• KSBB Journal
• /
• v.9 no.3
• /
• pp.332-338
• /
• 1994

Solubilization phenomena of a protein in a reversed micellar solution were investigated and a hollow fiber membrane extractor was tested for reversed micellar protein extraction equipment. Alkaline protease was used as a model protein compound and the reversed micellar solution was consisted of AOT and isooctane. It was found that protein solubilization was strongly influenced by ionic strength and pH. The distribution coefficient of the protease between the aqueous solution and the AOT/isooctane solution was also observed to be as high as 4.0 within the scope of this experiment. A hollow fiber membrane extractor was constructed and tested for the protein extraction. The overall mass transfer coefficient at a typical experimental condition of this study was observed to be $6.7{\times}10^{-5}cm/s$. It was also found that the mass transfer resistance on reversed micellar solution was the dominant resistance for the protein transfer.

• Journal for History of Mathematics
• /
• v.23 no.1
• /
• pp.53-66
• /
• 2010

This study concerns with partial sum of Fourier series, Fourier coefficients and the $L^1$-convergence of Fourier series. First, we introduce the $L^1$-convergence results. We consider equivalence relations of the partial sum of Fourier series from the early 20th century until the middle of. Second, we investigate the minor lineage of $L^1$-convergence theorem from W. H. Young to G. A. Fomin. Finally, we compare and reinterpret the $L^1$-convergence theorems.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2013.06a
• /
• pp.23-24
• /
• 2013

본 연구에서는 해군함정에서 투묘 시 함정별 묘의 파주계수와 그에 파주력 그리고 외력의 세기를 고려한 묘쇄의 적정 신출량을 구할 수 있는 수리모델을 정립하여 제시하고, 이것을 해군이 보유하고 있는 전 함정 승조원들로 하여금 쉽게 사용할 수 있는 적정 묘쇄 신출량을 그래프한 자료를 제시하였다. 본 연구 결과는 해군함정이 투묘시 바로 적용될 수 있을 뿐만 아니라, 이론적인 근거를 제공하는 참고자료로 유용하게 활용될 수 있을 것이다.

• Korean Journal of Optics and Photonics
• /
• v.14 no.5
• /
• pp.521-529
• /
• 2003

For complex-coupled (CC) DFB lasers, we found that there might be little correlation between the single mode yields at threshold and above threshold. At threshold, the single mode yield considering f number of in-phase (IP) CC DFB lasers is the same as that of anti-phase (AP) CC DFB lasers. However, the single mode yield as a function of injection current above threshold of IP CC DFB lasers is much different from that of AP CC DFB lasers. In the case of IP CC DFB lasers, the single mode yield increases as the coupling coefficient ratio (CR) increases, while, in the case of AP CC DFB lasers, the single mode yield decreases rapidly regardless of CR as the injection current increases. In the case of AR-HR combinations, the effect of AR ref1ectivity on the single mode yield increases as the coupling strength decreases. As the coupling strength decreases, the CR at which the increase rate of the single mode yield starts to decrease, increases, and the maximum single mode yield increases. Single mode yields of AR-HR and AR-AR combinations are larger than those of AR-CL and CL-CL combinations.

• Korean Journal of Optics and Photonics
• /
• v.6 no.2
• /
• pp.135-141
• /
• 1995

Phenomenological nonlinear gain saturation effect on the noise characteristics of a multi-electrode DBR laser, when the lasing wavelength changes continuously, is presented theoretically. Using the optical transmission line theory, noise characteristics reliant on output power are analyzed by taking into account both the spontaneous enhancement factor K due to the distribution of the spontaneous emission along the active cavity and the nonlinear gain saturation effect. Spontaneous emission rate was increased due to an increase in injected current into the passive section, which in turn lead to increase in relative intensity noise (RIN) and frequency noise. Phenomenological nonlinear gain saturation was found to have significant effect on RIN and frequency noise characteristics. However. Iinewidth was found to decrease due to a phenomenological nonlinear gain saturation effect. ffect.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.26 no.2
• /
• pp.283-290
• /
• 2002

In this paper, we consider the dynamic electromechanical behavior of an eccentric Yoffe permeable crack in a piezoelectric ceramic strip sandwiched between two elastic orthotropic materials under the combined anti-plane mechanical shear and in-plane electrical loadings. Fourier transforms are used to reduce the problem to the solution of two pairs of dual integral equations, which are then expressed to a Fredholm integral equation of the second kind. The initial crack propagation orientation for PZT-5H piezoceramics is predicted by maximum energy release rate criterion.

• Proceedings of the KSME Conference
• /
• 2001.11a
• /
• pp.22-26
• /
• 2001

In this paper, we examine the steady state dynamic electromechanical behavior of an eccentric Yoffe crack in a piezoelectric ceramic layer bonded between two orthotropic elastic layers under the combined anti-plane mechanical shear and in-plane electrical loadings. We adopted permeable crack face condition. Numerical values on the dynamic energy release rate are obtained. The initial crack propagation orientation for PZT-5H piezoceramic is also predicted by maximum energy release rate criterion.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.21 no.12
• /
• pp.2165-2171
• /
• 1997

The analysis model is the infinite power law creep material containing the rigid inclusion with crack shape. The present analysis is performed using the complex pseudo-stress function method. The strain rate intensity factor is developed as new fracture mechanics parameter which represents the stress and strain rate distribution near a crack tip in power law creep material. The strain rate intensity factor is developed in terms of Kolosoff stress functions.

• Proceedings of the KSME Conference
• /
• 2001.06a
• /
• pp.304-309
• /
• 2001

In this paper, we consider the dynamic electromechanical behavior of an eccentric Yoffe permeable crack in a piezoelectric ceramic strip sandwiched between two elastic materials under the combined anti-plane mechanical shear and in-plane electrical loadings. Fourier transforms are used to reduce the problem to the solution of two pairs of dual integral equations, which are then expressed to a Fredholm integral equation of the second kind. The initial crack propagation orientation for PZT-5H piezoceramics is predicted by maximum energy release rate criterion.

• Progress in Medical Physics
• /
• v.25 no.1
• /
• pp.15-22
• /
• 2014

The IMRT is proper implement to get high dose deliver to tumor as its shape and selective approach in radiation therapy. Since the IMRT is performed as modulated the radiation fluence by the MLC created the open shapes and its irradiation time, the dose of segment of radiation field effects on the cumulated portal dose. The accurate output factor of small and step shape of segment is important to improve the determination of deliver tumor dose as it is directly proportional to dose. This experiment performed with the 6 MV photon beam of Clinac Ex(Varian) from $3{\times}3cm^2$ to $0.5{\times}0.5cm^2$ small field size for collimator jaw in MLC free and/or for MLC open field in fixed collimator jaw $10{\times}10cm^2$ using the CC01 ion chamber, SFD diode, diamond detector and X-Omat film dosimetry. As results of normalized to the reference field of $10{\times}10cm^2$ of MLC, the output factor of $3{\times}3cm^2$ showed $0.899{\pm}0.0106$, $0.855{\pm}0.0106$ for $2{\times}2cm^2$, $0.764{\pm}0.0082$ for $1{\times}1cm^2$ and $0.602{\pm}0.0399$ for $0.5{\times}0.5cm^2$. The output factor of MLC open field has shown a maximum 3.8% higher than that of the collimator jaw open field.