• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.4
• /
• pp.634-641
• /
• 2000

A switchable VCO for DECT handset is designed and fabricated. In dual mode radios, a single VCO is desired to operate at two different frequencies to meet the requirement of two mode(Tx, Rx). The three design types of switchable VCO are switched resonator VCO, switched mode VCO and dual band VCO. In this paper, we use the switched resonator VCO type using pin diode switch to change the total amount of capacitance in the tank circuit. At the bias condition of 3 V and 13mA, the output power and phase noise are better than6.5dBm and -104dBc/Hz at 25khz offset from the carrier, respectively , across the operating frequency range. From these results, the fabricated switched VCO is applicable to the DECT handset.

• Journal of the Institute of Convergence Signal Processing
• /
• v.5 no.1
• /
• pp.60-65
• /
• 2004

Induction heating system is time varying system around curie point. So, it has many troubles which are system shut down and change the load impedance. In this paper has been designed the parallel resonant inverter which controlling the constant power and tracking the load resonant frequency with PLL is possible, in order to minimize switching losses and solve it's many troubles. The current full-bridge type parallel resonant inverter of an induction heating system was composed of IGBT in switching device. For regulating the output power of an induction heating system, the Fuzzy logic controller is used. The Fuzzy controller makes the control signal for a stable power regulating control and when reference is changed, it is superior to adaptability. It has been evaluated a stable behavior for a noise with switching and a load disturbance.

• Proceedings of the KIPE Conference
• /
• 2014.07a
• /
• pp.299-300
• /
• 2014

본 논문에서는 넓은 입력전압 및 부하 변동에 적합한 대전력용 $L^3C$ 공진형 컨버터를 제안한다. 제안하는 컨버터는 직렬공진탱크와 병렬공진탱크를 조합하여 승압과 강압이 가능하며 다른 공진형 컨버터에 비해 적은 주파수 변동에도 넓은 입출력 범위를 만족 시킬 수 있다. 제안하는 컨버터는 삼차권선을 이용하여 공진 탱크를 구성하기 때문에 공진 커패시터에 흐르는 전류를 최소화 할 수 있으며 공진에 참여하는 인덕터는 변압기의 누설 인덕턴스를 사용하여 소자를 최소화 할 수 있다. 제안하는 컨버터의 스위칭 특성의 경우 모든 스위치가 ZVS 턴온을 달성하고 다이오드는 ZCS 턴온/턴오프가 가능하다.

• Proceedings of the KIPE Conference
• /
• 2020.08a
• /
• pp.76-78
• /
• 2020

본 논문에서는 부스트 프리레귤레이터가 통합된 새로운 고효율 고정-주파수 LLC 공진형 컨버터를 제안한다. 기존 부스트 프리레귤레이터가 사용된 2단-구조의 컨버터는 연속적인 입력전류 및 넓은 전압이득 범위를 가져 태양광 및 연료전지에 적합한 토폴로지이다. 하지만, 부스트 프리레귤레이터 단에서 하드 스위칭으로 인한 큰 스위칭 손실, 큰 다이오드 도통 손실이 발생하여 낮은 효율을 갖는 문제가 발생한다. 따라서 이를 해결하기 위해, 제안된 회로는 부스트 프리레귤레이터를 통합시킨 새로운 구조를 사용하여 모든 스위치의 영전압 스위칭을 달성하고, 다이오드를 소거하였다. 따라서 제안된 회로는 높은 효율을 갖는다. 제안된 회로의 효용성을 증명하기 위해, 24-32V 입력전압과 12-16V(200W)출력에서 실험이 진행되었다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.4
• /
• pp.466-473
• /
• 2013

In this paper, a compact planar multi-loop self-resonant coil of high quality factor with a coaxial cross section is proposed for effective wireless charging. The proposed coil has high Q-factor and a resonant frequency of a coil can be easily controlled by adjusting distributed capacitance. For designing the coil, a self-inductance and a distributed capacitance are calculated theoretically. The self-inductance is calculated from the sum of the mutual energies between small circular loops that are made by dividing the cross section of the coil. To verify its properties and calculation results, the self-resonant coils are fabricated by using a coaxial cable with characteristic impedance of $50{\Omega}$. The measured frequencies are very consistent with the calculated ones. In addition, the resonant frequency can be adjusted slightly by the tuning parameter ${\gamma}$. The resonant coils are applied to a tablet PC, the Q-factors of the Tx and Rx resonant coils are 282 and 135, respectively. As a result of measurement when height between the two resonant coils is 4.4 cm, the power transfer efficiency is more than 80 % within a radius of 5 cm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.8
• /
• pp.1485-1492
• /
• 1994

In this paper, we design and implement the Combline Bandpass Filters for the satellite transponder by using the least-squares curve-fitting method. The Combline Bandpass Filters are located front of the mixer and behind of it, which is the component of down converter. Comparing with the filters which have $\lambda$/4 resonance length. Combline Filter has wide range of stop-band by using $\lambda$/8. So, it is useful to the satellite transponder owing to its low mass and small size. The filters described are realized as coupled rectangular coaxial transmission lines. The choice of this type is due to the ease of machining and wide variations in coupling coefficients rather than the use of the round rod resonators. We determine 800 MHz bandwidths for the combline bandpass filters. By using Chebyshev filter function, we design and implement 4-pole combline filters.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.3
• /
• pp.253-261
• /
• 2010

In this paper, the design and the fabrication of dual bandpass filter using heterogeneous resonators is presented. Each resonator would not have an effect on each resonant frequency. Two types of resonators are designed to have different fundamental resonant frequencies, one for the lower passband and the other for the upper passband. In the lower band, half and quarter wavelength resonators were used. In the upper band, a dual-mode resonator was used for adjusting bandwidth. In the upper pass band frequency, resonators of lower passband acts as the input and output. For WLAN, Proposed filters with different second passband frequencies at 2.45/5.2 GHz and 2.45/5.8 GHz are designed and fabricated.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.5
• /
• pp.489-494
• /
• 2013

This study aims to understand the mode characteristics of a droplet under a periodic forced vibration. To predict the resonance frequency of a droplet, theoretical and experimental approaches were employed. A high-speed camera was used to capture the various deformation characteristics of a droplet-mode shape, detachment, separated secondary droplet, and skewed deformation. The comparison between the theoretical and the experimental approaches shows a ~10% discrepancy in the prediction of the resonance frequency, which appears to be caused by the effect of contact line friction, nonlinear wall adhesion, and experimental uncertainty. Owing to contact-line pinning and smaller amplitude, the droplet shape becomes symmetric and the size of each lobe at the resonance frequency exceeds that at the neighbor, which is out of resonance.

• Proceedings of the KIPE Conference
• /
• 2017.07a
• /
• pp.254-255
• /
• 2017

공진형 컨버터에서 일반적으로 소프트 스위칭과 같은 조건을 만족시키기 위해 주파수 제어를 많이 사용한다. 그러나 전계결합형 무선전력전송 시스템 특성상 이격 거리나 정렬 오차 정도 따라 송 수신부를 연결하는 링크 캐패시턴스 값이 민감하게 변한다. 이런 시스템에서는 공진 주파수 추종과 동시에 시비율 제어가 필요하다. 송신부 앞 또는 부하단에 dc/dc컨버터를 추가하는 2단 구성은 시스템 효율이 1단 구성에 비해 낮다는 단점이 있다. 따라서 본 논문에서는 무선전력전송 시스템에 비대칭 하프 브릿지를 사용하여 시비율 제어와 주파수 추종제어를 할 수 있는 구조를 제안한다. 이는 시뮬레이션을 이용하여 검증한다.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.36S no.8
• /
• pp.113-122
• /
• 1999

A new resonant switching Watkins-Johnson converter was proposed, which minimizes the switching loss and is well suited for high-frequency operation. The steady-state analyses revealed that the voltage gain of the proposed converter is solely determined by the switching frequency. Consequently, to regulate the output voltage of the converter for variable load current the switching frequency should be varied accordingly. Based on the results of analyses, an optimum design procedure for the resonant component values is proposed, which minimized the voltage stress of power switch while maintaining the desired property of zero-voltage switching. Finally, accuracy of analyses and validity of an optimum design procedure are verified on an experimental resonant switching Watkins-Johnson converter prototype.