DOI QR코드

DOI QR Code

Calibration of flush air data sensing systems for a satellite launch vehicle

  • Mehta, R.C. (Department of Aeronautical Engineering, Noorul Islam Centre for Higher Education)
  • 투고 : 2021.06.25
  • 심사 : 2021.12.10
  • 발행 : 2022.01.25

초록

This paper presents calibration of flush air data sensing systems during ascent period of a satellite launch vehicle. Aerodynamic results are numerically computed by solving three-dimensional time dependent compressible Euler equations over a payload shroud of a satellite launch vehicle. The flush air data system consists of four pressure ports flushed on a blunt-cone section of the payload shroud and connected to on board differential pressure transducers. The inverse algorithm uses calibration charts which are based on computed and measured data. A controlled random search method coupled with neural network technique is employed to estimate pitch and yaw angles from measured transient differential pressure history. The algorithm predicts the flow direction stepwise with the function of flight Mach numbers and can be termed as an online method. Flow direction of the launch vehicle is compared with the reconstructed trajectory data. The estimated values of the flow direction are in good agreement with them.

키워드

참고문헌

  1. An, M.Y., Wang, K.C. and Tam L.T. (1993), "Computation of inviscid flow field around 3-D aerospace vehicles and comparison with experimental and flight data", 31st Aerospace Sciences Meeting, 885. https://doi.org/10.2514/6.1993-885.
  2. Anderson, W., Thomas, J. and van Leer, B. (1986), "A comparison of finite volume flux vector splitting for the Euler equations", AIAA J., 24(9), 1453-1460. https://doi.org/10.2514/3.9465.
  3. Baumann, E., Pahle, J.W., Davis, M.C. and White, J.T. (2010), "X-43a flush air data sensing system flight-test results", J. Spacecraft Rocket., 47(1), 48-61. https://doi.org/10.2514/1.41163.
  4. Bertin, J.J. (2006), Aerodynamics for Engineers, 4 th Edition, Pearson Education in South Asia, New Delhi.
  5. Chen, G., Chen, B., Li, P., Bai, P. and Ji, C. (2015), "Study on algorithms of flush air data sensing system for hypersonic vehicle", Procedia Eng., 99, 860-865. https://doi.org/10.1016/j.proeng.2014.12.613.
  6. Cobleigh, B.R., Whitmore, S.A., Haering, Jr., E.A., Borrer, J. and Roback, V.E. (1999), "Flush air data sensing (FADS) system calibration procedures and results for blunt forebodies", 9th International Space Planes and Hypersonic Systems and Technologies Conference, 4816. https://doi.org/10.2514/6.1999-4816.
  7. Davis, M.C., Pahle, J.W., Marshall, L.A., Mashburn, M.J. and Franks, R. (2000), "Development of a flush air data sensing system on a sharp-nosed vehicle for flight at Mach 3 to 8", Aerospace Sciences Meeting and Exhibit, 504. https://doi.org/10.2514/6.2000-504.
  8. Fan, H.Y., Lu, W., Xi., G. and Wang, S. (2003), "An improved neural network based calibration method for aerodynamic pressure probes", J. Fluid. Eng., 125(1), 113-120 https://doi.org/10.1115/1.1523063.
  9. Haykin, S. (2005), Neural Networks, Pearson Prentice Hall, New Delhi, India
  10. Hillje, E.R. and Nelson, R.L. (1983), "Ascent air data system results from the space shuttle flight test program", AIAA Paper, 1980. AIAA-80-0422. https://doi.org/10.2514/6.1981-2457.
  11. Johnston, I.A., Tuttle, S.L., Jacobs, P.A. and Shimoda, T. (1999), "The numerical and experimental simulation of hypervelocity flow around the HYFLEX vehicle forebody", Shock Wav., 9, 57-67. https://doi.org/10.1007/s001930050139.
  12. Karlgaard, C.D., Kutty, P. and Schoenenberger, M. (2017), "coupled inertial navigation and flush air data sensing algorithm for atmosphere estimation", J. Spacecraft Rocket., 54(1), 128-140. https://doi.org/10.2514/1.A33331.
  13. Larson, T.J., Moes, T.R. and Siemers III, P.M. (1990), "Wind-tunnel investigation of a flush airdata system at Mach numbers from 0.7 to 1,4", NASA TM 101697, NASA Ames Research Centre California, USA.
  14. Liepmann, H.W. and Roshko, A. (2007), Elements of Gas Dynamics, First South Asian Edition, Dover Publications, Inc., printed at Gopsons Papers LTD, Noida, India.
  15. Liou, M.S. (2006), "A sequel to AUSM, Part II: AUSM+-up for all speeds", J. Comput. Phys., 214(1), 137-170. https://doi.org/10.1016/j.jcp.2005.09.020.
  16. Liu, Y., Xiao, D. and Lu, Y. (2014), "Comparative study on a solving model and algorithm for a flush air data sensing system", Sensor., 14(5), 9210-9226. https://doi.org/10.3390/s140509210.
  17. Mehta, R.C. (2020a), "Drag reduction for payload fairing of satellite launch vehicle with aerospike in transonic and low supersonic speeds", Adv. Aircraft Spacecraft Sci., 7(4), 371-385 https://doi.org/10.12989/aas.2020.7.4.371.
  18. Mehta, R.C. (2017b), "Analysis of payload compartment venting of satellite launch vehicle", Adv. Aircraft Spacecraft Sci., 4(4), 437-448. https://doi.org/10.12989/aas.2017.4.4.437.
  19. Mehta, R.C. (2017c), "Multi-block structured grid generation method for computational fluid dynamics", Scholar. J. Eng. Technol., 5(8), 387-393. https://doi.org/10.21276/sjet.
  20. Mehta, R.C. and Tiwari, S.B. (2017), "Controlled random search technique for estimation of convective heat transfer coefficient", Heat Mass Transf., 43(11) 1171-1177. https://doi.org/10.1007/s00231-006-0185-8.
  21. Paces, P., Draxler, K., Hanzal, V., Censky, T. and Vasko, O. (2010), "A combined angle of attack and angle of sideslip smart probe with twin differential sensor modules and doubled output signal", SENSORS, 2010 IEEE, 284-289. https://doi.org/10.1109/ICSENS.2010.5689866.
  22. Price, A. (2010), "A controlled random search procedure for global optimization", Comput. J., 26(4), 367-370. https://doi.org/10.1093/comjnl/20.4.367.
  23. Quindlen, J.F. and Langelaan, J.W. (2013), "Flush air data sensing for soaring-capable UAVs", 51st AIAA Aerospace Sciences Meeting including the New Horizons Forum and Aerospace Exposition, 1153. https://doi.org/10.2514/6.2013-1153.
  24. Reis, C.J.B., Manzanares-Filho, N. and de Lima, A.M.G. (2019), "Robust optimization of aerodynamic loadings for airfoil inverse designs", J. Brazil Soc. Mech. Sci. Eng., 41, 207. https://doi.org/10.1007/s40430-019-1705-z.
  25. Rohlf, D., Brieger, O. and Grohs, T. (2004), "X-31 vector system identification-approach and results", AIAA Atmospheric Flight Mechanics Conference and Exhibit, 4830. https://doi.org/10.2514/6.2004-4830.
  26. Rohloff, T.J., Whitmore, S.A. and Catton, I. (1998), "Air data sensing from surface pressure measurements using a neural network method", AIAA J., 36(11), 2094-2101. https://doi.org/10.2514/2.312.
  27. Rosemount Model (1984), Aerospace Division, Rosemount Inc., Burnsville, Minnesota, USA.
  28. Samy, I., Postlethwaite, I., Gu, D.W. and Green, J. (2010), "Neural-Network-Based flush air data sensing system demonstrated on a Mini Air Vehicle", J. Aircraft, 47(1), 18-31. https://doi.org/10.2514/1.44157.
  29. Shevchenko, A.M. and Shmakov, A.S. (2017), "Multi-hole pressure probes to wind tunnel experiments and air data systems", AIP Conference Proceedings, 1893(1), 030088. https://doi.org/10.1063/1.5007546.
  30. Srivastava, A. and Meade, A.J. (2015), "A comprehensive probabilistic framework to learn air data from surface pressure measurements", Int. J. Aerosp. Eng., 1-19, Article ID 183712. http://doi.org/10.1155/2015/183712.
  31. Watanabe, S., Ishimoto, S. and Yamamoto. Y. (1997), "Aerodynamic characteristics evaluation of hypersonic flight experiment vehicle based on flight data", J. Spacecraft Rocket., 34(4), 464-470. https://doi.org/10.2514/2.3259.
  32. Whitmore, S.A., Cobleigh, B.R. and Haering, E.A. (1998), "Design and calibration of the X-33 Flush Airdata Sensing (FADS) system", NASA TM 206540, NASA Dryden Flight Research Centre, California, USA.