, such as radioactive decay, equilibrium sorption, and matrix diffusion, as well as the advection-dispersion were selected as the factors to influence on the elapsed time. From the simulation results, the effects of the sorption and matrix diffusion, determined by the properties of the radionuclides and underground media, on the transport of the radionuclides were analyzed and a decay chain of the radionuclides was also examined. The radionuclide ratio of the mass discharge into the surface environment to the mass released from the supposed repository did not exceed $10^{-3}$, and it decreased when the matrix diffusion were considered. The method used in this study could be used in preparing the data on radionuclide transport for a safety assessment of a geological disposal facility because the method could evaluate the travel time of the radionuclides considering the transport retention mechanism.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.4C
• /
• pp.231-238
• /
• 2008

A column testing device capable of measuring the electrical resistivity of soil at 3 different locations was developed to verify applicability of bulk electrical conductivity (BEC) breakthrough curves in monitoring contaminant transport. Tracer injection tests were conducted with three different types of saturated sands to obtain average linear velocities and longitudinal hydrodynamic dispersion coefficients based on BEC breakthrough curves and effluent solute breakthrough curves. Comparative analysis of transport parameters obtained from curve fitting the results into the analytical solutions confirmed the validity of resistance measurements in estimating time-continuous resident solute concentration. Under the assumption that a linear relationship exists between ${\sigma}_{sat}-{\sigma}_w-C$, the BEC breakthrough curves are able to effectively reduce the laborious and time-consuming processes involved in the conventional method of sampling and analysis. In order to reduce possible uncertainties in analyzing the BEC breakthrough curves, it was recommended that resistance measurements take place nearby the effluent boundary. In addition, a sufficient electrical contrast or difference in the electrical conductivity of the influent and the saturating solution is required to conduct reliable analysis.

• Membrane Journal
• /
• v.9 no.1
• /
• pp.51-62
• /
• 1999

The recovery of trace volatile organic components from water by pervaporation was investigated. Permeation experiments through homogeneous polydimethylsiloxane(PDMS) membrane was carried out and the effect of feed concentrations and membrane thicknesses on the permeation characteristics were investigated. A solution-diffusion model is used to describe the pervaporation transport mechanism. In homogeneous PDMS membrane it appeared that the selectivities of MEK and toluene are constant, and that organic flux has a linear relationship with feed concentration. These results indicate that the coupling effects between organics were negligible. The selectivity of PDMS membranes is invariant with respect to the membrane thickness. The intrinsic membrane permeability of organic components determined by using a solution-diffusion model. Comparing with various composite type membrane, the membrane using PEG treated nonwoven fabric as sublayer showed the best performance in VOC recovery by pervaporation.

• Journal of Korea Water Resources Association
• /
• v.30 no.1
• /
• pp.23-34
• /
• 1997

The Nanji-Do ladnfill is an ill-conditioned reclaimed land without pollution intercepting facilities, and has high ground water table and deep stratum. The purpose of this study is to analyze the solute transport in steady-state groundwater flow and to predict the solute dispersion in Nanji-Do landfill using HST-3D model. As results, the groundwater flows radially outward from the center of No. 1 and No. 2 landfills, and large amount of runoff is moved into Han River. The predicted relative concentration of total dissolved solute(TDS) at two years later was 0.25 in the weathering zone, 0.26 in the lower alluvium, and 0.28 in the upper alluvium. Thus, the further pollution to bottom rock and Han River was predicted by comparing the corresponding present values of 0.29, 0.32 and 0.35.

• Korean Chemical Engineering Research
• /
• v.56 no.5
• /
• pp.679-686
• /
• 2018

Reverse osmosis (RO) concentration of sodium chloride, sodium acetate, and sodium citrate solutions has been performed by polyamide RO membrane. Concentration polarization phenomena was also studied by changing pressure, solute kinds, and initial solution concentration. Pressure effect on permeation flux was that the increase of flux was accompanied by the increase of pressure. Flux increase was observed by the decrease of initial solution concentration. Surface concentration on the RO membrane increases and so flux declines due to the concentration polarization. In the later phase of concentration, concentration polarization effect was decreased by the back diffusion of solute from the polariztion layer. In case of sodium citrate, its large ion size and charge density resulted in the discrepancy between theory and experimental data of concentration polarization. It may be due to electric repulsion on the membrane surface.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1996.04a
• /
• pp.46-47
• /
• 1996

막분리 공정의 공업적인 이용을 위해서는 막을 특정 용기에 적재한 모듈의 형태가 요구되는데 모듈의 형태에 따라 평판형(plate and frame), 나권형(spiral wound), 관형(tubular), 중공사형(hollow fiber)모듈 등이 있다. 이 중에서 관형 시스템은 내경이 12.5~25 mm, 길이 0.6~6.4 m에 이르는 비교적 큰 open channel로 되어 있으며 공급액 유로가 일반적으로 커서 전처리를 행하지 않고도 fouling이 적으며, 또한 막 표면의 세정이 약품에 의한 것 이외에 스폰지 볼 등에 의한 물리적 세정도 가능하므로 응용 범위가 넓다는 것이 특징이다. 한외여과 공정의 가장 큰 문제점은 농도분극 및 fouling 현상에 의한 플럭스 감소이다. 농도분극 현상은 경계층에서 용질의 대류,확산적인 전달에 기인하여 막 표면으로 갈수록 진해지는 용액층의 형성을 의미한다. 이 현상은 가역적인 과정으로서 감압함으로 원상태로 회복이 가능하며 조작 압력에서 정상상태가 되면 막투과 플럭스는 일정한 값을 유지한다.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2011.05a
• /
• pp.57.2-57.2
• /
• 2011

MX 석출물 형성 원소인 V과 Nb을 첨가한 11Cr-1Mo-VNb 페라이트계 내열강의 각각의 시험 온도에서 파단 시간에 따른 미세조직의 변화를 연구하였다. 초기 조직은 템퍼드 마르텐사이트 조직을 갖고 있었으며, 고온 강도를 저하시키는 ${\delta}$-페라이트는 존재하지 않았다. 주 석출상은 $M_{23}C_6$와 MX로 확인되었다. 또한, 모든 크리프 파단재에서 응력을 받은 게이지 부분이 응력을 받지 않은 그립 부분보다 석출물 및 마르텐사이트 래스 폭의 성장이 가속되는 결과를 나타내었다. 이는 크리프 변형 중 응력 집중에 의해 래스 경계를 따라 전위가 집적되고, 이에 따른 용질원자의 확산 속도가 증가하여 석출물의 성장에 따른 래스 경계의 이동이 일어나 게이지 부분이 그립 부분보다 마르텐사이트 회복이 가속된 것으로 판단된다.

• Journal of the Korean Applied Science and Technology
• /
• v.24 no.1
• /
• pp.79-85
• /
• 2007

The diffusion behavior of phenol, toluene and benzoic acid in aqueous SDS solution was examined. It showed a similar experimental results for phenol and toluene. The diffusion coefficients of the solutes were characterized by the presence of two distinct regions: below the cmc and above the cmc. For phenol and toluene, it remained approximately unchanged when the SDS concentration was below the cmc. Above the cmc there was an apparent decrease in the diffusion coefficients of the two solutes with increasing SDS concentration. However, for benzoic acid the diffusion behavior was different from that of phenol and toluene. The diffusion coefficient of benzoic acid decreased slightly with increasing SDS concentration, however the diffusion coefficient was almost constant above the cmc. For benzoic acid the diffusion behavior was dependent on the joint contribution of benzoic acid molecules as well as the benzoate ions.