DOI QR코드

DOI QR Code

Research on eccentric compression of ultra-high performance fiber reinforced concrete columns

  • Ma, Kaize (Department of Civil Engineering, Chang'an University) ;
  • Ma, Yudong (Department of Civil Engineering, Chang'an University) ;
  • Liu, Boquan (Department of Civil Engineering, Chang'an University)
  • 투고 : 2019.02.18
  • 심사 : 2019.03.30
  • 발행 : 2019.08.10

초록

To study the eccentric compression behavior of ultra-high performance fiber reinforced concrete (UHPFRC) columns, six UHPFRC columns and one high-strength concrete (HSC) column were tested. Variation parameters include load eccentricity, volume of steel fibers and stirrup ratio. The crack pattern, failure mode, bearing capacity, and deformation of the specimens were studied. The results showed that the UHPFRC columns had different failure modes. The large eccentric compression failure mode was the longitudinal tensile reinforcements yielded and many horizontal cracks appeared in the tension zone. The small eccentric compression failure mode was the longitudinal compressive reinforcements yielded and vertical cracks appeared in the compressive zone. Because of the bridging effect of steel fibers, the number of cracks significantly increased, and the width of cracks decreased. The load-deflection curves of the UHPFRC columns showed gradually descending without sudden dropping, indicating that the specimens had better deformation. The finite element (FE) analysis was performed to stimulate the damage process of the specimens with monotonic loading. The concrete damaged plasticity (CDP) model was adopted to characterize the behaviour of UHPFRC. The contribution of the UHPFRC tensile strength was considered in the bearing capacity, and the theoretical calculation formulas were derived. The theoretical calculation results were consistent with the test results. This research can provide the experimental and theoretical basis for UHPFRC columns in engineering applications.

키워드

과제정보

연구 과제 주관 기관 : National Natural Science Foundation of China, Natural Science Foundation of Shanxi Province

참고문헌

  1. Abaqus 6.11 (2011), Abaqus Analysis User's Manual Dassault Systemes, Hibbit, Karlsson and Sorensen. Inc., RI, USA.
  2. AFGC (Association Francaise du Genie Civil) (2013), Ultra High Performance Fibre-Reinforced Concretes, AFGC, Bagneux, France.
  3. Al-Osta M.A., Isa, M.N. and Baluch, M.H. (2017), "Flexural behavior of reinforced concrete beams strengthened with ultrahigh performance fiber reinforced concrete", Construct. Build. Mater., 134(3), 279-296. https://doi.org/10.1016/j.conbuildmat.2016.12.094.
  4. ASTM C1609-12. (2012), Standard Test Method for Flexural Performance of Fiber-Reinforced Concrete (Using Beam with Third-Point Loading), ASTM International, West Conshohocken, USA.
  5. Belarbi, A. and Hsu, T.T.C. (1994), "Constitutive laws of concrete in tension and reinforcing bars stiffened by concrete", ACI Struct. J., 91(4), 465-474.
  6. Alsalman, A., Dang, C.N. and Hale, W.H. (2017), "Development of ultra-high performance concrete with locally available materials", Construct. Build. Mater., 133(2), 135-145. https://doi.org/10.1016/j.conbuildmat.2016.12.040.
  7. Chen, S.M., Zhang, R., Jia, L.J. and Wang, J.Y. (2018), "Flexural behaviour of rebar-reinforced ultra-high performance concrete beams", Mag. Concrete Res., https://doi.org/10.1680/jmacr.17.00283.
  8. CSTCC (Chinese Standardization Technical Committee of Concrete) (2015), "Reactive powder concrete", GB/T 31387-2015; China Stand Press, Beijing, China.
  9. Fehling, E., Schmidt, M., Walraven, J., Leutbecher, T. and Frohlich, S. (2014), Ultra-High Performance Concrete UHPC: Fundamentals, Design, Examples, Ernst and Sohn, Berlin, Germany.
  10. FHWA (2013), "Ultra-high performance concrete: A state-of-theart report for the bridge community", FHWA-HRT-13-060;FHWA, Washington, DC, USA.
  11. Graybeal, B.A. (2007), "Compressive behavior of ultra-high performance fiber reinforced concrete", ACI Mater. J., 104(2), 146-152.
  12. Habel, K., Viviani, M., Denarie, E. and Bruhwiler, E. (2006), "Development of the mechanical properties of an ultra-high performance fiber reinforced concrete", Cement Concrete Res., 36(7), 1362-1370. https://doi.org/10.1016/j.cemconres.2006.03.009.
  13. Heinz, D., Urbonas, L. and Gerlicher, T. (2012), "Effect of heat treatment method on the properties of UHPC", Proceedings of Hipermat 3rd International Symposium on UHPC and Nanotechnology for High Performance Construction Materials, Kassel, Germany, March.
  14. Hoang, A.L. and Fehling, E. (2017), "Influence of steel fiber content and aspect ratio on the uniaxial tensile and compressive behavior of ultra-high performance concrete", Construct. Build. Mater., 153(10), 790-806. https://doi.org/10.1016/j.conbuildmat.2017.07.130.
  15. Hosinieh, M.M. and Aoude, H. (2015), "Behavior of ultra-high performance fiber reinforced concrete columns under pure axial loading", Eng. Struct., 99(9), 388-401. https://doi.org/10.1016/j.engstruct.2015.05.009.
  16. Hu, A.X., Yu, J., Liang, X.W. and Shi, Q.X. (2018), "Tensile characteristics of ultra-high-performance concrete", Mag. Concrete Res., 70(6), 314-324. https://doi.org/10.1680/jmacr.17.00126.
  17. JSCE (Japan Society of Civil Engineers) (2006), "Recommendations for design and construction of ultra-high strength fiber reinforced concrete structures (Draft)", JSCE, Tokyo, Japan.
  18. KCI (Korea Concrete Institute) (2012), KCI-M-12-003: Design Recommendations for Ultra-high Performance Concrete, Korea Concrete Institute, Seoul, Korea.
  19. Kazemi, S., and Lubell, A.S. (2012), "Influence of specimen size and fiber content on mechanical properties of ultra-highperformance fiber-reinforced concrete", ACI Mater. J., 109(6), 75-684.
  20. Larrard, F., and Sedran, T. (1994), "Optimization of ultra-high performance concrete by the use of a packing model", Cement Concrete Res., 24(6), 997-1009. https://doi.org/10.1016/0008-8846(94)90022-1.
  21. Lubliner, J., Oliver, J., Oller, S., and Onate, E. (1989), "A plasticdamage model for concrete", J. Solids Struct., 25(3), 299-326. https://doi.org/10.1016/0020-7683(89)90050-4.
  22. Magureanu, C., Sosa, I., Negrutiu, C. and Heghes, B. (2012), "Mechanical properties and durability of ultra-high-performance concrete", ACI Mater. J., 109(2), 177-184.
  23. MHURDC (Ministry of Housing and Urban-Rural Development of China) (2010), "Code for design of concrete structures", GB50010-2010; Chinese Architecture and Building Press, Beijing, China.
  24. Qi, J.N., Ma, Z.J. and Wang, J.Q. (2017), "Flexural response of high-strength steel-ultra-high-performance fiber reinforced concrete beams based on a mesoscale constitutive model: Experiment and theory", Struct. Concrete, 19(3), 1-16. http://doi.org/10.1002/suco.201700043.
  25. Murthy, A.R., Aravindan, M. and Prakasam, G. (2018), "Prediction of flexural behaviour of RC beams strengthened with ultra-high performance fiber reinforced concrete", Struct. Eng. Mech., 65(3), 315-325. https://doi.org/10.12989/sem.2018.65.3.315.
  26. Richard, P. and Cheyrezy, M. (1995), "Composition of reactive powder concretes", Cement Concrete Res., 25(7), 1501-1511. https://doi.org/10.1016/0008-8846(95)00144-2.
  27. Rossi, P. (2001) "Ultra high-performance concrete", Concrete, 23(12), 46-52.
  28. Safdar, M., Matsumoto, T. and Kakuma, K. (2016), "Flexural behavior of reinforced concrete beams repaired with ultra-high performance fiber reinforced concrete (UHPFRC)", Compos. Struct., 157(11), 448-460. https://doi.org/10.1016/j.compstruct.2016.09.010.
  29. Schachinger, I., Hilbig, H. and Stengal, T. (2008), "Effect of curing temperatures at an early age on the long-term strength development of UHPC", Proceedings of the Second International Symposium on Ultra High Performance Concrete, Kassel, Germany, March. 205-212.
  30. Shin H.O., Min, K.H. and Mitchell, D. (2017), "Confinement of ultra-high performance fiber reinforced concrete columns", Compos. Struct., 176(9), 124-142. https://doi.org/10.1016/j.compstruct.2017.05.022.
  31. Singh, M., Sheikh, A.H. and Ali, M.S.M. (2017), "Experimental and numerical study of the flexural behavior of ultra-high performance fibre reinforced concrete beams", Construct. Build. Mater., 8(5), 12-25. https://doi.org/10.1016/j.conbuildmat.2017.02.002.
  32. Su, Y., Wu, C.Q. and Li, J. et al (2017), "Development of novel ultra-high performance concrete: from material to structure", Construct. Build. Mater., 135(3), 517-528. https://doi.org/10.1016/j.conbuildmat.2016.12.175.
  33. Prem, P.R., Murthy, A.R. and Bharatkumar, B.H. (2015), "Influence of curing regime and steel fibres on the mechanical properties of UHPC", Mag. Concrete Res., 67(18), 988-1002. http://dx.doi.org/10.1680/macr.14.00333.
  34. Wang, C., Yang, C. and Liu, F. (2012), "Preparation of ultra-high performance concrete with common technology and materials", Cement Concrete Compos., 34(2), 538-544. https://doi.org/10.1016/j.cemconcomp.2011.11.005.
  35. Wu, Z., Shi, C., He, W. and Wu, L. (2016), "Effects of steel fiber content and shape on mechanical properties of ultra-high performance concrete", Construct. Build. Mater., 103(1), 8-14. https://doi.org/10.1016/j.conbuildmat.2015.11.028.
  36. Xu, S.C., Wu, C.Q. and Liu, Z.X. (2017), "Experimental investigation of seismic behavior of ultra-high performance steel fiber reinforced concrete columns", Eng. Struct., 152(12), 129-148. https://doi.org/10.1016/j.engstruct.2017.09.007.
  37. Yang I.H., Joh C.B. and Kim, B.S. (2012), "Flexural response predictions for ultra-high performance fibre reinforced concrete beams", Mag. Concrete Res., 64(2), 113-127. https://doi.org/10.1680/macr.10.00115.
  38. Yoo, D.Y. and Yoon, Y.S. (2015), "Structural performance of ultrahigh performance concrete beams with different steel fibers", Eng. Struct., 102(11), 409-423. https://doi.org/10.1016/j.engstruct.2015.08.029.
  39. Yoo, D.Y. and Yoon, Y.S. (2016), "A review on structural behavior, design, and application of ultra-high-performance fiberreinforced concrete", J. Concrete Struct. Mater., 10(2), 125-142. https://doi.org/10.1007/s40069-016-0143-x.
  40. Yu, R., Spiesz, P. and Brouwers, H.J.H. (2015), "Development of an eco-friendly Ultra-high performance concrete with efficient cement and mineral admixtures uses", Cement Concrete Compos., 55(1), 383-394. https://doi.org/10.1016/j.cemconcomp.2014.09.024.