• Phonetics and Speech Sciences
• /
• v.15 no.2
• /
• pp.31-40
• /
• 2023

Tube phonation in water has been widely used for voice training among semi-occluded vocal tract (SOVT) exercises in which the patient bubbles with phonation keeping the tube submerged in water. This study aims to investigate the effect of tube diameter and water depth on bubble height and maximum phonation time (MPT) for patients with hyperfunctional voice disorders. Seventeen patients with hyperfunctional voice disorders were asked to bubble with sustained /u/ at the different inner diameters of tube (5, 7, and 10 mm), water depth (4, 7, and 10 cm). A water resistance phonation biofeedback system using a water height sensor was used for recording bubble height and MPT. The bubble height was significantly changed by the tube diameter while MPT was significantly changed with the tube diameter and water depth. Although the wider tube presented significantly lower bubble height for a given depth, relatively consistent bubble height was maintained. Depending on the water depth, the bubble height did not significantly differ for a given tube diameter. In addtion, MPT significantly decreased with water depth and a wider tube led significantly shorter MPT. A water level-driven water resistance biofeedback system provided useful information on bubble characteristics and vocal fold vibration depending on tube diameter and water depth. It can be useful to monitor the breath support during water resistance phonation for patients with hyperfunctional voice disorders.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.6B
• /
• pp.689-694
• /
• 2006

The system performance of a bioactive foam reactor (BFR), that consists of a foam column using a surfactant and a biodegradation basin containing suspended bacteria, was investigated for the treatment of gaseous toluene or a mixture of four volatile organic compounds (VOCs, benzene, toluene, p-xylene, and styrene). Overall, the BFR achieved stable VOC removal efficiencies, indicating that it can be used as a potential alternative over conventional packed-bed biofilters. Furthermore, a dynamic loading test showed that relatively constant removal was maintained at the elevated loading due to a high mass transfer rate in the foam column. However, as the inlet concentration of VOCs increased, a portion of the VOCs mass-transferred to the liquid phase was stripped out from the biodegradation basin, resulting in a decrease in the overall removal efficiency. In the BFR, the removal efficiency of the individual VOC was mainly determined depending on the biodegradation rate (styrene > toluene > benzene > p-xylene), rather than the mass transfer rate. Consequently, increases in the microbial activity and the volume of the basin could improve the overall performance of the BFR system. Further investigation on microbial activity and community dynamics is required for the BFR when subjected to high loadings of VOC mixtures.

• Proceedings of the Korean Society of Developmental Biology Conference
• /
• 2003.10a
• /
• pp.119-119
• /
• 2003

분만후 젖소의 자궁내 미생물상을 조사하고 미생물로부터 분리한 Lipopolysaccharide를 적용하여 소의 번식효율 증진에 기여하고자 분만후 젖소의 도축장 유래 자궁을 채취하여 혐기적 상태에서 균분리 동정을 실시하였다. 균분리 동정을 위하여, 시료를 1cm$\times$1cm로 채취하여 혐기상태에서 거품이 생길 때까지 vortexing한 후 균액 300$\mu l$를 뽑아 혐기배지에 도말하였고 도말한 plate는 $37{\circ}C$ 혐기chamber에서 24시간 배양하였다. 혐기배지에서 자란 균의 colony를 따서 Mac, BHI+B, BHI 배지에 배양한 후 Gram stain을 실시하였다. BHI 배지에서 자란 균의 colony를 따서 BUA+B 배지에 계대배양하였고 BUA+B 배지에서 자란 균중에 가장 마지막으로 자란 균을 따서 An-IF에 넣고 탁도를 63%T로 맞춘 후 An micro plate에 100$\mu l$씩 분주하였다. 분주한 plate를 $37{\circ}C$ 혐기 chamber에서 20~24시간 동안 배양한 후 Biolog를 실시하였다. 시료의 UV측정을 위하여 Sonic Processor로 세포를 분쇄하였고 분쇄한 세포를 $4{\circ}C$에서 10,000rpm으로 10분간 원심분리한 후 상층액을 분리하여 0.45$\mu m$ 필터로 여과한 다음 여과액을 취하여 UV로 standard(E.coli O26 B6 LPS)와 sample(10배 및 20배 희석액)을 측정하였다. (중략)

• Electronics and Telecommunications Trends
• /
• v.31 no.2
• /
• pp.95-106
• /
• 2016

사물인터넷(Internet of Things: IoT)이란 모든 사물이 인터넷에 연결되어 상호 간에 직접 통신하는, 향후 정보통신의 미래 인프라 및 서비스이다. 이것이 필요한 이유는 초연결 사회에 기반을 둔 삶의 질 향상과 생산성 향상에 있으며, 최종적으로는 국가 자체의 인프라, 더 나아가서는 인류를 위한 중추 신경계를 이루기 때문에 무엇보다 중요하다. IoT는 셀룰러 이동통신 기반의 IoT와 비셀룰러기반의 IoT로 대분되어 오다가 두 분야의 융합이 이루어지고 있다. 그러나 IoT는 현재 거품 최고조기에 있으며, 아직까지 주목할 만한 큰 수익모델이 없는 상태이다. 그 이유는 사물인터넷 서비스 활성화에 가장 걸림돌이 되어온 보안문제, 배터리수명, 통신거리, IoT 디바이스를 포함한 솔루션 가격 그리고 월정료 문제가 여전히 존재하기 때문이다. 최근 이들 문제 해결을 목적으로, 대량의 IoT 디바이스를 필요로 하는 새로운 사물인터넷 커넥티비티에 대한 재정의, 표준화 및 솔루션 개발이 핫이슈이다. 본고에서는 셀룰라 및 비셀룰라 IoT기반의 Low Power Wide Area(LPWA), 즉 저전력 광역 IoT에 대한 시장, 기술 및 솔루션 비교 그리고 표준화 동향을 다룬다. 또한, 비셀룰라기반 즉 비면허대역과 프리밴드 활용을 통한 기술적 및 정책적 대응전략을 살펴본다.

• The Korean Journal of Food And Nutrition
• /
• v.9 no.3
• /
• pp.325-330
• /
• 1996

Foaming capacity (FC) and stability (FS) of protein recovered from red crab (Chitinonecetes opilio) processing in water and soybean protein isolate were determined at pH 2.0~10.0 in water and NaCl solution. The FC values for both proteins showed the lowest values at the isoelectric point (pH 4.0) and increased nth an increase in pH above the isoelectric point. FC of RCP was higher than that of SPI at pH 10.0 in water and both NaCl solutions. FC of SPI increased with an increase in NaCl concentration at pH 4.0 and 6.0, but FC of RCP was not affected. The highest FS values for both proteins were obtained at pH 4.0 in water. At pH 2.0, FC of RCP decreased with NaCl concentration increase, but FS increased. NaCl concentration had little effect on FS of RCP at pH 4.0 and 6.0, but the FS decreased at pH 10.0. FS of SPI was similar to that of RCP at pH 2.0 and increased with NaCl concentration Increase from 0.1 to 0.5M NaCl at pH 10.0.

• Textile Coloration and Finishing
• /
• v.4 no.3
• /
• pp.82-90
• /
• 1992

To optimize the foam dyeing procedures for polyester and polyester/nylon blended non-woven fabrics, the effects of organic solvents and surfactants were investigated by measuring the foam heights and surface tensions of the foam dyeing solution. The results of the experiments can be summarized as follows: 1) Organic solvents and surfactants (sodium lauryl sulphate: SLS) solution lower the surface tension (ST) of the water, but ST lowering rate of SLS solution is greater than that of solvents. For a 0.25% SLS solution, the minimum surface tension was 30.3 dyne/cm, which is nearly the same value for organic solvents. 2) For 0.25% SLS solutions, additional adding of a 4.0% organic solvent makes the foam height (FH) be its maximum. 3) At 0.6 g/ι dye concentration, incorporation of 0.4% SLS makes the surface tension of the foam solution be its minimum. The foam height did not show any trend due to the dye type. 4) The effect of foam stabilizers (sodium alginate (Alg-Na) and hydroxy ethyl cellulose (HEC)) were also investigated. The foam height of the foaming solution with HEC was greater than that with Alg-Na. The foam stability of the foaming solution with Alg-Na was better than that with HEC.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.6
• /
• pp.1-7
• /
• 2005

Incompressible Reynolds-averaged Navier-Stokes equations with $\varepsilon{-SST}$ turbulence model are adopted for the investigation of the flow fields between the square cylinder and the ground. When the grounds moves, the diminish of the shear layer intensity on the ground promotes the interaction between the lower and the upper separated shear layer of the cylinder. Hence vortex shedding occurs at the lower gap height than stationary ground. In the moving ground, the secondary shedding frequency disappears due to the absence of the separation bubble on the ground which exists in the stationary ground. In addition, the shedding frequency and aerodynamic coefficients in the moving ground become higher than those of the stationary ground.

• Archives of design research
• /
• v.11 no.3
• /
• pp.91-99
• /
• 1998

In 1995, the department of multimedia-related study was first founded in Technical Institute and has carried out the fundamental education at academic level in trial and error. Following a bubble situation of multimedia-related industries, the education of multimedia-related departments has mass-produced hurriedly prepared multimedia designers and programmers. With the current IMF economic crisis, demand for the multimedia expert manpower has shrunk drastically and competitiveness for getting a job becomes intense. Therefore, it is an urgent problem to specialize the multimedia education of Technical Institute and to differentiate it from the education of Universe. In this paper, I am going to analyze the cause of various practical problems occurring in the multimedia education in Technical Institute and to suggest the solution and education goal for the specialized and differentiated education in multimedia-related department of Technical Institute.

• Journal of computational fluids engineering
• /
• v.20 no.1
• /
• pp.47-56
• /
• 2015

In this paper, we study the effect of various turbulence models by comparing the aerodynamic characteristics and the flow patterns computed for aircraft models. An in-house CFD solver, MSAPv, that solves the three dimensional RANS equations with the turbulence model equations is used. The turbulence models used in this study are the Spalart-Allmaras model, Menter's $k-{\omega}$ SST model, Coakley's $q-{\omega}$ model, and Huang and Coakley's $k-{\varepsilon}$ model. DLR-F6 WB and WBNP configurations are selected for the study. We concentrate on the separated flow pattern variations with the turbulence models at the wing-body junction and the wing-pylon junction as well as drag polar curves.

• Applied Chemistry for Engineering
• /
• v.4 no.2
• /
• pp.358-364
• /
• 1993

Low foaming scouring agents(SLFS) were prepared by blending of 2-ethylhexylaminoethyl sulfate, Na-dioctyl sulfosuccinate, Newpol PP-2000, MJU-100, ethylene glycol and organic solvent. As the results of several tests, SLFS-2 showed good scouring effect, penetrating ability, emulsifiability and anti-alkaline property, and showed not much water pollution. The foaming power of SLFS-2 measured by Ross & Mites method was 8mm foam height immediately after foaming. And the foaming power of SLFS-2 measured by Ross & Clark method were less than 300mm foam height at $30^{\circ}C$, and 15mm at $80^{\circ}C$. As a result, SLFS-2 was proved as a good low foaming scouring agent.