• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2011년도 춘계학술대회 논문집
• /
• pp.264-270
• /
• 2011

This paper reports a filtered velocity feedback (FVF) controller, which is an alternative to direct velocity feedback (DVFB) controller. The instability problems due to high frequency response under DVFB can be alleviated by the suggested FVF controller. The FVF controller is designed to filter out the unstable high frequency response. The FVF controller and the dynamics of clamped beams under forces and moments are first formulated The effects of the design parameters (cut-off frequency, gain, and damping ratio) on the stability and the performance are then investigated. The cut-off frequency should be selected not to affect the system stability. The magnitude of the open loop transfer function (OLTF) at the cut-off frequency should be small. As increasing the gain of the FVF controller, the magnitude of the OLTF is increased, so that the closed loop response can be reduced more. The enhancement of the OLTF at the cut-off frequency is reduced but the phase behavior around the cut-off frequency is distorted, as the damping ratio is increased The control performance is finally estimated for the clamped beam. More than 10dB reductions in velocity response can be achieved at the modal frequencies from the first to eighth modes.

• 한국소음진동공학회논문집
• /
• 제21권10호
• /
• pp.940-950
• /
• 2011

This paper reports a filtered velocity feedback(FVF) controller, which is an alternative to direct velocity feedback(DVFB) controller. The instability problems at high frequencies due to non-collocated sensor/actuator configuration with the DVFB can be alleviated by the proposed FVF controller. The FVF controller is designed to filter out the unstable high frequency response. The dynamics of a clamped plate under forces and moments and the FVF controllers are formulated. The stability of the control system and performance are investigated with the open loop transfer function(OLTF). It is found that the FVF controller has a higher gain margin than the corresponding DVFB controller owing to the rapid roll-off behavior at high frequencies. Although the gain margin cannot be fully utilized because of the enhancement at the high frequencies, the vibration at the modes lower than the tuning frequency is well controlled. This performance of the FVF controller is shown to be improved from that of the DVFB controller. It is, however, noted that the stability around the tuning frequency is very sensitive so that the enhancement in vibration level should be followed. The reduction performance at low frequencies using the FVF controller should be compromised with the enhancement in the vibration at high frequencies while designing the controller.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 추계학술대회논문집
• /
• pp.834-839
• /
• 2004

In this paper, we have studied on the active vibration control of an automotive roof in passenger car's structure using piezoelectric material as the actuator and sensor attached on the surface of the automotive roof, As a control algorithm, negative velocity feedback control method is used in the study and the position of the sensor is almost attached on the nearest position of maximum normal stresses occurring while the roof is vibrating due to disturbance or exciting, Also, the actuator is attached on the other side mostly collocated to the sensor. The optimum positions have the maximum stresses of the roof which have been found in the result of the finite element analysis using Nastran software, As the fundamental experiments, a beam and plate have also been implemented to verify the performance of vibration suppression. Finally the experiment of the roof has been carried out and The roof experiment has just given a possibility to an active vibration control of the automotive structure still not applied for passenger cars.

• 한국소음진동공학회논문집
• /
• 제18권12호
• /
• pp.1293-1300
• /
• 2008

This paper presents an active vibration control of cantilever beams under disturbances by a primary force. A direct velocity feedback control using a pair of PZT actuator and a velocity sensor is considered. Variation of the stability and performance with the locations of the sensor/actuator pair is investigated. It is found that the maximum gain varies with the locations of the sensor/actuator pair significantly. The maximum gain shows a symmetric distribution along the beam length with respect to the center point, although the boundary condition of the beam is unsymmetric. The control performance is affected by the location of the primary force as well as the location of the sensor/actuator pair. The active control system can more effectively reduce the vibration when the primary force is located close to the fixed boundary.

• 대한기계학회논문집A
• /
• 제37권1호
• /
• pp.25-30
• /
• 2013

군용 견마로봇차량은 전시 임무수행간 야지를 주행하게 되는데, 이때 발생하는 지속적인 충격에 의한 차체의 진동은 내부 구성품에 손상을 초래할 수 있다. 현재 차체 진동저감을 위한 제어의 수단으로 능동 또는 반능동 현가장치을 사용한 많은 연구가 진행 되고 있다. 본 연구에서는 기존의 반능동 현가장치와 더불어 $6{\times}6$ 차량의 회전형 현가장치와 독립적인 구동제어에 의한 진동저감 기법을 제안한다. 진동 제어기로는 스카이훅의 수정기법 중의 하나인 SH-ADD 를 적용하였다. ISO E 등급의 노면을 주행노면으로 선정하였으며, 시뮬레이션은 ADAMS Control 과 Matlab Simulink 를 연동하여 수행하였다. 야지에서의 내부장비의 피로누적에 초점을 두어 주행 제어조건에 따른 RMS 수치로서 결과를 비교 및 분석하였다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 춘계학술대회논문집
• /
• pp.587-592
• /
• 2004

Direct velocity feedback (DVFB) control is known that it offers an unconditional stability with very high performance when the control strategy is applied at a point collocated sensor and actuator pair, because the sensor-actuator pair has strictly positive real (SPR) property. In this paper, two types of collocated sensor-actuator pairs are considered for practical active vibration control of a structure. They are a point collocated sensor-actuator pair and a point sensor-distributed actuator pair. Both pairs with DVFB sho robust stability and performance. It is noted that the collocated point sensor-actuator ultimately acts as a 'skyhook' damper, but the point sensor-distributed actuator pair with DVFB acts as a 'skyhook' rotational dmaper pair.ational dmaper pair.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1990년도 추계학술대회논문집; 한양대학교, 서울; 24 Nov. 1990
• /
• pp.193-198
• /
• 1990

전자기 베어링은 기계적 접촉이 없고 전기적 제어가 가능하여 최근 고속 정 밀 회전기에 사용되고 있다. 본 논문에서는 능동 자기베어링을 모형화하고 제어 이득에 따른 계의 안정성 판별 및 응답특성의 변화를 고찰하였다. 이를 토대로 두개의 반경방향 베어링과 회전체를 제작하고 아날로그 제어회로를 구성하여 안정되게 회전체를 부상시킬수 있었으며 이로부터 계의 응답특성 을 구하였다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 춘계학술대회논문집
• /
• pp.926-931
• /
• 2003

본 연구는 비압축성 유동에 노출되어 있는 2-D wing-flap 시스템의 공탄성 응답의 능동제어를 다루고 있다. 본 연구 논문의 목표는 LQG 제어법칙을 수행함으로써 임계 비행속도하에서 플러터의 비안정성을 억제하고 돌풍이나 blast load에 의한 임계 공탄성 응답의 성능을 향상시키는 것과 동적응답을 감쇠하는 수행능력들을 증명하는데 있다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1993년도 추계학술대회논문집; 반도아카데미, 26 Nov. 1993
• /
• pp.125-130
• /
• 1993

본 연구에서는 소음의 주기성분에 해당하는 전기적 참조신호인 주기적 펄스 신호(pulse train)를 사용하는 실시간 제어용 어셈블리 프로그램을 작성하고, Synchronous Sampling Method를 사용하여 능동소음제어를 실시, 이것에 대 한 장단점 및 한계를 고찰하는데 있다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2010년도 추계학술대회 논문집
• /
• pp.324-329
• /
• 2010

Vibrations caused by automobile engine are absorbed mostly by a passive-type engine mount. However, user specifications for automobile vibrations require more stringent conditions and higher standard. Hence, active-type engine mount have been developed to cope with such specifications. The active-type engine mount consists of sensor, actuator and controller where a control algorithm is implemented. The performance of the active engine mount depends on the control algorithm if the sensor and actuator satisfies the specification. The control algorithm should be able to suppress persistent vibrations caused by the engine which are related to engine revolution. In this study, three control algorithms are considered for suppressing persistent vibrations, which are the positive position feedback control algorithm, the strain-rate feedback control algorithm, and the modified higher harmonic control algorithm. Experimental results show that all the control algorithms considered in this study are effective in suppressing resonant vibrations but the modified higher harmonic controller is the most effective controller for non-resonant vibrations.