• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05b
• /
• pp.237-242
• /
• 1998

Zr합금의 수소화 반응속도에 미치는 합금원소의 영향을 평가하기 위하여 Zr과 Zr-0.8Sn-XNb계열(X=0.2, 0.4, 0.8, 1.0) 및 Zr-0.4Nb-YSn계열(Y=0.5, 0.8, 1.5, 2.0)의 3원계 합금으로 electro-microbalance가 장착된 TGA (thermo-gravimetric apparatus)장치를 이용하여 40$0^{\circ}C$에서 1기압 수소와의 반응에 따른 무게증가를 in-situ로 측정하였다 Sn 첨가량이 증가함에 따라 1.5% 까지는 수소반응에 따른 무게증가율이 낮게 나타났으나 Sn을 2.0% 함유한 Zr-0.4Nb-2.0Sn합금의 경우 가장 높게 나타났다. 이는 Sn의 함량이 증가할수록 수소침투에 대한 저항성이 증가함을 의미하지만 Sn이 고용도 이상 함유되면 Sn을 함유한 다량의 석출물이 대량수소침투의 site로 작용하여 수소침투가 가속화된 것으로 평가된다. Nb의 경우 첨가량을 증가시킬수록 무게증가는 크게 나타났는데 이는 Nb이 수소흡수성이 크기 때문이며 Zr-0.8Sn-0.2Nb 및 Zr-0.8Sn-0.4Nb 합금보다 Zr-0.8Sn-0.8Nb 및 Zr-0.8Sn-1.0Nb 합금의 경우 TEM을 이용한 금속간 석출물(intermetallic precipitates) 분석에서 이러한 석출물들의 평균크기 및 개수가 크게 평가되었고, 또한 Zr-0.8Sn-0.2Nb, Zr-0.8Sn-0.4Nb 합금에서는 관찰이 되지 않는 $\beta$-Zr 석출물이 관찰되었다 이러한 사실로부터 Nb의 큰 수소흡수성에 부가적으로 이러한 석출물들이 수소침투를 가속화 하는 데에 기여하는 것으로 여겨진다.

• Journal of Korea Foundry Society
• /
• v.33 no.3
• /
• pp.127-133
• /
• 2013

The influences of a small amount of CaO addition on the microstructure and corrosion behavior of AZ81 casting alloy have been investigated by means of optical microscopy, scanning electron microscopy, X-ray photoelectron spectroscopy, immersion and electrochemical tests. The added CaO led to the refinement of ${\alpha}$-Mg grains and the decrease in ${\beta}$ precipitate content by the formation of an $Al_2Ca$ phase. The AZ81-CaO alloy had a better corrosion resistance than the AZ81 alloy. The microstructural characterization on the corroded surface revealed that the enhanced corrosion resistance of the CaO-containing alloy may well be ascribed to the increased barrier effect of precipitates formed more continuously along the grain boundaries and the incorporation of Al and Ca elements into the corrosion film, by which it became more protective.

• Journal of the Korean Society for Heat Treatment
• /
• v.17 no.5
• /
• pp.299-304
• /
• 2004

Influence of Ca addition on microstructure and room temperature mechanical properties has been studied for AZ31(Mg-3%Al-1%Zn-0.2%Mn)-(0~0.5)%Ca wrought alloys, based on experimental results from metallography, X-ray diffractometry and mechanical tests. Yield strength, ultimate tensile strength and hardness of the alloys increased remarkably with increasing Ca content, whereas elongation was deteriorated continuously. Microstructural examination revealed that Ca addition efficiently refined grains of ${\alpha}$(Mg) phase and that some of the Ca dissolved in ${\beta}(Mg_{17}Al_{12})$ precipitates. The former and the latter facts are thought to be responsible for improved strength and loss of ductility of the AZ31+Ca wrought alloys, respectively.

• Journal of the Korean Society for Heat Treatment
• /
• v.13 no.4
• /
• pp.239-245
• /
• 2000

Effect of tin and iron content on the recrystallization behavior of temary Zr-0.8Sn-x%Nb alloys were studied. The specimens with 0.1, 0.2 and 0.4 wt.% of iron were prepared under various annealing temperatures from $400^{\circ}C$ to $800^{\circ}C$ and times from 30 to 5000 minutes after vacuum arc remelting. The recrystallization behavior was observed using a polarized optical microscope, TEM and micro-vickers hardness tester. The recrystallization temperature of the alloys slightly increased with iron content due to increase of activation energy. The grain growth of the alloys with 0.1 and 0.2 wt.% of iron occured rapidly, however, that of the alloys with 0.4 wt.% iron was gradually retarded due to precipitation. The hardness of the alloy with a high iron slightly increased by the precipitation of beta phase after annealing at $800^{\circ}C$.

• Journal of Korea Foundry Society
• /
• v.19 no.1
• /
• pp.38-46
• /
• 1999

Microstructural characteristics and strengthening behavior in Mg-5wt%Zn-0.6wtZr alloys have been investigated by a combination of optical, secondary electron and transmission electron microscopy, differential thermal analysis, and hardness and tensile, creep property measurements. The result have been compared with those of Mg-5wt%Zn alloys. The as-squeeze cast microstructure consisted of dendrite ${\alpha}-Mg$, interdendrite or intergranular $Mg_7Zn_3$ and fine dispersoids of $ZnZr_2$. The size of secondary solidification phases in Mg-5wt%Zn-0.6wtZr alloys was significantly smaller than that of the Mg-5wt%Zn alloys due to the existence of fine dispersoid of $ZnZr_2$ which also effected the refinement of grain size. TEM study showed that the main cause of age hardening is formation of fine rodlike ${\beta}_1\;'$ precipitates as well as fine $ZnZr_2$ dispersoids. Due to the observed microstructural characteristics mechanical propeties of Mg-5wt%Zn-0.6wtZr alloys was found to be superior to those of Mg-5wt%Zn alloys.

• Journal of Korea Foundry Society
• /
• v.17 no.3
• /
• pp.258-266
• /
• 1997

The purpose of this study is to improve hardness and wear resistance of high strength yellow brass by adding Fe, Cr, Mn, Si and Ni. Results showed that NiO, $FeCr_2O_4$ and intermetallic compound $Mn_5Si_3$ were produced when Ni, Fe-Cr and Mn-Si were added to the yellow brass. The hardness and wear tests showed the best results with the presence of the product precipitates and intermetallic compound. The calculation of relative wear resistance by volume fraction of each phases showed that the relative wear resistance of $Mn_5Si_3$ had the highest value, that of ${\beta}$ phase had the lowest. Observation of the worn surface showed that the main wear mechanism were found to be the abrasive wear, and also showed that the wear is caused by mechanical failure at the early stage.

• Journal of the Korean Society for Heat Treatment
• /
• v.17 no.4
• /
• pp.230-235
• /
• 2004

Present work was carried out to investigate the influence of welded conditions, such as welding current, diameter of welding wire on the microstructural change and mechanical properties of TIG welded joint in AZ31B Mg alloy. It was found that good and sound welded joint was achieved in all welding conditions. The grain size decreased with increasing welding current and decreasing diameter of welding wire. Also, the second phases were homogeneously distributed in the grain and grain boundary as decreasing welding current and diameter of welding wire. The ${\beta}$ discontinuos precipitates were observed in the welded joint, but this microstructure has not been reported by previous researchs in AZ31B Mg alloy. The hardness value is affected by the existence state of the second phase and the hardness of the welded joint region is lower than the other regions in welded AZ31B Mg alloy. The strength of the welded joint region was influenced by the grain size and has more than 90%, compared to that of ASTM standard specification.

• Bulletin of the Korean Chemical Society
• /
• v.15 no.2
• /
• pp.150-153
• /
• 1994

By treating mer, trans-Re(${\equiv}NC_6H_5)(PPh_3)_2Cl_3$, Ⅰ, with 5 atm of CO at room temperature for 52 h, fac-Re(${\equiv}NC_6H_5)(CO)(PPh_3)Cl_3$, Ⅱ, was obtained as dark green precipitates in 81% yield. The crystal structure of Ⅱ was determined through X-ray diffraction. Ⅱ crystallizes in the monoclinic system, space group $P2_1/n$ with cell parameters a=9.740 (2) ${\AA}$, b=16.210 (5) ${\AA}$, c=16.192 (6) ${\AA}$, ${\beta}$=97.50 $(2)^{\circ}$, and Z=4. Least-squares refinement of the structure led to a R$(R_w)$ factor of 0.030 (0.036) for 2878 unique reflections of I>3${\sigma}(I)$ and for 241 variables. In comparison to the starting material Ⅰ, the bond distance of Re-N became longer from 1.726 (6) to 1.736 (5) ${\AA}$ and the bond angle of Re-N-C(Ph) became smaller from 172.6 (6) to 167.0 $(2)^{\circ}$, indicating that the Re-N bond in Ⅱ is weakened and has a less triple-bond character than that in Ⅰ.

• Archives of Pharmacal Research
• /
• v.16 no.1
• /
• pp.36-42
• /
• 1993

To find biologically active components of the higher fungi of Korea, the carpophores of Auricularia polytricha, a well-known edible mushroom, were extracted with 0.14 M NaCl solution. The extract was successively fractionated by adding ammonium sulfate at various concentrations, and the respective precipitates were separated by centrifugation, then dialyzed and freeze-dried. When a does of 60 mg/kg of each was injected i.p. into ICR mice, the fraction which precipitated at 20% ammonium sulfate showed the highest toxicity, killing seven out of seven mice within two days. The fraction obtained at 40% ammonium sulfate showed the second highest toxicity. The two fractions were named auritoxin I and II after the genus name. However, they Nere shown to have nearly identical composition by physicochemical and 6.8% protein. The polysaccharide moiety was found to have 12.3% $\alpha$-linkage and 87.7% $\beta$-linkage and to be a heteromannoglucan consisting of 45.1% glucose, 435 mannose and 11.0% xylose. The protein moiety contained ten amino adids. The molecular weight of the toxin was $1.5\times10^6$ dalton by Sepharose CL-4B gel filtration. The modian lethal doses of auritoxin in mice were 56.4, 157.2 and 454.6 mg/kg by i.p., s.c. and p.o.administrations, respectively. The signs of intrxication were convulsion during the first 30 minutes after the injection, coma or sleeping within an hour, termor, lacrimation, nasal bleeding congestion, and death in 24 hours. Smong the various organs, the spleen was found to be enlarged remarkably. Human platelet aggregation was inhibited by the addition of auritoxin. The activity of malic dehydrogenase in vitro was inhibited by the toxin.

• Clinical and Experimental Pediatrics
• /
• v.61 no.7
• /
• pp.217-220
• /
• 2018

Purpose: Type 1 diabetes mellitus (T1DM) is a chronic and immune-mediated disease, which is characterized by the progressive destruction of pancreatic beta cells. T1DM precipitates in genetically susceptible individuals through environmental factors. In this study, we aimed to evaluate the impact of autoimmunity and intestinal colonization of Candida albicans on the development of T1DM. Methods: Forty-two patients newly diagnosed with T1DM and 42 healthy subjects were included in this monocentric study. The basic and clinical characteristics of the patients were recorded. T1DM-, thyroid-, and celiac-associated antibodies were evaluated. Stool cultures for C. albicans were performed to assess whether or not gut integrity was impaired in patients with T1DM. Results: The evaluation of T1DM- and thyroid-associated antibodies showed that the prevalences of islet cell antibodies and antithyroperoxidase positivity were higher in the study patients than in the patients in the control group. Furthermore, the direct examination and culture of fresh stool samples revealed that 50% of the patients with T1DM and 23.8% of the control subjects had fungi (C. albicans). Conclusion: Through this study, we suggest that the presence of intestinal C. albicans colonization at the time of the diagnosis of T1DM may indicate impairment of normal intestinal microbiota. We also suggest that there may be a tendency of T1DM in patients with a high prevalence of intestinal C. albicans.