DOI QR코드

DOI QR Code

Seismic behavior of non-seismically designed eccentric reinforced concrete beam-column joints

  • Liu, Ying (Faculty of Science and Technology, Technological and Higher Education Institute of Hong Kong) ;
  • Wong, Simon H.F. (Faculty of Science and Technology, Technological and Higher Education Institute of Hong Kong) ;
  • Zhang, Hexin (School of Engineering and The Built Environment, Edinburgh Napier University Edinburgh) ;
  • Kuang, J.S. (Department of Civil and Environmental Engineering, The Hong Kong University of Science and Technology) ;
  • Lee, Pokman (Faculty of Science and Technology, Technological and Higher Education Institute of Hong Kong) ;
  • Kwong, Winghei (Faculty of Science and Technology, Technological and Higher Education Institute of Hong Kong)
  • 투고 : 2021.06.16
  • 심사 : 2021.08.18
  • 발행 : 2021.12.25

초록

Non-seismically designed eccentric reinforced concrete beam-column joints were extensively used in existing reinforced concrete frame buildings, which were found to be vulnerable to seismic action in many incidences. To provide a fundamental understanding of the seismic performance and failure mechanism of the joints, three 2/3-scale exterior beam-column joints with non-seismically designed details were cast and tested under reversed cyclic loads simulating earthquake excitation. In this investigation, particular emphasis was given on the effects of the eccentricity between the centerlines of the beam and the column. It is shown that the eccentricity had significant effects on the damage characteristics, shear strength, and displacement ductility of the specimens. In addition, shear deformation and the strain of joint hoops were found to concentrate on the eccentric face of the joint. The results demonstrated that the specimen with an eccentricity of 1/4 column width failed in a brittle manner with premature joint shear failure, while the other specimens with less or no eccentricity failed in a ductile manner with joint shear failure after beam flexural yielding. Test results are compared with those predicted by three seismic design codes and two non-seismic design codes. In general, the codes do not accurately predict the shear strength of the eccentric joints with non-seismic details.

키워드

과제정보

The work described in this paper was fully supported by a grant from the Research Grants Council of the Hong Kong Special Administrative Region, China (Project No. UGC/FDS25/E08/17).

참고문헌

  1. ACI (2014), Building Code Requirements for Structural Concrete, American Concrete Institute, Farmington Hills, MI, USA.
  2. Al-Osta, M.A., Khan, M.I., Bahraq, A.A. and Xu, S.Y. (2020), "Application of ultra-high performance fiber reinforced concrete for retrofitting the damaged exterior reinforced concrete beam-column joints", Earthq. Struct., 19(5), 361-377. http://doi.org/10.12989/eas.2020.19.5.361.
  3. Basha, A.M. and Fayed, S. (2019), "Behavior of RC eccentric corner beam-column joint under cyclic loading: an experimental work", Civil Eng. J., 5(2), 295-308. https://doi.org/10.28991/cej-2019-03091245.
  4. Building Department (2013), Code of Practice for Structural Use of Concrete 2013, Building Department, Mongkok, Kowloon, Hong Kong.
  5. Choi, K.K., Dinh, N.H. and Kim, J.C. (2017), "Behaviour of non-seismic detailed reinforced-concrete beam-column connections", P. I. Civil Eng-Struct. B., 170(SB7), 504-520. https://doi.org/10.1680/jstbu.16.00201.
  6. EERI (1991), The Newcastle, Australia Earthquake, Earthquake Engineering Field Investigation Team, Institution of Structural Engineers, UK.
  7. EERI (Earthquake Engineering Research Institute) (2001), "Chi-Chi, Taiwan, Earthquake of September 21, 1999", Report No. 02/2001, Earthquake Engineering Research Institute, Oakland, America.
  8. Eurocode (2013), Design of Structures for Earthquake Resistance-Part 1: General Rules, Seismic Actions and Rules for Buildings, European Committee for Standardization, Brussels, Belgium.
  9. Eurocode (2014), Design of Concrete Structures-Part1-1: General Rules and Rules for Buildings, European Committee for Standardization, Brussels, Belgium.
  10. GEO (Geotechnical Engineering Office) (2015), "Seismicity of Hong Kong (GEO information Note 08/2015)", 1-5.
  11. Hakuto, S., Park, R. and Tanaka, H. (2000), "Seismic load tests on interior and exterior beam-column joints with substandard reinforcing details", ACI Struct. J., 97(1), 11-25. https://doi.org/10.14359/829.
  12. Halahla, A.M., Rahman, M.K., Al-Gadhib, A.H., Al-Osta, M.A. and Baluch, M.H. (2019), "Experimental investigations and FE simulation of exterior BCJs retrofitted with CFRP fabric", Earthq. Struct., 17(4), 337-354. http://doi.org/10.12989/eas.2019.17.4.337.
  13. Kaplan, H., Bilgin, H., Yilmaz, S., Binici, H. and Oztas, A. (2010), "Structural damages of L'Aquila (Italy) earthquake", Nat. Hazard. Earth Syst. Sci., 10(3), 499-507. https://doi.org/10.5194/nhess-10-499-2010.
  14. Karayannis, C.G. and Golias, E. (2021), "Strengthening of deficient RC joints with diagonally placed external C-FRP ropes", Earthq. Struct., 20(1), 123-132. http://doi.org/10.12989/eas.2021.20.1.123.
  15. Kuang, J.S. and Wong, H.F. (2006), "Effects of beam bar anchorage on beam-column joint behaviour", P. I. Civil Eng-Struct. B., 159(2), 115-124. https://doi.org/10.1680/stbu.2006.159.2.115.
  16. Kuang, J.S. and Wong, H.F. (2013), "Horizontal hoops in non-seismically designed beam column joints", HKIE Tran., 20(3), 164-171. https://doi.org/10.1080/1023697x.2013.812388.
  17. Kwon, G.J., Park, J.W., Yoon, S.G., Kim, T.J. and Lee, J.Y. (2012), "Behavior of reinforced concrete inclined column-beam joints", J. Korea Concrete Inst., 24(2), 147-156. https://doi.org/10.4334/JKCI.2012.24.2.147.
  18. Lee, H.J. and Ko, J.W. (2007), "Eccentric reinforced concrete beam-column connections subjected to cyclic loading in principal directions", ACI Struct. J., 104(4), 459-467. https://doi.org/10.14359/18776.
  19. Lee, J.Y., Kim, J.Y. and Oh, G.J. (2009), "Strength deterioration of reinforced concrete beam-column joints subjected to cyclic loading", Eng. Struct., 31(9), 2070-2085. https://doi.org/10.1016/j.engstruct.2009.03.009.
  20. Marthong, C. (2019), "Behavior of repaired RAC beam-column joints using steel welded wire mesh jacketed with cement mortar", Adv. Concrete Constr., 8(2), 91-100. http://doi.org/10.12989/acc.2019.8.2.091.
  21. Mirzabagheri, S., Tasnimi, A.A. and Issa, F. (2018), "Experimental and numerical study of RC interior wide beam-column joints subjected to lateral load", Can. J. Civil Eng., 45(11), 947-957. https://doi.org/10.1139/cjce-2018-0049.
  22. Moehle, J.P. and Mahin, S.A. (1991), "Observations on the behavior of reinforced concrete buildings during earthquakes", ACI Spec. Publ., 127, 67-90,
  23. Mogili, S., Kuang, J.S. and Huang, Y.C (2019), "Effects of beam-column geometry and eccentricity on seismic behaviour of RC beam-column knee joints", Bull. Earthq. Eng., 19(5), 2671-2686. https://doi.org/10.1007/s10518-019-00562-y.
  24. Oinam, R.M., Kumar, P.C.A. and Sahoo, D.R. (2019), "Cyclic performance of steel fiber-reinforced concrete exterior beam-column joints", Earthq. Struct., 16(5), 533-546. http://doi.org/10.12989/eas.2019.16.5.533.
  25. Park, R. (1997), "A static force-based procedure for the seismic assessment of existing reinforced concrete moment resisting frame", Bull. N.Z. Nat. Sci. Earthq. Eng., 30(3), 213-226. https://doi.org/10.5459/bnzsee.30.3.213-226.
  26. Park, R. and Paulay, T. (1975), Reinforced Concrete Structures, John Wiley and Sons, Inc., New York, USA.
  27. Parker, D.E. and Bullman, P.J.M. (1997), "Shear strength within reinforced concrete beam-column joints", Struct. Eng., 75(4), 53-57.
  28. Raj, S.D., Ganesan, N. and Abraham, R. (2020), "Role of fibers on the performance of geopolymer concrete exterior beam column joints", Adv. Concrete Constr., 9(2), 115-123. http://doi.org/10.12989/acc.2020.9.2.115.
  29. Standards New Zealand (2017), Concrete Structure Standard-Incorporating Amendment No. 1, 2, and 3, Standards New Zealand, Wellington, New Zealand.
  30. Vanlalruata, J. and Marthong, C. (2021), "Behaviour of RC beam-column joint with varying location of construction joints in the column", Earthq. Struct., 20(1), 29-38. http://doi.org/10.12989/eas.2021.20.1.029.
  31. Zhang, L. and Jirsa, J.O. (1982), "A study of shear behaviour of reinforced concrete beam-column joints", PMFSEL Report No. 82-1, Department of Civil Engineering, University of Texas at Austin, Austin, USA.