• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2014.04a
• /
• pp.216-216
• /
• 2014

과거 유체 유발 진동(FIV : Fluid Induced Vibration)은 배관계 설계 하중에 고려되지 않은 설계 하중이었다. 하지만, 원자력 발전소 또는 화력 발전소의 배관형상이 복잡하고 고온수가 배관 내부에서 유동하는 배관계에서 육안으로 관측이 가능한 배관진동이 발생하였다. 이에 배관 진동에 대하여 원인 분석과 배관 구조 건전성 평가에 관심을 가지게 되었다. 배관 진동은 배관 형상에 따라 배관 내부 난류 유동에 대한 압력 변동이 하나의 원인이며, 고온수가 유동하는 배관일수록 압력 변동에 대한 배관 진동이 크게 나타나는 것으로 분석되었다. 배관 내부 난류 유동에 대한 압력 변동을 불규칙 수력하중이라고 한다. 본 연구에서는 배관 내부에서 난류 유동으로 발생하는 불규칙 수력하중을 유동해석을 이용하여 PSD(Power Spectral Density)로 산출하고, PSD 하중을 이용하여 불규칙 구조 응답 해석을 수행하여 배관계 응력 분포에 대하여 연구하였다. 배관 내부 난류 유동에 대한 불규칙 수력하중은 DES 난류 모델을 사용하여 시간에 대한 배관 내부 표면의 유체 속도를 유동 해석으로 산출하였으며, 유체 속도를 동압으로 계산한 후 FFT(Fast Fourier Transform)를 수행하여 PSD 하중으로 산출하였다. 그리고 불규칙 구조 응답 해석에서 배관 내부 유체 영향에 대한 진동 감쇠를 표현하기 위하여 유체 질량을 산출하고, 배관 구조 해석 모델 표면에 질량을 입력하는 방법으로 배관 고유진동수 및 불규칙 구조 응답 해석을 수행하였다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.33 no.7
• /
• pp.552-558
• /
• 2009

An experimental study using the combustor with branch tube was conducted in order to model the industry combustor with FGR (flue gas recirculation) system and to study a thermo-acoustic instability generated by a branch tube. The branch tube is a structure used to modify a system geometry and then to change its pressure field, and the thermo-acoustic instability, usually occurs in a confined geometry, can result in serious problems on industrial combustors. Thus understanding of the instability created by modifying geometry of combustor is necessary to design and operate combustor with FGR system. Pressure fluctuation in the combustion chamber was observed according to diameter and length of branch and it was compared with the solution of 1-D wave equation. It was found that branch tube affects the pressure field in the combustion chamber, and the pressure fluctuation in the combustion chamber was reduced to almost zero when phase difference between an incipient wave in the combustion chamber and a reflected wave in the branch tube is $\pi$ at the branch point. Also, the reduction of pressure fluctuation is irrespective of the installed height of branch tube if it is below $h^*=0.9$ in the close-open tube and open-open tube.

• Proceedings of the Korean Society for Rock Mechanics Conference
• /
• 2007.10a
• /
• pp.19-36
• /
• 2007

When the trains runs at a high speed in the tunnel, passengers feel a pain in the ear that fast pressure fluctuation inside the tunnel being delivered with pressure fluctuation inside the passenger car. These phenomena are called "aural discomfort". Aural discomfort increase the passengers' uncomfort so that it is decreased a service level and serious case, it is able to damage the ear of the passenger. therefore aural discomfort must be considered the high-speed railroad tunnel cross-section design. To solve the problem of aural discomfort in a railway tunnel, some countries have standards on aural discomfort. It has been studied that different countries have different standards on aural discomfort. For that reason, the criteria of aural discomfort was reviewed through the standards of Kyungbu HSR line and different countries in this paper. And then Numerical Analysis of the Characteristics with tunnel cross-section change has been used for the selection of the optimum cross-section of Honam. The numerical analysis results were compared to field test results in order to verifying the reliability of the numerical analysis.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2001.11a
• /
• pp.57-62
• /
• 2001

본 연구에서는 검증된 BSU 3톤/일급 석탄가스화공정에 대해 개발된 동적모델을 폐유가스화 공정모텔에 적용하였다. 대상공정에 포함된 조작변수들의 변동에 따른 주요 공정변수인 산소/폐유비를 3% 계단증가시킨 결과, 폐유가스화기의 압력은 15분의 시상수를 보이며 최종적으로 2.4%가 증가된 정상상태에 도달하였고, 온도는 초기 1분 이내에 약 3.2%의 급격한 증가를 보인 후 최종적으로 4.1% 증가된 정상상태에 도달하였다. 그리고 생성가스의 조성은 이산화탄소가 6% 증가되었고, 일산화탄소와 수소는 각각 2% 및 8% 감소된 새로운 정상상태에 도달하였다. 이러한 결과를 토대로 폐유가스화기의 부하변동에 따른 주요 공정변수들의 변동경향 및 신뢰성 있는 동적모사 결과를 얻고, 개발된 모델에 cascade 및 ratio 방식의온도, 압력 제어로직을 설계하여 실공정 적용실험을 통한 전산모사결과 및 안정된 운전특성을 검증할 수 있는 기초를 마련하였다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.31 no.2 s.257
• /
• pp.202-207
• /
• 2007

In order to understand the phenomena of combustion instability, an experimental study was conducted at the moderate pressure and ambient temperature conditions. The flame behavior and the pressure fluctuations were measured in a dump combustor. Various types of combustion modes occurred in accordance with the equivalence ratio and the fuel supplying conditions. The fluctuation of pressure, heat release and equivalence ratio were measured by piezoelectric pressure sensor, high speed Intensified Charge Coupled Device (HICCD) camera and gas chromatography respectively. Two representative modes were self-excited pressure oscillations at the resonance of combustion chamber (200Hz) and instabilities related to the modulated fuel flow rate through the fuel holes (10Hz). It is found that, especially in an unchoked fuel flow condition, the modulation of the fuel flow rate affects the characteristics of flame behavior and pressure fluctuations in a lean premixed flame.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.6
• /
• pp.390-395
• /
• 2019

Hydrogymnastics so that sufficient exercise effect can be obtained using the resistance of water has a positive effect on patients who have to receive arthritis or rehabilitation treatment. However, the studies on the effect are insufficient, and the main cause of their effects has not been unclear yet. In this study, in order to identify the main cause of the effects of Hydrogymnastics, conducted Unsteady fluid flow simulation under the same conditions as the actual environment. The analysis model based on real hands, and the pressure fluctuation applied to the knuckle was analyzed by the computational fluid method. During the underwater movement of the hands, Various sizes of vortices were generated between fingers due to skin surface velocity and flow resistance. Pressure of about -500 Pa to +500 Pa is applied by the vortex flow. Also It was confirmed that the positive pressure and the negative pressure were continuously repeated up to maximum + 2000 Pa at the minimum of -2000 Pa at the portion where the direction was changed. Pressure fluctuations with a frequency of 20 Hz to 70 Hz were added continuously for each knuckle. These continuous pressure fluctuations provide a direct massage effect on the knuckles, an It is judged that the blood circulation at the relevant part is positively affected.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2354-2359
• /
• 2007

Influence of changing combustor pressure on flame stabilization and emission index in the swirl-stabilized flame was investigated. The combustor pressure was controlled by suction fan at combustor exit. Pressure index ($P^{\ast}$=Pabs/Patm), where Pabs and Patm indicated the absolute pressure and atmosphere pressure, respectively, was controlled in the range of 0.7${\sim}$1.3 for each equivalence ratio conditions. The flammable limits of swirl flames were largely influenced by changing combustor pressure and they showed similar tendency with laminar flames. NOx emission index decreased with decreasing pressure index for overall equivalence ratio conditions. R.m.s. of pressure fluctuations is increased with decreasing combustor pressure. This flame fluctuation caused incomplete combustion, hence CO emission index increased. These oscillating flames were measured by simultaneous $CH^{\ast}$ chemiluminescence time-series visualization and pressure fluctuation measurement.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.3264-3269
• /
• 2007

Combustion instability is a serious obstacle for the lean premixed combustion of gas turbines, and can even cause fatal damage to the combustor and the entire system. Thus, improved understanding of the mechanisms of combustion instability is necessary for designing and operating gas turbine combustors. In this study, in order to understand the instability phenomena, an experimental study was conducted in a rearwardstep dump combustor with LPG and air. The fluctuations of pressure and heat release were measured by piezoelectric pressure sensor and High speed Intensified Charge Coupled Device (ICCD) camera respectively. Various types of combustion modes occurred in accordance with the equivalence ratio and the fuel supplying conditions. The unmixedness of the fuel and air can be controlled by changing the mixing distance ($L_{fuel}$). It is found that the unmixedness of the fuel and air affects the characteristics of flame behavior and pressure fluctuations in a lean premixed flame.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.10a
• /
• pp.737-740
• /
• 2002

Pressure fluctuation in the cylinder is one of the major sources on noise emission in oil hydraulic piston pumps. This paper reports an experimental study of pressure fluctuation characteristics in the cylinder of oil hydraulic piston pumps. We measured pressure fluctuation at BDC with delivery pressure, rotational speed. Because the pre-compression and the V-grooves in the valve plate is known of noise reduction, we investigated also the effect of pre-compression and V-grooves at the ends of the kidney ports with four types valve plates. We found that the pre-compression and the V-grooves in valve plate could reduce the noise of oil hydraulic piston pumps.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.14 no.1
• /
• pp.179-188
• /
• 1990

The characteristic of volumetric efficiency considering gas exchange process in a reciprocating engine is presented in this paper. The characteristic method is used for solving gas exchange problems of engine system in theoretical studies. The validity of the simulation is investigated by a comparison with the results obtained by the experiment which have been performed on the practical 4-cycle, 4-cylinder gasoline engine. The relationship between the volumetric efficiency and the intake pressure variation according to configuration of intake pipe, position of branch point, valve timing, compression ratio is clarified through simulation and experiment. The results predicted by the simulation are found to be in approximate agreement with those obtained by the experiment.