DOI QR코드

DOI QR Code

Design method for the 2DOF electromagnetic vibrational energy harvester

  • Park, Shi-Baek (Department of Mechanical Engineering, Yonsei University) ;
  • Jang, Seon-Jun (School of Mechanical Engineering, Hoseo University)
  • Received : 2019.05.17
  • Accepted : 2019.07.31
  • Published : 2020.04.25

Abstract

In this paper, the design method and experimental validation for the two-degree-of-freedom (2DOF) electromagnetic energy harvester are presented. The harvester consists of the rigid body suspended by four tension springs and electromagnetic transducers. Once the two resonant frequencies and the mass properties are specified, both the constant and the positions for the springs can be determined in the closed form. The designed harvester can locate two resonant peaks close to each other and forms the extended frequency bandwidth for power harvesting. Halbach magnet array is also introduced to enhance the output power. In the experiment, two resonant frequencies are measured at 34.9 and 37.6 Hz and the frequency bandwidth improves to 5 Hz at the voltage level of 207.9 mV. The normalized peak power of 4.587 mW/G2 is obtained at the optimal load resistor of 367 Ω.

Keywords

Acknowledgement

Supported by : Hoseo University

This research was supported by the Academic Research fund of Hoseo University in 2015(2015-0120).

References

  1. Ashraf, K., Md Khir, M.H., Dennis, J.O. and Baharudin, Z. (2013), "Improved energy harvesting from low frequency vibrations by resonance amplification at multiple frequencies", Sens. Actuators, A, 195, 123-132. https://doi.org/10.1016/j.sna.2013.03.026
  2. Beeby, S.P., Torah, R.N., Tudor, M.J., Glynne-Jone P., O'Donnell T., Saha C.R. and Roy S. (2007), "A micro electromagnetic generator for vibration energy harvesting", J. Micromech. Microeng., 17, 1257-1265. https://doi.org/10.1088/0960-1317/17/7/007
  3. Blanchet, P. (1988), "Linear vibration analysis using screw theory", Ph.D. Dissertation; Georgia Institute of Technology, Atlanta, GA, USA.
  4. Chen, S.-J. and Wu, J.-Y. (2016), "Fabrication of a 2-DOF electromagnetic energy harvester with in-phase vibrational bandwidth broadening", Smart Mater. Struct., 25, 095047. https://doi.org/10.1088/0964-1726/25/9/095047
  5. Ferrari, M., Ferrari, V., Guizzetti, M., Marioli, D. and Taroni, A. (2008), "Piezoelectric multifrequency energy converter for power harvesting in autonomous microsystems", Sens. Actuators, A, 142, 329-335. https://doi.org/10.1016/j.sna.2007.07.004
  6. Griffis, M. and Duffy, J. (1991), "Kinestatic control: a novel theory for simultaneously regulating force and displacement", J. Mech. Des., 113, 508-515. https://doi.org/10.1115/1.2912812
  7. Jang, S.-J., Rustighi, E., Brennan, M.J, Lee, Y.P. and Jung, H.-J. (2010), "Design of a 2DOF vibrational energy harvesting device", J. Intell. Mater. Syst. Struct., 22, 443-448. https://doi.org/10.1177/1045389X10393766
  8. Kim, I.-H., Jung, H.-J., Lee, B.M. and Jang, S.-J. (2011), "Broadband energy-harvesting using a two degree-of-freedom vibration body", Appl. Phys. Lett., 98, 214102. https://doi.org/10.1063/1.3595278
  9. Kim, J.-M., Han, M., Lim, H.J., Yang, S. and Sohn, H. (2016), "Operation of battery-less and wireless sensor using magnetic resonance based wireless power transfer through concrete", Smart Struct. Syst., Int. J., 17(4), 631-646. https://doi.org/10.12989/sss.2016.17.4.631
  10. Liu, H., Soon, B.W., Wang, N., Tay, C.J., Quan, C. and Lee, C. (2012), "Feasibility study of a 3D vibration-driven electromagnetic MEMS energy harvester with multiple vibration modes", J. Micromech. Microeng., 22, 125020. https://doi.org/10.1088/0960-1317/22/12/125020
  11. Makihara, K., Hirai, H. and Yamamoto, Y. (2015), "Self-reliant wireless health monitoring based on tuned-mass-damper mechanism", Smart Struct. Syst., Int. J., 15(6), 1625-1642. https://doi.org/10.12989/sss.2015.15.6.1625
  12. Marin, A., Turner, J., Ha, D.S. and Priya, S. (2013), "Broadband electromagnetic vibration energy harvesting system for powering wireless sensor nodes", Smart Mater. Struct., 22, 075008. https://doi.org/10.1088/0964-1726/22/7/075008
  13. Meirovitch, L. (2001), Fundamentals of Vibration, McGraw-Hill Companies, Inc., New York, NY, USA.
  14. Nammari, A., Caskey, L., Negrete, J. and Bardaweel, H. (2018), "Fabrication and characterization of non-resonant magnetomechanical low-freqeucny vibration energy harvester", Mech. Syst. Sig. Process., 86, 29-39. https://doi.org/10.1016/j.ymssp.2017.09.036
  15. Nico, V., Boco, E., Frizzell, R. and Punch, J. (2016), "A high figure of merit vibrational energy harvester for low frequency applications", Appl. Phys. Lett., 108, 013902. https://doi.org/10.1063/1.4939545
  16. Marian, L. and Giaralis, A. (2017), "The tuned mass-damperinerter for harmonic vibrations suppression, attached mass reduction, and energy harvesting", Smart Struct. Syst., Int. J., 19(6), 665-678. https://doi.org/10.12989/sss.2017.19.6.665
  17. O'Donoghue, D., Frizzell, R. and Punch, J. (2018), "Scaling and characterisation of a 2-DoF velocity amplified electromagnetic vibration energy harvester", Smart Mater. Struct., 27, 075019. https://doi.org/10.1088/1361-665X/aac297
  18. Ramlan, R., Brennan, M.J., Mace, B.R. and Kovacic, I. (2010), "Potential benefits of a non-linear stiffness in an energy harvesting device", Nonlinear Dyn., 59, 545-558. https://doi.org/10.1007/s11071-009-9561-5
  19. Shahruz, S.M. (2006), "Design of mechanical band-pass filters with large frequency bands for energy scavenging", Mechatronics, 16, 523-531. https://doi.org/10.1016/j.mechatronics.2006.04.003
  20. Tang, L. and Yang, Y. (2012), "A nonlinear piezoelectric energy harvester with magnetic oscillator", Appl. Phys. Lett., 101, 094102. https://doi.org/10.1063/1.4748794
  21. Wang, H. and Tang, L. (2017), "Modeling and experiment of bistable two-degree-of-freedom energy harvester with magnetic coupling", Mech. Syst. Sig. Process, 86, 29-39. https://doi.org/10.1016/j.ymssp.2016.10.001
  22. Wong, Z.J., Yan, J., Soga, K. and Seshia, A. (2009) "A multidegree-of-freedom electrostatic MEMS power harvester", Power Micro Electro Mechanical Systems, Washington, DC, USA, December.
  23. Wu, H., Tang, L., Yang, Y. and Soh, C.K. (2014), "Development of a broadband nonlinear two degree-of-freedom piezoelectric energy harvester", J. Intell. Mater. Syst. Struct., 25, 1875-1889. https://doi.org/10.1177/1045389X14541494
  24. Zhang, Y., Wang, T., Zhang, A., Peng, Z., Luo, D., Chen, R. and Wang, F. (2016), "Electrostatic energy harvesting device with dual resonant structure for wideband random vibration sources at low frequency", Rev. Sci. Instrum., 87, 125001. https://doi.org/10.1063/1.4968811
  25. Zhu, D., Tudor, M.J. and Beeby, S.P. (2010), "Strategy for increasing the operating frequency range of vibration energy harvesters: a review", Meas. Sci. Technol., 21, 022001. https://doi.org/10.1088/0957-0233/21/2/022001
  26. Zhu, D., Beeby, S., Tudor, J. and Harris, N. (2012), "Vibration energy harvesting using the Halbach array", Smart Mater. Struct., 21, 075020. https://doi.org/10.1088/0964-1726/21/7/075020