• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.7
• /
• pp.741-753
• /
• 2008

This paper explores the throughput performance of CSMA/CA-based DCF protocol over both ideal channels and fading channels with payload size at the MAC layer in the 802.11a wireless LAN. In the ideal channel, there are no errors and at the transmission cycle there is one and only one active station which always has a packet to send and other stations can only accept packets and provide acknowledgements. In the fading channel, bit errors appear in the channel randomly and the number of stations is assumed to be fixed. And each station always has packets for transmission. In other words, we operate in saturation conditions. Up to now conventional research work about DCF throughput analysis of IEEE 802.11 a wireless LAN has been done over the ideal channel, but this paper is done over the Rayleigh/Ricean fading channel. So, the ratio of received average energy per bit-to-noise power spectral density $E_b/N_o$ is set to 25 dB and the ratio of direct-to-diffuse signal power in each sub-channel $\xi$ is set to 6 for combined Rayleigh/Ricean fading channel. In conclusion, it is shown that the saturation throughput is always less than the maximum throughput at all the payload size and the higher the transmission rate be, the higher the decreasing rate of saturation throughput compared to the maximum throughput be.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.11
• /
• pp.1320-1331
• /
• 1992

The error rate equation of FH/MFSK signal of repeated diversity received over m-distribution fading channel with partial-band interference has been derived and the error rate has been evaluated to show in figures as a function of signal to noise ratio, signal to interference ratio, fading figure, repeated number, partial-band interference fraction and power correlation coefficient between signal and interference. In this paper, we assumed that repeated diversity technique is used in transmitter against fading occurred in mobile radio channel. By comparing the error rate performance in diversity against fading and the obtainable degree of improvement of error performance with diversity technique has been found out. From the result, it is known that error rate performance deteriorates more as $\rho$ becomes small i.e., the partial-band interference gives more effect on error performance than full-band interference. Also when the values of $E_b/N_1$ and $\rho$ are small. as depth of fading diversity technique.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.2
• /
• pp.111-116
• /
• 2016

This paper proposes a high-frequency (MHz) LLC resonant converter for a capacitor coupling wireless power transfer (CCWPT). The CCWPT uses electric field in the coupling capacitor between the transmitter and receiver electrodes with a dielectric layer. Given that capacitance is very small and the impedance is large, transferring power with a simple series resonance is difficult. Therefore, the high frequency (MHz) and high Q factor LLC converter is proposed to reduce the impedance of the coupling capacitance and to obtain a high output voltage. This paper deals with the operation analysis of the proposed LLC converter and a theoretical capacitance estimation. The operation and features of the proposed CCWPT LLC converter is verified with a 4.2 W prototype for charging mobile devices.

• Proceedings of the KIPE Conference
• /
• 2015.11a
• /
• pp.25-26
• /
• 2015

Inductive Power Transfer (IPT) method becomes more and more popular for the Electric Vehicle (EV) battery charger due to its convenience and safety in comparison with plugged-in charger. In recent years, Lithium batteries are increasingly used in EVs and Constant Current/Constant Voltage (CC/CV) charge needs to be adopted for the high efficiency charge. However, it is not easy to design the IPT Battery Charger which can charge the battery with CC/CV charge under the wide range of load variation due to the wide range of variation in its operating frequency. This paper propose a new design and control method which makes it possible to implement the CC/CV mode charge with minimum frequency variation (less than 1kHz) during all over the charge process. A 6.6kW prototype charge has been implemented and 96.1% efficiency was achieved with 20cm air gap between the coils.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.4
• /
• pp.42-51
• /
• 2003

In this paper, we are going to analyze on relation of an output spectrum along phase distortion of power amplifier in wireless LAN system, and then considered an ACPR characteristic of power amplifier and consideration of an OFDM method for this. Also, we did implementation for OFDM modulation and transmission section of an IEEE 802.11a standard to have transmission speed of the maximum 54Mbps in order to know an OFDM modulation method and relation of non-linear characteristic of power amplifier. The non-linear characteristic of power amplifier did modeling with AM-to-AM and AM-to-PM, and we analyzed an output spectrum characteristic along phase distortion composed input signal supply for power amplifier. When output spectrum analysis results phase distortion increased, and an AM-to-PM characteristic of power amplifier in 5 degrees, the output spectrum was satisfied with a demand spectrum in P1 dB, but 10-20 degrees were able to confirm what cannot be satisfied with a demand spectrum in phase distortion. Also, an output spectrum of power amplifier by frequency re-growth generated by a non-linear characteristic of power amplifier did not satisfied in P1dE. therefore, a back-off value was requested according to an AM-to-PM distortion degree, and smaller back-off value were able to know what demand became in case of modulation section that used OFDM.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.11A
• /
• pp.1182-1189
• /
• 2007

Frequency reuse in a cellular wireless communication environment gives rise to a phenomenon of cochannel interference. This paper introduces a power control strategy for OFDM based communication systems operating in such an environment. Among the existing power control schemes, IWF(iterative waterfilling) is known to exhibit relatively good performance. However, it requires feedback of power level and bit allocation information for each subcarrier from a receiver to its associated transmitter, which can lead to a considerable overhead, especially for the case of employing large number of subcarriers. Motivated by this, we present a simplified power control scheme with reduced overhead feedback, which allocates some nonzero identical power to the subcarriers of which channel conditions are above a certain threshold and zero power to the other ones. Computer simulations show that the proposed strategy produces a good approximation to the performance of the IWF in terms of the transmission power level while it requires less overhead feedback.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.10A
• /
• pp.1042-1049
• /
• 2007

Frequency reuse in a cellular wireless communication environment gives rise to a phenomenon of cochannel interference. This paper introduces a power control strategy for OFDM based communication systems operating in such an environment. Among the existing power control schemes, IWF(iterative waterfilling) is known to exhibit relatively good performance. However, it requires feedback of power level and bit allocation information for each subcarrier from a receiver to its associated transmitter, which can lead to a considerable overhead, especially for the case of employing large number of subcarriers. Motivated by this, we present a simplified power control scheme with reduced overhead feedback, which allocates some nonzero identical power to the subcarriers of which channel conditions are above a certain threshold and zero power to the other ones. Computer simulations show that the proposed strategy produces a good approximation to the performance of the IWF in terms of the transmission power level while it requires less overhead feedback.

• Journal of Advanced Navigation Technology
• /
• v.12 no.4
• /
• pp.324-331
• /
• 2008

In this paper, we developed the crops monitoring system using wireless sensor networks. It can acquire the information about the cultivation environments from a temperature, humidity, illumination and soil sensor then use the detailed information for very useful. The acquisition about the cultivation environment information with wireless sensor networks can be made up an environment that an administrator is able to confirm the information and wherever in a remote place instead of conventional way visiting the cultivate place by investing a lot of money and time. Therefore, it could be saving money, time and effort, and reduced the damages from the natural disasters such as a cold-weather damage and drought. In addition, we could be possible preventing from the damages of blight and harmful insects according to the temperature by an analysis. In agriculture field, this system could be supported for making a foundation of the advanced technology developing endless, and, in IT field, it is look forward to preparing the opportunity which creates a new requirement on the new technology.

• Journal of Satellite, Information and Communications
• /
• v.11 no.3
• /
• pp.133-137
• /
• 2016

Millimeter wave wireless communication systems, especially those targeting indoor high rate data transfer, have a strong requirement for high quality wireless link. Unfortunately, in this frequency band, the electromagnetic wave has to sustain the high propagation loss caused by the smaller wavelengths. In this scenario, beamforming technique, which enhances the link quality by focusing the radiation power on a direction, becomes one of the most important techniques in millimeter wave band wireless communication. In recent year, there been conducted many research on beamforming to improve the performance of wireless system. In this paper, we evaluate the performance of a simplified codebook-based beamforming scheme which is based on multiple-procedure and three-state beam selection. The simplified scheme significantly reduces beamforming setup time, comparing to the exhaustive searching, two-level searching adopted in IEEE 802.15.3c standard, and also conventional multi-level scheme.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.45 no.6
• /
• pp.27-32
• /
• 2008

Impulse Radio Ultra Wide Band (IR-UWB) system can be used to wireless position location system because of its unique very short pulse in the order of nanosecond. A few algorithms have been proposed to calculate location of sensors or tags. In this paper, we compare these algorithms and propose 'TDoA with wireless synchronization' as practical solution. Earlier algorithms need special logic to fix the duration to receive and send pulse or assume synchronization with wire. In proposed method, beacons synchronize each other using impulse and nodes can be made simple and cheap. We evaluated the performance and it shows 50% improved accuracy at the error range of 50cm.