DOI QR코드

DOI QR Code

Inverse system optimal control of interleaved boost converters

  • Xiao, Dongyi (School of Electrical Engineering, Guangxi University) ;
  • Lu, Yimin (School of Electrical Engineering, Guangxi University)
  • Received : 2021.10.17
  • Accepted : 2022.02.27
  • Published : 2022.06.20

Abstract

When compared with the conventional boost converter, the interleaved boost converter (IBC) has the advantages of low current stress. Thus, they have been widely used in DC microgrids. However, the IBC is a multiple input single output (MISO) high-order nonlinear system. To simplify the controller design, a reduced order model of an interleaved boost converter is proposed in this paper. By selecting an appropriate output function, the nonlinear reduced order system is transformed into a pseudo-linear system through the inverse system theory. Then an optimal controller is designed based on the linear quadratic regulator (LQR) theory. As a result, the output voltage can track the reference value. In addition, a current balance controller is designed to balance the interphase inductor current. Simulation results of a 3-phase IBC show that when compared with PI control, the proposed control strategy has better regulation performance. Finally, the correctness and effectiveness of the proposed control strategy are further verified by experiment on 2-phase IBC.

Keywords

Acknowledgement

This work was supported in part by the National Natural Science Foundation of China under Grant 52167021, and in part by the Key Program of Natural Science Foundation of Guangxi Province of China under Grant 2018GXNSFDA281037.

References

  1. Bianchi, M.A., Zurbriggen, I.G., Paz, F., Ordonez, M.: Improving DC microgrid dynamic performance using a fast state-plane-based source-end controller. IEEE Trans. Power Electron. 34(8), 8062-8078 (2019) https://doi.org/10.1109/tpel.2018.2878383
  2. Wu, J., Lu, Y.: Adaptive backstepping sliding mode control for boost converter with constant power load. IEEE Access. 7, 50797-50807 (2019) https://doi.org/10.1109/access.2019.2910936
  3. Jiang, W., Zhang, X., Guo, F., Chen, J., Koh, L.H.: Large-signal stability of interleave boost converter system with constant power load using sliding-mode control. IEEE Trans. Ind. Electron. 67(11), 9450-9458 (2019) https://doi.org/10.1109/tie.2019.2955401
  4. Ma, R., Xu, L., Xie, R., Zhao, D., Gao, F.: Advanced robustness control of DC-DC converter for proton exchange membrane fuel cell applications. IEEE Trans. Ind. Applications. 55(6), 6389-6400 (2019) https://doi.org/10.1109/tia.2019.2935981
  5. Zhuo, S., Gaillard, A., Xu, L., Paire, D., Gao, F.: Extended state observer-based control of DC-DC converters for fuel cell application. IEEE Trans. Power Electron. 35(9), 9923-9932 (2020) https://doi.org/10.1109/TPEL.2020.2974556
  6. Thounthong, P., Mungporn, P., Pierfederici, S., Guilbert, D., Burikham, P.: robust Hamiltonian-energy control based on Lyapunov function for four-phase parallel fuel cell boost converter for DC microgrid applications. IEEE Trans. Sustain. Energy. 12(3), 1500-1510 (2021) https://doi.org/10.1109/TSTE.2021.3050783
  7. Mungporn, P., Shah, Z., Khomfoi, S., Kumam, P., Bizon, N.: Modeling and control of multiphase interleaved fuel-cell boost converter based on Hamiltonian control theory for transportation applications. IEEE Trans. Transp Electrification. 6(2), 519-528 (2020) https://doi.org/10.1109/tte.2020.2980193
  8. Chen, H.C., Lu, C.Y., Rout, U.S.: Decoupled master-slave current balancing control for three-phase interleaved boost converters. IEEE Trans. Power Electron. 33(5), 3683-3687 (2017) https://doi.org/10.1109/tpel.2017.2760887
  9. Roy, J., Ayyanar, R.: Sensor-less current sharing over wide operating range for extended-duty-ratio boost converter. IEEE Trans. Power Electron. 32(11), 8763-8777 (2017) https://doi.org/10.1109/TPEL.2016.2640319
  10. Azer, P., Emadi, A.: Generalized state space average model for multi-phase interleaved buck, boost, and buck-boost DC-DC converters: transient, steady-state and switching dynamics. IEEE Access. 8, 77735-77745 (2020) https://doi.org/10.1109/access.2020.2987277
  11. Dragievi, T., Lu, X., Vasquez, J.C., Guerrero, J.: DC microgrids-part I: a review of control strategies and stabilization techniques. IEEE Trans. Power Electronics. 30(7), 4876-4891 (2016)
  12. Zeng, J., Zhang, Z., Qiao, W.: An interconnection and damping assignment passivity-based controller for a DC-DC boost converter with a constant power load. IEEE Trans. Industry Applicat. 50(4), 2314-2322 (2014) https://doi.org/10.1109/TIA.2013.2290872
  13. Rahimi, A.M., Emadi, A.: Active damping in DC/DC power electronic converters: a novel method to overcome the problems of constant power loads. IEEE Trans. Ind. Electron. 56(5), 1428-1439 (2009) https://doi.org/10.1109/TIE.2009.2013748
  14. Singh, S., Fulwani, D., Kumar, V.: Robust sliding-mode control of dc/dc boost converter feeding a constant power load. IET Power Electron. 8(7), 1230-1237 (2015) https://doi.org/10.1049/iet-pel.2014.0534
  15. Li, C., Fneg, K.: Inverse system method for multivariable nonlinear control. Beijing-Tsinghua Press (1991)
  16. Sun, X., Zhou, S., Long, C., Yang, Z.: Internal model control for a bearingless permanent magnet synchronous motor based on inverse system method. IEEE Trans. Energy Conversion. 31(4), 1539-1548 (2016) https://doi.org/10.1109/TEC.2016.2591925
  17. Fang, J., Ren, Y.: Decoupling control of magnetically suspended rotor system in control moment gyros based on an inverse system method. IEEE Trans. Mechatron. 17(6), 1133-1144 (2012) https://doi.org/10.1109/TMECH.2011.2159618
  18. Lu, Y., Zhu, H., Huang, X., Lorenz, R.: Inverse-system decoupling control of DC/DC converters. Energies 12(1), 179 (2019) https://doi.org/10.3390/en12010179
  19. Wu, J., Lu, Y.: Decoupling and optimal control of multilevel buck DC-DC converters with inverse system theory. IEEE Trans. Ind. Electron. 67(9), 7861-7870 (2019) https://doi.org/10.1109/tie.2019.2942565