• Economic and Environmental Geology
• /
• v.53 no.4
• /
• pp.383-395
• /
• 2020

The stratigraphical position of the Haengmae Formation can provide clues towards solving the hot issue on the Silurian formation, also known as Hoedongri Formation. Since the 2010s, there have been several reports denying the Haengmae Formation as a lithostratigraphic unit. This study aimed to clarify the lithostratigraphic and chronostratigraphic significance of the Haengmae Formation. The distribution and structural geometry of the Haengmae Formation were studied through geologic mapping, and the correlation of relative geologic age and the absolute age was performed through conodont biostratigraphy and zircon U-Pb dating respectively. The representative rock of the Haengmae Formation is massive and yellow-yellowish brown pebble-bearing carbonate rocks with a granular texture similar to sandstone. Its surface is rough with a considerable amount of pores. By studying the mineral composition, contents, and microstructure of the rocks, they have been classified as pebble-bearing clastic rocks composed of dolomite pebbles and matrix. They chiefly comprise of euhedral or subhedral dolomite, and rounded, well-sorted fine-grained quartz, which are continuously distributed in the study area from Biryong-dong to Pyeongan-ri. Bedding attitude and the thickness of the Haengmae Formation are similar to that of the Hoedongri Formation in the north-eastern area (Biryong-dong to Haengmae-dong). The dip-direction attitudes were maintained 340°/15° from Biryong-dong to Haengmae-dong with a thickness of ca. 200 m. However, around the southwest of the studied area, the attitude is suddenly changed and the stratigraphic sequence is in disorder because of fold and thrust. Consequently, the formation is exposed to a wide low-relief area of 1.5 km × 2.5 km. Zircon U-Pb age dating results ranged from 470 to 449 Ma, which indicates that the Haengmae Formation formed during the Upper Ordovician or later. The pebble-bearing carbonate rock consisted of clastic sediments, suggesting that the Middle Ordovician conodonts from the Haengmae Formation must be reworked. Therefore, the above-stated evidence supports that the geologic age of the Haengmae Formation should be Upper Ordovician or later. This study revealed that the Haengmae Formation is neither shear zone, nor an upper part of the Jeongseon Limestone, and is also not the same age as the Jeongseon Limestone. Furthermore, it was confirmed that the Haengmae Formation should be considered a unit of lithostratigraphy in accordance with the stratigraphic guide of the International Commission on Stratigraphy (ICS).

• Journal of Korean Society of Forest Science
• /
• v.111 no.2
• /
• pp.263-275
• /
• 2022

We conducted this study to provide essential data for implementing restoration measures on the physical properties of the geology, topography, and soil of the landcreep areas in Yangpyeong-gun, Gyeonggi-do. The strata of the survey area comprised topsoil, weathered soil, weathered rock, and soft rock layers. The landcreep area, caused by colluvial debris, was located in a convex topography shape distributed as bedrock with shales and incorporated with sandstone. According to the measurement of the displacement meter, the surveyed area has crept from 1.1 mm to 6.5 mm during the recurrent landcreep between 1 July and 27 August, 2020. The landcreep had progressed over two directions (S65° W, E45° S, and E70° S) which were similar to the groundwater flow direction (E82.5° S and S16.8° W). The average slope of the landcreep area occurred on a gentle slope (19.3°), lower than the average slope of the mountain area (25°) in Korea. The bulk density in the groundwater areas was lower than that in other surveyed areas.

• Journal of the Korean Geophysical Society
• /
• v.9 no.1
• /
• pp.37-45
• /
• 2006

Velocity structures were defined in the vicinty of the 140-m deep test borehole in the pungam basin through simultaneous inversion of surface seismic refraction and far-ofset VSP traveltime data. Seismicenergy generated at the surface by a seisgun was recorded both at 42 surface locations at 3-m intervalsalong the profiles in the N20E and its orthogonal directions and at 71 m depth in the borehole. Forthe ofset VSP study, seismic energy was generated by a 5 kg sledgehamer at the surface in the horizontal ofset range of -19.5∼+19.5 m from the borehole. The seismic signals were detected at 9∼99 m depths with 1∼2 m intervals and recorded for 204 ms per shot. After shot static corrections,first-arrival times picked from both the surface refraction and borehole records were simultaneouslyinverted to yield velocity tomograms. The tomograms indicate that a 1.5 m thick soil layer with velocities les than 500 m/s overlies basements having a velocity range of 3,067 ∼5,717 m/s. Within the basements,∼4 m and deeper than 71 m. The high-velocit yzones may be due to conglomerates intercalated with sandstones and siltstones. No evidence for large-scale fracture zones or faults is detected near the borehole

• Korean Journal of Heritage: History & Science
• /
• v.53 no.4
• /
• pp.250-273
• /
• 2020

The three-story stone pagodas in Hyeon-ri and Hwacheon-ri,Yeongyang Gyeongsangbuk-do are stone pagodas that exhibit the typical style of Unified Silla. The two pagodas are believed to have been built in the mid- and late 9th centuries at the latest, considering the style of the three-story roof stone on top of the double-tier base. This is also confirmed by the reliefs carved at the base and the first-story of the pagoda. The Four Heavenly Kings and the Twelve Zodiacal Animal Deities were first combined in the late 8th century in the stone pagoda at the Wonwonsa Temple Site, and the Eight Classes of Divine Beings was also the most popular carved pagoda reliefs in the 9th century. However, the two Yeongyang stone pagodas are characterized by a combination of the Four Heavenly Kings (1st story), the Eight Classes (top base), and the Twelve Zodiacal Animals (lower base), and the stone used for the pagoda consists of sedimentary rocks of the sandstone family, which comprise most of the geological strata in the Yeongyang area, rather than ordinary granite. The new combinations of the three types of guardian deities and the Eight Classes changed from seated to standing poses is interpreted as an attempt to enhance the Buddhist faith and cultural status of the Yeongyang area, along with the fact that the stone pagoda was built using local natural materials. The Eight Classes of the Yeongyang stone pagoda does not follow the two types of arrangement of the pagodas with the Eight Classes, but some of the deities have been relocated to a new location. Composed of AsuraGandharva on the east side, Naga-Mahoraga on the south, Deva-Garuda on the west, and Kimnara-Yaksa on the north, this form can be classified as a unique 'third layout of the Eight Classes' in the Yeongyang area. Such changes in the shape and posture of the reliefs reflect a new perception of the pagodas. The reason why the Gandharva and Yaksa statues were carved on the east and north sides, respectively, was because they were deemed subordinate to the Four Heavenly Kings, and the fact that the Naga and the Mahoraga were carved on the south side was presumed to have influenced the geographical location of the two pagodas on the northern side of Banbyeoncheon Stream. The Hyeon-ri and Hwacheon-ri three-story stone pagodas inherited the tradition of typical Unified Silla-period pagodas, while also bearing their own new regional characteristics.

• Geophysics and Geophysical Exploration
• /
• v.10 no.1
• /
• pp.89-97
• /
• 2007

A three-dimensional (3D) magnetotelluric (MT) survey has been carried out to delineate subsurface structures and possible fractures, for development of low-temperature geothermal resources in Pohang, Korea. Quite good quality MT data could be obtained throughout the survey region by locating the remote reference in Kyushu, Japan, which is ${\sim}480\;km$ from the centre of the field site. 3D modelling and inversion are performed taking into account the sea effect in MT measurements near the seashore. The nearby sea in the Pohang area affects MT data at frequencies below $1\;Hz{\sim}0.2\;Hz$, depending on the distance from the seashore. The most severe sea effects were observed in the south-east parts of the survey area, closer to Youngil Bay. 3D inversion with and without the seawater constraint showed very similar results at shallow depths, roughly down to 2 km. At greater depths, however, a strong sea effect seems to form a fictitious conductive structure in ordinary 3D inversion, especially in the south-eastern part of the survey region. Comparison between drilling results and the resistivity profiles from inversions showed that five layered structures can be distinguished the subsurface beneath the target area. They are: (a) semi-consolidated mudstones with resistivity less than $10\;{\Omega}m$, which are ${\sim}300\;m$ thick in the northern part and ${\sim}600\;m$ thick in the southern part of the survey area; (b) occasional occurrence of trachybasalt and lapilli tuff within the mudstone layer has resistivity of a few tens of${\Omega}m$, (c) intrusive rhyolite ${\sim}400\;m$ thick has resistivity of several hundreds of ${\Omega}m$, (d) alternating sandstone and mudstone down to 1.5 km depth shows resistivity of ${\sim}100\;{\Omega}m$, (e) a conductive structure was found at a depth of ${\sim}3\;km$, but more geological and geophysical study should be carried out to identify this structure.

• Geophysics and Geophysical Exploration
• /
• v.13 no.1
• /
• pp.80-87
• /
• 2010

This study was conducted to develop a reservoir modelling workflow to reproduce the heterogeneous distribution of effective permeability that impacts on the performance of SAGD (Steam Assisted Gravity Drainage), the in-situ bitumen recovery technique in the Athabasca Oil Sands. Lithologic facies distribution is the main cause of the heterogeneity in bitumen reservoirs in the study area. The target formation consists of sand with mudstone facies in a fluvial-to-estuary channel system, where the mudstone interrupts fluid flow and reduces effective permeability. In this study, the lithologic facies is classified into three classes having different characteristics of effective permeability, depending on the shapes of mudstones. The reservoir modelling workflow of this study consists of two main modules; facies modelling and permeability modelling. The facies modelling provides an identification of the three lithologic facies, using a stochastic approach, which mainly control the effective permeability. The permeability modelling populates mudstone volume fraction first, then transforms it into effective permeability. A series of flow simulations applied to mini-models of the lithologic facies obtains the transformation functions of the mudstone volume fraction into the effective permeability. Seismic data contribute to the facies modelling via providing prior probability of facies, which is incorporated in the facies models by geostatistical techniques. In particular, this study employs a probabilistic neural network utilising multiple seismic attributes in facies prediction that improves the prior probability of facies. The result of using the improved prior probability in facies modelling is compared to the conventional method using a single seismic attribute to demonstrate the improvement in the facies discrimination. Using P-wave velocity in combination with density in the multiple seismic attributes is the essence of the improved facies discrimination. This paper also discusses sand matrix porosity that makes P-wave velocity differ between the different facies in the study area, where the sand matrix porosity is uniquely evaluated using log-derived porosity, P-wave velocity and photographically-predicted mudstone volume.

• Korean Journal of Soil Science and Fertilizer
• /
• v.6 no.3
• /
• pp.141-152
• /
• 1973

The mineralogical studies of the eleven sub-soil samples derived from granite, granodiorite, diorite and arkose sandstone, taken from apple orchards in the province of Kyungsangbukdo, Korea are made to investigate the relationships between the mineral weathering, soil forming processes and mineralogical composition. The fine sand fraction (less than 0.2mm) and the clay fraction (less than 2 micron) are dispersed with the shaker after hydrogen peroxide treatment for the removal of organic matter, and separated from each suspension by gravity sedimentation. The fine sand are observed by mineral microscope and the clay are observed by X-ray diffraction patterns, differential thermal analysis curves and infrared spectrum. The outline of the results are as follows. 1. The primary minerals ; Quartz, changed-feldspar, plagioclase, alkali-feldspar are dominant in almost all samples, and some samples contain an appreciable amount of hornblende, biotite, muscovite and plant opal. There are also those samples which contain very small quantity of pyroxene group, tourmaline, epidote, cyanite, magnetite, volcanic glass and zircon. They are mainly derived from weathering products of granite, granodiorite, diorite, arkose or its mixtures. 2. All samples contain expanding or nonexpanding $14{\AA}$ minerals, illite and kaolin minerals, and some samples contain chlorite, cristobalite, gibbsite, and those primary minerals as quartz and feldspar, but the quantities vary according to the parent matrials. 3. Non-expanding $14{\AA}$ minerals may be dioctahadral vermiculite which sandwiches gibbsite layer or chlorite in between layer lattices. 4. As for clay minerals, montmorillonite was principal component in the samples derived from weathering products of arkose sandstone and tertiary. Minerals which are derived from weathering products of arkose have kaolin minerals and vermiculite as their principal component, and minerals derived from weathering products of acidic rock group are generally classified into two groups, the kaolin mineral group, and the kaolin minerals and vermiculite group.