DOI QR코드

DOI QR Code

Experimental and numerical investigations on remaining strengths of damaged parabolic steel tubular arches

  • Huang, Yonghui (Guangzhou University-Tamkang University Joint Research Center for Engineering Structure Disaster Prevention and Control, Guangzhou University) ;
  • Liu, Airong (Guangzhou University-Tamkang University Joint Research Center for Engineering Structure Disaster Prevention and Control, Guangzhou University) ;
  • Pi, Yong-Lin (Guangzhou University-Tamkang University Joint Research Center for Engineering Structure Disaster Prevention and Control, Guangzhou University) ;
  • Bradford, Mark A. (Centre for Infrastructure Engineering and Safety (CIES), School of Civil and Environmental Engineering, The University of New South Wales) ;
  • Fu, Jiyang (Guangzhou University-Tamkang University Joint Research Center for Engineering Structure Disaster Prevention and Control, Guangzhou University)
  • 투고 : 2019.01.15
  • 심사 : 2019.12.15
  • 발행 : 2020.01.10

초록

This paper presents experimental and numerical studies on effects of local damages on the in-plane elastic-plastic buckling and strength of a fixed parabolic steel tubular arch under a vertical load distributed uniformly over its span, which have not been reported in the literature hitherto. The in-plane structural behaviour and strength of ten specimens with different local damages are investigated experimentally. A finite element (FE) model for damaged steel tubular arches is established and is validated by the test results. The FE model is then used to conduct parametric studies on effects of the damage location, depth and length on the strength of steel arches. The experimental results and FE parametric studies show that effects of damages at the arch end on the strength of the arch are more significant than those of damages at other locations of the arch, and that effects of the damage depth on the strength of arches are most significant among those of the damage length. It is also found that the failure modes of a damaged steel tubular arch are much related to its initial geometric imperfections. The experimental results and extensive FE results show that when the effective cross-section considering local damages is used in calculating the modified slenderness of arches, the column bucking curve b in GB50017 or Eurocode3 can be used for assessing the remaining in-plane strength of locally damaged parabolic steel tubular arches under uniform compression. Furthermore, a useful interaction equation for assessing the remaining in-plane strength of damaged steel tubular arches that are subjected to the combined bending and axial compression is also proposed based on the validated FE models. It is shown that the proposed interaction equation can provide lower bound assessments for the remaining strength of damaged arches under in-plane general loading.

키워드

과제정보

연구 과제 주관 기관 : National Natural Science Foundation of China

This research is financially supported by the National Natural Science Foundation of China (No. 51678169, 51878188), Pearl River S&T Nova Program of Guangzhou (No. 201710010147), and Technology Planning Project of Guangzhou (No. 201807010021).

참고문헌

  1. Ahn, J., Kim, I.T., Kainuma, S. and Lee, M.J. (2013), "Residual shear strength of steel plate girder due to web local corrosion", J. Constr. Steel Res., 89(5), 198-212. https://doi.org/10.1016/j.jcsr.2013.07.008.
  2. ANSYS (2014), Multiphysics, Release 14.5, Ansys Inc., Canonsburg, PA, USA.
  3. Appuhamy, J.M.R.S., Ohga, M., Kaita, T., Fujii, K. and Dissanayake, P.B.R. (2011), "Development of analytical method for predicting residual mechanical properties of corroded steel plates", Int. J. Corros., 1-10. https://doi.org/10.1155/2011/385083.
  4. Appuhamy, J.M.R.S., Ohga, M., Chun, P. and Dissanayake, P.B.R. (2013), "Role of corrosion and earthquakes on degradation of dynamic behaviour of steel bridge plates", J. Civ. Eng. Sci., 2(1), 7-14.
  5. Bradford, M.A. and Pi, Y.L. (2004), "Design of steel arches against in-plane instability", Int. J. Appl. Mech. Eng., 9(1), 37-45. https://doi.org/10.1016/B978-008044017-0/50011-1.
  6. Cai, J.G., Feng, J., Chen, Y. and Huang, L.F. (2009), "In-plane elastic stability of fixed parabolic shallow arches", Sci. China Ser. E: Technol. Sci., 52(3), 596-602. https://doi.org/10.1007/s11431-009-0057-9.
  7. Dou, C., Guo, Y.L., Pi, Y.L. and Zhao, S.Y. (2014), "Flexuraltorsional buckling and ultimate resistance of parabolic steel arches subjected to uniformly distributed vertical load", J. Struct. Eng., 140(10), 04014075. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000997.
  8. Dou, C., Guo, Y.L., Zhao, S.Y. and Pi, Y.L. (2015), "Experimental investigation into flexural-torsional ultimate resistance of steel circular arches", J. Struct. Eng., 141(10), 04015006. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001240.
  9. Dou, C., Guo, Y.F., Jiang, Z.Q., Gao, W. and Pi, Y.L. (2018), "Inplane buckling and design of steel tubular truss arches", Thin- Wall. Struct., 130, 613-621. https://doi.org/10.1016/j.tws.2018.06.024.
  10. Eurocode 3 (2004), Design of steel structures, Part 1-1: General rules and rules for buildings, EN 1993-1-1, European Committee for Standardization; Brussels, Belgium.
  11. GB50017 (2017), Code for design of steel structures. Ministry of Construction of the People's Republic of China; Beijing, P.R. China.
  12. Guo, Y.L., Chen, H., Pi, Y.L. and Bradford, M.A. (2016), "In-plane strength of steel arches with a sinusoidal corrugated web under a full-span uniform vertical load: Experimental and numerical investigations", Eng. Struct., 110(3), 105-115. https://doi.org/10.1016/j.engstruct.2015.11.056.
  13. Hadjoannou, M., Douthe, C. and Gantes, C. (2011), "Influence of residual stresses induced by cold curving on the resistance of ISection steel members", Eurosteel 2011, 729-734.
  14. Han, L.H., Zhao, X.L. and Tao, Z. (2001), "Tests and mechanics model for concrete-filled SHS stub columns, columns and beam-columns", Steel Compos. Struct., 1(1), 51-74. https://doi.org/10.12989/scs.2001.1.1.051.
  15. Han, L.H., Yao, G.H. and Tao, Z. (2007), "Performance of concrete filled thin-walled steel tubes under pure torsion", Thin-Wall. Struct., 45(1), 24-36. https://doi.org/10.1016/j.tws.2007.01.008.
  16. Huang, Y.H. (2010), "Mechanism and effect of arch rib disease and suspender replacement for concrete-filled steel tube arch bridges", Ph.D. Dissertation; South China University of Technology, Guangzhou, China. [In Chinese]
  17. Kainuma, S., Jeong, Y.S. and Ahn, J.H. (2015), "Stress distribution on the real corrosion surface of the orthotopic steel bridge deck", Steel Compos. Struct., 18(6), 1479-1492. https://doi.org/10.12989/scs.2015.18.6.1479.
  18. Kaita, T., Appuhamy, J., Ohga, M. and Fujii, K. (2012), "An enhanced method of predicting effective thickness of corroded steel plates", Steel Compos. Struct., 12(5), 379-393. https://doi.org/10.12989/scs.2012.12.5.379.
  19. Kim, I.T., Lee, M.J., Ahn, J.H. and Kainuma, S. (2013), "Experimental evaluation of shear buckling behaviors and strength of locally corroded web", J. Constr. Steel Res., 83(2), 75-89. https://doi.org/10.1016/j.jcsr.2012.12.015
  20. Lin, B. and Guo, Y.L. (2009), "In-plane stability behavior and application of parabolic arches under pure compression", J. Build. Struct., 30(3), 103-111. [In Chinese]
  21. Liu, A.R., Huang, Y.H., Fu, J.Y., Yu, Q.C and Rao, R. (2015), "Experimental research on stable ultimate bearing capacity of leaning-type arch rib systems", J. Constr. Steel Res., 114(11), 281-292. https://doi.org/10.1016/j.jcsr.2015.08.011
  22. Liu, A.R., Lu, H.W., Fu, J.Y. and Pi, Y.L. (2017), "Lateraltorsional buckling of fixed circular arches having a thin-walled section under a central concentrated load", Thin-Wall. Struct., 118, 46-55. https://doi.org/10.1016/j.tws.2017.05.002
  23. Mateus, A.F. and Witz, J.A. (1998), "On the post-buckling of corroded steel plates used in marine structures", RINA Trans, 140, 165-183.
  24. Pi, Y.L. and Bradford, M.A. (2004), "In-plane strength and design of fixed steel I-section arches", Eng. Struct., 26(3), 291-301. https://doi.org/10.1016/j.engstruct.2003.09.011.
  25. Pi, Y.L. and Trahair, NS (1999), "In-plane buckling and design of steel arches", J. Struct. Eng., 125(11), 1291-1298. https://doi.org/10.1061/(ASCE)0733-9445(1999)125:11(1291).
  26. Pi, Y.L., Bradford, M.A. and Tin-Loi, F. (2008), "In-plane strength of steel arches,. Adv. Steel Constr., 4(4), 306-322.
  27. Rahbar-Ranji, A. (2013), "Elastic buckling strength of corroded steel plates", Sadhana, 38(1), 89-99. https://doi.org/10.1007/s12046-013-0116-6.
  28. Rahgozar, R. (2009), "Remaining capacity assessment of corrosion damaged beams using minimum curves", J. Constr. Steel Res., 65(2), 299-307. https://doi.org/10.1016/j.jcsr.2008.02.004
  29. Rahgozar, R., Sharifi, Y. and Malekinejad, M. (2010), "Buckling capacity of uniformly corroded steel members in terms of exposure time", Steel Compos. Struct., 10(6), 475-487. https://doi.org/10.12989/scs.2010.10.6.475.
  30. Sakimoto, T., Yamao, T. and Komatsu, S. (1979), "Experimental study on the ultimate strength of steel arches", Proc. Jpn. Soc. Civ. Eng., 286, 139-149. https://doi.org/10.2208/jscej1969.1979.286_139.
  31. Sharifi, Y. and Paik, J.K. (2011), "Ultimate strength reliability analysis of corroded steel-box girder bridges", Thin-Wall. Struct., 49(1), 157-166. https://doi.org/10.1016/j.tws.2010.09.001
  32. Silva, J.E., Garbatov, Y. and Soares, C.G. (2013), "Ultimate strength assessment of rectangular steel plates subjected to a random localised corrosion degradation", Eng. Struct., 52(9), 295-305. https://doi.org/10.1016/j.engstruct.2013.02.013
  33. Timoshenko, S.P. and Gere, J.M. (1961), Theory of Elastic Stability, (2th Ed.), McGraw-Hill Book Company, Inc., New York.
  34. Yang, Z.C., Huang, Y.H., Liu, A.R., Fu, J.Y. and Wu, D. (2019) "Nonlinear in-plane buckling of fixed shallow functionally graded grapheme reinforced composite arches subjected to mechanical and thermal loading", Appl. Math. Model., 70, 315-327. https://doi.org/10.1016/j.apm.2019.01.024