• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.12
• /
• pp.1347-1351
• /
• 2006

It was tried to utilize organic waste sludge from wastewater treatment plant as a starting material to produce a solid fuel by vacuum flying. The effects of decompression levels, frying time and temperature on the calorific value and moisture of vacuum fried sludge were systematically investigated. Dewatered raw sludge used in this study had a moisture of 81.1% and calorific value of 2,930 kcal/kg. Based on the experimental observation, it was identified that the decompression level and frying time have the greatest influence on the calorific value of vacuum fried sludge. Moistures of the fried sludge at $180^{\circ}C$ for 25 min in 760 mmHg, 684 mmHg and 630 mmHg were 32.4%, 14.2% and 11.6%, respectively. Calorific values of the vacuum fried sludge at $140^{\circ}C$ for 15 min and 25 min were 5,400 kcal/kg and 5,540 kcal/kg in 684 mmHg and 5,520 kcal/kg and 5,660 kcal/kg in 630 mmHg, respectively.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.13 no.2
• /
• pp.74-84
• /
• 2005

The objectives of this study was to investigate the improvement of thermal kinetics for disposal of sewage sludge using thermal wind drying. The operational parameters varied are the temperature of $130{\sim}170^{\circ}C$ and evaporation velocity WD. Important parameters effect on thermal kinetics for evaporation of water in sewage sludge studied include the drying time, water content of sewage sludge, solids amount of sewage sludge(TS%) by the varied temperature. The saturation point of water evaporation was observed at the drying time of 60 min in conditions of drying temperature $170^{\circ}C$ and drying time of 120 min by drying temperature $130^{\circ}C$ and WD=0.95 m/s. Operation at drying temperature of $170^{\circ}C$ led to higher rate of evaporation than those 130, $150^{\circ}C$ at WD=1.0 m/s and WD=1.0 m/s was higher than WD=0.5 m/s at drying temperature of $130^{\circ}C$.

• Applied Biological Chemistry
• /
• v.41 no.2
• /
• pp.181-186
• /
• 1998

The effects of sewage treatment on characteristics of sludge as a composting material were investigated for a year during the initial operation at the full-scale Chunan sewage treatment plant. Due to the shortage of design capacity of belt press, a sludge dewatering unit, non-volatile solids were recirculating and concentrating in the treatment plant, resulting in an increase of MLSS and a decrease in F/M ratio at the activated sludge system. Special attention is required for long term operations since the increase of non-volatile solids in the plant would deteriorates the treatment efficiency. The sewage sludge of the Chunan sewage treatment plant showed 79.5% of water content, 11.6% of organic content, and C/N ratio of 6.1, and contained As 1.8 mg/kg, Cd 27 mg/kg, Hg <0.1 mg/kg, Pb 54 mg/kg, T-Cr 370 mg/kg, and Cu 1,100mg/kg of heavy metals. In order to be used as raw material for optimum composting, the sewage sludge requires bulking agents for moistrure/porosity control and a carbon source for adjusting C/N ratio. However, the sewage sludge is not adequate as a soil conditioner after composing due to a high content of heavy metals. If the sewage sludge has to he used as a soil conditioner after composting, it as required to identify and remove tire industrial wastewater portions in tire influent of the plant since heavy metals in the influent were mostly concentrated in dewatered sludge.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.3 no.2
• /
• pp.47-57
• /
• 1995

The purpose of this study was to investigate the effect of mechanical mixing intensity on composting. The major parameters investigated were the mixing intensity and initial moisture content. Laboratory scale composting reactors with mixing equipment were used in this study. Wastes used for the study were raw nightsoil sludge, nightsoil sludge after vacuum evaporation treatment and pig manure. When moisture contents were 60% and 63%, amount of organic material degraded in the continuous mixing reactors was higher than that in the intermittent mixing reactors. Compost produced from reactors with continuous mixing had better texture than that obtained from reactors with intermittent mixing. When moisture content was 68%, organic waste was kneaded rather than mixed in the continuous mixing reactors. Amount of organic material degraded in the continuous mixing reactors also was lower than that in the intermittent mixing reactors.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.12 no.2
• /
• pp.52-60
• /
• 2004

The basic approach to sewage sludge is organic waste minimization, promotion of energy recovery; volume and weight reduction by final treatment, and environmentally final disposal of natural circulation. Dry and pyrolysis of maize was experimentally investigated in full-scale rotary kiln in semi-continuous operation. The operational parameters varied are the operating temperature $160{\sim}175^{\circ}C$ of dry and $450{\sim}800^{\circ}C$ of pyrolysis, the solids residence time 9 min for pyrolysis. Important parameters studied include the running time, water content of sewage sludge, solids amount of sewage sludge(TS%) by the varied temperature. Also, with the increasing of temperature, how the yield of oil and char product change was observed, and the distribution of gas production components was observed. The gas of $C_1{\sim}C_3$ yield increased and oil of $C_4{\sim}C_6$ yield decreased along with pyrolysis temperature of $670^{\circ}C$ by the run time of 9 min.

• Korean Journal of Environmental Agriculture
• /
• v.16 no.4
• /
• pp.382-389
• /
• 1997

To study the optimum conditions of composing with sewage sludge, the variations of temperature and $CO_2$ generation amount during composting periods were investigated. The conditions were that sewage sludge added to bulking agents such as sawdust and rice hull were used and differently treated with microorganism seeding or not, initial C/N ratio, air flow rate and initial moisture contents. The results were summarized as follows : Seeding of 5% microorganism was higher temperature than not seeding. And using rice hull as bulking agents, and adjusting 21${\sim}$22 of initial C/N ratio, $200ml/l\;{\cdot}\;min$. of air flow rate and 64${\sim}$65% of initial moisture contents were higher temperature than any other conditions. Seeding of 5% microorganism was more $CO_2$ generation amount than not seeding. And using saw dust was more $CO_2$ generation amount than using rice hull as bulking agents. In the case of initial C/N ratio, adjusting 21${\sim}$42 was also more $CO_2$ generation amount than adjusting 12${\sim}$14. Judging from the result, it should be considered that the optimum conditions of composting with sewage sludges were seeding of 5% microorganism and adjusting 21${\sim}$22 of initial C/N ratio, $200ml/l\;{\cdot}\;min$. of air flow rate and 64${\sim}$65% of initial moisture contents.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.10 no.4
• /
• pp.112-117
• /
• 2002

This study was conducted to induce the optimal composting conditions of pig manure mixed with sawdust and dried paper-mill sludge in the composting for production of high quality compost. Pig manure contains high water content and How C/N ratio because of comparatively high nitrogen content than sawdust and dried paper-mill sludge. Therefore the addition of dried paper-mill sludge and sawdust to the raw materials helps controlling the C/N and the water content of compost pile. The composting system used in the experiment was agitated static bed system. The physical properties of the mixed raw materials was not good at the working conditions in the early stage of composting. The temperature of compost heap reaches at $60^{\circ}C$within 5 day after starting composting in P-2 treatment mixed with pig manure and sawdust(56.6 : 43.4). Then the water content of P-2 was 58%. The pH in all treatments were slowly decreased as the composting was proceeded. Although the changes of T-C and T-N were not extended because of the short composting experiment period. Reduction rates of T-C in treatments were 5-12% without special difference. By considering the efficiency of composting in each of five treatments with pig manure the optimal water contents was about 57% level. Mixing a sawdust as a bulking agent was more positive than dried paper-mill sludge from a viewpoint of compost quality.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.2
• /
• pp.96-99
• /
• 2016

This study characterized fly ash produced from a sewage sludge incineration facility in Korea to determine if the byproducts can be utilized. All the incinerated sewage sludge was from a city in Korea. To characterize fly ash and to determine if it can be utilized, pH, water contents, elemental components, particle size, surface morphology, heavy metal compositions, and others were analyzed. In average, pH was 6.2, and water contents was about 5%. T-N and $T-P_2O_5$ were 3% and 24.5%, respectively. Particle size averaged 836 nm; surface morphology did not exhibit any significant results. X-ray diffraction (XRD) analysis results revealed that major components of the fly ash were $P_2O_5$, CaO, MgO, $K_2O$. Composition of heavy metals by the Korea Standard Methods for Waste Quality did not exceed the criteria for specified wastes in Korea.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.11 no.3
• /
• pp.42-50
• /
• 2003

Pyrolysis of maize is experimentally investigated in bench-scale rotary kiln in semi-continuous operation. The operational parameters varied are the temperature($450{\sim}800^{\circ}C$), the solids residence time(7~20 min). Important parameters studied include the running time, water content of sewage sludge, solids amount of sewage sludge(TS%) by the varied temperature. Also, with the increasing of temperature, how the yield of oil and char product change was observed, and the distribution of gas production components was observed. The gas of $C_1{\sim}C_3$ yield increased and oil of $C4{\sim}C6$ yield decreased along with pyrolysis temperature of $670^{\circ}C$ by the run time of 9 min. The results showed the expected strong influence of pyrolysis temperature and a noticeable influence of running time.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.7
• /
• pp.488-494
• /
• 2012

This study was conducted to determine the optimal ratio of sludges from milk processing industry (MPS), paper-mill industry (PMS) and night-soil treatment plant (NSS) for vermicomposting. Five different ratios, 0 : 80 : 20 (MPS-0), 25 : 60 : 15 (MPS-25), 50 : 40 : 10 (MPS-50), 75 : 20 : 5 (MPS-75), and 100 : 0 : 0 (MPS-100 : control) MPS : PMS : NSS by wet weight were tested in a small plot experiment. The experiment for each mixing ratio was performed for 2 weeks with the three replications. MPS-100 (100 : 0 : 0) only had the highest decomposition rate with 19.9%, followed by MPS-25, MPS-50, MPS-75 and MPS-0 with 19.5, 19.1, 17.6 and 16.7%, respectively. Except for MPS-100, Vermicomposting resulted in increase in ash, T-P, $NO_2{^-}-N$, $NO_3{^-}-N$, Mg, K, As, Cd and Cu, whereas moisture, VS (Volatile Substance), TKN (Total Kjeldahl Nitrogen), $NH_4{^+}-N$, Ca, Hg and Pb were lower in the final cast than the initial feed mixture. Meanwhile Zn showed very slight difference and Cr and Ni did not show any tendency between the feed mixture and the final cast. In the case of MPS-100, where the decomposition rate was the highest, all the heavy metals in the final cast except for Hg were increased. All the vermicomposts produced from five different mixing ratios of the vermicomposting sludges met the Korea Standard as by-product compost.