DOI QR코드

DOI QR Code

Dynamic tensile behavior of SIFRCCs at high strain rates

  • Kim, Seungwon (Department of Civil Engineering, Kangwon National University) ;
  • Park, Cheolwoo (Department of Civil and Environmental Engineering, Sejong University) ;
  • Kim, Dong Joo (Department of Civil and Environmental Engineering, Sejong University)
  • 투고 : 2020.02.24
  • 심사 : 2020.08.25
  • 발행 : 2020.09.25

초록

Reinforced concrete (RC) does not provide sufficient resistance against impacts and blast loads, and the brittle structure of RC fails to protect against fractures due to the lack of shock absorption. Investigations on improving its resistance against explosion and impact have been actively conducted on high-performance fiber-reinforced cementitious composites (HPFRCCs), such as fiber-reinforced concrete and ultra-high-performance concrete. For these HPFRCCs, however, tensile strength and toughness are still significantly lower compared to compressive strength due to their limited fiber volume fraction. Therefore, in this study, the tensile behavior of slurry-infiltrated fiber-reinforced cementitious composites (SIFRCCs), which can accommodate a large number of steel fibers, was analyzed under static and dynamic loading to improve the shortcomings of RC and to enhance its explosion and impact resistance. The fiber volume fractions of SIFRCCs were set to 4%, 5%, and 6%, and three strain rate levels (maximum strain rate: 250 s-1) were applied. As a result, the tensile strength exceeded 15 MPa under static load, and the dynamic tensile strength reached a maximum of 40 MPa. In addition, tensile characteristics, such as tensile strength, deformation capacity, and energy absorption capacity, were improved as the fiber volume fraction and strain rate increased.

키워드

과제정보

This research was supported by a grant (20SCIP-B146646-03) from Construction Technology Research Project funded by the Ministry of Land, Infrastructure and Transport of Korea government and by Basic Science Research Program through the National Research Foundation (NRF) of Korea funded by the Ministry of Education (NRF-2019R1I1A1A01062942).

참고문헌

  1. Banthia, N. and Sappakittipakorn, M. (2007), "Toughness enhancement in the steel fiber reinforced concrete through fibers hybridization", Cement Concrete Res., 37(9), 1366-1372. https://doi.org/10.1016/j.cemconres.2007.05.005.
  2. Behinaein, P., Cotsovos, D.M. and Abbas, A.A. (2018), "Behaviour of steel-fiber-reinforced concrete beams under high-rete loading", Comput. Concrete, 22(3), 337-353. https://doi.org/10.12989/cac.2018.22.3.337.
  3. Bindiganavile, V. and Banthia, N. (2005), "Generating dynamic crack growth resistance curves for fiber-reinforced concrete", Exp. Mech., 45, 112-122. https://doi.org/10.1007/BF02428183.
  4. Chan, Y.W. and Chu, S.H. (2004), "Effect of silica fume on steel fiber bond characteristics in reactive powder concrete", Cement Concrete Res., 34(7), 1167-1172. https://doi.org/10.1016/j.cemconres.2003.12.023.
  5. Choi, J.I., Park, S.E., Lee, B.Y. and Kim, Y.Y. (2018), "Tensile properties of polyethylene fiber-reinforced highly ductile composite with compressive strength of 100 MPa class", J. Korea Concrete Inst., 30(5), 497-503. https://doi.org/10.4334/jkci.2018.30.5.497
  6. Kang, S.T. (2013), "Bond strength of steel fiber incorporated in ultra high performance fiber-reinforced concrete", J. Korea Concrete Inst., 25(5), 547-554. https://doi.org/10.4334/JKCI.2013.25.5.547.
  7. Kim, D.J., Kim, S.W., Yoon, Y.S. and Park, C. (2015), "Impact resistance of strain hardening cementitious composites", Mag. Korea Concrete Inst., 27(4), 27-31. https://doi.org/10.22636/MKCI.2015.27.4.27.
  8. Kim, H.S., Kim, G.Y., Lee, S.K., Son, M.J., Choe, G.C. and Nam, J.S. (2019), "Strain rate effects on the compressive and tensile behavior of bundle-type polyamide fiber-reinforced cementitious composites", Compos. Part B-Eng., 160, 50-65. https://doi.org/10.1016/j.compositesb.2018.10.008.
  9. Kim, H.S., Kim, G.Y., Lee, S.K., Choe, G.C. and Nam, J.S. (2019), "Direct tensile properties of fiber-reinforced cement based composites according to the length and volume fraction of amorphous metallic fiber", J. Korea Inst. Build. Constr., 19(3), 201-207. https://doi.org/10.5345/JKIBC.2019.19.3.201.
  10. Kim, S. (2017), "Strengthening effect on impact resistance of externally reinforced RC member with SIFRCC and FRP", Ph.D. Dissertation, Kangwon National University, Samcheok.
  11. Kim, S. and Park, C. (2019), "Flexural behavior characteristics of high performance slurry infiltrated fiber reinforced cementitious composite with respect to exposure to high temperature", J. Korea Concrete Inst., 31(2), 139-146. https://doi.org/10.4334/jkci.2019.31.2.139
  12. Kim, S., Han, S., Park, C. and Yun, K.K. (2020), "Compressive behavior characteristics of high-performance slurry-infiltrated fiber-reinforced cementitious composites (SIFRCCs) under uniaxial compressive stress", Mater., 13(159), 1-13. https://doi.org/10.3390/ma13010159.
  13. Kim, S., Jung, H., Kim, Y. and Park, C. (2018), "Effect of steel fiber volume fraction and aspect ratio type on the mechanical properties of SIFCON-based HPFRCC", Struct. Eng. Mech., 65(2), 163-171. https://doi.org/10.12989/sem.2018.65.2.163.
  14. Kim, S., Kim, D.J., Kim, S.-W. and Park, C. (2019), "Tensile behavior characteristics of high-performance slurry-infiltrated fiber-reinforced cementitious composite with respect to fiber bolume fraction", Mater., 12(3335), 1-11. https://doi.org/10.3390/ma12203335.
  15. Kim, S., Kim, Y., Kim, S.W., Kim, Y.J., and Park, C. (2018), "Strengthening effect of externally reinforced RC structure with SIFRCC on impact load", Proceeding of ICPS5, Poznan, August.
  16. Kim, S.W., Park, C.W., Kim, S.W., Cho, H.M., Jeon, S.P. and Ju, M.K. (2014) "Optimum mix proportions of in-fill slurry for high performance steel fiber reinforced cementitious composite", J. Korean Recy. Constr. Res. Inst., 2(3), 196-201. https://doi.org/10.14190/JRCR.2014.2.3.196.
  17. Lee, Y.O. and Yun, H.D. (2010), "Effects of expansive admixture on the mechanical properties of strain-hardening cement composite (SHCC)", J. Korea Concrete Inst., 22(5), 617-624. https://doi.org/10.4334/JKCI.2010.22.5.617.
  18. Liu, Q., Zhou, D., Wang, J. and Liu, W. (2018), "Mechanical behavior of FRP confined steel tubular columns under impact", Steel Compos. Struct., 27(6), 691-702. https://doi.org/10.12989/scs.2018.27.6.691.
  19. Malvar, L.J., Crawford, J.E. and Morrill, K.B. (2007), "Use of composites to resist blast", J. Compos. Constr., 11, 601-610. https://doi.org/10.1061/(ASCE)1090-0268(2007)11:6(601).
  20. Meraji, L., Afshin, H. and Abedi, K. (2019), "Flexural behavior of RC beams retrofitted by ultra-high performance fiber-reinforced concrete", Comput. Concrete, 24(2), 159-172. https://doi.org/10.12989/cac.2019.24.2.159.
  21. Mosaberpanah, M.A. and Eren, O. (2017), "Statical models for mechanical properties of UHPC using response surface methodology", Comput. Concrete, 19(6), 667-675. https://doi.org/10.12989/cac.2017.19.6.673.
  22. Nam, J.S., Shinohara, Y., Atou, T., Kim, H.S. and Kim, G.Y. (2016), "Comparative assessment of failure characteristics on fiber-reinforced cementitious composite panels under high-velocity impact", Compos. Part B-Eng., 99, 84-97. https://doi.org/10.1016/j.compositesb.2016.06.008.
  23. Park, J.K., Kim, S.W. and Kim, D.J. (2017), "Matrix-strength-dependent strain-rate sensitivity of strain-hardening fiber-reinforced cementitious composites under tensile impact", Compos. Struct., 162, 313-324. https://doi.org/10.1016/j.compstruct.2016.12.022.
  24. Park, J.W. and Lee, G.C. (2017), "Effect of compressive strength and curing condition on the direct tensile strength properties of ultra high performance concrete", J. Korea Inst. Build Constr., 17(2), 175-181. https://doi.org/10.5345/JKIBC.2017.17.2.175.
  25. Park, J.W., Lee, G.C., Koh, K.T. and Ryu, G.S. (2018), "Study on direct tensile properties and reliability review of steel fiber reinforced UHPC", J. Korea Inst. Build. Constr., 18(2), 125-132. https://doi.org/10.5345/JKIBC.2018.18.2.125.
  26. Poorhosein, R. and Nematzadeh, M. (2018), "Mechanical behavior of hybrid steel-PVA fibers reinforced reactive powder concrete", Comput. Concrete, 21(2), 167-179. https://doi.org/10.12989/cac.2018.21.2.167.
  27. Tran, T.K. and Kim, D.J. (2013), "Investigating direct tensile behavior of high performance fiber reinforced cementitious composites at high strain rates", Cement Concrete Res., 50, 62-73. https://doi.org/10.1016/j.cemconres.2013.03.018.
  28. Wang, J., Yuan, W., Wu, X. and Wei, K. (2017), "Dynamic performance of girder bridges with explosion-proof and aseismic system", Struct. Eng. Mech., 61(3), 419-426. https://doi.org/10.12989/sem.2017.61.3.419.