• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.3
• /
• pp.278-283
• /
• 2004

Due to the complex arrangement of frequency plans and spatial overages in modern satellite communications, channels that are non-contiguous in frequency may be amplified by a single power amplifier and transmitted to the ground through one beam. In this paper, a dual-mode canonical filter with dual-passband is presented. The filter adopts dual-mode technique for mass and volume reduction. Canonical structure is adopted for maximum transmission zero realization. To validate the design technique, a 6-pole dual-mode canonical dual-passband filter for Ka-band(30/20 ㎓) satellite transponder is realized. The measured frequency response of the filter shows good agreement with the computed one.

• Journal of Navigation and Port Research
• /
• v.30 no.5 s.111
• /
• pp.331-334
• /
• 2006

In this paper, we designed and fabricated the lowpass filter with the wide stopband characteristics using microp- strip line. Adding the $\lambda_g/4$ open stub at the input and output ports, we developed the L-C ladder type lowpass filter using the open stub which has wide stopband characteristics. In order to reduce the entire size qf this filter, the high impedance microstrip lines were made with the meander structure. The lowpass filter was fabricated with the cutoff frequency 2.3 GHz and its measured frequency responses agree well with the simulation results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.12B
• /
• pp.2407-2414
• /
• 1999

This paper introduces the concept of warped discrete cosine transform (WDCT) and an image compression algorithm based on the WDCT. The proposed WDCT is a cascade connection of a conventional DCT and all-pass filters whose parameters can be adjusted to provide frequency warping. In the proposed image compression scheme, the frequency response of the all-pass filter is controlled by a set of parameters with each parameter for a specified frequency range. For each image block, the best parameter is chosen from the set and is sent to the decoder as a side information along with the result of corresponding WDCT computation. For actual implementation, the combination of the all-pass IIR filters and the DCT can be viewed as a cascade of a warping matrix and the DCT matrix, or as a filter bank which is obtained by warping the frequency response of the DCT filter bank. Hence, the WDCT can be implemented by a single matrix computation like the DCT. The WDCT based compression, outperforms the DCT based compression, for high bit rate applications and for images with high frequency components.

• Journal of the Korea Convergence Society
• /
• v.11 no.11
• /
• pp.249-255
• /
• 2020

This study developed the health monitoring method of press process using the acoustic emission (AE) sensor and high-pass filter. Also, the AE parameters such as ring-down count and peak amplitude are used. Based on this AE signal, the AE parameters were acquired and was utilized to detect the crack of the specimen. Since the defect detection is difficult due to noise and low magnitude of signal, the signal noise and press operation frequency were checked through the Short Time Fourier Transform(STFT) and damped. High-pass Filtering data was applied to AE parameters to select effective parameters. By using this signal processing techniques, the proposed AE parameters could improve the performance of defect detection in the press process.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.12
• /
• pp.2337-2342
• /
• 2008

In this paper, we propose the novel approach to enhance the visual quality of the digital image with adaptively sharpening and removing the noise. Image enhancement is performed in two ways. The pixels in the high dynamics area are sharpened by the adaptive unsharp mask with the parameter, which is derived using the statistical information of the image. On the other hand, the proposed algorithm do not perform the sharpening process in the uniform area that may cause the undesired artifact due to noise amplification, rather it performs smoothing to suppress the noise in this area. The decision, which process will be applied at the pixel, is also controlled by the statistics of the pixel dynamics. The proposed algorithm enhances the visual quality almost automatically by sharpening and smoothing at the same time with less parameter selection.

• Journal of the Korean Society for Railway
• /
• v.11 no.5
• /
• pp.477-481
• /
• 2008

This paper dealt with a detection method of series arc existence which is a symptom of electric fires in low-voltage system. The proposed detection circuit consists of a high-pass filter with a low cut-off frequency of 3kHz to attenuate power frequency voltage by 80 dB and an active band-pass filter with a center frequency of 4kHz to detect only the series arc signals. The performance of the circuit was evaluated in a phase-controlled incandescent lamp as a non-linear load and an inverted-fed induction motor as a high frequency load by using the arc generator specified in UL1699. From the experimental results, it was confirmed that the proposed method solved the detection error, which is being the most problem, by discriminating the series arc signal even in non-linear and high frequency loads.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.5
• /
• pp.123-131
• /
• 2016

To capture color and near-infrared images simultaneously, a multi-spectral filter array(MSFA) sensor is used. This is because an NIR band gives additional invisible information to human eyes to see subject under extremely low light level. However, because lenses have different refractive indices for different wavelengths, lenses may fail to focus widely different rays to the same convergence point. This is why a chromatic aberration(CA) problem occurs and images are degraded. In this paper, the image restoration algorithm for an MSFA image, which removes the CA problem, is presented. The obtained MSFA image is filtered by the estimated low-pass kernel to generate a base image. This base image is used to remove CA problem in multi-spectral(MS) images. By modeling the image degradation process and by using the least squares approach of the difference between the high-frequencies of the base and MS images, the desired high-resolution MS images are reconstructed. The experimental results show that the proposed algorithm performs well in estimating the high-quality MS images and reducing the chromatic aberration problem.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.21 no.1
• /
• pp.32-37
• /
• 1984

In this paper, a practical and simple scheme is described for the implementation of a moving average filter which is known to be able to provide low pass filter characteristics, and the estimated cut off frequency formulation of the filter and filtering algorithm are presented for the filter design. Some results of an experimental system using the commerical Z-80 microprocessor are given. It shown that high frequency noises are canceled effectively in frequency domain and time domain experiments and that results of the estimated cut off frequency formular is compared with measured one.

• Proceedings of the KIPE Conference
• /
• 2017.07a
• /
• pp.56-57
• /
• 2017

본 논문에서는 배터리의 노화에 따른 내부 저항 및 전압변동(Differential Voltage; DV)곡선 변화를 실시간으로 추정하는 SOH (State of Health) 알고리즘을 개발한다. 개발된 알고리즘은 정확한 내부 저항 추정을 위해 동작 및 측정 환경에 따른 고주파 통과 필터의 최적 설계 방안을 제안하며 동적 전류 특성을 고려한 DV곡선의 온라인 업데이트 로직을 이용한다. 알고리즘의 정확도는 단전지 시험 결과를 기반으로 시뮬레이션을 통해 검증한다.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.12 s.354
• /
• pp.8-14
• /
• 2006

This paper proposed noise insensitive 4*4 mid frequency-OCT (MF-DCT) focus measure operator. Proposed operator enhanced low power 8*8 MDCT operator to have 4*4 rotationally same form for Gaussian noise. MF-DCT operator acting like band-pass filter suppresses both low-frequency signal useless for focus measure and high-frequency signal affected by impulsive noise. Also it is proved to be linear because it uses the energy of band-pass filtered signal as focus measure. Experimental result shows its superiority by comparing AUM with traditional operators.