DOI QR코드

DOI QR Code

Daily influent variation for dynamic modeling of wastewater treatment plants

  • Dzubur, Alma (Department of Sanitary Engineering and Department of Environmental Engineering, Faculty of Civil Engineering, University of Sarajevo) ;
  • Serdarevic, Amra (Department of Sanitary Engineering and Department of Environmental Engineering, Faculty of Civil Engineering, University of Sarajevo)
  • Received : 2020.01.11
  • Accepted : 2020.04.01
  • Published : 2020.04.25

Abstract

Wastewater treatment plants (WWTPs) with activated sludge system are widely used throughout the most common technologies in the world. Most treatment plants require optimization of certain treatment processes using dynamic modeling. A lot of examples of dynamic simulations require reliable data base of diurnal variation of the inflow and typical concentrations of parameters such as Chemical Oxygen Demand (COD), Total Kjeldahl Nitrogen (TKN), etc. Such detailed data are not available, which leads to problemsin the application of dynamic simulations. In many examples of plants, continuous flow measurements are only performed after the primary clarifier, whereas measurements from influent to the plant are missing, as is the case with the examples in this paper. In some cases, a simpler, faster and cheaper way can be applied to determine influent variations, such as the "HSG-Sim" method ("Hochschulgruppe Simulation"). "Hochschulgruppe Simulation" is a group of researchers from Germany, Austria, Switzerland, Luxembourg, Netherlands and Poland (see http://www.hsgsim.org). This paper presents a model for generating daily variations of inflow and concentration of municipal wastewater quality parameters, applied to several existing WWTPs in Bosnia and Herzegovina (B&H). The main goal of the applied method is to generate realistic influent data of the existing plants in B&H, in terms of flow and quality, without any prior comprehensive survey and measurements at the site. The examples of plants show the influence of overflow facilities on the dynamics of input flow and quality of wastewater, and a strong influence of the problems of the sewerage systems.

Keywords

Acknowledgement

Measured flow data and wastewater quality parameters were obtained from municipal utilities water supply and sewerage (Sarajevo, Bihac, Konjic and Ljubuski) with the help of plant managers and their associates. Special gratitude for a good mutual cooperation is expressed to the employees of these WWTPs, who perform the tasks of control and maintenance.

References

  1. Alex, J., Ahnert, M., Durrenmatt, D.J., Langergraber, G., Hobus, I., Schmuck, S. and Spering, V. (2015), "Voraussetzungen fur eine dynamische Simulation als Bestandteil einer statischen Klaranlagenbemessung nach DWA-A 131", Korrespondenz Abwasser, 62(5), 436-446. https://doi.org/10.3242/kae2015.05.003.
  2. Alex, J., Wichern, M., Halft, N., Spering, V., Ahnert, M., Frehmann, T., Hobus, I., Langergraber, G., Plattes, M., Winkler, S. and Woerner, D. (2007), "A method to use dynamic simulation in compliance to stationary design rules to refine WWTP planning", 10th IWA Specialised Conference on Design, Operation and Economics of Large Wastewater Treatment Plants, Vienna, Austria, September.
  3. ATV-DVWK-A 131E (2000), German ATV-DVWK Rules and Standards, Dimensioning of Single-Stage Activated Sludge Plants, German Association for Water, Wastewater and Waste, Hennef, Germany. (in English)
  4. Dzubur, A., Schutze, M. and Serdarevic, A. (2018), "Odredivanje dnevnih varijacija influenta za primjenu dinamicke simulacije uredaja za preradu otpadnih voda", Vodoprivreda, 50(291-293), 157-1641.
  5. Gernaey, K.V., Loosdrecht, M.C.M., Henze, M., Lind, M. and Jorgensen, B. (2004) "Activated sludge wastewater treatment plant modelling and simulation: state of the art", Environ. Model. Softw., 19(9), 763-783. https://doi.org/10.1016/j.envsoft.2003.03.005.
  6. Gernaey, K.V., Rosen, C. and Jeppson, U. (2006), "WWTP dynamic disturbance modelling - an essential module for long-term benchmarking development", Water Sci. Technol., 53(4-5), 225-234. https://doi.org/10.2166/wst.2006.127.
  7. Goumas, G., Kourtis, K., Anastopoulos, N., Karakasis, V. and Koziris, N. (2008), "Performance evaluation of the sparse matrix-vector multiplication on modern architectures", J. Supercomput., 50(1), 36-77. https://doi.org/10.1007/s11227-008-0251-8.
  8. Hauduc, H., Gillot, S., Rieger, L., Ohtsuki, T., Shaw, A., Takacs, I. and Winkler, S. (2009), "Activated sludge modelling in practice: an international survey", Water Sci. Technol., 60(8), 1943-1951, https://doi.org/10.2166/wst.2009.223.
  9. Henze, M., Gujer, W., Mino, T. and Van Loosdrecht, M.C.M. (2000), "Activated sludge models ASM1, ASM2, ASM2d, and ASM3", International Water Association Scientific and Technical Report No. 9, IWA Publishing, London, UK.
  10. Jusic, S. and Milasinovic, Z. (2015), "Model based control of filter run time on potable water treatment plant", Coupl. Syst. Mech., 4(2), 157-172. http://dx.doi.org/10.12989/csm.2015.4.2.157.
  11. Kozar, I., Ibrahimbegovic, A. and Rukavina, T. (2018), "Material model for load rate sensitivity", Coupl. Syst. Mech., 7(2), 141-162. https://doi.org/10.12989/csm.2018.7.2.141 141.
  12. Krvavica, N., Kozar, I. and Ozanic, N. (2018) "The relevance of turbulent mixing in estuarine numerical models for two-layer shallow water flow", Coupl. Syst. Mech., 7(1), 95-109. https://doi.org/10.12989/csm.2018.7.1.095 95.
  13. Langergraber, G., Alex, J., Weissenbacher, N., Woerner, D., Ahnert, M., Frehmann, T., ... & Winkler, S. (2007), "Generation of diurnal variation for influent data for dynamic simulation", Water Sci. Technol., 57(9), 1483-1486. https://doi.org/10.2166/wst.2008.228.
  14. Langergraber, G., Spering, V., Alex, J., Ahnert, M., Cernochoca, L., Durrenmatt, D.J., Frehmann, T., Hobus, I., Weissenbacher, N., Winkler, S. and Yucesoy, E. (2009), "Using numerical simulation to optimize control strategies during activated sludge plant design", Proceedings 10th IWA Conference on Instrumentation, Control and Automation (ICA), Cairns, Australia, June.
  15. Lipschutz, S. and Lipson,M. L. (2008), Linear Algebra, Schaum's outlines, McGraw-Hill eBooks, New York, NY, United States.
  16. Rieger, L., Gillot, S., Langergraber, G., Ohtsuki, T., Shaw, A., Takacs, I. and Winkler, S. (2013), IWA Task Group on Good Modelling Practice - Guidelines for Use of Activated Sludge Models, IWA Publishing, London, UK.
  17. Schatz, M.D., Van De Geijn, R.A. and Poulson, J. (2016), "Parallel matrix multiplication: A systematic journey", Siam J. Sci. Comput., Soc. Indus. Appl. Math., 38(6), 748-C781. https://doi.org/10.1137/140993478.
  18. Schutze, M.R., Butler, D. and Beck, M.B. (2002), Modelling, Simulation and Control of Urban Wastewater Systems, Springer-Verlag, London, UK.
  19. Serdarevic, A. and Dzubur, A. (2016), "Wastewater process modeling", Coupl. Syst. Mech., 5, 21-39. http://dx.doi.org/10.12989/csm.2016.5.1.021.
  20. Serdarevic, A. and Dzubur, A. (2018), "Importance and practice of operation and maintenance of wastewater treatment plants", 10th Days of BHAAAS IN B&H, Jahorina, Bosnia and Herzegovina, June.
  21. Serdarevic, A. and Dzubur, A. (2019), "Importance and practice of operation and maintenance of wastewater treatment plants", Advanced Technologies, Systems, and Applications III, Springer Nature, Switzerland. https://doi.org/10.1007/978-3-030-02577-9_14.
  22. Spering, V., Alex, J., Langergraber, G., Ahnert, M., Halft, N., Hobus, I., Weissenbacher, N., Winkler, S. and Yucesoy, E. (2008), "Using dynamic simulation for design of activated sludge plants", Proceedings International Symposium on Sanitary and Environmental Engineering - SIDISA.08, Florence, Italy, June.
  23. Tasiopoulou, P, Taiebat, M, Tafazzoli, N. and Jeremic, B. (2015), "Solution verification procedures for modeling and simulation of fully coupled porous media: Static and dynamic bBehavior" Coupl. Syst. Mech., 4(1), 67-98. http://dx.doi.org/10.12989/csm.2015.4.1.067.
  24. Wang, W. and Yan, Y. (2018) "Simulation of turbulent flow of turbine passage with uniform rotating velocity of guide vane", Coupl. Syst. Mech., 7(4), 421-440. https://doi.org/10.12989/csm.2018.7.4.421 421.