DOI QR코드

DOI QR Code

Damage evaluation of RC beams strengthened with hybrid fibers

  • Sridhar, Radhika (Department of Civil Engineering, National Institute of Technology) ;
  • Prasad, Ravi (Department of Civil Engineering, National Institute of Technology)
  • Received : 2018.08.17
  • Accepted : 2019.04.09
  • Published : 2019.08.25

Abstract

This paper describes an experimental investigation on hybrid fiber reinforced concrete (HYFRC) beams. And the main aim of this present paper is to examine the dynamic characteristics and damage evaluation of undamaged and damaged HYFRC beams under free-free constraints. In this experimental work, totally four RC beams were cast and analyzed in order to evaluate the dynamic behavior as well as static load behavior of HYFRCs. Hybrid fiber reinforced concrete beams have been cast by incorporating two different fibers such as steel and polypropylene (PP). Damage of HYFRC beams was obtained by cracking of concrete for one of the beams in each set under four-point bending tests with different percentage variation of damage levels as 50%, 70% and 90% of maximum ultimate load. And the main dynamic characteristics such as damping, fundamental natural frequencies, mode shapes and frequency response function at each and every damage level has been assessed by means of non-destructive technique (NDT) with hammer excitation. The fundamental natural frequency and damping values obtained through dynamic tests for HYFRC beams were compared with control (reference) RC beam at each level of damage which has been acquired through static tests. The static experimental test results emphasize that the HYFRC beam has attained higher ultimate load as compared with control reinforced concrete beam.

Keywords

References

  1. 10262 (2009), Guidelines for Concrete Mix Proportioning.
  2. Alberti, M.G., Enfedaque, A. and Galvez, J.C. (2014), "On the mechanical properties and fracture behavior of polyolefin fiber reinforced self-compacting concrete", Constr. Build. Mater., 55, 274-288. https://doi.org/10.1016/j.conbuildmat.2014.01.024.
  3. Alberti, M.G., Enfedaque, A. and Galvez, J.C. (2014), "Polyolefin fiber-reinforced concrete enhanced with steel-hooked fibers in low proportions", Mater. Des., 60, 57-65. https://doi.org/10.1016/j.matdes.2014.03.050.
  4. ASTM C78-94, Standard Test Method for Flexural Strength of Concrete.
  5. Barros, J.A.O. and Dias, S.J.E. (2006), "Near surface mounted CFRP laminates for shear strengthening of concrete beams", Cement Concrete Compos., 28(3), 276-292. https://doi.org/10.1016/j.cemconcomp.2005.11.003.
  6. Brandt, A.M. (2008) "Fiber reinforced cement-based (FRC) Composites after over 40 years of development in building and civil engineering", Compos. Struct., 83(3), 3-9. https://doi.org/10.1016/j.compstruct.2008.03.006.
  7. Caleb, C.W., Li, H.C.H. and Whittingham, B. (2009), "Damage detection in repairs using frequency response technique", Compos. Struct., 87, 175-180. https://doi.org/10.1016/j.compstruct.2008.05.010.
  8. Capozucca, R. (2009), "Static and dynamic response of damaged RC beams strengthened with NSM CFRP rods", Compos. Struct., 91, 237-248. https://doi.org/10.1016/j.compstruct.2009.05.003.
  9. Capozucca, R. (2013), "A reflection on the application of vibration tests for the assessment of cracking in PRC/RC beams", Eng. Struct., 48, 508-518. https://doi.org/10.1016/j.engstruct.2012.09.022.
  10. Capozucca, R. (2018), "Vibration analysis of damaged RC beams strengthened with GFRP", Compos. Struct., 200, 624-634. https://doi.org/10.1016/j.compstruct.2018.05.112.
  11. Capozucca, R., Domizi, J. and Magagnini, E. (2016), "Damaged RC beams strengthened with NSM CFRP rectangular rods under vibration in different constrain conditions", Compos. Struct., 154, 660-683. https://doi.org/10.1016/j.compstruct.2016.07.044.
  12. Chaohua, J., Ke, F. and Da, C. (2014) "Experimental study on the mechanical properties and microstructure of chopped basalt fiber reinforced concrete", Mater. Des., 58, 187-193. https://doi.org/10.1016/j.matdes.2014.01.056.
  13. Constatine, E.C., Chris, G.K., Georgia, M.A., Nikos, A.P., Maria, J.F. and Costas, P.P. (2016), "Applications of smart piezoelectric materials in a wireless admittance monitoring system (WiAMS) to structures-Tests in RC beams", Case Stud. Constr. Mater., 5, 1-18. https://doi.org/10.1016/j.cscm.2016.03.003.
  14. Dawood, E.T. and Ramli, M. (2010), "Development of high strength flowable mortar with hybrid fiber", Constr. Build. Mater., 6, 1043-1050. https://doi.org/10.1016/j.conbuildmat.2010.11.008.
  15. Di Prisco, M., Lamperti, T. and Lapolla, S. (2008), "HPFRCC thin plates for precast roofing", Procedings of the Second International Symposium on Ultra-high Performance Concrete.
  16. Filip, G., Michal, M. and Tomasz, T. (2019), "Mechanical properties of fiber reinforced concrete with recycled fibers", Constr. Build. Mater., 198, 323-331. https://doi.org/10.1016/j.conbuildmat.2018.11.183.
  17. Ganesan, N., Indira, P.V. and Himasree, P.R. (2018), "Strength and behavior of bamboo reinforced concrete wall panels under two way in-plane section", Adv. Concrete Constr., 6(1), 1-13. https://doi.org/10.12989/acc.2018.6.1.001.
  18. Hamed, A., Iman, M.N., Saman, R.R. and Ahmed, A. (2018), "Experimental measurement of dynamic properties of composite slabs from frequency response", Measure., 114, 150-161. https://doi.org/10.1016/j.measurement.2017.09.030.
  19. Huang, X., Ma, G.W. and Li, J.C. (2010), "Damage assessment of reinforced concrete structural elements subjected to blast load", Int. J. Protect. Struct., 1(1), 103-124. https://doi.org/10.1260/2041-4196.1.1.103.
  20. Huszav, Z. (2008), "Vibrations of cracked reinforced and pre-stressed concrete beams", Arch. Civil Mech. Eng., 6(2), 155-164. https://doi.org/10.2298/FUACE0802155H.
  21. IS 12269 (1987), Indian Standard Specification for 53 Grade Ordinary Portland Cement.
  22. IS 383 (1999), Indian Standard Specification for Coarse and Fine Aggregates from Natural Source for Concrete.
  23. Kim, D.J., Park, S.H. and Ryu, G.S. (2011), "Comparative flexural behavior of hybrid ultra-high performance FRC with different micro fibers", Constr. Build. Mater., 25(11), 4144-4155. https://doi.org/10.1016/j.conbuildmat.2011.04.051.
  24. Lim, J.C. and Ozbakkaloglu, T. (2014), "Influence of silica fume on stress-strain behavior of FRP confined HSC", Constr. Build. Mater., 63, 11-24. https://doi.org/10.1016/j.conbuildmat.2014.03.044.
  25. Muntean, R., Cazacu, C. and Mizgan, P. (2017), "Practical applications of dispersely reinforce concrete with polypropylene fibers", Procedia Eng., 181, 285-292. https://doi.org/10.1016/j.proeng.2017.02.391
  26. Naaman, A.E. and Reinhardt, H.W. (2006), "Proposed classification of HPFRC composites based on their tensile response", Mater. Struct., 39(5), 547-555. https://doi.org/10.1617/s11527-006-9103-2.
  27. Shahiron, S., Rhys, P., Norazura, M.B. and Karen, M.H. (2013), "Damage classification of reinforced concrete beam by acoustic emission signal analysis", Constr. Build. Mater., 45, 78-86. https://doi.org/10.1016/j.conbuildmat.2013.03.095.
  28. Shaikh, F.U.A. and Taweel, M. (2015), "Compressive strength and flexural behavior of fiber reinforced concrete at elevated temperature", Adv. Concrete Constr., 3(4), 283-293. https://doi.org/10.12989/acc.2015.3.4.283.
  29. Tiberti, G., Minelli, F. and Plizzari, G.A. (2014), "Influence of concrete strength on crack development of SFRC members", Cement Concrete Compos., 45, 176-185. https://doi.org/10.1016/j.cemconcomp.2013.10.004.
  30. Yang, K.H. (2011), "Tests on concrete reinforced with hybrid or monolithic steel and polyvinyl alcohol fibers", ACI Mater. J., 108(6), 664-672.
  31. Yao, W., Li, J. and Wu, K. (2003), "Mechanical properties of hybrid fibers-RC a low fiber volume fraction", Cement Concrete Res., 33(1), 27-30. https://doi.org/10.1016/S0008-8846(02)00913-4.

Cited by

  1. Experimental Investigation of Shear Strength for Steel Fibre Reinforced Concrete Beams vol.15, pp.1, 2019, https://doi.org/10.2174/1874836802115010081