• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.1
• /
• pp.34-43
• /
• 2007

As a method to improve the poor torque capacity on the continuously variable transmission(CVT), power splitted devices(PSD) reducing the power entering into the transmission has been considered. But this kind of PSD requires for the variator to be a large coverage of the speed ratio (CSR) Since the CSRs of the well-known push belt or the toroidal ones are not enough large, the power splitted CVTs (PSCVTs) using them should be made with multiple modes. inevitably adding the do9 clutches and the associated accessories. In this paper a PSCVT with single mode is conceptually designed A new continuously variable unit (CVU) consisting of the paired inner and outer spherical rotors is used. The CVU has large CSR and excellent compactness. As a PSD. a variable bridge (VB) using the Planetary gear units (PGUs) is considered because it has an upper bound on the power ratio. An optimal design to minimize the effective efficiency of the PSCVT is carried out. Through the performance analysis on the designed model, good expectation on the practicability in the heavy vehicle system is shown.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.11
• /
• pp.697-704
• /
• 2017

This study was carried out to investigate and alleviate the vibration problem of commercial high-speed trains. First, the measurement of the carbody vibration was performed, in order to determine the vibration level of the high-speed train. The measurement result showed that the vibration level of the driver cab was higher than that of the passenger car and that the vibration became bigger toward the trailing end of the train. The vertical vibration of the driver cab and passenger car was larger than the transverse vibration, and the maximum value of the vibration in the ballast section was larger than that in the concrete section. A dynamic analysis was carried out to improve the vibration of the KTX-Sancheon train. The results of the analysis showed that it is necessary to reduce the vibration of the driver cab and both ends of the passenger cars. To reduce the vibration of the driver cab, it was recommended that the stiffness of the secondary coil spring be reduced and the damping coefficient of the secondary vertical damper be increased. It was found that the failure of the suspension system could be the origin of the vibration problem of the high-speed train. The proper management of wheel wear plays an important role in the improvement of the operation efficiency and reduction of the carbody vibration of high-speed trains, and research is underway to change the present wheel profile to increase the mileage between wheel turning.