• Journal of Radiation Protection and Research
• /
• v.13 no.2
• /
• pp.29-40
• /
• 1988

A spectrum-exposure rate conversion operator G(E) for a portable HPGe detector used for field environmental radiation survey was theoretically developed on the basis of a space distribution function of gamma flux emitted from a disk source and an areal efficiency of the detector. The radiation exposure rates measured using this G(E) and the portable HPGe. detector connected to a portable multichannel analyzer were compared with those measured by a 3' ${\phi}\;{\times}$3' NaI(Tl) scintillation detector with the reported G(E) and a pressurized ionization chamber. A comparison of the three results showed that the result obtained using the HPGe detector was lower than those determined using the NaI(Tl) detector and ionization chamber by 17% to 29%, The difference obtained is close to that reported in literature. The method developed here can be easily applicable to obtain a G(E) factor suitable to any detector for detecting the exposure rate of environmental gamma radiation, since the spectrum-exposure rate conversion operator can be calculated by a hand calculator.

• Journal of Radiation Protection and Research
• /
• v.10 no.1
• /
• pp.67-73
• /
• 1985

The manganous sulfate bath method for neutron source calibrations at the K-SRI is described together with the measurement of neutron emission rate of a source and the corrections applied for capture by competing nuclei of neutrons, and thermal neutron leakage, neutron absorption in the source itself. The commercially available neutron sources (Am-Be, $^{252}Cf$) for the calibration checks of neutron radiation instruments in the MeV range are considered in this paper.

• Nuclear Engineering and Technology
• /
• v.7 no.3
• /
• pp.223-226
• /
• 1975

The relative detection efficiency of ${\gamma}$-ray full-energy Peaks was obtained by a pair-point method using the $^{56}$ Co source whose ${\gamma}$-ray relative emission rates were well measured. Three Ge(Li) detectors with active volumes of 43.8cc, 32.6cc, and 6cc were calibrated over the ${\gamma}$-ray energy energy range 800-5, 500keV.

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.340-345
• /
• 2003

In this paper, the ultrasonic attenuation coefficient was measured by variation of crack length for double-cantilever beam(DCB) specimen. The energy release rate, G, was obtained by the experimental measurement of compliance. The experimental results represents that the relation between crack length for the ultrasonic attenuation coefficient and energy release rate is increased proportionally. From the results of experiments, the measurement method of crack length by the ultrasonic attenuation coefficient was proposed and discussed.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1109-1114
• /
• 2003

The initial crack often occurs on the bonded interface and it is the general cause of the interface fracture. It is very significant to establish the measurement method of interfacial crack by applying the ultrasonic technology into the interface of bonded dissimilar materials. In this paper, the interfacial crack length was measured by ultrasonic attenuation coefficient in the Al/Epoxy bonded dissimilar materials of double-cantilever beam(DCB). The energy release rate, G, was obtained by the experimental and Ripling's equation measurement of compliance. The experimental results represent that the relation between interfacial crack length for the ultrasonic attenuation coefficient and energy release rate is increased proportionally. From the experimental results, a measurement method of the interfacial crack length by the ultrasonic attenuation coefficient was proposed and discussed.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.4 no.4
• /
• pp.171-178
• /
• 1996

DCB(pure mode I) and CLS(mixed mode) tests were performed to investigate the effect of fracture mode on the interlaminar fracture of composite laminate. Mode I critical strain energy release rate was found to be $133J/m^2$ from the DCB test and total strain energy release rate decreased from $1, 270J/m^2$ as thickness ratio(tl/t) varied from 0.333 to 0.667 from the crease from the CLS test. Crack length had no effect on the total strain energy release rate and load was almost constant during the crack growth of the specimen which had the specific thickness ratio. Crack initiated when the stress of the strap ply reached constant stress $42kgf/mm^2$ which was found to be independent of the thickness ratio.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05a
• /
• pp.227-232
• /
• 1998

하나로 1차 배관에서 중성자를 측정하고 발생 원인을 분석하였으며, 이를 통하여 중성자 계측 계통을 이용하여 핵연료 파손을 감시할 수 있는 가능성을 검토하였다. 중성자 측정에는 BF$_3$비례 계수관을 이용하였고, 1차 배관의 주 방사선원인 N-16에 의한 감마선 펄스의 영향은 무시 할 정도로 작았다. 중성자의 발생 원인을 규명하기 위해 원자로 정지 전후에 중성자 계수율의 변화를 측정하였다. 편자로의 정상 운전시 1차 배관에서 발생되는 중성자는 물속의 중수소가 고에너지 감마선을 흡수하여 방출하는 광중성자와 핵연료의 표면 오염에 의해 발생된 지발 중성자라고 가정하여 원자로 정지 전후의 발생량 변화를 계산하였다. 계산 결과와 측정값을 비교하여 1차 배관 주변에서 측정된 중성자 가운데 지발 중성자가 약 70 %, N-16에 의한 광중성자가 약 30%임을 확인하였다. 핵연료의 표면 오염 정도로 발생하는 지발 중성자도 민감하게 측정되므로, 이러한 지발 중성자 계측법이 핵연료의 손상 여부를 알아낼 수 있는 유용한 방법임을 확인할 수 있었다.

• Journal of Ocean Engineering and Technology
• /
• v.7 no.1
• /
• pp.25-32
• /
• 1993

In composite materials, the fracture perpendicular to the fiber direction usually shows a non-linear behavior accompannying blunting and plastic deformation around the crack tip. In this study, the fracture thoughness in random short fiber SMC composite material and Carbon/Epoxy composite material is estimated by the A.M.(Area Method) and the G.L.M.(Generalized Locus Method) which can determine a stable total energy release rate(G$_T$) not only in highly elghly elastic material but also in highly non-linear materials.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.28 no.4
• /
• pp.386-393
• /
• 2004

In this paper, the ultrasonic attenuation coefficient was measured by variation of crack length for double-cantilever beam(DCB) specimen. The energy release rate, G, was obtained by the experimental measurement of compliance. The experimental results represents that the crack length for the ultrasonic attenuation coefficient and energy release rate is increases proportionally From the experimental results, we proposed a detecting method of the crack length by the ultrasonic attenuation coefficient and discussed it.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2020.01a
• /
• pp.165-166
• /
• 2020

산업화 이후 무분별한 자원 개발로 인해 쓰레기 배출량은 증가하였으나 그 양을 감당할 쓰레기통의 개수는 부족하다. 그리고 쓰레기통이 있음에도 불구하고 시민의식 부족으로 인해 일반 쓰레기와 재활용쓰레기가 같이 버려져 있는 상태를 흔히 볼 수 있다. 작은 예로 자취하고 있는 대학생들 자취방 앞이나 상가 건물 앞에 분류되지 않고 아무렇게나 버려져있는 쓰레기들을 많이 볼 수 있다. 이는 환경 미화원이 직접 재분류를 하고 청소하는데 시간과 인력 비용이 낭비하게 된다. 본 논문은 이러한 문제점들을 개선하고 보완하고자 쓰레기를 자동으로 분리수거할 수 있는 '자동 분리수거가 가능한 쓰레기통'기술을 제안한다. 이는 분리수거율을 증가시키고 분리수거 다시 할 불필요한 시간과 인력과 예산을 줄일 수 있고 재활용된 자원을 사용하여 생산 자원을 줄여 원가 절감효과와 에너지 소비를 줄일 수 있다. 이로 인해 자원을 생산할 때 발생하는 탄소와 온실가스 방출량을 감소시켜 지구 온난화를 예방할 수 있다.