• Journal of Soil and Groundwater Environment
• /
• v.12 no.3
• /
• pp.23-28
• /
• 2007

A number of batch isotherm and electrokinetic experiments were conducted in order to investigate the migration of zinc and its removal efficiency during electrokinetic soil processing. Sorption and desorption characteristics of zinc spiked kaolin clay have been examined by comparison with electrically induced desorption and precipitation occurring in the anode and cathode regions, respectively. The removal efficiency of zinc under the applied voltage gradient of 300 V/m was found to be up to approximately 80 % within 4 hours of the electrokinetic treatment. The study is significant with respect to the remediation of contaminated areas.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.1C
• /
• pp.1-8
• /
• 2006

The purpose of this study is to experimentally analysis the eletrokinetic phenomena and remediation characteristics developed during the application of electrokinetic remediation technique to unsaturated soils contaminated by heavy metals. In the laboratory a series of column tests are performed on degree of saturation for shooting range soil. The test results indicated that Pb is mainly removed under unsaturated conditions by electromigration within diffuse double layer, and if the initial containment concentration is below cation exchange capacity and equals to adsorption per unit soil solid weight, the remedial efficiency decreases with the decreasing of transport efficiency due to the changes in the degree of saturation in the electric gradient of 1V/cm.

• Journal of Soil and Groundwater Environment
• /
• v.8 no.1
• /
• pp.9-16
• /
• 2003

A new method has been proposed and developed that solves the problem of decreasing electroosmotic flow rate by excess $H^{+}$ and precipitation of heavy metal by $OH^{-}$. An electrolytic solution was circulated between the anode and cathode compartments that enabled the pH at the anode and cathode to be controlled. The change of the soil pH by circulation systems affects the operation time, by lowering the rate of increase of the electric potential gradient, and the removal efficiency of heavy metals, by affecting the soil pH. Since there was no effluent from the cathode compartment in circulation system, there was no need to treat the wastewater after the experiment, which resulted in the reduction of influent electrolyte volume.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.1
• /
• pp.131-142
• /
• 2003

The characteristics of electroosmosis drainage in clayey soil were investigated, when an electrokinetic technique was applied for the purpose of separating heavy metals in contaminated ground. A series of laboratory tests, considering voltage, zeta potential, pH distribution, and current, were performed for a lead-contaminated kaolin. The results of laboratory tests were compared with numerical analysis of finite difference method. The 1311owing conclusions were obtained: The flow velocity in electroosmosis was very sensitive to the chemical and electrical characteristics of the clay. As the concentration of ion increases, the flow rate decreases and the amount of drainage also decreases as time elapses.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.4
• /
• pp.385-390
• /
• 2011

In this study, we developed a micromixer based on the non-equilibrium electrokinetics at the junction of a microchannel and nanochannel. Two fluid streams were mixed by an electro-osmotic flow and a vortex flow created as a result of the non-equilibrium electrokinetics at the junction of the microchannel and nanochannel. Initially, the microchannel was fabricated using Polydimethylsiloxane (PDMS) by the general soft lithography process and the nanochannel was created at a specific position on the microchannel by applying a high voltage. To evaluate the mixing performance of the micromixer, fluorescent distribution was analyzed by using the fluorescent dye, Rhodamine B. About 90% mixing was achieved with this novel micromixer, and this micromixer can be used in microsystems for biochemical sample analysis.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.5C
• /
• pp.291-301
• /
• 2006

In this study the characteristics of electrokinetic remediation, which is dependent on a various electrode configuration, was predicted from 2-D numerical analysis program (HERO-2D). Based on the predicted results for one dimensional and two dimensional electrode configurations, the optimized electrode configuration was determined by analyzing remediation efficiency, consumed electric power, installation cost of electrode and so on. When proposed electrode configurations were applied for in-situ remediation of the soils contaminated by heavy metals, the electrode configuration of high remediation efficiency should be chosen in case the high removal effect would be required, and one dimensional electrode configuration should be chosen in case the hard field works would be expected. Because the rectangular electrode configuration is better than others for consumed electric power, remediation efficiency per unit power, installation cost of electrode and so on, it can obtain the best results for the cost reduction.

• Journal of Soil and Groundwater Environment
• /
• v.8 no.1
• /
• pp.1-8
• /
• 2003

Three different surfactants, APG, Brij30, and SDS, were tested to study the characteristics of sorption on soil surfaces, washing ability, biodegradability, and electrokinetic removal. Kaolinite and phenanthrene were selected as a model soil and a representative HOC, respectively. Phenanthrene was sorbed on kaolinite up to 2,200 mg/kg dry soil. The APG, Brij30, and SDS were sorbed on soil to 40, 7, and 4g/kg soil, respectively. The washing ability of phenanthrene was in order of Brij30＆gt;SDS＆gt;APG. The biodegradability tested with sludge was in order of APG＆gt;Brij30＆gt;SDS. In the electrokinetic test, the highest removal efficiency was obtained with APG that exhibited the highest electroosmotic flow. To increase the removal efficiency of HOC in the electrokinetic remediation, the most important factor was the selection of surfactant which maximized the electroosmotic flow.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.1C
• /
• pp.17-25
• /
• 2010

Electrophoresis may offer a new technique to repair in service leaking geomembrane liner of municipal solid waste (MSW) impoundment. The method involves introducing a suspended clay particles, which are charged negatively, into the leakage in geomembrane liners by electrokinetic phenomena and formation of clay cake around leakage for prevention of leachate outflows. Therefore, the 3-dimensional leakage simulation experiments are conducted to evaluate the field applicability of sealing leaks of waste impoundment. In addition, the adequateness of optimum influence factors deduced from 1-dimensional experiments is evaluated. After the test, the total size (width, length) of clay cake formation around leak is increased with enlargement of leakage diameter and distance decrease detween anode and cathode.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.5
• /
• pp.5-12
• /
• 2006

In this study a series of tests (bench scale test) are carried out for increasing the strength of clayey soil by EK-Injection method. In addition, the effects of strength increase in the treated sample are measured by operating the vane shear test device during 25 days at 5 days intervals in order to estimate the effect of ground improvement caused by diffusion. Also, the effects of strength increase in the treated sample are measured by operating the vane shear test device to estimate the effect by treatment durations (5, 10, 15, 20, 25). The test results show that the strength increase was developed approximately 2 to 7 times in comparison to initial shear strength, and outstanding strenfth increase was created as much as 7 times while injecting the sodium silicate and phosphoric acid in anolyte and catholyte. In addition, the measured shear strength with the influence of diffusion and reduction of water-content had a tendency to converge in constant value in proportion to elapsed time. As a result of this study, strength increment developed by the influence of EK-Injection and diffusion rather than the reduction of water-content was 1000% high on average. In case of changes of treatment duration, strength increment developed by the influence of treatment durations rather than the reduction of water-content was 3 to 4 times high on average.

• Journal of Soil and Groundwater Environment
• /
• v.11 no.1
• /
• pp.7-13
• /
• 2006

The effects of electrolytes were investigated on the removal efficiency when several different electrolytes were used to change the electrode reaction in an electrokinetic (EK)-Fenton process to remediate phenanthrene-contaminated soil. Electrical potential gradient decreased initially due to the ion entrance into soil and then increased due to the ion extraction from soil under the electric field. Accumulated electroosmotic flow was $NaCl>KH_2PO_4>MgSO_4$ at the same concentration because the ionic strength of $MgSO_4$ was the highest and $Mg(OH)_2$ formed near the cathode reservoir plugged up soil pore to inhibit water flow. When hydrogen peroxide was contained in electrolyte solution, removal efficiency increased by Fenton reaction. When NaCl was used as an electrolyte compound, chlorine ($Cl_2$) was generated at the anode and dissolved to form hypochlorous acid (HClO), which increased phenanthrene removal. Therefore, the electrode reaction of electrolyte in the anode reservoir as well as its transport into soil should be considered to improve removal efficiency of EK-Fenton process.