• Composites Research
• /
• v.31 no.1
• /
• pp.12-16
• /
• 2018

Composite material and mold steel can be expanded differently with the temperature gradients during the forming process because their coefficients of thermal expansions are not the same. Therefore, in order to manufacture the product with accuracy, it is necessary to verify that the forming pressure on the surface of the composite material is maintained to the required level from the material supplier. In this paper, the pressure between the composite material and mold due to the temperature difference was predicted by finite element analysis and the accuracy of predicted value was verified by measuring the thermal expansions of mold steel by the ruler. The predicted value by finite element analysis is closely in agreement with one by the experiment within the required tolerance value of ${\pm}0.05mm$.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.9
• /
• pp.731-737
• /
• 2014

A vortex chamber is a simple device that separates compressed gas into a high-temperature stream and a low-temperature stream. It is increasing in popularity as a next-generation heat exchanger, but the flow physics associated with it is not yet well understood. In the present study, both experimental and numerical analyses were performed to investigate the temperature separation phenomenon inside the vortex chamber. Static pressures and temperatures were measured using high-sensitivity pressure transducers and thermocouples, respectively. Computational fluid dynamics was applied to simulate 3D unsteady compressible flows. The simulation results showed that the temperature separation is strongly dependent on the diameter of the vortex chamber and the supply pressure at the inlet ports, where the latter is closely related to the viscous work. The previous concept of a pressure gradient wave may not be a reasoning for temperature separation phenomenon inside the vortex chamber.

• Journal of Biomedical Engineering Research
• /
• v.23 no.4
• /
• pp.309-315
• /
• 2002

Since the discovery, in the 1980s, of erosion-pit-induced fractures in implanted mechanical heart valves. cavitation on the surface of mechanical heart valves has been widely studied as a possible cause of pitting. Several factors, including peak dp/dt of the ventricular pressure. maximum closing velocity of the leaflet, and squeeze flow. have been studied as indices of the cavitation threshold. In the present study. cavitation erosion on the surface of a mechanical valve was examined by focusing on squeeze flow and the water hammer phenomenon during the closing period of the valve. In this study, we measures pressure wave forms near a valve and closing velocities of a disk, which were placed in a holder with and without compliance. In case of all holders, pressure drop of below vapor pressure expect at near the surface disk. It was also found that the closing velocity of the disk increased and that cavitation erosion was enhanced too. These results suggest that disk closing velocity during the closing phase has signifiant effects on pitting erosion.

• The Journal of the Petrological Society of Korea
• /
• v.4 no.2
• /
• pp.104-123
• /
• 1995

Mantle xenoliths in alkali basalt from Boun, Gansung area, and Baegryung island in S. Korea are spinel lherzolites composed of olivine, orthopyroxene, clinopyroxene, and spinel. The xenoliths generally show triple junctions among grams, kink-banding in olivine and pyroxenes, and protogranular and eqigranular textures having m orlentatron of specific direction. Anhedral brown spinels are disseminated in the intergranular spaces of minerals. Mineral compositions are very homogeneous without compositional zonation from rim to core in grains regardless different locahties. Olivine shows Fo. component of 89.0-90.2 and low CaO of 0.03-0.12wt%, orthopyroxene is enstatite with En component of 89.0 - 90.0 and $Al_2O_3$ of 4-5wt%, and clinopyroxene is diopside having En. component of 47.2-49.1 and $Al_2O_3$ of 7.42-7.64wt% from Boun and 4.70-4.91wt% from Baegryung showing local variation. Spinel shows the distinctive negative trend with increasing of A1 and decreasing of Cr, and Mg value and Cr number are 75.1-81.9 and 8.5-12.6, respectively. To estlmate T and P for these mantle xenoliths pyroxene-geothermometers (Wood and Banno, 1973; Wells, 1977; Mercier, 1980; Sachtleben and Seck, 1981; Bertrand and Mercier, 1985; Brey and Kohler, 1990) and Al-solubility geobarometer (Mercier, 1980; Lane and Ganguly, 1980) are used. Temperatures of Mercier (1980) and Sachtleben and Seck (1981) are compatible and equilibrium temperatures of xenoliths, average value of these two, aiie from $970^{\circ}C$ to $1020^{\circ}C$, and equihbrium pressures derived from Mercier (1980) are in the range of 12-19 Kb (42-63 Km). These temperatures and pressures seem to be reasonble wlth the consideration of Al-isopleths in MAS system (Lane and Ganguly, 1980) and Fe effect on Al-solubility in orthopyroxene (Lee and Ganguly, 1988). Equllibrium of temperatures and pressures of xenoliths in P-T space belong to ocenanic geothem among the Mercier's mantle geotherms (1980) and are completely different from continental geotherms of S. Africa (Lesotho) and S. India having different geologcal ages. anera1 compositions of spmel-lherzohtes in S. Korea and eastern China are primitwe and paleogeothems of both are very s~mllar, but degrees of depletion of upper mantle could be locally different from each other since eastern China has various depleted xenoliths due to different degrees of partial melting.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.7
• /
• pp.1-8
• /
• 2005

For study on the unsteady wall interference effect, flows around a circular cylinder in closed test-section wind tunnels have been numerically investigated by solving compressible Navier-Stokes equations. The numerical scheme is based on a node-based finite-volume method with the Roe's flux-difference splitting and an implicit time-integration method coupled with dual time-step sub-iteration. The computed results showed that the unsteady pressure gradient over the cylinder is enhanced by the wall interference, and as a result the fluctuations of lift and drag are augmented. The drag is further increased because of the lower base pressure. The vortex shedding frequency is also increased by the wall interference. The pressure on the test section wall shows the harmonics having the shedding frequency contained in the wall effect.

• Nuclear Engineering and Technology
• /
• v.18 no.2
• /
• pp.107-116
• /
• 1986

The steady and unsteady state models were established for the performance analysis and design of heavy water distillation columns packed with corrugated wire mesh. After the steady state model was derived with pressure drops, separated D$_2$O concentration and temperature profiles and pressure gradients in the column were obtained by solving MESH equations with equation tearing method. For the analysis of unsteady state behavior, the equilibrium stage transient model deduced from modifying the Cohen's ideal cascade equation was used to predict the concentration change of heavy water with time. These models were in good agreement with the experimental results of heavy water distillation at total reflux. And the newly developed packing material turned out to be very efficient separation device for very small HETP, pressure drop and holdup.

• The Korean Journal of Petroleum Geology
• /
• v.7 no.1_2 s.8
• /
• pp.1-6
• /
• 1999

Natural gas hydrate, a solid compound of natural gas (mainly methane) and water in the low temperature and high pressure, is widely distributed in permafrost region and deep sea sediments. Gas hydrate stability field (GHSF), which corresponds to the conditions of a stable existence of solid gas hydrate without dissociation, depends on temperature, pressure, and composition of gas and interstitial water. Gas hydrate-saturated sediment are easily recognized by the bottom simulating reflector (BSR), a strong-amplitude sea bottom-mimic reflector in seismic profiles. It is known that BSR is associated with the basal boundary of the GHSF, The purpose of this study is to define the GHSF and its occurrence in the southwestern part of Ulleung Basin, East Sea. The hydrothermal gradient is measured using the expandable bathythermograph (XBT) and the geothermal gradient data are utilized from previous drilling results for the adjacent area. By the laboratory work using methane and NaCl $3.0 wt{\%}$ solution, it is shown that the equilibrium pressures of the gas hydrate reach to 2,920.2 kPa at 274.15 K and to 18,090 kPa at 289.95 K for the study area. Consequently, it is interpreted that the lower boundary of the GHSF is about 210 m beneath 400-m-deep sea bottom and about 480 m beneath 1,100-m-deep sea bottom. The resultant boundary is well matched with the depth of the BSR obtained from the seismic data analysis for the study area.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.14 no.6
• /
• pp.151-159
• /
• 2006

A one-dimensional numerical analysis is carried out to investigate the effects of inlet gas humidities, inlet gas pressures, and thicknesses of membrane on the performance of a proton exchange membrane fuel cell. It is found that the relative humidity of inlet gases at anode and cathode sides has a significant effect on the fuel cell performance. Especially, the desirable fuel cell performance occurs at low relative humidity of the cathode side and at high humidity of the anode side. In addition, an increase in the pressure ranging from 1 atm to 4 atm at the cathode side results in a significant improvement in the fuel cell performance due to the convection effect by a pressure gradient toward the anode side, and with decreasing the thickness of membrane, the fuel cell performance is enhanced reasonably.

• KSBB Journal
• /
• v.14 no.1
• /
• pp.109-113
• /
• 1999

Supercritical $CO_2$ chromatography was applied for purification of eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA) from fish oil. Various supercritical $CO_2$ pressures were tested to find out the pressure effects on solubility and selectivity of low fatty acids in the silver nitrate column. The solubility of low fatty acids was increased as the supercntical $CO_2$ Pressure increased. However, the selectiviy between low fatty acids and EPA waw decreased. Stepwise density gradient method was applied to increase the purification efficiency of EPA. Low fatty acids were easily separated at the early elution steps with low $CO_2$ densities. Successive fractions containing 92.1~97.8% of EPA were collected. The average concentration of three purified fractions was 95.6% with the recovery rate of 30%.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2008.04a
• /
• pp.179-186
• /
• 2008

현재 대부분의 산업용 열기관은 효율을 높이기 위하여 연소에 사용되는 공기를 예열하는 방법을 사용한다. 하지만, 산업용 열기관에서 평균적으로 발생되는 $1000^{\circ}C$ 이상의 배기가스는 일반 금속 열교환기에는 적합하지 않다. 이에 반해 세라믹 열교환기의 경우 고온에서 견디는 장점이 있다. 본 연구에서는 기본적인 열교환기 설계 이론을 이용하여 설계프로그램을 제작하였다. 또한 세라믹 열교환기 내 열 유체 거동을 CFD 상용코드인 FlUENT 6.2를 이용한 전산해석을 수행하여 설계결과를 비교 검증하였다. 설계 결과에서 휜의 형태 변화에 따라 열전달율과 온도구배는 무시할 수 있을 정도로 작았으나, 압력강하는 크게 변동되는 결과가 도출되었다. 제한된 모듈 크기에서 휜 간거리는 휜의 두께에 비해 약 3배 이상 클 경우가 적당하며, 판(plate)의 두께는 작을수록 압력손실이 적고, 열전달율이 상승하지만 두께가 너무 얇게 된다면 제작상의 어려움이 생긴다. 향후 연구에서는 단순한 구조에서 벗어나 off-set이나 판형구조를 고려하여 설계함으로서 열전달 면적을 넓히거나 난류유동을 발생시켜 열전달율을 높이는 연구를 진행 할 필요가 있다.