• Journal of the Korean Society of Propulsion Engineers
• /
• v.23 no.3
• /
• pp.96-103
• /
• 2019

In this study, a comparison was conducted to verify the propellant isolation assembly of the Korea Pathfinder Lunar Orbiter (KPLO). An engineering validation model (EVM) is being developed to simulate the flow of the flight model. Three factors were selected for comparison: the total pressure drop during propellant isolation assembly, the waterhammer by driving thruster valve, and the orifice set up for flow control and damping the waterhammer. The analysis results are compared with EVM test results. In the future, backup data to confirm the design will be established.

• Journal of the Korean Society of Radiology
• /
• v.17 no.3
• /
• pp.367-373
• /
• 2023

Aircrews and passengers are exposed to radiation from cosmic rays and secondary scattered rays generated by reactions with air or aircraft. For aircrews, radiation safety management is based on the exposure dose calculated using a space-weather environment simulation. However, the exposure dose varies depending on solar activity, altitude, flight path, etc., so measuring by route is more suggestive than the calculation. In this study, we developed an instrument to measure the cosmic radiation dose using a general-purpose Si sensor and a multichannel analyzer. The dose calculation applied the algorithm of CRaTER (Cosmic Ray Telescope for the Effects of Radiation), a space radiation measuring device of NASA. Energy and dose calibration was performed with Cs-137 662 keV gamma rays at a standard calibration facility, and good dose rate dependence was confirmed in the experimental range. Using the instrument, the dose was directly measured on the international line between Dubai and Incheon in May 2023, and it was similar to the result calculated by KREAM (Korean Radiation Exposure Assessment Model for Aviation Route Dose) within 12%. It was confirmed that the dose increased as the altitude and latitude increased, consistent with the calculation results by KREAM. Some limitations require more verification experiments. However, we confirmed it has sufficient utilization potential as a cost-effective measuring instrument for monitoring exposure dose inside or on personal aircraft.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.9
• /
• pp.46-51
• /
• 2013

In this paper, the optimum placement and shape of UHF antenna on the unmanned aerial vehicle (UAV) are analyzed by using the electromagnetic (EM) simulation on the various locations. The FEKO was used for the EM-simulation. In order to reduce the complexity of simulation and minimize the runtime and memory usage, the composite aircraft structure is simplified as the PEC model excluding the radome structure. The simulation was performed on the wing and ventral fin of UAV, and the antenna shape used the monopole, dipole, and bent monopole antennas. When the monopole antenna is mounted under the wing, two antennas need to be mounted under the right and left wings, and those antennas have to be switched as the direction of UAV wing to the line of sight (LOS) data-link (DL) ground antenna. In the case of mounting under the ventral fin, one antenna can be used regardless of the direction of UAV wing to the LOS DL ground antenna. Also, the antenna gain is improved by the blockage reduction. The antenna gain is further improved by using the bent monopole antenna. The optimum solution of UHF antenna placement and shape on UAV is to mount the bent monopole antenna under the ventral fin.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.23 no.3
• /
• pp.12-25
• /
• 2020

The purpose of this study was to obtain information about the type of drones suitable for the management of entrants and entrants of islands in the marine national park. The research sites were 25 islands in the Hallyeohaesang National Park. The target islands were divided into three zones, and were investigated with different types of drones. The survey period was from October to November, 2019. As a result of the operation of drone airframe, drone with fixed wings was found to be favorable for the management of marine parks in medium and long distances compared to other types, but stopping flights for broadcasting was found to be unsuitable. Drone with rotational wings was found to be suitable for image acquisition and broadcasting through close flight. However, it was deemed suitable for short and medium distance flights because of the fast battery consumption. In the case of helicopter rotorcraft drone, image acquisition and broadcasting were possible, but noise and vibration caused by propellers were disadvantageous. The number of entrants to the islands totaled 410 and the main act was fishing. The proportion of entrants to the islands in Area A was higher than that of other areas, and thus it was deemed more necessary to manage the area. Broadcasting was found to have had a positive effect on the management of fishers.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.4
• /
• pp.357-367
• /
• 2008

Preparing for future Korean Lunar missions, preliminary Lunar mission design software is developed using a impulsive thrusting method. Developed software is capable of design and analysis every required mission phases to design Lunar mission, including the Earth departure, Lunar transfer, Lunar arrival and mission operation phases. Also, assuming that KSLV-II is selected as a launch vehicle, future Korean Lunar explorer's mass budget is estimated based on driven optimal trajectory characteristics. Tracking analysis is also performed using Deep Space Network including angle geometry analysis between Earth - Moon - Lunar explorer - Sun which are very important for communication, solar panel pointing strategy and eclipse analysis when Lunar missions are under designing phase.

• Korean Journal of Remote Sensing
• /
• v.19 no.2
• /
• pp.159-169
• /
• 2003

This paper presents a method for automatic 3-d building reconstruction using high resolution aerial imagery. First, by using edge preserving filtering, noise is eliminated and then images are segmented by watershed algorithm, which preserves location of edge pixels. To extract line segments between control points from boundary of each region, we calculate curvature of each pixel on the boundary and then find the control points. Line segment linking is performed according to direction and length of line segments and the location of line segments is adjusted using gradient magnitudes of all pixels of the line segment. Coplanar grouping and pplygonal patch formation are performed per region by selecting 3-d line segments that are matched using epipolar geometry and flight information. The algorithm has been applied to high resolution aerial images and the results show accurate 3D building reconstruction.

• Journal of Space Technology and Applications
• /
• v.1 no.3
• /
• pp.302-318
• /
• 2021

A basic study was conducted on how to determine the launch timing of a space probe targeting an Earth-approaching asteroid. In the future, when a probe mission targeting an asteroid approaching Earth's orbit is conducted in Korea, in order to determine the launch time, an appropriate solution should be obtained by applying the Global Optimization technique. For this, accurate current orbit information of each asteroid must be obtained first, and prior scenarios such as Earth's orbit information, main engine performance information of the probe and launch vehicle, the number of gravity-assisted maneuvers, and maximum flight time limit should be discussed. Also, the criteria for optimization should be determined first. In this paper, based on these prerequisites and information, a method for finding the launch time of an asteroid probe was studied using the open source software such as PyKEP and Evolutionary Mission Trajectory Generator (EMTG) which are the programs for interplanetary trajectory generation purpose.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.46 no.3
• /
• pp.251-256
• /
• 2018

In the case of a radar repeater that used for the trajectory tracking of a high-speed aircraft, it emits pulses of short width. For phase displacement of these signals a branch type phase shifter is used. The phase on the transmission line is changed by utilizing the variable reactance at the end of the displacement branch transmission line. Further, it is easy to control the high output signal, and there is an advantage that the insertion loss is not large even when the reactance fails. In this paper, we will discuss the fabrication test results of a 400 W class phase shifter that sequentially displaces the phase at $0^{\circ}$, $30^{\circ}$, $60^{\circ}$, $90^{\circ}$.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.44 no.7
• /
• pp.562-567
• /
• 2016

Morphing wing which has a configuration optimized to flight speed and condition is faced to a lot of barriers to be overcome such as actuator technique, structural mechanization technique, flexible skin material, control law, and so on. As the first step for developing a morphing wing with rapid response, we designed and fabricated the morphing airfoil using a SMA(shape memory alloy) wire actuator and torsional bias springs. The design concept of the morphing airfoil was verified through operation test. The measured results show that the flap deflects smoothly and fast.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.196.2-196.2
• /
• 2012

본 논문은 달착륙선의 개념설계를 위하여 고려한 전력시스템의 설계와 달착륙선의 지상시험모델용 추력기 밸브구동 전원장치 개발에 대해 기술하였다. 달착륙선의 임무특성을 고려하여 전력시스템의 구조를 검토하고, 극한의 온도환경에서 달착륙선의 임무수행을 위하여 필요한 전력에너지를 충분히 공급할 수 있도록 태양전지 배열기와 배터리의 용량, 그리고 전장품의 용량을 설계하였다. 특히 경량의 달착륙선 개발을 위하여 고효율의 태양전지를 이용한 태양전지 배열기와 리튬-이온 배터리를 검토하였다. 극한의 우주환경에서 태양전지배열기의 동작특성을 검토하고 생성될 수 있는 최대 전력을 분석하여 최적의 태양전지 배열기의 면적을 분석하고, 장시간의 월식을 고려하여 배터리의 방전특성에 따른 배터리의 전압특성을 검토하였다. 그리고 달착륙선의 전력시스템 개념설계의 타당성 검토를 위하여 유럽에서 개념설계 중인 달착륙선의 전력시스템 사양과 용량에 대해 비교검토를 수행하였다. 현재 개발중인 지상검증모델용 달착륙선의 전력시스템 설계와 추력기 밸브구동 전원장치의 개발에 관해 기술하였다. 지상검증용 전력시스템은 태양전지배열기의 장착 없이 배터리의 전력만을 사용하여 지상검증모델용 달착륙선의 부하에 전력을 공급할 수 있도록 설계되었다. 달착륙선 지상시험모델의 비행시간과 임무에 따른 부하특성을 고려하여 상용 리튬-이온 배터리의 용량을 선정하였으며, 부하의 전력을 고려하여 간단한 보호회로를 설계하였다. 그리고 지상검증용 전원시스템은 추력기의 밸브구동을 위한 추력기 밸브구동 전원장치, DC/DC 컨버터 전원 모듈, 모니터링 모듈, 그리고 위급상황에서 전원을 차단하기 위한 "Emergency STOP" 모듈로 구성되어 있다.