Steel and Composite Structures

  • 제45권3호
  • /
  • Pages.389-408
  • /
  • 2022
  • /
  • 1229-9367(pISSN)
  • /
  • 1598-6233(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Residual capacity assessment of post-damaged RC columns exposed to high strain rate loading

  • Abedini, Masoud (Multidisciplinary Center for Infrastructure Engineering, Shenyang University of Technology) ;
  • Zhang, Chunwei (Multidisciplinary Center for Infrastructure Engineering, Shenyang University of Technology)
  • 투고 : 2020.02.14
  • 심사 : 2022.10.24
  • 발행 : 2022.11.10
⟨ 이전 논문 다음 논문 ⟩

초록

Residual capacity is defined as the load carrying capacity of an RC column after undergoing severe damage. Evaluation of residual capacity of RC columns is necessary to avoid damage initiation in RC structures. The central aspect of the current research is to propose an empirical formula to estimate the residual capacity of RC columns after undergoing severe damage. This formula facilitates decision making of whether a replacement or a repair of the damaged column is adequate for further use. Available literature mainly focused on the simulation of explosion loads by using simplified pressure time histories to develop residual capacity of RC columns and rarely simulated the actual explosive. Therefore, there is a gap in the literature concerning general relation between blast damage of columns with different explosive loading conditions for a reliable and quick evaluation of column behavior subjected to blast loading. In this paper, the Arbitrary Lagrangian Eulerian (ALE) technique is implemented to simulate high fidelity blast pressure propagations. LS-DYNA software is utilized to solve the finite element (FE) model. The FE model is validated against the practical blast tests, and outcomes are in good agreement with test results. Multivariate linear regression (MLR) method is utilized to derive an analytical formula. The analytical formula predicts the residual capacity of RC columns as functions of structural element parameters. Based on intensive numerical simulation data, it is found that column depth, longitudinal reinforcement ratio, concrete strength and column width have significant effects on the residual axial load carrying capacity of reinforced concrete column under blast loads. Increasing column depth and longitudinal reinforcement ratio that provides better confinement to concrete are very effective in the residual capacity of RC column subjected to blast loads. Data obtained with this study can broaden the knowledge of structural response to blast and improve FE models to simulate the blast performance of concrete structures.

키워드

과제정보

This research is financially supported by the Ministry of Science and Technology of China (Grant No. 2019YFE0112400), the Department of Science and Technology of Shandong Province (Grant No. 2021CXGC011204), and the State Key Laboratory of Precision Blasting of Jianghan University.

참고문헌

  1. Abedini, M. and Mutalib, A.A. (2020), "Investigation into damage criterion and failure modes of RC structures when subjected to extreme dynamic loads", Archiv. Comput. Meth. Eng., 27(2), 501-515. https://doi.org/10.1007/s11831-019-09317-z.
  2. Abedini, M. and Zhang, C. (2021), "Dynamic performance of concrete columns retrofitted with FRP using segment pressure technique", Compos. Struct., 260, 113473. https://doi.org/10.1016/j.compstruct.2020.113473.
  3. Abedini, M. and Zhang, C. (2021), "Performance assessment of concrete and steel material models in ls-dyna for enhanced numerical simulation, a state of the art review", Archiv. Comput. Meth. Eng., 28(4), 2921-2942. https://doi.org/10.1007/s11831-020-09483-5.
  4. Baaskaran, N., Ponappa, K. and Shankar, S. (2018), "Assessment of dynamic crushing and energy absorption characteristics of thin-walled cylinders due to axial and oblique impact load", Steel Compos. Struct., 28(2), 179-194. https://doi.org/10.12989/scs.2018.28.2.179.
  5. Bao, X. and Li, B. (2010), "Residual strength of blast damaged reinforced concrete columns", Int. J. Impact Eng., 37(3), 295-308. https://doi.org/10.1016/j.ijimpeng.2009.04.003.
  6. Baylot, J.T. and Bevins, T.L. (2007), "Effect of responding and failing structural components on the airblast pressures and loads on and inside of the structure", Comput. Struct., 85(11), 891-910. https://doi.org/10.1016/j.compstruc.2007.01.001.
  7. beton, C. e.-i.d. (1993), CEB-FIP Model Code 1990: Design Code: Telford.
  8. Cai, Y. and Young, B. (2019), "Experimental investigation of carbon steel and stainless steel bolted connections at different strain rates", Steel Compos. Struct., 30(6), 551-565. https://doi.org/10.12989/scs.2019.30.6.551.
  9. Fanning, P. (2001), "Nonlinear models of reinforced and posttensioned concrete beams", Electronic J. Struct. Eng., 1, 111- 119. https://doi.org/10.56748/ejse.1182.
  10. Glanville, W.H., Grime, G., Fox, E.N. and Davies, W.W. (1938), An Investigation of the Stresses in Reinforced Concrete Piles During Driving: HM Stationery Office.
  11. Hou, X., Liu, K., Cao, S. and Rong, Q. (2019), "Factors governing dynamic response of steel-foam ceramic protected RC slabs under blast loads", Steel Compos. Struct., 33(3), 333-346. https://doi.org/10.12989/scs.2019.33.3.333.
  12. Jayasooriya, R., Thambiratnam, D.P., Perera, N.J. and Kosse, V. (2011), "Blast and residual capacity analysis of reinforced concrete framed buildings", Eng. Struct., 33(12), 3483-3495. https://doi.org/10.1016/j.engstruct.2011.07.011.
  13. Kee, J.H., Park, J.Y. and Seong, J.H. (2019), "Effect of one way reinforced concrete slab characteristics on structural response under blast loading", Adv. Concrete Construct., 8(4), 277-283. https://doi.org/10.12989/acc.2019.8.4.277.
  14. LS-DYNA (2015), Keyword User's Manual V971,CA: Livermore Software Technology Corporation(LSTC), Livermore, California.
  15. Luccioni, B.M., Lopez, D.E. and Danesi, R.F. (2005), "Bond-slip in reinforced concrete elements", J. Struct. Eng., 131(11), 1690-1698. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:11(1690)
  16. Malvar, L.J. (1998), "Review of static and dynamic properties of steel reinforcing bars", ACI Mater. J., 95(5).
  17. Mashhadi, J. and Saffari, H. (2017), "Dynamic Increase factor based on residual strength to assess progressive collapse", Steel Compos. Struct., 25(5), 617-624. https://doi.org/10.12989/scs.2017.25.5.617.
  18. Mutalib, A.A. and Hao, H. (2011), "Development of P-I diagrams for FRP strengthened RC columns", Int. J. Impact Eng., 38(5), 290-304. http://dx.doi.org/10.1016/j.ijimpeng.2010.10.029.
  19. Mutalib, A.A., Tawil, N.M., Baharom, S. and Abedini, M. (2013), "Failure probabilities of FRP strengthened RC column to blast loads", Jurnal Teknologi (Sciences and Engineering), 65(2), 135-141. https://doi.org/10.11113/jt.v65.2202.
  20. Rashad, M. and Yang, T. (2018), "Numerical study of steel sandwich plates with RPF and VR cores materials under free air blast loads", Steel Compos. Struct., 27(6), 717-725. https://doi.org/10.12989/scs.2018.27.6.717.
  21. Roller, C., Mayrhofer, C., Riedel, W. and Thoma, K. (2013), "Residual load capacity of exposed and hardened concrete columns under explosion loads", Eng. Struct., 55, 66-72. http://dx.doi.org/10.1016/j.engstruct.2011.12.004.
  22. Shi, Y., Hao, H. and Li, Z.X. (2008), "Numerical derivation of pressure-impulse diagrams for prediction of RC column damage to blast loads", Int. J. Impact Eng., 35(11), 1213-1227. http://dx.doi.org/10.1016/j.ijimpeng.2007.09.001.
  23. Tavarez, F.A. (2001), Simulation of Behavior of Composite Grid Reinforced Concrete Beams Using Explicit Finite Element Methods. University of Wisconsin-Madison.
  24. Wijesundara, L.M. and Clubley, S.K. (2016), "Residual axial capacity of reinforced concrete columns subject to internal building detonations", Int. J. Struct. Stab. Dyn., 16(08), 1550050. https://doi.org/10.1142/S0219455415500509.
  25. Zhang, C. and Abedini, M. (2021), Time-History Blast Response and Failure Mechanism of RC Columns Using Lagrangian Formulation. Paper presented at the Structures.
  26. Zhang, C., Abedini, M. and Mehrmashhadi, J. (2020), "Development of pressure-impulse models and residual capacity assessment of RC columns using high fidelity Arbitrary Lagrangian-Eulerian simulation", Eng. Struct., 224, 111219. https://doi.org/10.1016/j.engstruct.2020.111219.
  27. Zhang, C., Gholipour, G. and Mousavi, A.A. (2019), "Nonlinear dynamic behavior of simply-supported RC beams subjected to combined impact-blast loading", Eng. Struct., 181, 124-142. https://doi.org/10.1016/j.engstruct.2018.12.014.
  28. Zhang, F., Lu, Y., Li, S. and Zhang, W. (2018), "Eccentrically compressive behaviour of RC square short columns reinforced with a new composite method", Steel Compos. Struct., 27(1), 95-108. https://doi.org/10.12989/scs.2018.27.1.095.
  29. Zhao, W., Guo, Q., Dou, X., Zhou, Y. and Ye, Y. (2018), "Impact response of steel-concrete composite panels: Experiments and FE analyses", Steel Compos. Struct., 26(3), 255-263. https://doi.org/10.12989/scs.2018.26.3.255.