• 전기의세계
• /
• v.18 no.3
• /
• pp.34-39
• /
• 1969

종래 사용되어온 교류발전기의 자동전압조정기는 직류여자기의 계자전류를 제어함으로써 교류 발전기의 단자전압을 일정하게 유지하는 방식이었다. 이경우 정정시의 전압변동을 적게하는 것은 비교적 용이하지만 급격한 부하변동에 대해서는 불경하였다. 즉 발전기에 급히 부하가 걸리면 발전기의 특성에 의하여 결정되는 전압이 순간적으로 떨어지고 또 발전기에는 복권작용이 없고 직류여자기및 제어장치의 시정수에 의한 조정작용의 시간적 늦음이 있기때문에 발전기의 전압은 더욱 강하한다. 이 전압강하의 방지책으로 발전기를 필요이상 크게하여 단종비를 크게하고 또 속응여자를 행하고 있다. 그리고 발전기의 부하가 유도전동기이 가능한 것은 소용량에 한하고 거의 모두 감압기동을 하고 있었다. 이 난점을 보상하기 위해 주회로전류에 의한 복권특성을 갖는 자여자교류발전기가 개발되어 왔으며 근래에는 S.C.R (Silicon Controlled Rectifier)의 발달에 따라 자기증폭기식에서 Transistor-Thyristor식으로 변천하고 있다. 여기서는 자여자발전기를 이용한 정전압장치부 자려자교류벌전기 75KVA에 대한 특성을 소개하고자 한다.

• Proceedings of the KIPE Conference
• /
• 2010.07a
• /
• pp.408-409
• /
• 2010

본 논문에서는 소형 PEM(Proton Exchange Membrane) 연료전지를 이용하는 충전기에 관해 서술한다. 기존에 개발된 대부분의 충전기는 On-Grid 방식으로 벅타입 컨버터를 이용한 감압 충전방식을 사용하였으나, 연료전지를 이용할 경우 승압식 컨버터를 통해 배터리를 충전하여야 한다. 그러나 승압형 컨버터의 출력단에 인덕터가 없는 경우 큰 리플전류를 유도하게 되며, 이는 시스템의 효율 및 배터리의 수명에 좋지 않은 영향을 끼치게 된다. 본 논문에서는 Cuk 컨버터를 이용하는 충전용 전력변환기의 제어방법에 관해 제안하고 그 타당성을 검증하였다.

• Journal of Trauma and Injury
• /
• v.23 no.2
• /
• pp.188-191
• /
• 2010

A postoperative contralateral supra- and infratentorial epidural hematoma after decompressive surgery is an extremely rare event. We describe a 38-year-old male with a contralateral supra- and infratentorial acute epidural hematoma just after decompressive surgery for an acute subdural hematoma. A contralateral skull fracture involving a lambdoidal suture and an intraoperative brain protrusion may be warning signs. The mechanisms, along with relevant literature, are discussed.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.12 no.1
• /
• pp.44-47
• /
• 1988

The present experiments of transient temperature variation and temperature fluctuation were conducted by bead type thermistors in pool boiling without a heat surface. The experimentally obtained conclusion were as follows. (1) The high transient temperature Variatian of 11.64.deg. C for a duration of 0.08 sec and a temperature freguency having a duration of 5.6*10$^{-2}$ sec in a flashing were measured. (2) The highest variation of transient temperature was shown at saturated temperature of 80.deg. C and superheat of 7.9.deg. C. (3) Temperature frequency was found to increase with superheat below 60.deg. C of saturated temperature, but above 60.deg. C it was relative to lower superheat and was found to decrease with higher superheat..

• Solar Energy
• /
• v.20 no.3
• /
• pp.51-60
• /
• 2000

This paper deals with the design, construction and operation of a direct solar hot water heating system developed to harness the solar energy more effectively. The system introduced here uses a unique network of riser tubes and header pipes apart from the existing concept to exploit the physical properties of water which expands when it freezes. It also employs a special pressure relief mechanism for the header to prevent its breakage due to freezing. A number of tests are made to assure its functional reliability during frigid weather conditions and its superior performance over indirect systems.

• Aerospace Engineering and Technology
• /
• v.7 no.1
• /
• pp.40-48
• /
• 2008

Air mixing system which is composed of air pressure control system, hot pipe system and air mixer, is the facility for mixing hot air($1000^{\circ}C$, 10kg/s) from storage air heater (SAH) and decompressed air($20^{\circ}C$, 15kg/s) from high pressure air supply system. Air pressure control system reduce the pressure of the air, from 32MPa to 3.5 MPa and supply the decompressed air to air mixer. The hot pipe system supply hot air from SAH to air mixer which mix hot with the decompressed air from air pressure control system. Fully mixed air flow rate is 25kg/s and mixed temperature is up to $400^{\circ}C$. So, we can expand the operating envelop of the supersonic ground test facility to low Mach number and low altitude region.

• Pediatric Gastroenterology, Hepatology & Nutrition
• /
• v.8 no.2
• /
• pp.137-142
• /
• 2005

Purpose: To evaluate the safety, efficacy and technical problems of the endoscopic balloon dilatation of esophageal anomalies in children. Methods: The medical records of 8 children treated by endoscopic balloon dilatation for esophageal anomalies over a 10-year period at Pusan National University Hospital were reviewed retrospectively. The balloon catheter (Maxforce TTS or CRE, Boston Scientific Co., USA) was positioned across the area of narrowing by direct visualization. The balloon was slowly inflated with normal saline to specified pressures for each balloon and maintained for 60 seconds and then deflated. After 60 seconds pause, the procedure was repeated with a larger sized balloon (increments of 1 mm for each subsequent dilation) till effective dilatation was confirmed by direct visualization without complications. Results: Three male and five female were included and their mean age was 4.2 years. A total of 27 (average of 3.2 per patient) dilatation were performed. Underlying diseases of patients are postoperative stricture of esophageal atresia in 3 cases, esophageal ring in 2 cases, achalasia, corrosive esophagitis and hypertensive LES in one case respectively. The size of initial dilating balloon was chosen on the basis of the diameter of the narrowing determined by endoscopy. The first dilation in patients with severe esophageal stricture was made with a 6 mm sized balloon. Complications observed were esophageal perforation and respiratory holding during the procedure in one case respectively. Successful outcome was seen in 6 patients (75%). Conclusion: Endoscopic balloon dilatation can provide a safe and effective mean of treating esophageal anomalies in children and should be considered the treatment of choice in the initial management of those cases.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.290-293
• /
• 2017

A direct-connected, continuous type combustion test facility was developed to test a supersonic combustor model used in scramjet engines. The facility requirements were determined by assuming the flight speed of Mach 5, yielding the combustor inlet flow speed of Mach 2. Also the cross-section of the supersonic combustor under test was assumed as $32mm{\times}70mm$. As a result, the facility was designed to have the flow total pressure of 548 kPaA, total temperature of 1,320 K, and flow rate of 0.776 kg/s. The facility consists of a turbo type air compressor, electric air heater, vitiation air heater and a two dimensional facility nozzle to accelerate the flow to Mach 2. Also, an oxygen supply system was added to compensate the vitiation. The exhaust de-pressurization system is not added. Designed pressure, temperature, and flow rate were verified through the test operation of the facility.

• Korean Chemical Engineering Research
• /
• v.58 no.2
• /
• pp.307-312
• /
• 2020

Fluidized bed reactors operated in subatmospheric pressure has been focused because several industrial applications such as vacuum drying and plasma cvd requires reduced pressure fludization. However, the hydrodynamics of fluidized beds in subatmospheric pressure has not been extensively investigated. The pressure drop in the fluidized bed has been measured with variation of downstream pressures from 1.33 to 101.3 kPa in the shallow and deep fluidized beds under the sub-atmospheric pressures. The obtained minimum fluidization velocity of powders is a function of pressure due to the changes of gas density and mean free path. We can experimentally determine the critical Knudsen number and the critical pressure to define the slip regime significantly to influence the hydrodynamics of fluidized beds.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.487-490
• /
• 2005

재생 가능한 자원인 동식물성 기름으로부터 만들어지는 수송용 연료 바이오디젤은 낮은 대기오염물질 배출과 $CO_2$ Neutral 특성으로 환경친화적인 연료로 인정올 받으며 전세계적으로 그 생산량이 급격히 증가하고 있다 한국에서는 년간 20만톤의 폐식용유가 배출되며 이중 약 10만톤이 회수 가능한 것으로 추산된다. 폐식용유의 무단 폐기로 인한 수질오염과 폐기물의 자원 재활용 및 에너지 생산 관점에서 폐식용유를 바이오디젤 원료로 사용하는 연구가 많이 진행되었다. 높은 함량의 유리지방산을 함유한 폐식용유를 효율적으로 전이에스테르화(methanolysis) 하기 위해서는 먼저 산 촉매를 이용한 유리지방산의 전환 제거가 필요하다 본 연구에서는 다양한 종류의 강산성 이온교환 수지를 폐식용유의 전처리(pre-esterification)용 고체 산 촉매로 회분식 반응기에서 테스트하였으며 그 결과 Amberlyst-15가 유리지방산의 에스테르화 반응에 가장 적합한 것으로 나타났다. 회분식 반응기에서 도출된 최적 전처리 반응조건을 적용한 200시간 이상의 연속 전처리 운전결과 폐식용유에 함유된 $5\%$의 유리지방산이 $90\%$이상 전환제거 되었다 전처리 반응 후의 폐식용유를 균질계 염기촉매(KOH) 존재하에 메탄올과 전이에스테르화 반응을 시킨 결과 바이오디젤로 불리는 지방산메틸에스테르(Fatty Acid Methyl Ester, FAME)의 생산 수율은 $85\%$로 얻어졌으며 국내 바이오디젤 표준 규격에 따른 연료특성 분석 결과 FAME의 농도 규격을 제외한 모든 항목이 국내 규격을 만족하였다 폐식용유 바이오디젤의 FAME 농도가 $94.3\%$로 국내 규격$96.5\%$에 미달하는 문제는 식물성 원료유로 제조한 고순도 바이오디젤과 혼합 사용하거나 감압 증류 공정을 통해 고농도의 폐식용유 바이오디젤을 제조하여 해결 가능하다. 대전시 신성동 소재의 음식점에서 수거한 폐식용유를 원료로 하여 생산한 바이오디젤의 차량 배출가스 실증 테스트 결과 경유 차량의 주 오염물질인 PM과 Soot 및 기타 오염물질의 배출량은 감소하였으나 NOx의 배출량은 약간 증가하는 것으로 나타났다