• Fire Science and Engineering
• /
• v.32 no.6
• /
• pp.69-73
• /
• 2018

This study examined the reduction effect of a hydrodynamic force acting on the vertical wall of a portable water storage tank with a convex bottom floor. For the numerical simulation, the linearized Peregrine's equation was used to analyze the lapping waves in the tank caused by water falling from a supplying nozzle. The hydrodynamic force could be calculated by measuring the maximum run-up wave height at the vertical wall. The initial conditions of the numerical experiments were set up by controlling the positions and heights of the water supplying nozzle. Finally, the hydrodynamic force acting on the vertical wall can be reduced by the convex bottom design of the portable water storage tank so it can be applied to improve the structural stability.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.2 no.2
• /
• pp.95-104
• /
• 1998

The dynamic behavior of the marine cable is essentially nonlinear and dominated by geometric nonlinearity. Furthermore, fluid drag force makes the problem more complex and difficult. Therefore, it has certain limitations to obtain the dynamic behavior of the marine cable by analytical method. The purpose of this paper is to apply the elastic catenary cable element to the problem of under water cable including the hydrodynamic effects of fluids. The static and dynamic formulations for the three-dimensional elastic catenary coble under water effects are derived and the finite element analysis procedures are presented. In the analysis, the hydrodynamic forces are modeled by modified Morison equation. A comparison of the results obtained using present method with previously published results showed the validity of present method. The dynamic behavior of the marine cable subjected to current is investigated using present method and it can be illustrated that the dynamic behavior of the marine cable subjected to current varies with the incident angle of the current and inclined angle of the cable.

• Fire Science and Engineering
• /
• v.33 no.5
• /
• pp.61-65
• /
• 2019

In the present study, the hydrodynamic force affected by a lapping wave induced by supplied falling water acting on the vertical wall of a portable water storage tank was analyzed using a nonlinear Peregrine model. The lapping wave's maximum run-up amplitudes and the hydrodynamic forces in the wall of the tank measured by linear and nonlinear Peregrine's models were compared numerically. As a result, it was concluded that the linear model may underestimate the effects on the vertical wall; therefore, it is more appropriate to use a nonlinear Peregrine model. Furthermore, this result can contribute to the stable structural designs of portable water storage tanks.

• Fire Science and Engineering
• /
• v.31 no.3
• /
• pp.49-53
• /
• 2017

In the present study, the hydrodynamic force acting on the vertical wall of a portable water storage tank is examined. A Dispersion Relation Preserving (DRP) method, proposed by Jang, is applied for simulating lapping waves and their impact on the wall. A meaningful investigation has been observed, which may be applied to the strength design for the portable water storage tank.

• Proceedings of the Korean Nuclear Society Conference
• /
• 2002.10a
• /
• pp.165.1-165
• /
• 2002

• Korea Petroleum Association Journal
• /
• no.3 s.223
• /
• pp.6-7
• /
• 2001

• Transactions of the Korean Society of Pressure Vessels and Piping
• /
• v.16 no.1
• /
• pp.30-36
• /
• 2020

In SMART, the flow mixing header assembly (FMHA) is used to mix the coolant flowing into the reactor core to maintain a uniform temperature. The FMHA is designed to have enough stiffness so the resonance with reactor internal structures does not occurs during the pipe break and the seismic accidents. Since the gap between the FMHA and the core support barrel assembly is very narrow compared with the diameter of FMHA, the hydrodynamic mass effect acting on the FMHA is not negligible. Therefore the hydrodynamic mass characteristics on the FMHA are investigated to consider the fluid and structure interaction effects. The result of modal analysis for the dry and underwater conditions, the natural frequency of primary vibration mode for the horizontal direction is reduced from 136.67 Hz to 43.76 Hz. Also the result of frequency response spectrum seismic analysis for the dry and underwater conditions, the maximum equivalent stress are increased from 13.89 MPa to 40.23 MPa. Therefore, reactor internal structures located in underwater condition shall consider carefully the hydrodynamic mass effects even though they have sufficient stiffness required for performing its functions under the dry condition.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.3 no.1
• /
• pp.103-112
• /
• 1999

This is study to estimate the pump induced vibration in time and frequency domain by frequency response function between two points in case of 20Hp and 50Hp centrifugal pumps. The frequency response function has real and imaginary information of signals, and response function has also real and imaginary information. So the vibration force can be obtained from the response function and frequency response function by complex calculation. And it is compared with the theoretically estimated values and it is suggested that the amplitude of vibration with main frequency is about 10~25% of pump and motor weight, and the magnitude of unbalanced mass is about 30~60% of pump and motor weight to estimated vibration force in time domain. There are the other kinds of vibration components with different frequency values of 2~3 times of its main frequency, and these kinds of information are used to control the tuning ratio between operating frequency of pump and structural frequency of concrete slab.

• Journal of the KSME
• /
• v.25 no.5
• /
• pp.406-412
• /
• 1985

연소 동안에 크랭크 축은 오일 필름을 통하여 연소압력이 실린더 블록으로 전달된다. 점화 전에 관성력에 의한 크랭크 축의 굽힘 변형은 크랭크 축으로부터 메인 베어링까지의 연소하중 전달에 큰 영향을 미친다. 메인 베어링에 베어링 보를 부착시키거나 크랭크 축의 굽힘 강성을 변화시켜 실린더 블록의 스커어트 진동을 감소시키는 효과를 얻었다. 크랭크 축의 비틂 진 동을 일으키는 회전력과 관성력 변동의 합력은 크랭크 저어널의 횡진동을 일으킨다. 크랭크 축의 횡 강제진동은 베어링 1에서 최대값이기 때문에 실린더 블록의 굽힘, 비듦 진동에 대하여 기진력이 된다. 실린더 블록의 진동 진폭은 관성력 변동의 주파수가 실린더 블록의 공진진 동수에 가까워지는 정도와 크랭크 축 비듦 진동의 진폭에 의존한다. 크랭크 풀리의 극관성 모우멘트와 크랭크 축 비듦 진동을 감소시키는데 효과를 준다.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.29 no.10 s.241
• /
• pp.1307-1314
• /
• 2005

The most important factor of the traffic accident on the wet road is a tire slip caused by hydroplaning. Meanwhile, hydroplaning characteristics are influenced very greatly by the vehicle velocity, so it is very important to reveal the relation between hydroplaning and the vehicle velocity. Since the experiment study is considerably limited, recently the numerical simulation using finite element method(FEM) and finite volume method(FVM) is widely adopted. In this paper, the effect of the vehicle velocity on the hydroplaning characteristics is investigated through the hydroplaning analysis using MSC/Dytran.