Wind and Structures

  • 제35권3호
  • /
  • Pages.147-155
  • /
  • 2022
  • /
  • 1226-6116(pISSN)
  • /
  • 1598-6225(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Wind-lens turbine design for low wind speed

  • Takeyeldein, Mohamed M. (Faculty of Mechanical Engineering, Universiti Teknologi Malaysia) ;
  • Ishak, I.S. (UTM Aerolab, Institute for Vehicle System & Engineering, Universiti Teknologi Malaysia) ;
  • Lazim, Tholudin M. (Faculty of Mechanical Engineering, Universiti Teknologi Malaysia)
  • 투고 : 2021.10.16
  • 심사 : 2022.09.06
  • 발행 : 2022.09.25
⟨ 이전 논문 다음 논문 ⟩

초록

This research proposes a wind-lens turbine design that can startup and operate at a low wind speed (< 5m/s). The performance of the wind-lens turbine was investigated using CFD and wind tunnel testing. The wind-lens turbine consists of a 3-bladed horizontal axis wind turbine with a diameter of 0.6m and a diffuser-shaped shroud that uses the suction side of the thin airfoil SD2030 as a cross-section profile. The performance of the 3-bladed wind-lens turbine was then compared to the two-bladed rotor configuration while keeping the blade geometry the same. The 3-bladed wind-lens turbine successfully startup at 1m/s and produced a torque of 66% higher than the bare turbine, while the two-bladed wind-lens turbine startup at less than 4m/s and produced a torque of 186 % higher than the two-bladed bare turbine at the design point. Findings testify that adding the wind-lens could improve the bare turbine's performance at low wind speed.

키워드

과제정보

The authors are grateful to Universiti Teknologi Malaysia (UTM) for providing valuable technical support to conduct this research project. The authors are also indebted to the UTM-Research University Grant, Tier 2 Vot Number Q.J130000.2651.16J33.

참고문헌

  1. Abdelwaly, M., El-Batsh, H. and Hanna, M.B. (2019), "Numerical study for the flow field and power augmentation in a horizontal axis wind turbine", Sustain. Energy Technol. Assessment., 31, 245-253. https://doi.org/10.1016/j.seta.2018.12.028.
  2. Asl, H.A., Monfared, R.K. and Rad, M. (2017), "Experimental investigation of blade number and design effects for a ducted wind turbine", Renew. Energy, 105, 334-343. https://doi.org/10.1016/j.renene.2016.12.078.
  3. Alanis, A., Franco, J.A., Piedra, S. and Jauregui, J.C. (2021), "A novel high performance diffuser design for small DAWT's by using a blunt trailing edge airfoil", Wind Struct., 32(1), 47-53.
  4. Ali Kadhem, A., Abdul Wahab, N.I. and N. Abdalla, A. (2019), "Wind energy generation assessment at specific sites in a Peninsula in Malaysia based on reliability indices", Processes, 7(7), 399. https://doi.org/10.3390/pr7070399.
  5. Gilbert, B.L., Oman, R.A. and Foreman, K.M. (1978), "Fluid dynamics of diffuser-augmented wind turbines", J. Energy, 2(6), 368-374. https://doi.org/10.2514/3.47988.
  6. Islam, M.R., Saidur, R. and Rahim, N.A. (2011), "Assessment of wind energy potentiality at Kudat and Labuan, Malaysia using Weibull distribution function", Energy, 36(2), 985-992. https://doi.org/10.1016/j.energy.2010.12.011.
  7. Jeong, H., Lee, S. and Kwon, S.D. (2018), "Blockage corrections for wind tunnel tests conducted on a Darrieus wind turbine", J. Wind Eng. Ind. Aerod., 179, 229-239. https://doi.org/10.1016/j.jweia.2018.06.002.
  8. Kadhem, A.A., Abdul Wahab, N.I., Aris, I., Jasni, J. and Abdalla, A.N. (2017), "Advanced wind speed prediction model based on a combination of weibull distribution and an artificial neural network", Energies, 10(11), 1744. https://doi.org/10.3390/en10111744.
  9. Manwell, J.F., McGowan, J.G. and Rogers, A.L. (2009), "Wind energy explained". Wind Energy Explained. https://doi.org/10.1002/9781119994367.
  10. Muhle, F., Adaramola, M.S. and Sretran, L. (2016), "The effect of the number of blades on wind turbine wake-a comparison between 2-and 3-bladed rotors", Journal of Physics: Conference Series, 753(3), 032017. IOP Publishing https://doi.org/10.1088/1742-6596/753/3/032017.
  11. Ohya, Y. (2014), "Bluff body flow and vortex-its application to wind turbines", Fluid Dyn. Res., 46(6), 061423. https://doi.org/10.1088/0169-5983/46/6/061423.
  12. Ohya, Y. and Karasudani, T. (2010), "A shrouded wind turbine generating high output power with wind-lens technology", Energies, 3(4), 634-649. https://doi.org/10.3390/en3040634.
  13. Ohya, Y., Karasudani, T., Nagai, T. and Watanabe, K. (2017), "Wind lens technology and its application to wind and water turbine and beyond", Renew. Energy Environ. Sustain., 2(2). https://doi.org/10.1051/rees/2016022.
  14. Phillips, D.G., Flay, R.G.J. and Nash, T.A. (1999), "Aerodynamic analysis and monitoring of the Vortec 7 diffuser-augmented wind turbine", Transactions of the Institution of Professional Engineers New Zealand: Electrical/Mechanical/Chemical Engineering Section, 26(1), 13-19.
  15. Phillips, D.G., Richards, P.J. and Flay, R.G.J. (2002), "CFD modelling and the development of the diffuser augmented wind turbine", Wind Struct., 5(2_3_4), 267-276. https://doi.org/10.12989/WAS.2002.5.2_3_4.267.
  16. REN21 (2021), Renewables Global Status Report.
  17. Selig, M.S. and McGranahan, B.D. (2004), "Wind tunnel aerodynamic tests of six airfoils for use on small wind turbines", J. Sol. Energy Eng., 126(4), 986-1001. https://doi.org/10.1115/1.1793208
  18. Takahashi, S., Hata, Y., Ohya, Y., Karasudani, T. and Uchida, T. (2012), "Behavior of the blade tip vortices of a wind turbine equipped with a brimmed-diffuser shroud", Energies, 5(12), 5229-5242. http://doi.org/10.3390/en5125229.
  19. Takey, M., Lazim, T.M., Ishak, I.S., Mohd, N.N. and Othman, N. (2020), "Computational investigation of a wind turbine shrouded with a circular ring", CFD Letters, 12(10), 40-51. https://doi.org/10.37934/cfdl.12.10.4051.
  20. Takeyeldein, M.M., Lazim, T.M., Ishak, I.S., Mohd, N. and Ali, E.A. (2020), "Wind lens performance investigation at low wind speed", Evergreen, 7(4), 481-488. https://doi.org/10.5109/4150467
  21. Takeyeldein, M.M., Lazim, T.M., Nik Mohd, N.A.R., Ishak, I.S. and Ali, E.A. (2019), "Wind turbine design using thin airfoil sd2030", https://doi.org/10.5109/2321003.
  22. Toshimitsu, K., Kikugawa, H., Sato, K. and Sato, T. (2012), "Experimental investigation of performance of the wind turbine with the flanged-diffuser shroud in sinusoidally oscillating and fluctuating velocity flows", Open J. Fluid Dyn., 2(04), 215. https://doi.org/10.4236/ojfd.2012.24A024.
  23. Toshimitsu, K., Nishikawa, K., Haruki, W., Oono, S., Takao, M. and Ohya, Y. (2008), "PIV measurements of flows around the wind turbines with a flanged-diffuser shroud", J. Thermal Sci., 17(4), 375-380. https://doi.org/10.1007/s11630-008-0375-4.
  24. Wang, W.X., Matsubara, T., Hu, J., Odahara, S., Nagai, T., Karasutani, T. and Ohya, Y. (2015), "Experimental investigation into the influence of the flanged diffuser on the dynamic behavior of CFRP blade of a shrouded wind turbine", Renew. Energy, 78, 386-397. https://doi.org/10.1016/j.renene.2015.01.028.
  25. Wiriadidjaja, S., Hasim, F., Mansor, S., Asrar, W., Rafie, A.S.M. and Abdullah, E.J. (2012), "Subsonic wind tunnels in Malaysia: A Review", Appl. Mech. Mater., 225, 566-571. https://doi.org/10.4028/www.scientific.net/AMM.225.566