• Journal of Drive and Control
• /
• v.9 no.4
• /
• pp.52-57
• /
• 2012

In this study, in order to understand contents and ranges of design for the EGR Valve test system for improving quality and performance of EGR Valve, engine performance and exhaust gas characteristic of 3L-class diesel engine was analyzed. Experimental operation of engine performance test was performed with 50% engine load and 20% and 100% opening ratio of EGR Valve. From test of performance and exhaust gas characteristic of engine, torque output of engine and temperature and pressure of inlet and outlet of EGR Valve were measured. As a result, for design of EGR Valve test system, input fluid flow of EGR Valve must be set the same amount with exhaust gas flow that was below of engine speed of 2,500 rpm, and temperature of inlet of EGR Valve must be set under about $510^{\circ}C$. And the difference of temperature between inlet and outlet of EGR Valve must be over than about $200^{\circ}C$. Exhaust gas of inlet and outlet of EGR Valve were under 1 bar that was not considerable, and the difference of pressure between inlet and outlet of EGR Valve were under 1 bar that could not effect on mechanical operation of EGR Valve.

• Transactions of the Korean hydrogen and new energy society
• /
• v.19 no.6
• /
• pp.474-481
• /
• 2008

수소 기관에서 역화없이 고성능과 저$NO_x$를 실현시키기 위하여 밸브 타이밍 변화에 따른 흡기관 분사식 수소 기관의 성능을 파악하고 가솔린의 경우와 비교하였다. 그 결과 흡기밸브 타이밍은 역화억제와 성능향상에 큰 영향을 미치는 것을 확인하였다. 흡기밸브타이밍의 진각은 역화를 억제하며 효율과 출력을 동시에 향상된다. 비록 흡기밸브 타이밍 변화에 의해 NOx는 증가하지만, 희박영역인 출 ${\Phi}=0.5$에서 현저히 감소된다. 또한 열효율은 ${\Phi}=0.5$ 토크는 ${\Phi}=1.0$에서 가장 높게 나타난다. 흡기밸브 타이밍을 $ATDC20^{\circ}$에서 TDC로 변화시켰을 때, ${\Phi}=1.0$에서 토크는 약 28% 증가되고, ${\Phi}=0.5$에서 효율은 약 7%향상된다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.4
• /
• pp.379-387
• /
• 2011

Research and development of LP EGR system for the performance improvement and emission reduction on diesel engine is proceeding at a good pace. LP EGR system seems to be helpful method to further reduce$NO_x$ emissions while maintaining PM emissions at a low level because the boost pressure is unchanged while varying EGR rate. This study is experimentally conducted on a 2.0L common rail DI engine at the medium load condition (2000 rpm, BMEP 1.0 MPa, boost pressure 181.3 kPa) that difficult to use large amount of EGR gas because of deteriorations of performance and fuel consumption. And we investigated the characteristics of performance and fuel consumption while varying EGR systems. The overall results using LP EGR system equipped with ETC identified benefits on reduction of PM and improvement of fuel consumption and thermal efficiency while keep the $NO_x$ level compared to HP EGR and LP EGR with back pressure valve.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.39 no.1
• /
• pp.71-76
• /
• 2002

Because the driving time is increased under the low speed by rapidly increasing of vehicles, this paper is presented a new ignition control system for improvement the fuel economy, which only some of cylinders are using under the idle status or low speed and preserving the engine rpm. is applicable to effective in fuel economy. An actual hardware was made to prove this new control system. The developed variable cylinder engine concentrated the heat neat the cylinders in idle status or low speed, so there was a problem in re-ignition. It was the reason of a lot of exhaust gas, high fuel consumption and instability of engine revolution. In this paper, in order to solve above problem to show the improvement fuel economy using the new ignition control system and valve opening period at idle status of low speed.