DOI QR코드

DOI QR Code

Wind loads and wind-resistant behaviour of large cylindrical tanks in square-arrangement group. Part 2: CFD simulation and finite element analysis

  • Liu, Qing (Space Structures Research Center, Zhejiang University) ;
  • Zhao, Yang (Space Structures Research Center, Zhejiang University) ;
  • Cai, Shuqi (Space Structures Research Center, Zhejiang University) ;
  • Dong, Shilin (Space Structures Research Center, Zhejiang University)
  • 투고 : 2020.05.06
  • 심사 : 2020.12.18
  • 발행 : 2020.12.25

초록

To investigate the structural behaviour of grouped tanks under wind loads, 2 problems need to be figured out, wind pressures on tank shells and critical loads of the shell under these pressure distribution patterns. Following the wind tunnel tests described in the companion paper, this paper firstly seeks to obtain wind loads on the external wall in a squarely-arranged cylindrical tank group by numerical simulation, considering various layouts. The outcomes demonstrate that the numerical method can provide similar results on wind pressures and better insights on grouping effects through extracted streamlines. Then, geometrically nonlinear analyses are performed using several selected potentially unfavourable wind pressure distributions. It is found that the critical load is controlled by limit point buckling when the tank is empty while excessive deformations when the tank is full. In particular, significant reductions of wind resistance are found on grouped full tanks compared to the isolated tank, considering both serviceability and ultimate limit state, which should receive special attention if the tank is expected to resist severe wind loads with the increase of liquid level.

키워드

과제정보

The authors gratefully acknowledge the support of the National Natural Science Foundation of China (Nos. 51778567 & 51378459).

참고문헌

  1. ABAQUS (2014), ABAQUS analysis user's guide version 6.14, Dassault Systèmes Simulia Corp., Providence, R.I., U.S.A.
  2. Abedin, Z., Khan, N.A., Rizia, M.M. and Islam, M.Q. (2017), "Simulation of wind flow over square, pentagonal and hexagonal cylinders in a staggered form", AIP Conference Proceedings, 1919(1), 020004, https://doi.org/10.1063/1.5018522.
  3. ANSYS Fluent (2013), ANSYS Fluent User's guide, ANSYS, Inc., Canonsburg, Pennsylvania, U.S.A.
  4. Architectural Institute of Japan (2019), AIJ Recommendations for Loads on Buildings, Architectural Institute of Japan, Tokyo, Japan.
  5. ASME (2013), ASME Boiler and Pressure Vessel Code Section VIII Division 2: Rules for construction of pressure vessels - Alternative rules, American Society of Mechanical Engineers, New York, U.S.A.
  6. Bao, Y., Zhou, D. and Huang, C. (2010), "Numerical simulation of flow over three circular cylinders in equilateral arrangements at low Reynolds number by a second-order characteristic-based split finite element method", Comput. Fluids, 39(5), 882-899, https://doi.org/10.1016/j.compfluid.2010.01.002.
  7. Burgos, C.A., Jaca, R.C., Lassig, J.L. and Godoy, L.A. (2014), "Wind buckling of tanks with conical roof considering shielding by another tank", Thin-Walled Struct., 84, 226-240, https://doi.org/10.1016/j.tws.2014.06.007.
  8. Chen, W., Ji, C., Alam, M.M. and Xu, D. (2019), "Flow-induced vibrations of three circular cylinders in an equilateral triangular arrangement subjected to cross-flow", Wind Struct., 29(1), 43-53, https://doi.org/10.12989/was.2019.29.1.043.
  9. Eurocode 1 (2005), Actions on structures. Part 1-4: general actions - wind actions, European Committee for Standardization, Brussels, Belgium.
  10. Eurocode 3 (2007a), Design of steel structures. Part 4-1: silos, European Committee for Standardization, Brussels, Belgium.
  11. Eurocode 3 (2007b), Design of steel structures. Part 4-2: tanks, European Committee for Standardization, Brussels, Belgium.
  12. Gu, Z. and Sun, T. (1999), "On interference between two circular cylinders in staggered arrangement at high subcritical Reynolds numbers", J. Wind Eng. Ind. Aerod., 80(3), 287-309, https://doi.org/10.1016/S0167-6105(98)00205-0.
  13. Gu, Z. and Sun, T. (2001), "Classifications of flow pattern on three circular cylinders in equilateral-triangular arrangements", J. Wind Eng. Ind. Aerod., 89(6), 553-568, https://doi.org/10.1016/S0167-6105(00)00091-X.
  14. Hillewaere, J., Degroote, J., Lombaert, G., Vierendeels, J. and Degrande, G. (2015), "Wind-structure interaction simulations of ovalling vibrations in silo groups", J. Fluids Struct., 59, 328-350, https://doi.org/10.1016/j.jfluidstructs.2015.09.013.
  15. Iamandi, C., Georgescu, A. and Erbasu, C. (2003), "Experimental modeling of a four steel tanks battery", Proc. 11th Int. Conf. Wind Eng., Lubbock, TX, U.S.A.
  16. ICEM CFD (2016), ANSYS ICEM CFD User's Manual, ANSYS Inc., Canonsburg, USA.
  17. Liu, Q., Zhao, Y., Cai, S. and Dong, S. (2020), "Wind loads and stability analysis of large cylindrical tanks in square-arrangement group. Part 1: Wind tunnel test", Wind Struct., 31(6), 483-493, https://doi.org/10.12989/was.2020.31.6.483.
  18. Lo, Y.L., Kim, Y.C. and Li, Y.C. (2016), "Downstream interference effect of high-rise buildings under turbulent boundary layer flow", J. Wind Eng. Ind. Aerod., 159, 19-35, https://doi.org/10.1016/j.jweia.2016.10.002.
  19. MacDonald, P.A., Holmes, J.D. and Kwok, K. (1990), "Wind loads on circular storage bins, silos and tanks. II. Effect of grouping", J. Wind Eng. Ind. Aerod., 34(1), 77-95, https://doi.org/10.1016/01676105(90)90150B.
  20. Mahjoub Said, N., Mhiri, H., Bournot, H. and Le Palec, G. (2008), "Experimental and numerical modelling of the three-dimensional incompressible flow behaviour in the near wake of circular cylinders", J. Wind Eng. Ind. Aerod., 96(5), 471-502, https://doi.org/10.1016/j.jweia.2007.12.001.
  21. Maleki, S. and Mehretehran, A.M. (2019), "3D wind buckling analysis of steel silos with stepped walls", Thin-Walled Struct., 142, 236-261, https://doi.org/10.1016/j.tws.2019.05.007.
  22. Maraveas, C., Balokas, G.A. and Tsavdaridis, K.D. (2015), "Numerical evaluation on shell buckling of empty thin-walled steel tanks under wind load according to current American and European design codes", Thin-Walled Struct., 95, 152-160, https://doi.org/10.1016/j.tws.2015.07.007.
  23. Pasley, H. and Clark, C. (2000), "Computational fluid dynamics study of flow around floating-roof oil storage tanks", J. Wind Eng. Ind. Aerod., 86(1), 37-54, https://doi.org/10.1016/S01676105(99)00138-5.
  24. Portela, G. and Godoy, L.A. (2005), "Shielding effects and buckling of steel tanks in tandem arrays under wind pressures", Wind Struct., 8(5), 325-342, https://doi.org/10.12989/was.2005.8.5.325.
  25. Portela, G. and Godoy, L.A. (2007), "Wind pressure and buckling of grouped steel tanks", Wind Struct., 10(1), 23-44, https://doi.org/10.12989/was.2007.10.1.023.
  26. Sosa, E.M. and Godoy, L.A. (2005), "Nonlinear dynamics of above-ground thin-walled tanks under fluctuating pressures", J. Sound Vib., 283(1-2), 201-215, https://doi.org/10.1016/j.jsv.2004.04.023.
  27. Uematsu, Y., Yasunaga, J. and Koo, C. (2015), "Design wind loads for open-topped storage tanks in various arrangements", J. Wind Eng. Ind. Aerod., 138, 77-86, https://doi.org/10.1016/j.jweia.2014.12.013.
  28. Yu, X.F., Xie, Z.N., Zhu, J.B. and Gu, M. (2015), "Interference effects on wind pressure distribution between two high-rise buildings", J. Wind Eng. Ind. Aerod., 142, 188-197, https://doi.org/10.1016/j.jweia.2015.04.008.
  29. Zafar, F., Alam, M.M., Muhammad, Z. and Islam, M. (2019), "Wakes of two inline cylinders at a low Reynolds number", Wind Struct., 29(1), 55-64, https://doi.org/10.12989/was.2019.29.1.055.
  30. Zhang, Z. (2017), Wind load and wind resistant stability of large steel tanks, Master's thesis, Zhejiang University, Hangzhou, China, (In Chinese).
  31. Zhao, Y., Lin, Y. and Shen, Y.B. (2014), "Wind loads on large cylindrical open-topped tanks in group", Thin-Walled Struct., 78, 108-120, https://doi.org/10.1016/j.tws.2014.01.002.
  32. Zheng, Q., Alam, M.M., Rehma, S. and Maiti, D. (2019), "Forces and flow around three side-by-side square cylinders", Wind Struct., 29(1), 1-13, https://doi.org/10.12989/was.2019.29.1.001.
  33. Zheng, S., Zhang, W. and Lv, X. (2016), "Numerical simulation of cross-flow around three equal diameter cylinders in an equilateral-triangular configuration at low Reynolds numbers", Comput. Fluids, 130, 94-108, https://doi.org/10.1016/j.compfluid.2016.02.013.

피인용 문헌

  1. Wind loads and wind-resistant behaviour of large cylindrical tanks in square-arrangement group. Part 1: Wind tunnel test vol.31, pp.6, 2020, https://doi.org/10.12989/was.2020.31.6.483