• Aerospace Engineering and Technology
• /
• v.5 no.2
• /
• pp.205-212
• /
• 2006

Atmospheric drag is the most significant factor effecting the low Earth satellites under the altitude of 800 km Although the atmospheric density of the low Earth orbit is very low compared to that of the sea level, the accumulated effect of the atmospheric drag slowly lowers the satellite velocity at the perigee. Decrease in velocity at perigee directly causes decrease in altitude at apogee which changes the eccentricity of the orbit. The orbit finally reaches a circular orbit before reentering the Earth. This paper states the methods of calculating the atmospheric drag and the lifetime of the satellite. The lifetime of the kick motor and the satellites which will be used on KSLV-L are calculated by Satellite Tool Kit.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.7
• /
• pp.616-621
• /
• 2014

Consumption of the fuel on the satellite operating in low earth orbit, is increased due to the air resistance and the amount of increase makes the satellite lifetime decrease or the satellite mass risen. Therefore the prediction of drag force of the satellite is important. In the paper, drag force and drag coefficient analysis of the parabolic antenna satellite in low earth orbit using direct simulation monte carlo method (DSMC) is conducted according to the mission altitude and angle of attack. To verify the DSMC simulated rarefied air movement, Starshine satellite drag coefficient according to the altitude and gas-surface interaction are compared with the flight data. Finally, from the analysis results, it leads to appropriate satellite drag coefficient for orbit lifetime calculation.

• Journal of Aerospace System Engineering
• /
• v.12 no.3
• /
• pp.79-85
• /
• 2018

The demand for the development of atmospheric entry vehicles, dealing with reentry and solar-system planet exploration, is increasing. Generally, atmospheric drag and heating accompany the entry into atmospheric air. Accordingly, the selection of the thermal protection materials and the design and application of the thermal protection system are very important. In this paper, the atmospheric entry environment and the type and characteristics of the thermal protection materials are discussed. The design and application status of a thermal protection system for spaceplanes are described.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.30 no.1
• /
• pp.75-81
• /
• 2002

In the re-entry comtrol system, errors apt to induce because the time deriviative of drag acceleration is analytically estimated. Still more, the difficulty of estimation of th exact drag coefficient in hypersonic velocity and the non-reality of the scale height cause a steady-state drag errer. In the Space-Shuttle, a steady-state drag error is reduced by the addition of the integral term of drag acceleation error into the control system. This method, however, induces a difficulties in respect to the modern controller composition due to the multi-poles in a closed-loop system. Thus, this paper proposes the additional method of the disturbance observer. This reduces the steady-state drag error according to the following by the analytic calculation, and then creates the new drag acceleration time derivative using the estimated error. The performance of the re-entry control system is verified about 32 refernce trajectories.

• Journal of Aerospace System Engineering
• /
• v.16 no.2
• /
• pp.63-72
• /
• 2022

As interest in microsatellites increases, research has been actively conducted recently on the performance and use, as well as the orbital design and deployment techniques, for the microsatellite constellations. The purpose of this study was to investigate orbital deployment techniques using thrust and differential atmospheric drag control (DADC) for the Walker-delta constellation. When using thrust, the time and thrust required for orbital deployment vary, depending on the separation speed and direction of the satellite with respect to the launch vehicle. A control strategy to complete the orbital deployment with limited performance of the propulsion system is suggested and it was analyzed. As a result, the relationship between the deployment period and the total thrust consumption was derived. It takes a relatively longer deployment time using differential air drag rather than consuming thrusts. It was verified that the satellites can be deployed only with differential air drag at a general orbit of a microsatellite constellation. The conclusion of this study suggests that the deployment strategy in this paper can be used for the microsatellite constellation.

• Korean Journal of Remote Sensing
• /
• v.38 no.5_3
• /
• pp.851-861
• /
• 2022

In this study, we analyzed the effects of trees planted in urban areas on PM_2.5 reduction using a computational fluid dynamics (CFD) model. For realistic numerical simulations, the meteorological components(e.g., wind velocity components and air temperatures) predicted by the local data assimilation and prediction system (LDAPS), an operational model of the Korea Meteorological Administration, were used as the initial and boundary conditions of the CFD model. The CFD model was validated against, the PM_2.5 concentrations measured by the sensor networks. To investigate the effects of trees on the PM_2.5 reduction, we conducted the numerical simulations for three configurations of the buildings and trees: i) no tree (NT), ii) trees with only drag effect (TD), and iii) trees with the drag and dry-deposition effects (DD). The results showed that the trees in the target area significantly reduced the PM_2.5 concentrations via the dry-deposition process. The PM_2.5 concentration averaged over the domain in DD was reduced by 5.7 ㎍ m^-3 compared to that in TD.

• Journal of Advanced Navigation Technology
• /
• v.20 no.2
• /
• pp.134-140
• /
• 2016

This paper analyzed flight trajectory characteristics of ballistic missiles considering effects of drag forces. It is difficult to intercept ballistic missiles which fly over atmosphere with supersonic speeds and small radar cross section (RCS). In particular, the velocities in the phases of boost and terminal are changed significantly due to the steep variation of the drag force. Therefore, in order to build up a successful ballistic missile defense systems, the effects of the drag forces should be considered in the analysis of ballistic missile trajectory characteristics. In this point of view, this work analyzed the effects of drag forces and derived the flight trajectory characteristics of Scud B, C and Nodong missiles. Model of the ballistic missile flight trajectory is considered the effects of Coriolis and centrifugal forces, and specifications of the missiles are open sources.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.160.2-160.2
• /
• 2012

Unified State Model(이후 USM)은 Altman(1972)에 의해 처음 제안된 이후 Chodas(1981), Raol & Sinha(1985), Vittaldev et al.(2012) 등을 거치며 연구 발전되어 왔다. 이 모델은 공간상 6개 성분의 위치, 속도 벡터를 이용해 위성의 운동을 기술하는 기존 계산 방법과 달리 4개의 Quaternion 변수를 도입하여 위성의 위치를, 3개의 Hodograph 변수를 도입하여 위성의 속도를 각각 기술한다. USM의 장점은 직교좌표계로 표현된 위성의 위치, 속도 변수에 비해 USM 변수의 변화량이 상대적으로 작기 때문에 수치 계산 시 계산의 안정도가 높다. 또한 원궤도(${\omega}$ : undefined)와 적도면 궤도(i = 0, ${\Omega}$ : undefined) 계산 시에 나타나는 특이성(singularity) 문제가 발생하지 않는다. 본 연구에서는 USM 계산방법과 기존 방법에 의한 위성궤도 계산결과의 차이를 비교 분석하였다. 지구궤도 위성의 정밀계산을 위해 이체항 이외에 지구타원체 섭동항과 대기 항력에 의한 섭동항을 추가 적용하였다. 비구형 지구 중력 포텐셜에 의한 섭동은 J4항까지 고려하였으며, 대기 항력은 간단한 exponential 모델을 적용하였다. 또한 수치계산 시 적분 간격과 정밀도 차수를 조절하여 각 모델의 계산 안정성을 테스트하였다. 본 연구의 궤도계산 결과 USM 모델을 이용한 계산방법은 그 정밀성과 계산효율성이 매우 우수한 것으로 검증되었다.

• Korean Journal of Remote Sensing
• /
• v.38 no.6_1
• /
• pp.1395-1406
• /
• 2022

This study investigated the effects of the urban forest and street trees on flow and temperature distribution in the Daegu National Debt Redemption Movement Memorial Park. For this, we implemented tree-drag and tree-cooling parameterization schemes in a computational fluid dynamics (CFD) model and validated the simulated wind speeds, wind directions, and air temperatures against the measured ones. We used the wind speeds, wind directions, air temperatures predicted by the local data assimilation and prediction system (LDAPS) as the inflow boundary conditions. To investigate the flow and thermal characteristics in the presence of trees in the target area, we conducted numerical experiments in the absence and presence of trees. In the absence of trees, strong winds and monotonous flows were formed inside the park, because there were no obstacles inducing friction. The temperature was inversely proportional to the wind speed. In the presence of trees, the wind speeds(temperatures) were reduced by more than 40 (5)% inside the park with a high planting density due to the tree drag (cooling) effect, and those also affected the wind speeds and temperatures outside the park. Even near the roadside, the wind speeds and temperatures were generally reduced by the trees, but the wind speeds and air temperatures increased partly due to the change in the flow pattern caused by tree drag.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 1997.10a
• /
• pp.361-364
• /
• 1997

The re-enty guidance design involves trajectory optimization, generation of a reference drag acceleration profile with the satisfaction of trajectory constraints. This reference drag acceleration profile can be considered as the reference trajectory. This paper proposes the atmospheric re-entry system which is composed of longitudinal, later and range control. This paper shows the a performance of a re-entry guidance and control system using feedback linearization control and predictive control.