• 한국전기전자재료학회논문지
• /
• 제16권5호
• /
• pp.361-364
• /
• 2003

It was investigated that the structural and electrical Properties of Ce-doped Ba(Zr$_{x}$Ti$_{1-x}$ )O$_3$ (BCZT) thin films with a mole fraction of x=0.2 and a thickness about 100 nm. BCZT films were prepared on Pt/Ti/SiO$_2$/Si substrate by a RF magnetron sputtering system. We have measured the thickness profile with Ar/O$_2$ ratio and the surface roughness. It was observed that the oxygen gas, which introduced during the film deposition, have an influence on the roughness of the film and the film roughness was reduced by annealing from 2.33 nm to 2.02 nm (RMS at 500 $^{\circ}C$, Ar:6 sccm, $O_2$:6 sccm). It was found that annealing procedure after top electrode deposit can reduce the dissipation factor.

• 한국전기화학회:학술대회논문집
• /
• 한국전기화학회 1998년도 제1회 총회 및 추계학술발표회
• /
• pp.60-60
• /
• 1998

• 한국수소및신에너지학회논문집
• /
• 제23권3호
• /
• pp.213-218
• /
• 2012

Steam reforming of methane (SRM) is the primary method to produce hydrogen. Commercial Ni-based catalysts have been optimized for SRM with excess steam ($H_2O/CH_4$ > 2.5) at high temperatures (> $700^{\circ}C$). However, commercial catalysts are not suitable under severe conditions such as stoichiometric steam over methane ratio ($H_2O/CH_4$ = 1.0) and low temperature ($600^{\circ}C$). In this study, 15wt.% Ni catalysts supported on $Ce_{0.8}Zr_{0.2}O_2$ were prepared at various calcination temperatures for SRM at a very high gas hourly space velocity (GHSV) of $621,704h^{-1}$. The calcination temperature was systematically varied to optimize 15wt.% $Ni-Ce_{0.8}Zr_{0.2}O_2$ catalyst at a $H_2O/CH_4$ ratio of 1.0 and at $600^{\circ}C$. 15wt.% $Ni-Ce_{0.8}Zr_{0.2}O_2$ catalyst calcined at $500^{\circ}C$ exhibited the highest $CH_4$ conversion as well as stability with time on stream. Also, 15wt.% $Ni-Ce_{0.8}Zr_{0.2}O_2$ catalyst calcined at $500^{\circ}C$ showed the highest $H_2$ yield (58%) and CO yield (21%) among the catalysts. This is due to complex NiO species, which have relatively strong metal to support interaction (SMSI).

• Applied Science and Convergence Technology
• /
• 제25권1호
• /
• pp.19-24
• /
• 2016

In this study, we evaluated the change of electronic structure during redox process in cerium-doped $ZrO_2$ grown by sol gel method. By sol-gel method, we could obtain cerium-doped $ZrO_2$ in high oxygen partial pressure and low temperature. After post annealing process in nitrogen ambient, the film is deoxidized. We used spectroscopic and theoretical methods to analysis change of electronic structure. X-ray absorption spectroscopy (XAS) for O K1-edge and Density Functional Theory (DFT) calculation using VASP code were performed to verify the electronic structure of the film. Also, high resolution x-ray photoelectron spectroscopy (HRXPS) for Ce 3d was carried out to confirm chemical bond of cerium doped $ZrO_2$. Through the investigation of the electronic structure, we verified as followings. (1) During reduction process, binding energy of oxygen is increase. Simultaneously, oxidation state of cerium was change to 4+ to 3+. (2) Cerium 4+ and cerium 3+ states were generated at different energy level. (3) Absorption states in O K edge were mainly originated by Ce 4+ $f_0$ and Ce 3+, while occupied states in valance band were mainly originated from Ce 4+ $f_2$.

• 대한환경공학회지
• /
• 제22권12호
• /
• pp.2263-2273
• /
• 2000

희분식 고온/고압 미분반응기를 이용하여 습식산화 반응시 대표적 난분해성 중간 산화물질로 알려진 아세트산을 산화반응 기질로 하여 여러 가지 담체 및 촉매의 조합에 대한 산화반응성을 실험하였다. 사용된 담체는 다공성 실리카($SiO_2$), 티타니아($TiO_2$), 지르코니아($ZrO_2$), $ZrSiO_4$, $ZrO_2(10wt%)/TiO_2$ 등이었으며 촉매활성성분온 크게 Ru, Mn, Ce의 세 가지로서 단독 혹은 조합사용(2성분계 및 3성분계)시의 산화활성에 대하여 조사하였다. 이를 통하여 일차척인 활성이 우수한 것으로 나타난 $Mn(2.8)-Ce(7.2wt%)/TiO_2$ 혹은 $Ru(0.5)-Mn(2.7)-Ce(6.8wt%)/TiO_2$ 기준촉매의 활성증진을 위하여 p-type 반도체 물질(CoO, SnO 및 $Ag_2O$)를 첨가제로 소량 사용함으로써 이에 따른 습식산화 반응 상대 활성실험을 수행하였다. 우선, $Mn-Ce/TiO_2$ 기준촉매에 있어서, p-type 반도체 물질(CO, Sn Ag)을 첨가한 경우, 모두 활성증진효과를 보이며 크기 정도는 Co> Ag >Sn순이었다. 특히, $Mn(2.7)-Ce(6.8)-Co(0.5wt%) /TiO_2$에 있어서는 약 2.6배의 높은 활성상승이 나타났다. 이의 가시적인 주원인은 표면적 증가 및 시너지 효과에 기인하는 것으로 판단되었다. $Ru-Mn-Ce/TiO_2$ 기준 촉매에 있어서는 $Ru(O.5)-Mn(2.4)-Ce(6.1)-Co(1.0wt%)/TiO_2$에서만 활성증진효과를 보였으며 그 이외의 다른 경우에 있어서는 표면적 및 활성감소가 일어났다.

• 한국세라믹학회지
• /
• 제33권9호
• /
• pp.1057-1063
• /
• 1996

Y2O3-CeO2-ZrO2 powders were prepared from water-soluble salts using a coprecipitation method. The forming process of oxide and the characteristics of the calcined powders treated in different drying conditions were investigated. The oxidation was occurred at the temperature of around 40$0^{\circ}C$ and the main crystallization of ZrO2 around $600^{\circ}C$. On calcination at $600^{\circ}C$ heating lamp-dried powders consisted of agglomerates of globular morphology with average agglomerate size of 2.27${\mu}{\textrm}{m}$ and specific surface area of 68.3m2/g and spray dried powders contained dense spheric particles with average agglomerate size of 1.35${\mu}{\textrm}{m}$ and specific surface area of 11.0m2/g which exhibited low agglomeration tendency. Removal of the water by a freeze-drying technique produced calcined powders containing flake-like secondary particle structures with wide agglomerate size distri-bution of 0.1-60${\mu}{\textrm}{m}$ and specific surface area of 24.5${\mu}{\textrm}{m}$. The 20 MPa-pressed density (36.8-41.4% T,D) of calcined powders did not nealy depend on drying methods whilst compaction ratio of calcined powders derived from freeze-drying was the highest ( 6.24) among three drying methods. On continuous heating up to 150$0^{\circ}C$ the sinterability of calcined powders derived from heating lamp-drying was superior to those derived from spray-and freeze-drying. The final sintered density of calcined powders was the highest (96% T,D at 150$0^{\circ}C$) in case of heating lamp-drying.

• The Korean Journal of Ceramics
• /
• 제5권1호
• /
• pp.73-77
• /
• 1999

Capsule free hot isostatic pressing (HIPing) of 12 mol% $CeO_2-88 mo% ZrO_2 (12CeO_2-88ZrO_2)$ powder was conducted at 1100~$1200^{\circ}C$ using the powder crystallized in supercritical methanol followed by supercritical drying. Porous $12CeO_2-88ZrO_2$ ceramics with ~35% open porosity, micropore diameter of ~23 nm and a narrow pore size distribution were fabricated by capsule free hot isostatic pressing at $1100^{\circ}C$. The porosity increased with decrease in HIPing temperature and was accompanied by a steady decrease in fracture strength.

• 한국결정성장학회지
• /
• 제1권1호
• /
• pp.5-16
• /
• 1991

희토류 금속 산화물(RE=Ce, Pr, Nd, Eu, Er)을 1wt% 첨가한 큐빅 $ZrO_2(10 mol% Y_2O_3)$단결정을 스컬법으로 육성하였다. 육성된 단결정의 (111) 면에서의 임피던스 분석에 의한 전기적 성질을 조사하였다. 낮은 온도($500^{\circ}C$)에서 온도와 전기전도도와의 관계를 plot하였으며 $약300-400^{\circ}C$ 사이에서 전이를 관찰하였다. 저온 (전이전)과 고온(전이후 $50^{\circ}C$까지)산소 vacancy 이동에 관한 활성화 에너지를 구하였으며 전이로 인한 활성화 에너지의 차이는 안정제로 첨가한 이트륨 이온과 희토류 dopant 그리고 산소 vacancy와의 defect complexes를 붕괴하고 이온전도에 참여하게되는 산소 vacancy 형성에 관한 활성화 에너지로 볼 수 있다. yttria가 첨가됨에 따라, 또 희토류 산화물들의 첨가에 따른 활성화 에너지를 구하였으면 이온전도기구를 논의하였다. 육성된 단결정들은 첨가된 dopantdp 기인하여 Ce은 orang-red, Pr은 golden-yellow, Nd는 lilac, Eu는 옅은 pink, Er은 pink색으로 발현하였으며 가시광선 영역에서 광흡수 결과로서 나타내었다.

• Bulletin of the Korean Chemical Society
• /
• 제31권2호
• /
• pp.470-472
• /
• 2010

• 한국태양에너지학회 논문집
• /
• 제37권2호
• /
• pp.13-22
• /
• 2017

Two-step water splitting thermochemical cycle with $CeO_2/ZrO_2$ foam device was investigated by using a solar simulator composed of 2.5 kW Xe-Arc lamp and mirror reflector. The hydrogen production of $CeO_2/ZrO_2$ foam device depending on heat recovery of Thermal-Reduction step and Water-Decomposition step was analyzed, and the hydrogen production of $CeO_2/ZrO_2$ and $NiFe_2O_4/ZrO_2$ foam devices was compared. Resultantly, the quantity of hydrogen generation increased by 52.02% when the carrier gas of Thermal-Reduction step is preheated to $200^{\circ}C$ and, when the $N_2/steam$ is preheated to $200^{\circ}C$ in the Water-Decomposition step, the quantity of hydrogen generation increased by 35.85%. Therefore, it is important to retrieve the heat from the highly heated gases discharged from each of the reaction spaces in order to increase the reaction temperature of each of the stages and thereby increasing the quantity of hydrogen generated through this.