• Journal of the Society of Naval Architects of Korea
• /
• v.37 no.1
• /
• pp.10-25
• /
• 2000

The effects of Reynolds number of model propeller leading edge roughness and air content resolved in tunnel water on cavitation inception, cavitation extent and pressure fluctuation were investigated experimentally by using two model propellers in a cavitation tunnel. Cavitation observation and propeller induced fluctuating pressure measured in the present model test were compared with the model test results of other research institutes and the full-scale data of a German container ship(Sydney Express). The comparison shows a reasonable agreement.

• Journal of the Korean Society for Railway
• /
• v.15 no.2
• /
• pp.104-108
• /
• 2012

All of the Korean high speed train windows have been imported from abroad up to now. In this paper, the air pressure endurance test device for high speed train windows was studied and developed. This test device can create air pressure variation similar to train running real condition and carry out pressure endurance test according to international standard. Henceforward, this test device will be useful for domestic production of high speed train windows.

• 한국연소학회:학술대회논문집
• /
• 2006.10a
• /
• pp.27-35
• /
• 2006

It has been observed in experiments that combustion instability of low frequency (${\sim}$ 10Hz) results form the modulation of equivalence ratio at fuel injection hole when a pressure fluctuation propagates upwards along the channel of the burner under an unchoked fuel flow condition. In this study, a commercial program was used to determine how the fuel flow rate changed with respect to the pressure, velocity of the fuel flow and the mass fraction in a choked and an unchoked condition. The calculation focus on the upstream of the dump plane to know how the forced pressure with the fuel injection conditions affects the modulation of the equivalence ratio. Therefore, it is found that pressure fluctuation leads to oscillation of mass flow rate and then results in equivalence ratio modulation under the unchoked fuel flow condition.

• KDI Journal of Economic Policy
• /
• v.15 no.3
• /
• pp.37-52
• /
• 1993

우리나라에서는 70년대 중반 여후 공공요금관리(公共料金管理)가 물가정책의 주요수단으로 인식되어 왔으나, 다른 나라의 경험을 살펴보면 물가상승압력(物價上昇壓力)의 근본적인 해소가 전제되지 않는 가격규제정책(價格規制政策)은 유효한 물가대책(物價對策)이 아니라는 것이 보편적으로 인정되고 있다. 본고(本稿)의 분석(分析)에 의하면, 공공요금(公共料金)의 변동과 기타물가지수(소비자물가지수에서 공공요금 및 농축수산물지수를 제외한 것)의 변동간에는 장기적으로 같이 움직이는 공적분관계(共積分關係)가 존재한다. 그러나 일반의 인식과는 달리 공공요금의 변동이 기지물가변동(其地物價變動)을 초래하는 것이 아니라, 기타물가상승(其他物價上昇)이 공공요금상승을 유발하였던 것으로 나타났다. 이는 과거의 공공요금관리정책(公共料金管理政策)이 물가대책으로서의 유효성은 높지 않았음을 의미한다. 따라서 향후의 물가안정(物價安定)은 공공요금 등에 대한 직접적인 가격억제(價格抑制)보다는 경제전체의 물가상승압력(物價上昇壓力)을 완화시킬 수 있는 안정위주의 거시정책기조(巨視政策基調)를 통하여 이뤄 나가야 할 것이다.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05a
• /
• pp.386-391
• /
• 1998

국내 가압경수로 가압기 안전밸브는 운영기술지침서에 따라 운전 중과 같은 환경조건에서 압력설정치(2,485 psig) 시험을 수행하도록 규정되어 있다. 가압기 안전 밸브는 일정한 주기로 압력설정치 시험이 수행되고 있으나, 시험시의 주변 온도, 사용 유체 등 그 시험 조건에 따라 압력설정 허용치 $\pm$1% 이상의 편차가 발생할 수 있음이 확인되고 있다. 본 연구에서는 압력설정치 시험시의 주변온도 상태에 따른 설정치 변동 사례를 조사하고, 보수 후 압력설정치 조정을 위한 대체 방안과 그 문제점을 고찰하였다.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05a
• /
• pp.440-445
• /
• 1996

본 논문에서는 가압기에 기포가 형성되기전 원자로 냉각재계통의 압력을 자동으로 제어할 수 있는 원자로 냉각재 압력 제어기를 개발하여 원전 시뮬레이터를 통해 설계된 제어기의 성능시험을 수행하였다. 그 결과 냉각재의 압력변동을 주는 환경 요인 발생시에도 설정치에 안정된 압력제어 특성을 보여주었다. 원전 기동시 압력제어에 본 논문에서 제안한 제어기를 적용할 경우 운전원의 운전부하를 줄여줄 것으로 예측된다.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.12 no.4_1
• /
• pp.129-136
• /
• 1992

A precedure for recovering surface displacement from a time series of pressure measured by a pressure gage in a shallow water (that is, FFTM, LCM. IWM) is investigated with respect to a proper cut-off-frequency of a frequency response function for the accurate recovery of wave height and period. The authors examined the applicability of above mentioned three transformation procedures through field observations and laboratory experiments and the following results are obtained. i) The cut-off-frequency of the frequency response function used in FFTM is deeply depend on both the frequency response of the pressure sensor and the water depth at the sensor. In this study, a relatively accurate surface displacement can be recovered when the frequency response function is cut off at the frequency corresponding to kh=3.0 where k is a wave number at the depth of h. The frequency response function in the region higher than the cut-off-frequency is set constant to be the value at the cut-off-frequency. ii) The transformed surface displacements by LCM are affected by the small waves of short periods included in the measured pressure. It is found that pressure variation whose local frequency is higher than kh=1.5 has to be neglected to recover surface displacement sufficiently. iii) In IWM, the linear pressure response function is usually utilized by multiplying a coefficient N which is a function of the frequency (or kh) and takes a value around unity. However, in this study, a constant value of N(=1.0) gives a relatively accurate recovery of surface displacements.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.2
• /
• pp.191-199
• /
• 1992

This paper presents in experimental study of the dynamic internal pressure within an oil hydraulic vane pump. The measurements of the dynamic internal pressures near the vane of a pressure balance type of an oil hydraulic vane pump with intravanes has been made to provide the essential information for the study of the pump dynamics and control, the pump design and the analysis of tribological problems in the sliding components. The influences of the discharge pressure and rotating speed of the vane on the dynamic pressure in four chambers surrounding a vane have been investigated. The results indicate that the surge pressures of the chambers at the instant moment of discharge and closure are affected by the rotating speed. The pressure in the intravane chamber maintains almost constant values, which remarkably effects the pulsating discharge pressure.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.17 no.5 s.122
• /
• pp.405-414
• /
• 2007

In recent years, experimental and theoretical studies show that turbulent flows looking disordered have a definite structure produced repetitively with visible order. As a core structure of turbulence, hairpin vertices are believed to play a major role in developing and sustaining the turbulence process in the near wall region of turbulent boundary layers and may be regarded as the simplest conceptual model that can account for the essential features of the wall pressure fluctuations. In this work, fully developed typical hairpin vortices are focused and the associated surface pressure distributions and their corresponding spectra are estimated. On the basis of the attached eddy model, the overall surface pressure spectra are represented in terms of the eddy size distribution. The model is validated by comparison of predicted wavenumber spectra with existing empirical models, the results of direct numerical simulation (DNS) and also spatial correlations with experimental measurements.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.25 no.6
• /
• pp.765-771
• /
• 2019

With the increase in the speed of ships and the size of ocean structures, the importance of flow noise has become increasingly critical in meeting regulatory standards. However, unlike active investigations in aeroacoustics fields for airplanes and trains, which are based on acoustic analogy methods for tonal and broadband frequency noise, only the discrete blade passing frequency noise from propellers is considered in marine fields. In this study, prediction methods for broadband noise in marine propellers and underwater appendages are investigated using FW-H Formulation1B, which can consider the mechanism of primary noise generation of trailing edge noise. The original FW-H Formulation 1B is based on the pressure correlation function tolackitsgeneralityandaccuracy. To overcome these limitations, wall-pressure spectrum models are adopted to improve the generality in fluid mediums. The comparison of the experimental results obtained in air reveals that the proposed model exhibits a higher accuracy within 5 dB. Furthermore, the prediction procedures for broadband noise for hydrofoils are established, and the estimation of broadband noise is conducted based on the results of the computational fluid dynamics.