• Journal of Advanced Navigation Technology
• /
• v.16 no.5
• /
• pp.810-816
• /
• 2012

In this paper, BER(Bit Error Ratio) performances of the TransferJet system, which is the standard of a close proximity inductive wireless communication system, are presented and analyzed. Comparing to other wireless communication systems, the TransferJet system has some advantages such as short communication range(i.e., high security in the wireless communication environments), fewer effects of multipath distortion, and higher transmission rate. In order to demodulate the received signal, either SC(Soft-decision Combining) or HC(Hard-decision Combining) can apply to the despreader and demodulator of the receiver. When the spreading factor is more than 4, the SC scheme approximately has a minimum signal-to-noise ratio gain of 2 dB over the HC scheme. Moreover, from simulation results, we can conclude that the quantization bits of 3 bits are an optimum value for the SC scheme in the TransferJet system since the 3-bit quantization achieves nearly the performance as that attained by double-precision floating-point.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.6
• /
• pp.34-39
• /
• 2001

An adaptive multi-rate (AMR) speech coder was adopted as a standard of W-CDMA by 3GPP and ETSI. The AMR coder is based on the CELP algorithm operating at rates ranging from 12.2 kbps down to 4.75 kbps, and it is a source controlled codec according to the channel error conditions and the traffic loading. In this paper, we implement the DSP S/W of the AMR coder using OakDSPCore. The implementation is based on the CSD17C00A chip developed by C&S Technology, and it is tested using test vectors, for the AMR speech codec, provided by ETSI for the bit exact implementation. The DSP B/W requires 20.6 MIPS for the encoder and 2.7 MIPS for the decoder. Memories required by the Am coder were 21.97 kwords, 6.64 kwords and 15.1 kwords for code, data sections and data ROM, respectively. Also, actual sound input/output test using microphone and speaker demonstrates its proper real-time operation without distortions or delays.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.3
• /
• pp.268-275
• /
• 2003

In this paper, the capacity of VSG-CDMA system supporting multi-media service in the reverse link is analyzed by considering the two models according to the power control and user distribution. In analysis model I, assuming perfect power control and uniform distribution of users, the equation of blocking probability is calculated and the maximum number of voice and data user is derived in accordance with 1 % blocking probability. In analysis model II, it is analyzed by assuming power control error and non-uniform distribution of users. The result of analysis model I means the upper bound of system capacity in the 5 MHz wideband VSG-CDMA system, and the result of analysis model II shows the lower bound of system capacity. Also, the improved plan of performance for VSG-CDMA system is suggested by the analyzed result according to data activity and the value of $E_b/N_o$ in model II.

• Journal of Satellite, Information and Communications
• /
• v.9 no.2
• /
• pp.28-32
• /
• 2014

In this paper, we analyzed the performance of cyclostationary signal detection scheme for LTE system. We applied the cyclostationary signal detection scheme to the cognitive radio(CR) technology, which improves the usage efficiency of spectrums and shares frequencies, and we detected the signal in the long term evolution(LTE) band. LTE system has been designated as the standard to improve the maximum data rate and provide the low latency in the 3rd generation partnership project(3GPP). In this paper, we generated the LTE signals based on the orthogonal frequency division multiple access(OFDMA) and analyzed the performance of signal detection in accordance with the segment and threshold of the generated signals. Gaussian channel was used in the simulation and we discussed the future studies to apply the CR to the LTE system.

• 전자공학회논문지 IE
• /
• v.45 no.1
• /
• pp.44-49
• /
• 2008

In this paper, the performance for the non-linear satellite channel including the characteristics of group delay and gain ripple of transponder is analyzed with multi-level QAM-OFDM schemes. Comparing the BER performances between general OFDM and CI(Carrier Interferometry)-OFDM for various QAM schemes, the degree of performance improvement is presented in AWGN environments for specified nonlinear characteristics. The simulations are performed with the 36MHz bandwidth of transponder channel and 120Mbps transmission rate for QPSK, 8QAM, 16QAM, 32QAM, 64QAM schemes between normal and worst case condition. It is shown that the improvement measure by the CI-OFDM for the group delay of channel and nonlinear characteristic of HPA outperforms that for the gain ripple in the case of higher level QAM scheme in normal condition. And the simulation results show that the additional techniques like the channel coding and compensation scheme against the nonlinear characteristic are required for 32QAM and higher level QAM in worst case condition.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.8
• /
• pp.1901-1907
• /
• 2015

Today's smartphones and user devices are equipped with multiple radio interfaces increasingly. Aggregating theses multiple radio interfaces and using them concurrently will increase a user's communication speed immediately, but at the expense of increased power consumption. In this paper, we develop a mathematical performance model of an adaptive radio activation scheme by which a radio interface is activated only when needed for performance increase and deactivated otherwise. The developed model shows that the adaptive scheme reduces delay significantly and almost halves power consumption below a certain level of traffic input.

• Convergence Security Journal
• /
• v.11 no.1
• /
• pp.11-18
• /
• 2011

Wireless mesh network technology with transmission speeds similar to wired and wireless technology means to build, compared with wired networks, building a more efficient network to provide convenience and flexibility. The wireless mesh network router nodes in the energy impact of the mobility is less constrained and has fewer features entail. However, the characteristics of various kinds due to network configuration settings and the choice of multiple paths that can occur when the system overhead and there are many details that must be considered. Therefore, according to the characteristics of these network routing technology that is reflected in the design and optimization of the network is worth noting. In this paper, a multi-path setting can be raised in order to respond effectively to the problem of the router node data loss and bandwidth according to traffic conditions and links to elements of the hop count evaluation by using a genetic algorithm as a workaround for dynamic routing the routing metric for wireless mesh network scheme is proposed.

• The KIPS Transactions:PartC
• /
• v.18C no.3
• /
• pp.179-186
• /
• 2011

Wireless Mesh Network technology refers to the technology which establishes wireless network whose transmission speed is similar to that of the wire system, and provides more enhanced flexibility in the building of network, compared to the existing wired network. In addition, it has the feature of less mobility and less restriction from the energy effect. However, there follow many considerations such as system overhead in the case of setting or the selection of multi-path. Accordingly, the focus is on the design and optimization of network which can reflect this network feature and the technology to establish path. This paper suggests the methods on the programming of path in Wireless Mesh Network routing by applying the evaluation value of node service, making use of the loss rate of data, the hop count of bandwidth and link and the traffic status of node, considering the performance of link and load in the fitness evaluation function, in order to respond to the programming of multi-path effectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.7
• /
• pp.580-591
• /
• 2013

The Orthogonal Frequency Division Multiple Access (OFDMA) is considered as a novel modulation and multiple access technique for 4th generation wireless systems. In this paper, we formulate a base station's power allocation algorithm for each user to maximize the user's sum rate, subject to constraints on total power, bit error rate, and rate proportionality among the users for a better proportional rate adaptive (RA) resource allocation method for OFDMA based system. We propose a novel power allocation method based on the proportion of subcarrier allocation and the user's normalized proportionality constant. We adapt a greedy algorithm and waterfilling technique for allocating the subcarriers among the users. In an end-to-end simulation, we validate that the proposed technique has higher system capacity and lower CPU execution times, while maintaining the acceptable rate proportionality among users.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.6A
• /
• pp.555-567
• /
• 2010

Unlike single-hop systems, multi-hop systems that use relay nodes assign a part of the overall resources to relay communications. If efficient resource allocation schemes are not adopted, this leads to a loss of resources. Moreover, because we may not be able to guarantee high-link performance due to the adjacent-cell interference in relay-based cellular systems, resource efficiency can be severely decreased. In this paper, we propose efficient resource allocation schemes for downlink relay-based networks in 3GPP (3rd Generation Partnership Project) LTE (Long Term Evolution)-Advanced systems. Unlike conventional schemes that have static resource regions for each data link, the proposed schemes dynamically allocate the resources of each link to resource blocks, by considering the channel state and the capacity of each link. We also propose resource overlapping schemes in which two different links overlap at the same resource region, so as to improve cell or user throughput performance. The proposed resource overlapping schemes do not require additional processes such as interference cancellation in users, thank to considering additional interference from resource overlapping in advance.