DOI QR코드

DOI QR Code

Mechanical behaviour of composite columns composed of RAC-filled square steel tube and profile steel under eccentric compression loads

  • Ma, Hui (School of Civil Engineering and Architecture, Xi'an University of Technology) ;
  • Xi, Jiacheng (School of Civil Engineering and Architecture, Xi'an University of Technology) ;
  • Zhao, Yaoli (Research and Design Institute of water conservancy and hydropower, Xi'an University of Technology) ;
  • Dong, Jikun (School of Civil Engineering and Architecture, Xi'an University of Technology)
  • 투고 : 2019.03.01
  • 심사 : 2020.12.09
  • 발행 : 2021.01.10

초록

This research examines the eccentric compression performance of composite columns composed of recycled aggregate concrete (RAC)-filled square steel tube and profile steel. A total of 17 specimens on the composite columns with different recycled coarse aggregate (RCA) replacement percentage, RAC strength, width to thickness ratio of square steel tube, profile steel ratio, eccentricity and slenderness ratio were subjected to eccentric compression tests. The failure process and characteristic of specimens under eccentric compression loading were observed in detail. The load-lateral deflection curves, load-train curves and strain distribution on the cross section of the composite columns were also obtained and described on the basis of test data. Results corroborate that the failure characteristics and modes of the specimens with different design parameters were basically similar under eccentric compression loads. The compression side of square steel tube yields first, followed by the compression side of profile steel. Finally, the RAC in the columns was crushed and the apparent local bulging of square steel tube was also observed, which meant that the composite column was damaged and failed. The composite columns under eccentric compression loading suffered from typical bending failure. Moreover, the eccentric bearing capacity and deformation of the specimens decreased as the RCA replacement percentage and width to thickness ratio of square steel tube increased, respectively. Slenderness ratio and eccentricity had a significantly adverse effect on the eccentric compression performance of composite columns. But overall, the composite columns generally had high-bearing capacity and good deformation. Meanwhile, the mechanism of the composite columns under eccentric compression loads was also analysed in detail, and the calculation formulas on the eccentric compression capacity of composite columns were proposed via the limit equilibrium analysis method. The calculation results of the eccentric compression capacity of columns are consistent with the test results, which verify the validity of the formulas, and the conclusions can serve as references for the engineering application of this kind of composite columns.

키워드

과제정보

The research was financially supported by National Natural Science Foundation of China P.R. (No. 5140848), The Project Supported by Natural Science Basic Research Plan in Shaanxi Province of China (No. 2019JM-193), the Plan Projects of the Department of Housing and Urban-rural Development in Shaanxi Province of China (No. 2015-K129), which is gratefully acknowledged.

참고문헌

  1. Akhtar, A. and Sarmah, A.K. (2018), "Construction and demolition waste generation and properties of recycled aggregate concrete: a global perspective", J. Cleaner Production, 186(6), 262-281. https://doi.org/10.1016/j.jclepro.2018.03.085.
  2. Al-Eliwi, B.J., Ekmekyapar, T., Al-Samaraie, M.I. and Dogru, M.H. (2018), "Behavior of reinforced lightweight aggregate concrete-filled circular steel tube columns under axial loading", Structures. 16(11), 101-111. https://doi.org/10.1016/j.istruc.2018.09.001.
  3. Chen, J., Wang, Y.Y, Roeder, C.W. and Ma, J. (2017), "Behavior of normal-strength recycled aggregate concrete filled steel tubes under combined loading", Eng. Struct., 130(1), 23-40. https://doi.org/10.1016/j.engstruct.2016.09.046.
  4. De Brito, J., Ferreira, J., Pacheco, J., Soares, D. and Guerreiro, M. (2016), "Structural, material, mechanical and durability properties and behaviour of recycled aggregates concrete", J. Build. Eng., 6(6), 1-16. https://doi.org/10.1016/j.jobe.2016.02.003.
  5. Denavit, M.D., Hajjar, J.F., Perea, T. and Leon, R.T. (2018), "Elastic flexural rigidity of steel-concrete composite columns", Eng. Struct., 160(4), 293-303. https://doi.org/10.1016/j.engstruct.2018.01.044.
  6. Ekmekyapar, T. and Al-Eliwi, B.J. (2016), "Experimental behaviour of circular concrete filled steel tube columns and design specifications", Thin-Wall. Struct., 105(8), 220-230. https://doi.org/10.1016/j.tws.2016.04.004.
  7. El-Heweity, M.M. (2012), "On the performance of circular concrete-filled high strength steel columns under axial loading" Alexandria Eng. J., 51(2), 109-119. https://doi.org/10.1016/j.aej.2012.05.006.
  8. Elzien, A., Ji, B., Fu, Z. and Hu, Z. (2011), "The behavior of lightweight aggregate concrete filled steel tube columns under eccentric loading", Steel Compos. Struct., 11(6), 469-488. https://doi.org/10.12989/scs.2011.11.6.469.
  9. Fang, L., Zhang, B., Jin, G.F., Li, K.W. and Wang, Z.L. (2015), "Seismic behavior of concrete-encased steel cross-shaped columns", J. Constr. Steel Res., 109(6), 24-33. https://doi.org/10.1016/j.jcsr.2015.03.001.
  10. GB50010 (2015), Chinese Standard. Code for design of concrete structures. China Building Industry Press, Beijing, China.
  11. Han, L.H. (2000), Concrete filled steel tube structures-theory and practice (Second Edition), Science Press, Beijing, China.
  12. Ibanez, C., Romero, M.L., Espinos, A., Portoles, J.M. and Albero, V. (2017), "Ultra-high strength concrete on eccentrically loaded slender circular concrete-filled dual steel columns", Structures, 12(11), 64-74. https://doi.org/10.1016/j.istruc.2017.07.005.
  13. Johansson, M. and Gylltoft, K. (2001), "Structural behavior of slender circular steel-concrete composite columns under various means of load application", Steel Compos. Struct., 1(4), 393-410. https://doi.org/10.12989/scs.2001.1.4.393.
  14. Kadhim, I.T. and Guneyisi, E.M. (2018), "Code based assessment of load capacity of steel tubular columns infilled with recycled aggregate concrete under compression", Constr. Build. Mater., 168(4), 715-731. https://doi.org/10.1016/j.conbuildmat.2018.02.088.
  15. Katkhuda (2017), "Improving the mechanical properties of recycled concrete aggregate using chopped basalt fibers and acid treatment", Constr. Build. Mater., 140(6), 328-335. https://doi.org/10.1016/j.conbuildmat.2017.02.128.
  16. Katkhuda, H. and Shatarat, N. (2018), "Code based assessment of load capacity of steel tubular columns infilled with recycled aggregate concrete under compression", Constr. Build. Mater., 168(4), 715-731. https://doi.org/10.1016/j.conbuildmat.2018.02.088.
  17. Lacki, P., Derlatka, A. and Kasza, P. (2018), "Comparison of steel-concrete composite column and steel column", Compos. Struct., 202(10), 82-88. https://doi.org/10.1016/j.compstruct.2017.11.055.
  18. Liu, Y., Zha, X. and Gong, G. (2012), "Study on recycled-concrete-filled steel tube and recycled concrete based on damage mechanics", J. Constr. Steel Res., 71(4), 143-148. https://doi.org/10.1016/j.jcsr.2011.10.023.
  19. Ma, H., Dong, J., Hu, G.B. and Liu, Y.H. (2019) "Axial compression performance of composite short columns composed of RAC-filled square steel tube and profile steel", J. Constr. Steel Res., 153(2), 416-430. https://doi.org/10.1016/j.jcsr.2018.10.018.
  20. Ma, H., Xue, J.Y., Liu, Y.H. and Dong, J. (2016), "Numerical analysis and horizontal bearing capacity of steel reinforced recycled concrete columns", Steel Compos. Struct., 22(4), 797-820. https://doi.org/10.12989/scs.2016.22.4.797.
  21. Ma, H., Xue, J.Y., Liu, Y.H. and Zhang, X.C. (2015), "Cyclic loading tests and shear strength of steel reinforced recycled concrete short columns", Eng. Struct., 92(6), 55-68. https://doi.org/10.1016/j.engstruct.2015.03.009.
  22. Omrane, M., Kenai, S., Kadri, E.H. and Aït-Mokhtar, A. (2017), "Performance and durability of self-compacting concrete using recycled concrete aggregates and natural pozzolan", J. Cleaner Production, 165(11), 415-430. https://doi.org/10.1016/j.jclepro.2017.07.139.
  23. Silva, R.V., De Brito, J. and Dhir, R.K. (2014), "Properties and composition of recycled aggregates from construction and demolition waste suitable for concrete production", Constr. Build. Mater., 65(6), 201-217. https://doi.org/10.1016/j.conbuildmat.2014.04.117.
  24. Tailor, A., Dalal, S.P. and Desai, A.K. (2017), "Comparative performance evaluation of steel column building and concrete filled tube column building under static and dynamic loading" Jordan J. Civil Eng., 11(2), 1847-1853. https://doi.org/10.1016/j.proeng.2016.12.233.
  25. Tam, V.W., Soomro, M., and Evangelista, A.C.J. (2018), "A review of recycled aggregate in concrete applications (2000-2017)", Constr. Build. Mater., 172(5), 272-292. https://doi.org/10.1016/j.conbuildmat.2018.03.240.
  26. Tam, V.W.Y., Tam, C.M. and Wang, Y. (2007), "Optimization on proportion for recycled aggregate in concrete using two-stage mixing approach", Constr. Build. Mater., 21(10), 1928-1939. https://doi.org/10.1016/j.conbuildmat.2006.05.040.
  27. Tang, Y.C., Li, L.J., Feng, W.X., Liu, F. and Zhu, M. (2018), "Study of seismic behavior of recycled aggregate concrete-filled steel tubular columns", J. Constr. Steel Res., 148(9), 1-15. https://doi.org/10.1016/j.jcsr.2018.04.031.
  28. Tokgoz, S. (2015), "Tests on plain and steel fiber concrete-filled stainless-steel tubular columns", J. Constr. Steel Res., 114(11), 129-135. https://doi.org/10.1016/j.jcsr.2015.07.013.
  29. Verian, K.P., Ashraf, W. and Cao, Y.Z. (2018), "Properties of recycled concrete aggregate and their influence in new concrete production", Resources, Conservation and Recycling, 133(6), 30-49. https://doi.org/10.1016/j.resconrec.2018.02.005.
  30. Wijayasundara, M., Mendis, P. and Crawford, R.H. (2018), "Integrated assessment of the use of recycled concrete aggregate replacing natural aggregate in structural concrete", J. Cleaner Production, 174(2), 591-604. https://doi.org/10.1016/j.jclepro.2017.10.301.
  31. Wijayasundara, M., Mendis, P. and Crawford, R.H. (2018), "Net incremental indirect external benefit of manufacturing recycled aggregate concrete", Waste Management, 78(8), 279-291. https://doi.org/10.1016/j.wasman.2018.02.042.
  32. Xiao, J.Z., Huang, Y.J., Yang, J. and Zhang, C. (2012), "Mechanical properties of confined recycled aggregate concrete under axial compression", Constr. Build. Mater., 26(1), 591-603. https://doi.org/10.1016/j.conbuildmat.2011.06.062.
  33. Xiao, J.Z., Li, W.G., Fan, Y.H. and Huang, X. (2012), "An overview of study on recycled aggregate concrete in China (1996-2011)", Constr. Build. Mater., 31(6), 364-383. https://doi.org/10.1016/j.conbuildmat.2011.12.074.
  34. Xie, T.Y., Gholampour, A. and Ozbakkaloglu, T. (2018), "Toward the development of sustainable concretes with recycled concrete aggregates: comprehensive review of studies on mechanical properties", J. Mater. Civil Eng., 30(9), 04018211. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002304.
  35. Xue, J.Y., Chen, Z.P., Zhao, H.T., Gao, L. and Liu, Z.Q. (2012), "Shear mechanism and bearing capacity calculation on steel reinforced concrete special-shaped columns", Steel Compos. Struct., 13(5), 473-487. https://doi.org/10.12989/scs.2012.13.5.473.
  36. Zheng, C.C., Lou, C., Du, G., Li, X.Z., Liu, Z.W. and Li, L.Q. (2018), "Mechanical properties of recycled concrete with demolished waste concrete aggregate and clay brick aggregate", Results in Phys., 9(6), 1317-1322. https://doi.org/10.1016/j.rinp.2018.04.061.