• 발명특허
• /
• v.30 no.7 s.349
• /
• pp.68-70
• /
• 2005

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.10a
• /
• pp.526-528
• /
• 2018

This paper proposes a small, flexible dipole antenna for wireless power transmission of smart devices in a Wi-Fi environment. The proposed antenna is a mini-dipolar antenna structure with a split ring resonator in the center and is a small dipole antenna with a size of 32mm. The split ring resonator dipole antenna showed a reduction of about 20% compared to the same size of the dipole antenna.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12A
• /
• pp.1161-1167
• /
• 2005

In this Paper, a concept of virtual smart antenna (SA) is introduced for orthogonal Sequency division multiplexing (OFDM)-based cellular systems with a frequency reuse factor equal to 1. The OFDM-based cellular system is robust to multipath channels but has a disadvantage that the intercell interference (ICI) caused by adjacent base stations is large at the edge of a cell. In this paper, after deriving the symbol timing offset estimation scheme for the OFDM signal received from multiple base stations in a quasi-static fading channel, the ICI cancellation method based on virtual smart antenna is proposed using the steering vector formed by the symbol timing offset of the desired signal and interference signals.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.10
• /
• pp.1061-1070
• /
• 2002

In this paper, we present a performance analysis of the smart antenna test-bed operating in a IS2000 1x through a test-bed that has been implemented on a DSP(TMS320C6711) board. The test-bed consists of a PC (for generating the RX data), beam-former(i.e., a stand-alone PCB for weight computation), and an interfacing module. The performance improvements compared to a normal base station system consisting of a single antenna are shown in terms the BER(bit error rate) in the wide-band CDMA channel.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.4
• /
• pp.351-354
• /
• 2017

In this paper, a compact MIMO(Multiple Input Multiple Output) antenna for smart glasses is proposed. The proposed MIMO antenna is designed using T-shaped isolator inserted between two closely located Inverted-F Antenna(IFA) and using two slots located in the ground for isolation enhancement and impedance matching characteristic. The proposed antenna has only the overall dimensions of $35mm{\times}9mm{\times}0.8mm$ and operates in the 2.4 GHz industrial, scientific, and medical(ISM) band. To verify human body effect, the phantom is used for antenna performance. The measured specific absorption rate(SAR) value is 1.38 W/kg with an input power of 18 dBm. The performance of the proposed antenna is compared with that of previous works for verification.

• Smart Media Journal
• /
• v.9 no.4
• /
• pp.60-65
• /
• 2020

The monopulse tracking algorithm can estimate the location of a partner station based on an RF (Radio Frequency) signal. The location of the partner station is estimated based on the monopulse ratio curve (MR-C), which is calculated based on the sum and difference signal patterns of an antenna. Therefore, the range in which the estimated location can be calculated with high accuracy increases in proportion to the linear region of MR-C. In this paper, we proposed a method to extend the linear region of the MR-C curve using the beamforming technique for the tracking antenna system using the active phased array antenna. Simulation results based on the same antenna system, it was confirmed that the linear region of MR-C was enlarged by about twice as much as the general case where the proposed method was not applied.

• Journal of Aerospace System Engineering
• /
• v.16 no.5
• /
• pp.86-93
• /
• 2022

Generally, a deployable solar panel is used primarily to achieve sufficient power output to perform the mission. However, temperature distribution on the antenna reflector may increase due to the shading effect induced by the presence of the deployable solar panels. Appropriate thermal design is critical to minimize the thermal deformation of the mesh antenna reflector in harsh on-orbit thermal environments to ensure remote frequency (RF) performance. In this paper, we proposed a dual-surface primary reflector consisting of a mesh antenna and a flexible fabric membrane sheet. This design strategy can contribute to thermal stabilization by using a flexible solar panel on the rear side of membrane sheet to reduce the temperature distribution caused by the deployable solar panel. The effectiveness of the mesh antenna design strategy investigates through on-orbit thermal analysis.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.05a
• /
• pp.249-252
• /
• 2001

We, for the first time, propose a novel adaptive beamforming algorithm for smart antenna. The algorithm requires neither spatial knowledge nor reference signal. The algorithm is based on gradient method and its merit is in the simplicity of calculation load while maintaining good performance. Computer simulations are presented to verify the performance.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.2
• /
• pp.247-250
• /
• 2001

We, for the first time, propose a novel adaptive beamforming algorithm for smart antenna. The algorithm requires neither spatial knowledge nor reference signal. The algorithm is based on gradient method and its merit is in the simplicity of calculation load while maintaining good performance. Computer simulations are presented to verify the performance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.10
• /
• pp.945-948
• /
• 2016

Recent premium smartphones commonly employ a metal frame and this trend is currently spreading over mid-range smartphones. However, the metal frame becomes a good coupling path of electromagnetic noises emitted from digital components in smartphones and then increases radio-frequency interference(RFI) to RF antennas located at top and bottom sides of smartphones. This paper proposed a metal frame with EBG(Electromagnetic Band Gap) structure to reduce the noise coupling to antenna by suppressing surface wave on the metal frame. By simulation, it is confirmed that the proposed metal frame with $7{\times}6$ mushroom-type EBG array pattern with multi-via can reduce the noise coupling to RF antenna by about 20 dB.