• The Journal of Engineering Geology
• /
• v.20 no.3
• /
• pp.271-279
• /
• 2010

Time-dependent behavior similar to secondary deformation related to mineral dissolution is easily observed when performing a laboratory pressure experiment. In this research, to observe the dissolution of quartz found in bentonite used as buffer material for the geological disposal of high-level waste (HLW) under conditions of high pH, we calculated the diffusion of $OH^-$ ions and the behavior of quartz dissolution using the homogenization analysis method. The results reveal that the rate of quartz dissolution is proportional to the temperature and interlayer water thickness. In particular, in a high-pH environment, the reacted area (and therefore the dissolution rate) increases with decreasing interlayer water thickness.

• 대한치과보철학회:학술대회논문집
• /
• 2000.11a
• /
• pp.90-90
• /
• 2000

• Clean Technology
• /
• v.20 no.1
• /
• pp.51-56
• /
• 2014

In this study, PSf-$Al(OH)_3$ beads were prepared by immobilizating aluminum hydroxide $Al(OH)_3$ with polysulfone (PSf). The removal experiments of the fluoride ions by PSf-$Al(OH)_3$ beads were conducted batchwise and the parameters such as pH, initial fluoride concentration, and coexisting ions were investigated. The maximum removal capacity obtained from Langmuir isotherm was 52.4 mg/g and the optimum pH region of fluoride ions was in the range of 4 to 10. The removal process of fluoride ions by PSf-$Al(OH)_3$ beads was found to be controlled by both external mass transfer at the earlier stage followed by internal diffusion at the later stage. The presence of coexisting anions such as $HCO_3{^-}$, $SO{_4}^{2-}$, $NO_3{^-}$, and $Cl^-$ had a negative effect on removal of fluoride ions by PSf-$Al(OH)_3$ beads.

• Journal of the Korean Chemical Society
• /
• v.40 no.8
• /
• pp.535-541
• /
• 1996

In preparation of fine alumina powders with use of vesicle, the effect of variation of pH in extravesicular dispersion system to mechanism of precipitation and shape and size distribution of precipitate was investigated. The results of observation by TEM and turbidimeter were obtained as follows. Reaction between aluminum ion and hydroxyl ion to produce precipitate within vesicle was initiated at pH 11.4 and spherical fine precipitates, about 50 nm size, were formed at pH 12.0. About pH 12.3, size of precipitates in vesicle grew twice as great as those formed below pH 12.0 because of the agglomeration and coalescence of vesicleswith time.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.9
• /
• pp.69-74
• /
• 2012

This study investigated the TNT decomposition by the treatment of alkaline hydrolysis. To obtain this objecitive, spectrum shift characteristics, pH effect, kinetics, and product analysis were examined during the alkaline hydrolysis by means of hydroxide ions. At pH = 12, an aqueous solution of TNT was changed into yellow-brown coloring, in which its absorbances were newly increased in a range of wavelength 400-600 nm. From the kinetic data, pseudo-first-order rate constant in a excess of hydroxide ion, in contrast to TNT concentration, was $0.0022min^{-1}$, which means that the reaction rate between TNT and hydroxide ion can be very slow, and that 1,047 min is necessary to achieve a 90% reduction of the initial TNT. In products analyses, nitrite ions and formic acid were mainly produced by the alkaline hydrolysis, nitrate ions and oxalic acid as minor products were generated.

• Membrane Journal
• /
• v.13 no.3
• /
• pp.143-153
• /
• 2003

The effects of bipolar interface formed on the surface of cation-exchange membrane on water splitting phenomena were investigated. Results showed that the formation of immobilized bipolar interface resulted in significant water splitting during electrodialysis. In particular, the immobilized bipolar interface was easily created on the cation-exchange membrane surface in the electrodialytic systems where multivalent cations served as an electrolyte. Multivalent cations with low solubility product resulted in violent water splitting because they were easily precipitated on the membrane surface in hydroxide form. Therefore, the bipolar interface consisting of H- and OH-affinity groups were formed on the membrane-solution interface. Apparently, water splitting was largely activated with the help of strong electric fields generated between the metal hydroxide layer and fixed charge groups on the membrane surface. Likewise, the accumulation of large molecular counter ions on the membrane surface led to the formation of a fixed bipolar structure that could cause significant water splitting in the over-limiting current region. Therefore, the prevention of the immobilization of bipolar interface on the membrane surface is very essential in improving the process efficiency in a high-current operation.

• Journal of Forest and Environmental Science
• /
• v.13 no.1
• /
• pp.153-165
• /
• 1997

Hydroxyl radicals were detected and their qualitative yields were estimated by using chemiluminescence method and $\gamma$-irradiation technique in oxygen or chlorine dioxide radicals bleaching conditions. The correlation of hydroxyl radical formation and lignin model(Apocynol) or carbohydrate model($\alpha$-D-glucopyranose and methyl-$\beta$-D-glucopyranoside) degradation was studied in the presence of metal ion or without metal ion. The results showed that the presence of metal ions efficiently affected the formation of hydroxyl radicals in oxygen bleaching process, in the order of $Cu^{2+}$ > $Mn^{2+}$ > $Mg^{2+}$ > $Fe^{2+}$, and these metal gave also rise to the degradation of carbohydrate. But it was found that the addition of $100{\mu}m\;Mg^{2+}$ gave an efficient protection against carbohydrate degradation and suppressed the hydroxyl radical formation under oxygen bleaching conditions. And the presence of $Cu^{2+}$ had a detrimental effect on the stability of carbohydrates, whereas the addition of $3{\mu}m\;Mn^{2+}$ surprisingly had a small protective effect on methyl--$\beta$-D-glucopyranoside. In the $ClO_2$ radical bleaching conditions the hydroxyl radical expected to generate from water or substrates was not detected in the presence of metals.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.7
• /
• pp.779-785
• /
• 2015

Cathodic protection is recognized as the most cost-effective and technically appropriate corrosion prevention method for the submerged zone of offshore structures, ships, and deep-sea facilities. When cathodic protection is applied, the cathodic currents cause dissolved oxygen reduction, generating hydroxyl ions near the polarized surface that increase the interfacial pH and result in enhanced carbonate ion concentration and precipitation of an inorganic layer whose principal component is calcium carbonate. Depending on the potential, magnesium hydroxide can also precipitate. This mixed deposit is generally called "calcareous deposit." This layer functions as a barrier against the corrosive environment, leading to a decrease in current demand. Hence, the importance of calcareous deposits for the effective, efficient operation of marine cathodic protection systems is recognized by engineers and scientists concerned with cathodic protection in submerged marine environments. Calcareous deposit formation on a marine structure depends on the potential, current, pH, temperature, pressure, sea-water chemistry, flow, and time; deposit quality is significantly influenced by these factors. This study determines how calcareous deposits form in sea water, and assesses the interrelationship of formation conditions (such as the sea water temperature and surface condition of steel), deposited structure, and properties and the effectiveness of the cathodic protection.

• Journal of the Korean Chemical Society
• /
• v.55 no.1
• /
• pp.86-91
• /
• 2011

Modified lignins were prepared. Soda and peroxy lignins were precipitated from black liquor produced from bagasse pulping with soda and peroxyacid pulping process. The precipitated lignins were hydrolyzed using 10% HCl. Different functional groups were also incorporated into lignin by carboxylation and phosphorylation reactions. Moreover crosslinking of these lignins were carried out using epichlorohydrin. Characterization of the modified lignins and lignins derivative were carried out using Infrared spectroscopy. Thermal analysis of these compounds were also carried out using TGA and DTA techniques. Efficiency of sorption of metal ions by the modified lignin was also investigated. It was found that, the peroxylignin and its derivatives show higher efficiency toward metal ions uptake than the soda lignin.

• Resources Recycling
• /
• v.23 no.3
• /
• pp.21-29
• /
• 2014

This study was conducted to obtain the basic data for designing the lithium recovery process from the "salar de Uyuni" in Bolivia. For this study, the mock brine which has the similar chemical composition with the brine of "salar de Uyuni" was prepared, and the effects of reaction factors such as temperature, time, pH and so forth on the precitation reaction of magnesium hydroxide were investigated.