DOI QR코드

DOI QR Code

플라스틱 랙기어의 사출성형 해석에 관한 연구

A Study on Injection Molding Analysis of a Plastic Rack Gear

  • 김형국 (창원문성대학교 스마트기계자동차공학부)
  • Kim, Hyung-Kook (School of Smart Mechanical & Automotive Engineering, Changwon Moonsung University)
  • 투고 : 2020.05.05
  • 심사 : 2020.05.29
  • 발행 : 2020.08.31

초록

This study investigates the injection molding of a plastic rack gear and focuses on deflections in the part. The causes of deflections were found and resolved through a trade-off study by injection molding analysis. Based on a warpage analysis, the fiber orientation was found to be a dominant factor in the occurrence of deflections. Changes in the part design and various injection conditions were analyzed for their effects in reducing deflections. Based on the trade-off study, a new part bottom design, injection time, and melt temperature were recommended. A trial injection was done for the new plastic rack gear, and measurements showed that its flatness surpassed that of the original part and met the specified requirement. The short injection time, low melt temperature, and symmetric similar configuration of the part contributed to the reduction in deflections. Therefore, optimized gate design and injection conditions as well as a new part design were validated through injection molding analysis in this study.

키워드

참고문헌

  1. Lim, M. S., "Optimum Design of Plastics", Gijeon Press., pp. 387-388, 2003.
  2. Lim, S. H., "Injection Mold Design", Bosunggak Press., pp. 452-455, 2004.
  3. Han, S. R., "A Study on the Deformation Optimization of a Plastic Bezel Assembled on the Steering Wheel of an Automobiles", Journal of the Korean Society of Manufacturing Process Engineers, Vol. 16, No. 5, pp. 105-112, 2017. https://doi.org/10.14775/ksmpe.2017.16.5.105
  4. Kim, J. M. and Lyu, M. Y., "An Application of CAE in the Optimization of Runner Size in Injection Molding", Transactions of Materials Processing, Vol. 15, No. 5, pp. 145-151, 2006.
  5. Park, J. C. and Kim, K. M., "Determination of Gate Position Considering Robustness in Injection Mold Design", Journal of the Korean Society of Manufacturing Process Engineers, Vol. 16, No. 5, pp.113-118, 2017.
  6. Choi, H. J., Park, C. W., and Choi, S. D., "Analyses on Deformation Patterns Depending on the Injection Process for Rear Lamp Reflectors of automotive," Journal of the Korean Society of Manufacturing Process Engineers, Vol. 9 No. 4, pp. 32-37, 2010.
  7. Shin, N. H., Oh, H. S and Kang, S, K., "The Optimization of Injection Molding Process by CAE", Daekwang Press, pp. 254, pp.261-263, 2007.