DOI QR코드

DOI QR Code

Experimental Study on Effect of Water-based Iron(III) Oxide Nanofluid on Minimum Film Boiling Point During Quenching of Highly Heated Test Specimen

고온 시편의 급랭 시 산화철 나노유체가 최소막비등점에 미치는 영향에 대한 실험적 연구

  • Jeong, Chan Seok (Division of Architectural and Fire Protection Engineering, Pukyong National University) ;
  • Hwang, Gyeong Seop (Division of Architectural and Fire Protection Engineering, Pukyong National University) ;
  • Lee, Chi Young (Department of Fire Protection Engineering & Division of Architectural and Fire Protection Engineering, Pukyong National University)
  • 정찬석 (부경대학교 건축.소방공학부) ;
  • 황경섭 (부경대학교 건축.소방공학부) ;
  • 이치영 (부경대학교 소방공학과)
  • Received : 2020.07.14
  • Accepted : 2020.08.21
  • Published : 2020.10.31

Abstract

In the present experimental study, the effect of water-based iron(III) oxide nanofluid on the MFB(Minimum Film Boiling) point during quenching was investigated. As the highly heated test specimen, the cylindrical stainless steel rod was used, and as the test fluids, the water-based iron(III) oxide nanofluids of 0.001 and 0.01 vol% concentrations were prepared with the pure water. To examine the effect of location in the test specimen, the thermocouples were installed at the bottom and middle of wall, and center in the test specimen. Through a series of experiments, the experimental data about the influences of nanofluid concentrations, the number of repeated experiments, and locations in the test specimen on the reaching time to MFB point, MFBT(Minimum Film Boiling Temperature), and MHF(Minimum Heat Flux) were obtained. As a result, with increasing the concentration of nanofluid and the number of repeated experiments, the reaching time to MFB point was reduced, but the MFBT and MHF were increased. In addition, it was found that the effect of water-based iron(III) oxide nanofluid on the MFB point at the bottom of wall in the test specimen was observed to be greater than that at the middle of wall and center. In the present experimental ranges, as compared with the pure water, the water-based iron(III) oxide nanofluid showed that the maximum reduction of reaching time to MFB point was about 53.6%, and the maximum enhancements of MFBT and MHF were about 31.1% and 73.4%, respectively.

Keywords

References

  1. S. Yao and Z. Teng, "Effect of Nanofluids on Boiling Heat Transfer Performance", Appl. Sci., Vol. 9, No. 14, 2818, 2019. https://doi.org/10.3390/app9142818
  2. G. Liang and I. Mudawar, "Review of Pool Boiling Enhancement with Additives and Nanofluids", Int. J. Heat Mass Transfer, Vol. 124, pp. 423-453, 2018. https://doi.org/10.1016/j.ijheatmasstransfer.2018.03.046
  3. J. Barber, D. Brutin and L. Tadrist, "A Review on Boiling Heat Transfer Enhancement with Nanofluids", Nanoscale Res. Lett., Vol. 280, pp. 1-16, 2011.
  4. J. Buongiorno and L. W. Hu, "Nanofluid Heat Transfer Enhancement for Nuclear Reactor Applications", Proceedings of the ASME 2009 2nd Micro/Nanoscale Heat & Mass Transfer International Conference, 2009.
  5. H. H. Khoshmehr, A. Saboonchi and M. B. Shafii, "The Quenching of Silver Rod in Boiling Carbon Nano Tube-water Nanofluid", Int. J. Therm. Sci., Vol. 75, pp. 95-104, 2014. https://doi.org/10.1016/j.ijthermalsci.2013.07.022
  6. A. Dasgupta, A. S. Chinchole, P. P. Kulkarni, D. K. Chandraker and A. K. Nayak, "Quenching of a Heated Rod: Physical Phenomena, Heat Transfer, and Effect of Nanofluids", J. Heat Transfer, Vol. 138, pp. 1-7, 2016.
  7. H. D. Kim, G. Dewitt, T. Mckrell, J. Buongiorno and L. W. Hu, "On the Quenching of Steel and Zircaloy Spheres in Water-based Nanofluids with Alumina, Silica and Diamond Nanoparticles", Int. J. Multiphase Flow, Vol. 35, pp. 427-438, 2009. https://doi.org/10.1016/j.ijmultiphaseflow.2009.02.004
  8. H. D. Kim, J. Buongiorno, L. W. Hu and T. Mckrell, "Nanoparticle Deposition Effects on the Minimum Heat Flux Point and Quench Front Speed During Quenching in Water-based Alumina Nanofluids", Int. J. Heat Mass Transfer, Vol. 53, pp. 1542-1553, 2010. https://doi.org/10.1016/j.ijheatmasstransfer.2009.11.029
  9. N. Patra, V. Gupta, R. Singh, R. S. Singh, P. Ghosh and A. Nayak, "An Experimental Analysis of Quenching of Continuously Heated Vertical Rod with Aqueous Al2O3 Nanofluid", Resource-Efficient Technologies, Vol. 3, pp. 378-384, 2017. https://doi.org/10.1016/j.reffit.2017.02.006
  10. G. Paul, P. K. Das and I. Manna, "Assessment of the Process of Boiling Heat Transfer During Rewetting of a Vertical Tube Bottom Flooded by Alumina Nanofluid", Int. J. Heat Mass Transfer, Vol. 94, pp. 390-402, 2016. https://doi.org/10.1016/j.ijheatmasstransfer.2015.11.013
  11. S. Y. Chun, I. C. Bang, Y. J. Choo and C. H. Song, "Heat Transfer Characteristics of Si and SiC Nanofluids During a Rapid Quenching and Nanoparticles Deposition Effects", Int. J. Heat Mass Transfer, Vol. 54, pp. 1217-1223, 2011. https://doi.org/10.1016/j.ijheatmasstransfer.2010.10.029
  12. C. Y. Lee and J. H. Kim, "Investigation on Minimum Film Boiling Point of Highly Heated Vertical Metal Rod in Aqueous Surfactant Solution", Trans. Korean Soc. Mech. Eng. B, Vol. 41, No. 9, pp. 597-603, 2017. https://doi.org/10.3795/KSME-B.2017.41.9.597
  13. L. Colla, L. Fedele, M. Scattolini and S. bobbo, "Water-based Fe2O3 Nanofluid Characterization: Thermal Conductivity and Viscosity Measurements and Correlation", Adv. Mech. Eng., Vol. 2012, pp. 1-8, 2012.
  14. L. W. Fan, J. Q. Li, D. Y. Li, L. Zhang and Z. T. Yu, "Regulated Transient Pool Boiling of Water During Quenching on Nanostructured Surfaces with Modified Wettability from Superhydrophilic to Superhydrophobic," Int. J. Heat Mass Transfer, Vol. 76, pp. 81-89, 2014. https://doi.org/10.1016/j.ijheatmasstransfer.2014.04.025
  15. S. W. Lee, S. M. Kim, S. D. Park and I. C. Bang, "Study on the Cooling Performance of Sea Salt Solution During Reflood Heat Transfer in a Long Vertical Tube", Int. J. Heat Mass Transfer, Vol. 60, pp. 105-113, 2013. https://doi.org/10.1016/j.ijheatmasstransfer.2012.12.046
  16. J. P. Holman, "Experimental Methods for Engineers", McGraw Hill, pp. 51-62, 2001.