• Journal of the Korean Society of Marine Environment & Safety
• /
• v.27 no.2
• /
• pp.387-393
• /
• 2021

In this study, finite element analysis was performed to evaluate a method of increasing the fatigue life of the pipe connection structure commonly used in the topside structure of offshore platforms. MSC Patran/Nastran, a commercial analysis program, was used, and the critical structural model was selected from the global analysis. To realize the stress concentration phenomenon according to the load, modeling using 8-node solid elements was implemented. The main loads were considered to be two lateral loads and a tensile load on a diagonal pipe. To check the hotspot stress at the main location, a 0.01 mm dummy shell element was applied. After calculating the main stress at the 0.5-t and 1.5-t locations, the stress generated in the weld was estimated through extrapolation. In some sections, this stress was observed to be below the fatigue life that should be satisfied, and reinforcement was required. For reinforcement, a bracket was added to reduce the stress concentration factor where the fatigue life was insufficient without changing the thickness or diameter of the previously designed pipe. Regarding the tensile load, the stress in the bracket toe increased by 23 %, whereas the stress inside and outside of the pipe, which was a problem, decreased by approximately 8 %. Regarding the flexural load, the stress at the bracket toe increased by 3 %, whereas the stress inside and outside of the pipe, which was also a problem, decreased by approximately 48 %. Owing to the new bracket reinforcement, the stress in the bracket toe increased, but the S-N curve itself was better than that of the pipe joint, so it was not a significant problem. The improvement method of fatigue life is expected to be useful; it can efficiently increase the fatigue life while minimizing changes to the initial design.

• Journal of the Korean Society for Precision Engineering
• /
• v.22 no.12 s.177
• /
• pp.141-148
• /
• 2005

When one opens the door of a microwave oven during operation, microwave might leak through the clearance of the door. Present research has been motivated by the need to reduce the possible clearance by enhancing torsional stiffness of the door of the microwave oven. Static deformation of the door frame of the oven is analyzed under a door-opening force. On the basis of the topological optimization, the right flange of the door frame is shown to need reinforcing. Several types of reinforcing brackets weldable to the right flange is proposed, and their effects to the stiffness of the door frame are compared and evaluated.

• Journal of the Korean Society for Precision Engineering
• /
• v.23 no.8 s.185
• /
• pp.145-153
• /
• 2006

To minimize the possible leakage of microwave when one opens the door of a microwave oven during its operation, a structural design of the reinforcing brackets for the door frame is presented. Twisting deformation of the door frame resulting from a dynamic pulling force is analyzed by harmonic and transient response analyses. Several types of the reinforcing brackets weldable to the right flange of the door frame is taken into consideration, and their effects to the twisting deformation of the door frame are compared and evaluated. As a conclusion, a thick step-shaped bracket, which is welded to whole length of the right flange, is favorable.