DOI QR코드

DOI QR Code

Impact location on a stiffened composite panel using improved linear array

  • Zhong, Yongteng (College of Mechanical and Electrical Engineering, Wenzhou University) ;
  • Xiang, Jiawei (College of Mechanical and Electrical Engineering, Wenzhou University)
  • 투고 : 2018.10.23
  • 심사 : 2019.04.26
  • 발행 : 2019.08.25

초록

Due to the degradation of beamforming properties at angles close to $0^{\circ}$ to $180^{\circ}$, linear array does not have a complete $180^{\circ}$ inspection range but a smaller one. This paper develops a improved sensor array with two additional sensors above and below the linear sensor array, and presents time difference and two dimensional multiple signal classification (2D-MUSIC) based impact localization for omni-directional localization on composite structures. Firstly, the arrival times of impact signal observed by two additional sensors are determined using the wavelet transform and compared, and the direction range of impact source can be decided in general, $0^{\circ}$ to $180^{\circ}$ or $180^{\circ}$ to $360^{\circ}$. And then, 2D-MUSIC based spatial spectrum formula using uniform linear array is applied for locate accurate position of impact source. When the arrival time of impact signal observed by two additional sensors is equal, the direction of impact source can be located at $0^{\circ}$ or $180^{\circ}$ by comparing the first and last sensor of linear array. And then the distance is estimated by time difference algorithm. To verify the proposed approach, it is applied to a quasi-isotropic epoxy laminate plate and a stiffened composite panel. The results are in good agreement with the actual impact occurring position.

키워드

과제정보

연구 과제 주관 기관 : National Science Foundation of China

참고문헌

  1. Agarwal, K. and Machan, R. (2016), "Multiple Signal Classification Algorithm For Super-Resolution Fluorescence Microscopy", Nat. Commun., 7, 13752. https://doi.org/10.1038/ncomms13752.
  2. Cheng, X.Q., Zhao, W.Y., Liu, S.F., Xu, Y.Y. and Bao, JW. (2014), "Damage of scarf-repaired composite laminates subjected to low-velocity impacts", Steel Compos. Struct., 17(2), 199-213. https://doi.org/10.12989/scs.2014.17.2.199.
  3. Chang, C.M., Chou, J.Y., Tan, P. and Wang, L. (2017), "A sensor fault detection strategy for structural health monitoring systems", Smart Struct. Syst., 20(1): 43-52. https://doi.org/10.12989/sss.2017.20.1.043.
  4. Chen, X. (2010), "Multiple signal classification method for detecting point-like scatterers embedded in an inhomogeneous background medium", J. Acoust. Soc. Am., 127(4), 2392. https://doi.org/10.1121/1.3303984.
  5. Engholm, M. and Stepinski, T. (2011), "Direction of arrival estimation of Lamb waves using circular arrays", Struct. Health Monit., 10(5), 467-480. https://doi.org/10.1177/1475921710379512
  6. Giurgiutiu, V. (2014), Structural Health Monitoring with Piezoelectric Wafer Active Sensors (2nd Ed.), Elsevier, Waltham, MA, USA.
  7. Jeong, H. (2001), "Analysis of plate wave propagation in anisotropic laminates using a wavelet transform", NDT & E Int., 34(3), 185-190. https://doi.org/10.1016/s0963-8695(00)00056-6.
  8. Mahzan, S.,. Staszewski, W.J. and Worden, K. (2010), "Experimental studies on impact damage location in composite aerospace structures using genetic algorithms and neural networks", Smart Struct. Syst., 6(2), 838-844. https://doi.org/10.12989/sss.2010.6.2.147.
  9. Moon, Y.S., Lee, S.K., Shin, K. and Lee, Y.S. (2011), "Identification of multiple impacts on a plate using the timefrequency analysis and the kalman filter", J. Intel. Mat. Syst. Str., 22(12), 1283-1291. https://doi.org/10.1177/1045389X11411216.
  10. Purekar, S., Pines, D., Sundararaman, S. and Adams, D. (2004). "Directional piezoelectric phased array filters for detecting damage in isotropic plates", Smart. Mater. Struct., 13(4), 838-850. https://doi.org/10.1088/0964-1726/13/4/022.
  11. Purekar, A. and Pines, D. (2010), "Damage detection in thin composite laminates using piezoelectric phased sensor arrays and guided lamb wave interrogation", J. Intel. Mat. Syst. Str., 21(10), 995-1010. https://doi.org/10.1177/1045389X10372003.
  12. Qiu, L., Yuan, S., Zhang, X. and Wang, Y. (2011), "A time reversal focusing based impact imaging method and its evaluation on complex composite structures", Smart. Mater. Struct., 20(10), 105014. https://doi.org/10.1088/0964-1726/20/10/105014.
  13. Qiu, L. and Yuan, S. (2009), "On development of a multi-channel PZT array scanning system and its evaluating application on UAV wing box", Sensor. Actuat. A-Phys., 151(2), 220-230. https://doi.org/10.1016/j.sna.2009.02.032.
  14. Ren, Y., Qiu, L., Yuan, S. and Su, Z. (2017), "A diagnostic imaging approach for online characterization of multi-impact in aircraft composite structures based on a scanning spatialwavenumber filter of guided wave". Mech. Syst. Signal Pr., 90: 44-63. https://doi.org/10.1016/j.ymssp.2016.12.005.
  15. Reynolds, W., Doyle, D., Brown, J. and Arritt, B. (2010), "Wave Propagation in Rib-Stiffened Structures: Modeling and Experiments", Proceedings of the ASME 2010 Conference on Smart Materials, Adaptive Structures and Intelligent Systems, Philadelphia, October.
  16. Wang, Y., Yuan, S. and Qiu, L. (2011), "Improved wavelet-based spatial filter of damage imaging method on composite structures", Chinese J. Aeronaut. 24(5), 665-672. https://doi.org/10.1016/S1000-9361(11)60078-2.
  17. Wang, Z., Yuan, S., Qiu, L. and Liu, B. (2015), "Omni-directional damage detection and localization with a cruciform piezoelectric ultrasonic phased array", J. Vibroeng., 17(5), 2338-2349.
  18. Yang, H., Lee, Y. and Lee, S. (2013), "Impact source localization in plate utilizing multiple signal classification", P I Mech. Eng., C-J MES., 227(C4), 703-713. https://doi.org/10.1177/0954406212452233
  19. Yuan, S., Lai, X., Zhao, X., Xu, X. and Zhang, L. (2005), "Distributed structural health monitoring system based on smart wireless sensor and multi-agent technology", Smart. Mater. Struct,, 15(1), 1-8. https://doi.org/10.1088/0964-1726/15/1/029.
  20. Yuan, S., Zhong, Y., Qiu, L. and Wang, Z. (2014), "Twodimensional near-field multiple signal classification algorithm-based impact localization", J. Intel. Mat. Syst. Str., 26(4), 400-413. https://doi.org/10.1177/1045389X14529026.
  21. Yang, H., Shin, T.J. and Lee, S.K. (2014), "Source location in plates based on the multiple sensors array method and wavelet analysis", J. Mech. Sci. Techenol., 28(1), 1-8. https://doi.org/10.1007/s12206-013-0938-5.
  22. Yuan, S., Bao, Q., Qiu, L. and Zhong, Y. (2015),"A single frequency component-based re-estimated MUSIC algorithm for impact localization on complex composite structures", Smart. Mater. Struct., 24(10), 105021. https://doi.org/10.1088/0964-1726/24/10/105021.
  23. Zhong, Y., Yuan, S. and Qiu, L. (2014), "Multi-impact source localisation on aircraft composite structure using uniform linear PZT sensors array", Struct. Infrastruct. E., 11(3), 310-320. https://doi.org/10.1080/15732479.2013.878732.
  24. Zhong, Y. and Xiang, J. (2016), "A two-dimensional plumblossom sensor array-based multiple signal classification method for impact localization in composite structures". Comput.-Aided Civ. Inf., 31(8), 633-643. https://doi.org/10.1111/mice.12198.