DOI QR코드

DOI QR Code

Dynamic failure features and brittleness evaluation of coal under different confining pressure

  • Liu, Xiaohui (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University) ;
  • Zheng, Yu (Southwest Municipal Engineering Design & Research Institute of China) ;
  • Hao, Qijun (Key Laboratory of Deep Earth Science and Engineering, Sichuan University, Ministry of Education) ;
  • Zhao, Rui (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University) ;
  • Xue, Yang (CHN Energy Dadu River Hydropower Development Co., Ltd) ;
  • Zhang, Zhaopeng (Key Laboratory of Deep Earth Science and Engineering, Sichuan University, Ministry of Education)
  • 투고 : 2020.10.24
  • 심사 : 2022.07.12
  • 발행 : 2022.09.10

초록

To obtain the dynamic mechanical properties, fracture modes, energy and brittleness characteristics of Furong Baijiao coal rock, the dynamic impact compression tests under 0, 4, 8 and 12 MPa confining pressure were carried out using the split Hopkinson pressure bar. The results show that failure mode of coal rock in uniaxial state is axial splitting failure, while it is mainly compression-shear failure with tensile failure in triaxial state. With strain rate and confining pressure increasing, compressive strength and peak strain increase, average fragmentation increases and fractal dimension decreases. Based on energy dissipation theory, the dissipated energy density of coal rock increases gradually with growing confining pressure, but it has little correlation with strain rate. Considering progressive destruction process of coal rock, damage variable was defined as the ratio of dissipated energy density to total absorbed energy density. The maximum damage rate was obtained by deriving damage variable to reflect its maximum failure severity, then a brittleness index BD was established based on the maximum damage rate. BD value declined gradually as confining pressure and strain rate increase, indicating the decrease of brittleness and destruction degree. When confining pressure rises to 12 MPa, brittleness index and average fragmentation gradually stabilize, which shows confining pressure growing cannot cause continuous damage. Finally, integrating dynamic deformation and destruction process of coal rock and according to its final failure characteristics under different confining pressures, BD value is used to classify the brittleness into four grades.

키워드

과제정보

This research was funded by the General project of Sichuan Natural Science Foundation (Grant No: 2022NSFSC0279, 2022NSFSC1009), the Key Scientific Research Fund of Xihua University (Grant No: Z17113), and Graduate Innovation Fund of Xihua University (Grant No: YCJJ2021056).

참고문헌

  1. Afraei, S., Shahriar, K. and Madani, S.H. (2018), "Statistical assessment of rock burst potential and contributions of considered predictor variables in the task", Tunn. Undergr. Space Technol., 72, 250-271. https://doi.org/10.1016/j.tust.2017.10.009.
  2. Al-Salloum, Y., Alsayed, S., Almusallam, T., Ibrahim, S.M. and Abbas, H. (2014), "Investigations on the influence of radial confinement in the impact response of concrete", Comput. Concrete, 14(6), 675-694. https://doi.org/10.12989/cac.2014.14.6.675.
  3. Bernabe, Y. and Revil, A. (1995), "Pore-scale heterogeneity, energy dissipation and the transport properties of rocks", Geophys. Res. Lett., 22(12), 1529-1532. https://doi.org/10.1016/0148-9062(96)85059-5.
  4. Cai, W., Dou, L.M., Han, R.J., Zhang, G.H., and Li, X.W. (2011), "Bursting liability of coal based on damage statistical constitutive model", J. China Coal Soc., 36(S2), 346-352. https://doi.org/10.13225/j.cnki.jccs.2011.s2.029.
  5. Demirdag, S., Tufekci, K., Kayacan, R., Yavuz, H. and Altindag, R. (2010), "Dynamic mechanical behavior of some carbonate rocks", Int. J. Rock Mech. Min. Sci., 47(2), 307-312. https://doi.org/10.1016/j.ijrmms.2009.12.003.
  6. Feng, J.J., Wang, E.Y., Shen, R.X., Chen, L., Li, X.L. and Xu, Z.Y. (2016), "Investigation on energy dissipation and its mechanism of coal under dynamic loads", Geomech. Eng., 11(5), 657-670. https://doi.org/10.12989/gae.2016.11.5.657.
  7. Ghadernejad, S., Nejati, H.R. and Yagiz, S. (2020), "A new rock brittleness index on the basis of punch penetration test data", Geomech. Eng., 21(4), 391-399. https://doi.org/10.12989/gae.2020.21.4.391.
  8. Gong, F.Q., Si, X.F., Li, X.B. and Wang, S.Y. (2019), "Dynamic triaxial compression tests on sandstone at high strain rates and low confining pressures with split Hopkinson pressure bar", Int. J. Rock Mech. Min. Sci., 113, 211-219. https://doi.org/10.1016/j.ijrmms.2018.12.005.
  9. Hu, Q.B., Liang, H.A., Yang, T., Cheng, X.J., Chen, H.K. and Zhang, L.P. (2020), "A new method for rock brittleness evaluation based on statistical damage constitutive relation", J Harbin Inst. Technol., 52(11), 147-156. https://doi.org/10.11918/201906094.
  10. Hucka, V. and Das, B. (1974), "Brittleness determination of rocks by different methods", Int. J. Rock Mech. Min. Sci., 11(10), 389-392. https://doi.org/10.1016/0148-9062(74)91109-7.
  11. Kim, E.H., Garcia, A. and Changani, H. (2018), "Fragmentation and energy absorption characteristics of Red, Berea and Buff sandstones based on different loading rates and water contents", Geomech. Eng., 14(2), 151-159. https://doi.org/10.12989/gae.2018.14.2.151.
  12. Kivi, R.I., Ameri, M. and Molladavoodi, H. (2018), "Shale brittleness evaluation based on energy balance analysis of stress-strain curves", J. Pet. Sci. Eng., 167, 1-19. https://doi.org/10.1016/j.petrol.2018.03.061.
  13. Liu, X.H., Dai, F., Zhang, R. and Liu, J.F. (2015), "Static and dynamic uniaxial compression tests on coal rock considering the bedding directivity", Environ. Earth Sci., 73(10), 5933-5949. https://doi.org/10.1007/s12665-015-4106-3.
  14. Lu, Y.Q., Liu, X.H., Xie, J., He, Z.Q. and Li, C. (2019), "The energy evolution characteristics of coal under different dynamic strain rates and confining pressures", Therm. Sci., 23(3), 1409-1416. https://doi.org/10.2298/tsci180810205l.
  15. Meng, F.Z., Zhou, H., Zhang, C.Q., Xu, R.C. and Lu, J.J. (2015), "Evaluation methodology of brittleness of rock based on post-peak stress-strain curves", Rock Mech. Rock Eng., 48(5), 1787-1805. https://doi.org/10.1007/s00603-014-0694-6.
  16. Moska, R., Kasza, P. and Maslowski, M. (2018), "Rock anisotropy and brittleness from laboratory ultrasonic measurements in the service of hydraulic fracturing", Acta Geodyn. Geomater., 15(1), 67-76. https://doi.org/10.13168/AGG.2018.0005.
  17. Munoz, H., Taheri, A. and Chanda, E.K. (2016), "Fracture energy-based brittleness index development and brittleness quantification by pre-peak strength parameters in rock uniaxial compression", Rock Mech. Rock Eng., 49(12), 4587-4606. https://doi.org/10.1007/s00603-016-1071-4.
  18. Omidvar, M., Iskander, M. and Bless, S. (2012), "Stress-strain behavior of sand at high strain rates", Int. J. Impact Eng., 49, 192-213. https://doi.org/10.1016/j.ijimpeng.2012.03.004.
  19. Ozfirat, M. K., Yenice, H., Simsir, F. and Yarali, O. (2016), "A new approach to rock brittleness and its usability at prediction of drillability". J. Afr. Earth Sci., 119, 94-101. https://doi.org/10.1016/j.jafrearsci.2016.03.017.
  20. Rybacki, E., Meier, T. and Dresen, G. (2016), "What controls the mechanical properties of shale rocks?-Part II: Brittleness", J. Pet. Sci. Eng., 144, 39-58. https://doi.org/10.1016/j.petrol.2016.02.022
  21. Steffler, E.D., Epstein, J.S. and Conley, E.G. (2003), "Energy partitioning for a crack under remote shear and compression", Int. J. Fract., 120(4), 563-580. https://doi.org/10.1023/A:1025511703698.
  22. Ulusay, R. (2015), The ISRM Suggested Methods for Rock Characterization Testing and Monitoring 2007-2014, Springer, Cham., Switzerland.
  23. Wang, J.A. and Park, H.D. (2001), "Comprehensive prediction of rockburst based on analysis of strain energy in rocks", Tunn. Undergr. Space Technol., 16(1), 49-57. https://doi.org/10.1016/S0886-7798(01)00030-X.
  24. Xie, H.P., Wang, J.A. and Qan, P.G. (1996), "Fractal characters of micropore evolution in marbles", Phys. Lett. A., 218(3-6), 275-280. https://doi.org/10.1016/0375-9601(96)00390-8.
  25. Yagiz, S. (2009), "Assessment of brittleness using rock strength and density with punch penetration test", Tunn. Undergr. Space Technol., 24(1), 66-74. https://doi.org/10.1016/j.tust.2008.04.002.
  26. Zhou, C.T., Zhang, K., Wang, H.B., Xu, Y.X. and Afraei, S. (2020), "A plastic strain based statistical damage model for brittle to ductile behaviour of rocks", Geomech. Eng., 21(4), 349-356. https://doi.org/10.12989/gae.2020.21.4.349.